Photometry of pluto in the last decade and before: evidence for volatile transport?

Photometric observations of Pluto in the BVR filter system were obtained in 1999 and in 1990-1993, and observations in the 0.89-μm methane absorption band were obtained in 2000. Our 1999 observations yield lightcurve amplitudes of 0.30 ± 0.01, 0.26 ± 0.01, and 0.21 ± 0.02 and geometric albedos of 0.44 ± 0.04, 0.52 ± 0.03, and 0.58 ± 0.02 in the B, V, and R filters, respectively. The low-albedo hemisphere of Pluto is slightly redder than the higher albedo hemisphere. A comparison of our results and those from previous epochs shows that the lightcurve of Pluto changes substantially through time. We developed a model that fully accounts for changes in the lightcurve caused by changes in the viewing geometry between the Earth, Pluto, and the Sun. We find that the observed changes in the amplitude of Pluto’s lightcurve can be explained by viewing geometry rather than by volatile transport. We also discovered a measurable decrease since 1992 of ∼0.03 magnitudes in the amplitude of Pluto’s lightcurve, as the model predicts. Pluto’s geometric albedo does not appear to be currently increasing, as our model predicts, although given the uncertainties in both the model and the measurements of geometric albedo, this result is not firm evidence for volatile transport. The maximum of methane-absorption lightcurve occurs near the minimum of the BVR lightcurves. This result suggests that methane is more abundant in the brightest regions of Pluto. Pluto’s phase coefficient exhibits a color dependence, ranging from 0.037 ± 0.01 in the B filter to 0.032 ± 0.01 in the R filter. Pluto’s phase curve is most like those of the bright, recently resurfaced satellites Triton and Europa. Although Pluto shows no strong evidence for volatile transport now (unlike Triton), it is important to continue to observe Pluto as it moves away from perihelion.     

Search For Correlations Between Batse Gamma-Ray Bursts and Supernovae

We report on our statistical research of space–time correlated supernovae and CGRO-BATSE gamma-ray bursts (GRBs). There exists a significantly higher abundance of core-collapse supernovae among the correlated supernovae, but the subset of all correlated objects does not seem to be physically different from the whole set.     

The spectral variability of Triton from 1997-2000

We present the results of a three-year observational program of long-slit spectroscopy and UBVRI photometry of Triton. We find evidence for short-lived albedo variations at wavelengths less than 0.5 μm with the most notable reddening event measured in October 1997 and “normal” colors returning by May 1998. We report a possible variation in the relative 0.73/0.89 μm methane absorption band strengths, suggesting that the transport or denudation of this species may play a major role in the reddening events.     

Photometry of rough planetary surfaces: The role of multiple scattering

Topographic features affect the scattering properties of planetary surfaces by casting shadows and altering the local incidence and emission angles. Measurements of this phenomenon were obtained on the Cornell goniometer for both high and low albedo surfaces. For the low albedo surface, the decrease in reflected radiation due to topography increases sharply with increasing phase angle, whereas for the high albedo sample the effects are approximately constant between phase angles of 30 and 70°. The observations are in good agreement with a theoretical model in the case of the dark surface. However, for the high albedo surface the model overestimates the effects by about a factor of 2, since it does not include the partial illumination of shadows by multiple scattering. For both high and low albedo surfaces, the effects of topography do not become significant until a phase angle of 30–40°.     

Stability at high-pressure,elastic behaviour and pressure-induced structural evolution of CsAlSi<Subscript>5</Subscript>O<Subscript>12</Subscript>, a potential host for nuclear waste

The elastic and structural behaviour of the synthetic zeolite CsAlSi₅O₁₂ (a = 16.753(4), b = 13.797(3) and c = 5.0235(17) Å, space group Ama2, Z = 2) were investigated up to 8.5 GPa by in situ single-crystal X-ray diffraction with a diamond anvil cell under hydrostatic conditions. No phase-transition occurs within the P-range investigated. Fitting the volume data with a third-order Birch–Murnaghan equation-of-state gives: V ₀ = 1,155(4) ų, K _T0 = 20(1) GPa and K′ = 6.5(7). The “axial moduli” were calculated with a third-order “linearized” BM-EoS, substituting the cube of the individual lattice parameter (a ³, b ³, c ³) for the volume. The refined axial-EoS parameters are: a ₀ = 16.701(44) Å, K _T0a = 14(2) GPa (β_a = 0.024(3) GPa^?1), K′ _a = 6.2(8) for the a-axis; b ₀ = 13.778(20) Å, K _T0b = 21(3) GPa (β_b = 0.016(2) GPa^?1), K′ _b = 10(2) for the b-axis; c ₀ = 5.018(7) Å, K _T0c = 33(3) GPa (β_c = 0.010(1) GPa^?1), K′ _c = 3.2(8) for the c-axis (K _T0a:K _T0b:K _T0c = 1:1.50:2.36). The HP-crystal structure evolution was studied on the basis of several structural refinements at different pressures: 0.0001 GPa (with crystal in DAC without any pressure medium), 1.58(3), 1.75(4), 1.94(6), 3.25(4), 4.69(5), 7.36(6), 8.45(5) and 0.0001 GPa (after decompression). The main deformation mechanisms at high-pressure are basically driven by tetrahedral tilting, the tetrahedra behaving as rigid-units. A change in the compressional mechanisms was observed at P ≤ 2 GPa. The P-induced structural rearrangement up to 8.5 GPa is completely reversible. The high thermo-elastic stability of CsAlSi₅O_12, the immobility of Cs at HT/HP-conditions, the preservation of crystallinity at least up to 8.5 GPa and 1,000°C in elastic regime and the extremely low leaching rate of Cs from CsAlSi₅O₁₂ allow to consider this open-framework silicate as functional material potentially usable for fixation and deposition of Cs radioisotopes.     

