Advances in the fatigue assessment of wire ropes

This paper presents the findings from an in-depth analysis of the (axial) stiffness data recorded during tension–tension fatigue tests on wire ropes, particularly in relation to how changes in stiffness during testing relate to changes in rope strength. A linear relationship between stiffness and strength is shown to exist and a methodology presented for quantifying residual strength with applied cycles. New lower bound fatigue lines for six-strand rope and spiral strand are presented which are based on a 10% loss of strength. These new lines have the advantage of having been established using a common discard criterion for wire ropes.     

Effects of heavy metals on the survival ofDiacypris compacta (Herbst) (Ostracoda) from the Coorong,South Australia

The hypermarine southern Coorong is threatened by proposals to drain relatively fresh surface water and groundwater from adjacent agricultural areas into the Coorong. These influent waters carry moderate loads of heavy metals. Acute toxicity of heavy metals toDiacypris compacta, an abundant ostracod in the Coorong, was measured in the laboratory at 18°C in a static system using Coorong water (pH 7.8 salinity 50 ppt). At 4 days (96 h) the mean values of LC₅₀ for copper, zinc, lead and, cadmium respectively were 0.8, 2.1, 3.1 and 4.3 mg L^–1, and at 8 days the respective mean LC₅₀ s were 0.4, 0.7, 2.2 and 1.1 mgL^–1. The effect of two or three metals on mortality was additive in some cases and synergistic in other cases, but generally less than additive. However, in all cases mortality was greater in the presence of two or three metals than in the presence of a single metal. According to ANZECC (1992) guidelines, maximum acceptable concentrations of heavy metals should be no higher than 0.01 x the lowest LC₅₀ value. Using the lowest LC₅₀ values forDiacypris compacta obtained at 8 days, maximum acceptable concentrations in the Coorong would be 4, 5, 9 and 22 gL^–1 for copper, zinc, cadmium and lead respectively, the values for zinc and copper failling below those recommended by ANZECC (1992) for marine waters. Reported concentrations of copper and zinc in surface water and groundwater in areas adjacent to the Coorong sometimes exceed these values, hence drainage of these waters into the Coorong represents a significant hazard to the Coorong biota.     

Community‐Derived Standards for LA‐ICP‐MS U‐(Th‐)Pb Geochronology – Uncertainty Propagation,Age Interpretation and Data Reporting

The LA‐ICP‐MS U‐(Th‐)Pb geochronology international community has defined new standards for the determination of U‐(Th‐)Pb ages. A new workflow defines the appropriate propagation of uncertainties for these data, identifying random and systematic components. Only data with uncertainties relating to random error should be used in weighted mean calculations of population ages; uncertainty components for systematic errors are propagated after this stage, preventing their erroneous reduction. Following this improved uncertainty propagation protocol, data can be compared at different uncertainty levels to better resolve age differences. New reference values for commonly used zircon, monazite and titanite reference materials are defined (based on ID‐TIMS) after removing corrections for common lead and the effects of excess ²³⁰Th. These values more accurately reflect the material sampled during the determination of calibration factors by LA‐ICP‐MS analysis. Recommendations are made to graphically represent data only with uncertainty ellipses at 2s and to submit or cite validation data with sample data when submitting data for publication. New data‐reporting standards are defined to help improve the peer‐review process. With these improvements, LA‐ICP‐MS U‐(Th‐)Pb data can be considered more robust, accurate, better documented and quantified, directly contributing to their improved scientific interpretation.     

Ground-based FTIR Measurements with High Temporal Resolution

We outline how ground-based Fourier transform infrared (FTIR) measurements of stratospheric trace species, obtained with high temporal resolution, could be used to detect filaments of polar vortex air at mid-latitudes and therefore test high spatial resolution chemical transport models (CTMs). Vertical column abundances of HCl, ClONO2, HNO3, N2O and HF have been obtained from FTIR solar absorption measurements made throughout the day from Aberdeen, UK (57°N, 2°W) on several days during winter/spring 1993/94 and 1994/95. The short-timescale ( 2 hours) variability observed in the columns is attributed to real atmospheric variations and is often associated with the passage of high latitude air over Aberdeen. This is confirmed by 3D modelling studies which qualitatively reproduce and rationalise the observed changes in the column data on January 19 1994, January 20 1995 and February 26 1995. We describe the viewing geometry of ground-based FTIR measurements and we suggest a measurement strategy which should maximise the information retrieved on horizontal gradients in stratospheric trace species columns from FTIR measurements.     

