Evidence of magmatic CO2-rich fluids in peraluminous graphite-bearing leucogranites from Deep Freeze Range (northern Victoria Land,Antarctica)

Fine-grained peraluminous synkinematic leuco-monzogranites (SKG), of Cambro-Ordovician age, occur as veins and sills (up to 20–30 m thick) in the Deep Freeze Range, within the medium to high-grade metamorphics of the Wilson Terrane. Secondary fibrolite + graphite intergrowths occur in feldspars and subordinately in quartz. Four main solid and fluid inclusion populations are observed: primary mixed CO₂+H₂O inclusions + Al₂SiO₅ ± brines in garnet (type 1); early CO₂-rich inclusions (± brines) in quartz (type 2); early CO₂+CH₄ (up to 4 mol%)±H₂O inclusions + graphite + fibrolite in quartz (type 3); late CH₄+CO₂+N₂ inclusions and H₂O inclusions in quartz (type 4). Densities of type 1 inclusions are consistent with the crystallization conditions of SKG (750°C and 3 kbar). The other types are post-magmatic: densities of type 2 and 3 inclusions suggest isobaric cooling at high temperature (700–550°C). Type 4 inclusions were trapped below 500°C. The SKG crystallized from a magma that was at some stage vapour-saturated; fluids were CO₂-rich, possibly with immiscible brines. CO₂-rich fluids (±brines) characterize the transition from magmatic to post-magmatic stages; progressive isobaric cooling (T<670°C) led to a continuous decrease off _{O 2} can entering in the graphite stability field; at the same time, the feldspars reacted with CO₂-rich fluids to give secondary fibrolite + graphite. Decrease ofT andf _{O 2} can explain the progressive variation in the fluid composition from CO₂-rich to CH₄ and water dominated in a closed system (in situ evolution). The presence of N₂ the late stages indicates interaction with external metamorphic fluids.Contribution within the network Hydrothermal/metamorphic water-rock interactions in crystalline rocks: a multidisciplinary approach on paleofluid analysis. CEC program: Human Capital and Mobility     

Stochastic delineation of wellhead protection area in fractured aquifers and parametric sensitivity study

 In many countries, the setup of protection areas around every drinking water well was instituted at a national level in order to preserve the quality of water as well as the perennially of the resource. Wellhead protection surfaces have been defined using capture zones showing the area influenced by a well within a certain time. A stochastic method is developed for delineating time-related capture zones in fractured aquifers characterised by a low porosity and a high degree of fracturing. The flow velocity within the fractures is determined statistically depending on the distribution of the fracture features and the mass transfer solution is obtained through a particle tracking algorithm. Probabilistic capture zone curves are obtained as a function of the travel time of particles to the well and the percentage of particles apt to be extracted up to this time. A sensitivity study of fracture network parameters leads to the conclusion that orientations and aperture distribution of the fracture sets are of primary importance to the wellhead protection delineation.     

Point of zero charge of weathered forsterite

The point of zero charge of forsterite shifts from an estimated 8.9 for the unaltered mineral to 8.4 and 8.0, respectively, after being weathered artificially for 1 h and 4 h. These results corroborate the presence of magnesium-deficient surfaces on the weathered minerals, also indicated by chemical analyses of the solutions. H⁺ and OH^? are shown to be potential-determining ions in this system     

Influence of different GPS receiver antenna calibration models on geodetic positioning

To better understand how receiver antenna calibration models contribute to GPS positioning error budget, we compare station positions estimated with different calibration models: igs05.atx, igs08.atx and individual antenna calibrations. First, the impact of switching from the igs05.atx antenna calibration model to the igs08.atx antenna calibration model is investigated using the EUREF Permanent Network historical data set from 1996 until April 2011. It is confirmed that these position offsets can be effectively represented by the igs05.atx to igs08.atx latitude-dependent model. Then, we demonstrate that the position offsets resulting from the use of individual calibrations instead of type mean igs08.atx calibrations can reach up to 1 cm in the up component, while in the horizontal, the offsets generally stay below 4 mm. Finally, using six antennas individually calibrated by a robot as well as in an anechoic chamber, we observe a position agreement of 2 mm in the horizontal component and a bias of 5 mm in the up component. Larger position offsets, dependent on the antenna/radome type, are, however, found when these individual calibrations are compared to type mean calibrations of two tested antennas.     

