Buildings Damages after Elazığ, Turkey Earthquake on January 24, 2020

A 6.8-magnitude earthquake that occurred on January 24, 2020, has been effective in Turkey’s eastern regions. The earthquake, with recorded peak ground acceleration (PGA) value of 0.292 g, caused the destruction or heavy damage of buildings, especially in the city center of Elaz?? province. The purpose of this paper was to share the results of detailed investigation in the earthquake-stricken area. Additionally, the causes of damages and failures observed in the buildings were compared to those that had occurred in previous earthquakes in Turkey. In this study, the damages observed in especially RC buildings as well as in masonry and rural buildings were summarized, the lessons learned were evaluated, and the results were interpreted with reference to Turkish earthquake codes. In the study, it was particularly emphasized why the building stock underwent such damage even though the buildings were exposed to earthquake acceleration well below the design acceleration values.

     

Thermal Impact of Residential Ground-Water Heat Pumps

A computer simulation study was conducted to quantify the potential thermal impact of residential water-source heat pump usage on ground-water aquifers. In a first phase of the study, weather data for nine locations throughout the country were used to estimate the energy requirements for heating and air conditioning a typical residence. These energy requirements were then translated into the volumetric water demands for a selected heat pump at each location. A representative model aquifer was then defined and its characteristics used, along with the heat pump water requirements and design ΔT's (difference between inlet and outlet water temperature) to identify the important parameters that contribute to heat transfer and to model the movement of the thermal front resulting from injection of heat pump discharge water at the nine locations. The major factor that determines the heat pump thermal impact was found to be the net amount of heat injected into, or removed from an aquifer. Other significant factors included well design, heat pump design ΔT, and physical properties of the aquifer such as thickness, porosity and dispersivity. The study showed that, in climates where winter heating demand is very nearly equal to summer cooling demands, the injection of heat pump discharge water did not cause any significant modification of the ambient model aquifer temperature. However, in hot or cold climates where air conditioning or heating demand dominates, measurable thermal changes occurred in the model aquifer. In most cases, the maximum temperature     

Petrogenesis of ultramafic and mafic rocks of the Thompson Nickel Belt,Manitoba

Abundant sill-like bodies of serpentinized ultramafic rocks, with associated nickel sulfide deposits, are found on the western side of the Thompson Nickel Belt near the Moak Lake-Setting Lake cataclastic fault zone. The ultramafic rocks range in composition from dunite to orthopyroxenite and feature variable alteration. Chemical variation across the bodies is suggestive of in-situ differentiation controlled mainly by olivine and orthopyroxene. Relative abundances of some elements, incompatible for olivine and orthopyroxene, suggest a parental liquid of komatiitic affinity. Ultramafic and mafic rocks are petrogenetically linked. A high degree of partial melting of mantle material and subsequent low-pressure crystal fractionation are responsible for the spectrum of composition from ultramafic to mafic.Publication 19-84, Ottawa-Carleton Centre for Geoscience Studies     

Effect of attachment configuration on the trapping efficiency of Vaseline-coated slide catchers for windblown particles

There are various types of the windblown sediment traps developed for wind tunnel and field studies. One of the main supports expected from these traps is in measuring surface dust concentrations to appropriately derive flux equations. The measurement performance and accuracy of a trap is very important and depends strictly upon the physical characteristics and the behaviors of dust grains with air flows. This paper presents the measurement results of static pressure distribution (SPD) of wind flow around Vaseline-coated slide (VCS) catchers with an aim of finding out whether or not particle trapping efficiency (η) of the VCS is related to the SPD. The SPD was evaluated by a wind reduction coefficient (R _c) in a series of wind tunnel experiments with different VCS settings which have different attachment configurations on a pole. Three VCS configurations were considered: a configuration on a circular plastic pole (CPP) and two configurations on wooden square poles (WSP₁ and WSP₂, respectively). Thus, the primary contribution of this work was to experimentally analyze the effect of the different attachment configurations on the SPD, and the secondary objective was to determine the effect of the SPD on the η. It was shown that spatial correlation and spatial pattern of the R _c were different in the surrounding area of each configuration, and ANOVA and DUNCAN tests indicated that η(s) of WSP₁, WSP₂, and CPP were different at the significant level of P ≤ 0.05 with the mean of 0.94 ± 0.09, 0.63 ± 0.14, and 1.13 ± 0.07, respectively. Additionally, the amount of PM₂₀, PM₄₀, PM₆₀, PM₈₀, and PM₁₀₀ trapped by the configurations of WSP₁, WSP₂, and CPP considerably varied depending upon the particular aerodynamic circumstances associated with every configuration.     

