On the individual calibration of hailpads

This paper is a comparative study between the two most common hailpad calibration systems: one annual calibration of a whole consignment of material, and the individual calibration of each plate after a hailfall. Individual calibration attempts to minimize errors due to differences in sensitivity to the impact of hailstones between plates from the same consignment, or due to differences in the inking process before the actual measurement.The comparison was carried out using calibration data from the past few years in the hailpad network in south-western France, and data from an individual calibration process on material provided by the hailpad network in Lleida (Spain). The same type of material was used in the two cases.The results confirm that the error in measuring hailstone sizes is smaller in the case of an individual calibration of hailpads than when one single calibration process was carried out for a whole consignment. The former is approximately 80% of the latter. However, this error could have been higher if it had not been the same person carrying out the single calibration process and the measuring of the dents: it has been found that differences in the inking process may account for up to 20% of the error in the case of small hailstones. Calibration errors affecting other variables, e.g. energy or parameter λ of the exponential size distribution are generally higher (5% and 18%, respectively) than errors due to the spatial variability of the hailstones. However, the calibration method does not influence the maximum size, since the relative error attributed to the spatial variability is about 8 times the calibration error.In conclusion, if errors in determining energy or parameter λ are to be reduced to a minimum, it is highly advisable to be consistent in applying the measuring procedure (if possible with the same person carrying out the measurements all the time), and even to use individual calibration on each plate, always bearing in mind that technicians have to be trained appropriately in order to achieve the highest possible degree of uniformity.     

Polyphase metamorphism in the eastern Carnic Alps (N Italy–S Austria): clay minerals and conodont Colour Alteration Index evidence

Thermal evolution of the Palaeozoic–Triassic sequences of the Carnic Alps has been characterized by b cell dimension and Kübler Index (illite “crystallinity”) of K-white micas (KI), árkai Index (AI) of chlorites, clay mineral assemblages and conodont Colour Alteration Index (CAI). Data indicate at least two metamorphic events, Variscan and Alpine. In the older event high anchizonal conditions predominated although epizonal conditions were reached over wide areas. It was characterized by low-intermediate pressure facies. The thermal peak was mainly due to an extensional regime during the Bashkirian. A younger thermal overprint generated by Alpine orogeny was of lower grade, reaching high diagenetic–anchizonal conditions characterized by high-pressure facies. Inverted metamorphic patterns are associated with middle to late Miocene thrusting. Hydrothermal alteration in the northern part of the region can be linked with emplacement of Oligocene plutons and high heat flow along the Periadratic lineament. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Nutritional condition of two coastal rocky fishes and the potential role of a marine protected area

Knowledge of the nutritional conditions of coastal commercial fish populations is key to understanding stock health status, and is essential when making reasonable exploitation and management plans. Here, we present the first results on the condition and feeding preferences of two coastal fish species, Diplodus sargus (Linnaeus, 1758) and Pagellus erythrinus (Linnaeus, 1758). Using stable isotope and biochemical analyses, we tested the potential effects of a marine protected area (MPA) and the occurrence of a dramatic coastal storm on the condition and quality of nutrition. The results suggest that both condition (lipids) and nutrition quality (fatty acids, FAs) in P. erythrinus and D. sargus depend upon on food availability in the area in which they were captured. Pagellus erythrinus individuals inside the MPA stored higher quantities of lipids [46.73 ± 19.00 μg lipid·mg organic matter (OM)^?1] than those outside the MPA (15.63 ± 5.30 μg lipid·mg OM^?1) only before the storm. Diplodus sargus showed different FA signatures inside and outside the MPA before and after the storm. These results suggest that D. sargus increased their quality of nutrition inside (16.62 ± 3.17 μg FA·mg OM^?1) versus outside (7.88 ± 2.36 μg FA·mg OM^?1) the MPA, owing to increased food diversity and availability. Conversely, P. erythrinus did not show differences in nutritional quality inside (18.12 ± 1.13 μg FA·mg OM^?1) or outside (18.81 ± 1.42 μg FA·mg OM^?1) the MPA, possibly because of the increase in ingestion not affecting the studied parameters. In P. erythrinus, the FA concentration decreased after the storm, but in D. sargus, a change in lipid composition was observed. These results suggest that P. erythrinus appears to be more impacted by food quality (different saturated and unsaturated FAs) than D. sargus, owing to a more restrictive diet. We hypothesize that the observed differences between inside and outside the MPA are not only related to the degree of protection, but also to the feeding preferences and behaviour of both fishes.     

Tectono-thermal evolution in a region with thin-skinned tectonics: the western nappes in the Cantabrian Zone (Variscan belt of NW Spain)

 The palaeotemperature distribution in the transition from diagenesis to metamorphism in the western nappes of the Cantabrian Zone (Somiedo, La Sobia and Aramo Units) are analysed by conodont colour alteration index (CAI) and illite crystallinity (IC). Structural and stratigraphic control in distribution of CAI and IC values is observed. Both CAI and IC value distributions show that anchizonal conditions are reached in the lower part of the Somiedo Unit. A disruption of the thermal trend by basal thrusts is evidenced by CAI and IC values. There is an apparent discrepancy between the IC and CAI values in Carboniferous rocks of the Aramo Unit; the IC has mainly anchizonal values, whereas the CAI has diagenetic values. Discrepant IC values are explained as a feature inherited from the source area. In the Carboniferous rocks of the La Sobia Unit, both IC and CAI indicate diagenetic conditions. The anchimetamorphism predated completion of emplacement of the major nappes; it probably developed previously and/or during the early stages of motion of the units. Temperature probably decreased when the metamorphosed zones of the sheets rose along ramps and were intensely eroded. In the context of the Iberian Variscan belt, influence of tectonic factors on the metamorphism is greater in the internal parts, where the strain and cleavage are always present, than in the external parts (Cantabrian Zone), where brittle deformation and rock translation are dominant, with an increasing role of the burial on the metamorphism. Received: 11 May 1998 / Accepted: 19 January 1999     

Tectonothermal evolution of a foreland fold and thrust belt: the Cantabrian Zone (Iberian Variscan belt,NW Spain)

Analysis of the conodont colour alteration index and the Kübler index of illite allowed us the characterization of four types of very low‐ or low‐grade metamorphism in the Cantabrian Zone (CZ) and determination of their regional and temporal distribution. These types are: (1) an orogenic Variscan metamorphism present only in restricted areas of the western and north‐western parts of the CZ where epizonal conditions are reached; (2) a burial metamorphism that appears in the basal part of some nappes, where anchizonal conditions are sometimes achieved; the thermal peak preceded emplacement of the nappes; (3) a late‐Variscan metamorphism in the southern and south‐eastern parts of the CZ; a cleavage, cutting most of the Variscan folds, is associated with this metamorphism, which has been related to an extensional episode; (4) a contact metamorphism and hydrothermal activity associated with minor intrusive bodies. The extension continued after the Variscan deformation giving rise to hydrothermal activity during Permian times.