Community preparedness for lava flows from Mauna Loa and Hualālai volcanoes,Kona, Hawai‘i

Lava flows from Mauna Loa and Huallai volcanoes are a major volcanic hazard that could impact the western portion of the island of Hawaii (e.g., Kona). The most recent eruptions of these two volcanoes to affect Kona occurred in a.d. 1950 and ca. 1800, respectively. In contrast, in eastern Hawaii, eruptions of neighboring Klauea volcano have occurred frequently since 1955, and therefore have been the focus for hazard mitigation. Official preparedness and response measures are therefore modeled on typical eruptions of Klauea.The combinations of short-lived precursory activity (e.g., volcanic tremor) at Mauna Loa, the potential for fast-moving lava flows, and the proximity of Kona communities to potential vents represent significant emergency management concerns in Kona. Less is known about past eruptions of Huallai, but similar concerns exist. Future lava flows present an increased threat to personal safety because of the short times that may be available for responding.Mitigation must address not only the specific characteristics of volcanic hazards in Kona, but also the manner in which the hazards relate to the communities likely to be affected. This paper describes the first steps in developing effective mitigation plans: measuring the current state of peoples knowledge of eruption parameters and the implications for their safety. We present results of a questionnaire survey administered to 462 high school students and adults in Kona. The rationale for this study was the long lapsed time since the last Kona eruption, and the high population growth and expansion of infrastructure over this time interval. Anticipated future growth in social and economic infrastructure in this area provides additional justification for this work.The residents of Kona have received little or no specific information about how to react to future volcanic eruptions or warnings, and short-term preparedness levels are low. Respondents appear uncertain about how to respond to threatening lava flows and overestimate the minimum time available to react, suggesting that personal risk levels are unnecessarily high. A successful volcanic warning plan in Kona must be tailored to meet the unique situation there.     

Tectonic subsidence history and thermal evolution of the Orange Basin

The Orange Basin offshore southwest Africa appears to represent a classical example of continental rifting and break up associated with large-scale, transient volcanism. The presence of lower crustal bodies of high seismic velocities indicates that large volumes of igneous crust formed as a consequence of lithospheric extension.     

Tungsten isotopes in bulk meteorites and their inclusions—Implications for processing of presolar components in the solar protoplanetary disk

We present high precision, low‐ and high‐resolution tungsten isotope measurements of iron meteorites Cape York (IIIAB), Rhine Villa (IIIE), Bendego (IC), and the IVB iron meteorites Tlacotepec, Skookum, and Weaver Mountains, as well as CI chondrite Ivuna, a CV3 chondrite refractory inclusion (CAI BE), and terrestrial standards. Our high precision tungsten isotope data show that the distribution of the rare p‐process nuclide ¹⁸⁰W is homogeneous among chondrites, iron meteorites, and the refractory inclusion. One exception to this pattern is the IVB iron meteorite group, which displays variable excesses relative to the terrestrial standard, possibly related to decay of rare ¹⁸⁴Os. Such anomalies are not the result of analytical artifacts and cannot be caused by sampling of a protoplanetary disk characterized by p‐process isotope heterogeneity. In contrast, we find that ¹⁸³W is variable due to a nucleosynthetic s‐process deficit/r‐process excess among chondrites and iron meteorites. This variability supports the widespread nucleosynthetic s/r‐process heterogeneity in the protoplanetary disk inferred from other isotope systems and we show that W and Ni isotope variability is correlated. Correlated isotope heterogeneity for elements of distinct nucleosynthetic origin (¹⁸³W and ⁵⁸Ni) is best explained by thermal processing in the protoplanetary disk during which thermally labile carrier phases are unmixed by vaporization thereby imparting isotope anomalies on the residual processed reservoir.     

Penetrometry of granular and moist planetary surface materials: Application to the Huygens landing site on Titan

The Huygens probe landed on the then unknown surface of Titan in January 2005. A small, protruding penetrometer, part of the Surface Science Package (SSP), was pushed into the surface material measuring the mechanical resistance of the ground as the probe impacted the landing site. We present laboratory penetrometry into room temperature surface analogue materials using a replica penetrometer to investigate further the nature of Titan’s surface and examine the sensor’s capabilities. The results are then compared to the flight instrument’s signature and suggest the Titan surface substrate material consists of sand-sized particles with a mean grain size ～2 mm. A possible thin 7 mm coating with mechanical properties similar to terrestrial snow may overlie this substrate, although due to the limited data we are unable to detect any further layering or grading within the near-surface material. The unusual weakening with depth of the signature returned from Titan has, to date, only been reproduced using a damp sand target that becomes progressively wetter with depth, and supports the suggestion that the surface may consist of a damp and cohesive material with interstitial liquid contained between its grains. Comparison with terrestrial analogues highlights the unusual nature of the landing site material.