Improvement of distributed snowmelt energy balance modeling with MODIS‐based NDSI‐derived fractional snow‐covered area data

Describing the spatial variability of heterogeneous snowpacks at a watershed or mountain‐front scale is important for improvements in large‐scale snowmelt modelling. Snowmelt depletion curves, which relate fractional decreases in snow‐covered area (SCA) against normalized decreases in snow water equivalent (SWE), are a common approach to scale‐up snowmelt models. Unfortunately, the kinds of ground‐based observations that are used to develop depletion curves are expensive to gather and impractical for large areas. We describe an approach incorporating remotely sensed fractional SCA (FSCA) data with coinciding daily snowmelt SWE outputs during ablation to quantify the shape of a depletion curve. We joined melt estimates from the Utah Energy Balance Snow Accumulation and Melt Model (UEB) with FSCA data calculated from a normalized difference snow index snow algorithm using NASA's moderate resolution imaging spectroradiometer (MODIS) visible (0·545–0·565 µm) and shortwave infrared (1·628–1·652 µm) reflectance data. We tested the approach at three 500 m² study sites, one in central Idaho and the other two on the North Slope in the Alaskan arctic. The UEB‐MODIS‐derived depletion curves were evaluated against depletion curves derived from ground‐based snow surveys. Comparisons showed strong agreement between the independent estimates. Copyright © 2010 John Wiley & Sons, Ltd.     

Intermediate Alkali-Alumino-silicate Aqueous Solutions Released by Deeply Subducted Continental Crust: Fluid Evolution in UHP OH-rich Topaz-Kyanite Quartzites from Donghai (Sulu, China)

Minerals, fluid inclusions and stable isotopes have been studiedin ultrahigh-pressure (UHP) OH-rich topaz–kyanite quartzitesfrom Hushan (west of Dongai), in southern Sulu (China). Thequartzites underwent a metamorphic evolution characterized bya peak stage (3·5 GPa and 730–820°C) with theanhydrous assemblage coesite + kyanite I, followed by an earlynear-isothermal decompression stage (2·9 GPa and 705–780°C)with growth of kyanite II, muscovite, and OH-rich topaz, andby decompression-cooling stages, represented by paragonite (1·9GPa and 700–780°C) and pyrophyllite (0·3 GPaand 400°C) on kyanite (I and II) and OH-rich topaz, respectively.These rocks may exhibit unusually low ¹⁸O and D values acquiredbefore undergoing UHP metamorphism. Five distinct fluid generationsare recognized. Type I: concentrated peak solutions rich inSi, Al, and alkalis, present within multiphase inclusions inkyanite I. Type II: CaCl₂-rich brines present during the growthof early retrograde OH-rich topaz. Type III, IV, and V: lateaqueous fluids of variable salinity, and rare CO₂ present duringamphibolite- and late greenschist-facies conditions. A numberof conclusions may be drawn from these relationships that havean effect on fluid evolution in deeply subducted continentalrocks. (1) At a pressure of about 3·5 GPa alkali–alumino-silicateaqueous solutions, with compositions intermediate between H₂Ofluid and melt (H₂O > 25 and 50 wt %) evolved from quartzites,probably generated by dehydration reactions. (2) During earlydecompression stages, at the transition from UHP to high-pressure(2·9 GPa) conditions, brines of external origin withhigher water contents (82 wt % H₂O) initiated the growth ofOH-rich topaz and muscovite. (3) The subsequent decompression,at P <2 GPa, was defined by a limited circulation of NaClaqueous fluids, and CO₂ infiltration. Overall, fluid inclusionsand stable isotopes highlight a metamorphic fluid–rockinteraction characterized by internally derived intermediateaqueous solutions at UHP, followed by infiltration of Cl-richbrines with higher water activities. KEY WORDS: ultrahigh-pressure metamorphism; OH-rich topaz; fluid inclusions; stable isotopes; supercritical liquids