Biological and granulometric controls on sedimentary organic matter of an intertidal mudflat

A variety of measures of organic matter concentration and quality were made on samples collected from the top few mm of intertidal mudflat sediment over the course of a year, in order to assess the relative importance of biological and sedimentological influences on sedimentary organic matter. Winter and summer were times of relatively fine-grained sediment accumulation, caused by biological deposition or stabilization processes and resulting in higher organic matter concentrations. Stable carbon isotope and Br:C ratios indicated a planktonic source of bulk organic matter. Ratios of organic carbon to specific surface area of the sediments were consistent with an organic monolayer coverage of sediment grains. Correction for changing grain size during the year showed no change in the organic concentration per unit surface area, in spite of organic matter inputs by in situ primary production, buildup of heterotroph biomass and mucus coatings, and biodeposition of organic-rich seston. There were also no indications of changes in bulk organic quality, measured as hydrolyzable carbohydrates and amino acids, in response to these biological processes. It is concluded that biological processes on a seasonal time scale affect the bulk organic matter of these sediments via a modulation of grain size rather than creation or decay of organic matter.     

Transforming observational data and theoretical isochrones into the ACS/WFC Vega-mag system

We propose a zero-point photometric calibration of the data from the Advanced Camera for Surveys (ACS) Wide Field Channel (WFC) on board the Hubble Space Telescope , based on a spectrum of Vega and the most up-to-date in-flight transmission curves of the camera. This calibration is accurate at the level of a few hundredths of a magnitude. The main purpose of this effort is to transform the entire set of evolutionary models into a simple observational photometric system for ACS/WFC data, and to make them available to the astronomical community. We provide the zero-points for the most used ACS/WFC bands, and give basic recipes for calibrating both the observed data and the models. We also present the colour–magnitude diagram from ACS data of five Galactic globular clusters, spanning the metallicity range  −2.2 <[Fe/H] < −0.04  , and we provide fiducial points representing their sequences from several magnitudes below the turn-off to the red giant branch tip. The observed sequences are compared with the models in the newly defined photometric system.     

Palaeo-carbonate seep structures above an oil reservoir, Gryphon Field, Tertiary, North Sea

Petrographic and geochemical analyses performed on a North Sea core from the Gryphon Field reveal the presence of palaeo-degassing features surrounded by injected sandstones in the Eocene interval. The injected sandstones are oil-stained and poorly cemented by carbonate and quartz. ¹⁸O isotope analyses indicate that carbonate cementation occurred during shallow burial (likely less than about 300 m). Depleted ¹³C (around –30 V-PDB) carbonate cement suggests that bicarbonate was derived from the microbial oxidation of oil and gas. Late quartz overgrowths enclose oil present in the injected units. The tubular degassing conduits are composed of zoned cements and have ¹⁸O and ¹³C isotope values similar to the injected sandstones, indicating that oil and gas seepage induced the precipitation of authigenic carbonate in the shallow subsurface. Oil inclusions in inter- and intra-crystal cement sites in both injected sandstones and degassing conduits indicate that oil seepage was an ongoing feature at shallow burial. A proposed model involves oil and gas seepage and the formation of the degassing conduits, followed by a sand injection phase. It seems likely that oil and gas continued to leak towards the seabed by exploiting the network of permeable injected sandstones and the horizons of porous degassing features.     

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

Vertical distribution of the macrobenthic community and its relationships to trace metals and natural sediment characteristics in the lower Douro estuary, Portugal

Vertical distribution (0–15 cm) of the macrobenthic community and its relationships to natural sediment characteristics and trace metal contents and bioavailability were studied at five locations in the lower Douro estuary, Portugal. An analysis of vertical metal distribution, for the interpretation of anthropogenic impact on the estuarine sediments, was also investigated. Sediment characterisation included organic matter, grain size, metals (Al, Fe, Cu, Pb, Cr, Ni, Cd, Zn and Mn), acid volatile sulphide (AVS) and simultaneously extracted metals (SEM). The macrobenthic community had low diversity (14 species), was dominated by small size opportunists and seemed to be controlled mainly by natural factors such as grain size distribution, Al and Fe contents and sediment depth. The vertically heterogeneous distribution of macrobenthic community appears to affect redox status of the sediments and consequently metal bioavailability. Despite anthropogenic contamination in terms of Zn, Cu, Pb, Cr and Ni having already been detected in the north bank, the analysis of vertical distribution was essential for the identification of current anthropogenic contamination in terms of Zn, Pb and Cd in the south bank.     

Current trends in Great Lakes shipping

Shipping on the Great Lakes has changed rapidly in recent years. Internal Great Lakes traffic consists almost entirely of bulk movements, primarily of iron ore, coal, limestone, and grain. Ore shipments are mainly of taconite concentrate. Low-sulfur coal from the western areas of the United States is now moving downbound through the lakes, a movement in the opposite direction from the predominantly upbound movement of Appalachian coal. Opening of a larger lock in 1970 between lakes Superior and Huron has initiated a new generation of lake vessels, which are three times the size of the previous lake ships, and are too large to transit the Welland Canal and the St. Lawrence Seaway; for the first time since 1959 the largest “lakers” are land-locked. General cargo traffic between the Great Lakes and overseas has been declining rapidly since 1970, largely as the result of the rapid development of container ships, and the Interstate highway system, which increases the competitive advantages of salt-water ports.     

Organic matter in small mesopores in sediments and soils

The three-way correlation among organic matter concentrations, specific surface area and small mesopores observed for many soils and sediments led to the hypothesis that enclosure within the pores might explain the apparent protection of organic matter by minerals. We test this hypothesis by examining whether the bulk of organic matter resides within small mesopores. Pore volumes as a function of pore width were measured before and after organic matter removal, and the volume differences ascribed to organic matter filling of pores. Minor changes in small mesopore size distributions upon treatments such as centrifugation and muffling indicate the robustness of the mineral matrices that form these pores. We developed an additional method to assess organic matter densities using high-resolution pycnometry, and used these densities to convert pore volumes to organic matter contents. Although smaller mesopores are shown to have sufficient volumes to contain significant fractions of the total organic matter, only small fractions of total organic matter were found to reside in them. These results are consistent with preferential association between organic matter and aluminous clay particle edges, rather than the largely siliceous clay faces that contribute most surface area and form pore walls. While simple enclosure within smaller mesopores cannot, therefore, explain protection, network effects working at larger size scales may account for exclusion of digestive agents and hence organic matter protection.