Kinematics of the eastern part of the North Anatolian Fault Zone

The North Anatolian Fault Zone (NAFZ), which marks the boundary between Anatolia and the Eurasian plate, is one of the world's most seismically active structures. Although the eastern part of NAFZ has high seismic hazard, there is a lack of geodetic information about the present tectonics of this region. Even though many scientists would like to study this area, geographical and logistical problems make performing scientific research difficult. In order to investigate contemporary neotectonic deformation on the eastern NAFZ and in its neighborhood, a relatively dense Global Positioning System (GPS) monitoring network was established in 2003. Geodetic observations were performed in three GPS campaigns in an area of 350 km × 200 km with 12-month intervals. In addition, 14 new GPS stations were measured far from the deforming area. Since this region includes the intersection of the NAFZ and the East Anatolian Fault Zone (EAFZ), deformation is complex and estimating seismic hazard is difficult. One important segment is the Yedisu segment and it has not broken since the 1784 earthquake. After the 1992 Erzincan and 2003 Pulumur earthquakes, the Coulomb stress loading on the Yedisu segment of the NAFZ has increased significantly, emphasizing the need to monitor this region. We computed the horizontal velocity field with respect to Eurasia and strain rates field as well. GPS-derived velocities relative to Eurasia are in the range of 16–24 mm/year, which are consistent with the regional tectonics. The principal strain rates were derived from the velocity field. Results show that strain is accumulating between the NAFZ and EAFZ along small secondary fault branches such as the Ovacik Fault (OF).     

A comparative analysis of gridding systems for point-based land cover/use analysis

For spatial analyses, raster land cover/use maps are converted into points, where each point holds attribute of its corresponding land cover/use. However, these are not identical in terms of areas or shapes; thus assigning a point to each isolated shape is not an adequate solution and for that gridding is suggested. Square, hexagon and triangle are among the basic land use gridding systems where each of them has its own advantages in such process. This research aims to compare the systems in providing accurate representations of the original land cover/use maps, assess the data loss while increasing resolution and suggest suitable gridding system. The research finds the errors in area and feature numbers as criteria for selected classes. Modules that find out errors in each scale considering each criterion and class alone are proposed. The modules suggest both the best system for each criterion alone and for combined criteria.     

Integrated Radiolaria,benthic foraminifera and conodont biochronology of the pelagic Permian blocks/tectonic slices and geochemistry of associated volcanic rocks from the Mersin Mélange,southern Turkey: Implications for the Permian evolution of the northern Neotethys

Blocks and tectonic slices within the Mersin Mélange (southern Turkey), which are of Northern Neotethyan origin (Izmir–Ankara–Erzincan Ocean (IAE)), were studied in detail by using radiolarian, conodont, and foraminiferal assemblages on six different stratigraphic sections with well‐preserved Permian succesions. The basal part of the Permian sequence, composed of alternating chert and mudstone with basic volcanics, is assigned to the late Asselian (Early Permian) based on radiolarians. The next basaltic interval in the sequence is dated as Kungurian. The highly alkaline basic volcanics in the sequence are extremely enriched, similar to kimberlitic/lamprophyric magmas generated at continental intraplate settings. Trace element systematics suggest that these lavas were generated in a continental margin involving a metasomatized subcontinental lithospheric mantle source (SCLM). The middle part of the Permian sequences, dated by benthic foraminifera and conodont assemblages, includes detrital limestones with chert interlayers and neptunian dykes of middle Wordian to earliest Wuchiapingian age. Higher in the sequence, detrital limestones are overlain by alternating chert and mudstone with intermittent microbrecciated beds of early Wuchiapingian to middle Changhsingian (Late Permian) age based on the radiolarians. A large negative shift at the base of the Lopingian at the upper part of section is correlated to negative shifts at the Guadalupian/Lopingian boundary associated with the end‐Guadalupian mass extinction event. All these findings indicate that a continental rift system associated with a possible mantle plume existed during the late Early to Late Permian period. This event was responsible for the rupturing of the northern Gondwanan margin related to the opening of the IAE Ocean. When the deep basinal features of the Early Permian volcano‐sedimentary sequence are considered, the proto IAE oceanic crust formed possibly before the end of the Permian. This, in turn, suggests that the opening of the IAE Ocean dates back to as early as the Permian.