Recruitment patterns of Serpula vermicularis L. (Polychaeta, Serpulidae) in Loch Creran, Scotland

This study aimed to contribute to conservation management of reefs of Serpula vermicularis by increasing understanding of the factors influencing larval settlement. The study was carried out in Loch Creran, which supports the most extensive known development of S. vermicularis reefs in the world. Settlement plates were deployed to examine the influence of season, depth, reef density, substrate type and orientation. Monthly deployment of plates revealed settlement of S. vermicularis to occur predominantly from mid-June to mid-October, peaking in late August to early September. Settlement of Pomatoceros spp. peaked much earlier, in late May to early June. Deployment of plates at different depths revealed a marked reduction in S. vermicularis settlement intensity between 6 and 12 m. As this corresponds with the deeper limit of the peripheral fringe of serpulid reefs in the loch, it is suggested that this limit is imposed by a depth-correlated settlement response, rather than reduction in available substrata. Comparisons of various substrata showed a preference by S. vermicularis larvae for a slate over a scallop substrate and no evidence of enhanced recruitment to occupied or unoccupied tubes of S. vermicularis, suggesting that gregarious attraction is unlikely to be a factor causing reef formation. Settlement onto the upper side of a horizontal scallop substrate was found to be insignificant in comparison with the underside or a vertically orientated scallop. Evidence for the role of light in controlling the depth and substrate-orientation preferences of S. vermicularis larvae is discussed. Based on the results of this study, recommendations are made regarding remediation of areas suffering reef damage.     

Mercury speciation in surface and deep waters of the Mediterranean Sea

Mercury speciation and its distribution in surface and deep waters of the Mediterranean Sea were studied during two oceanographic cruises on board the Italian research vessel URANIA in summer 2003 and spring 2004 as part of the Med Oceaneor and MERCYMS projects. The study included deep water profiles of dissolved gaseous Hg (DGM), reactive Hg (RHg), total Hg (THg), monomethyl Hg (MeHg) and dimethyl Hg (DMeHg) in open ocean waters. Average concentrations of measured Hg species were characterized by seasonal and spatial variations. Overall average THg concentrations ranged between 0.41 and 2.65 pM (1.32 ± 0.48 pM) and were comparable to those obtained in previous studies of the Mediterranean Sea. A significant fraction of Hg was present as “reactive” Hg (average 0.33 ± 0.32 pM). Dissolved gaseous Hg (DGM), which consists mainly of Hg⁰, represents a considerable proportion of THg (average 20%, 0.23 ± 0.11 pM). The portion of DGM typically increased towards the bottom, especially in areas with strong tectonic activity (Alboran Sea, Strait of Sicily, Tyrrhenian Sea), indicating its geotectonic origin. No dimethyl Hg was found in surface waters down to the depth of 40 m. Below this depth, its average concentration was 2.67 ± 2.9 fM. Dissolved fractions of total Hg and MeHg were measured in filtered water samples and were 0.68 ± 0.43 pM and 0.29 ± 0.17 pM for THg and MeHg respectively. The fraction of Hg as MeHg was in average 43%, which is relatively high compared to other ocean environments. The concentrations reported in this study are among the lowest found in marine environments and the quality of analytical methods are of key importance. Speciation of Hg in sea water is of crucial importance as THg concentrations alone do not give adequate data for understanding Hg sources and cycling in marine environments. For example, photoinduced transformations are important for the presence of reactive and elemental mercury in the surface layers, biologically mediated reactions are important for the production/degradation of MeHg and DGM in the photic zones of the water column, and the data for DGM in deep sea indicate the natural sources of Hg in geotectonicaly active areas of the Mediterranean Sea.     

Heavy metals in marine sediments of Taranto Gulf (Ionian Sea, Southern Italy)

Al, Cr, Cu, Fe, Hg, Mn, Ni, Pb, Ti and Zn concentrations have been determined in surface sediment samples collected in the Taranto Gulf (Ionian Sea, Southern Italy) in order to evaluate their levels and spatial distribution in this important area of the Mediterranean Sea. For various metals, the geoaccumulation index has been calculated as a criterion to assess if their concentrations represent contamination levels or can be considered as background levels. The results show that metals concentrations in sediments can be considered near the background levels found in the Mediterranean Sea.Analytical results have been elaborated by using a Geographical Information System (GIS) software to show metals accumulation areas. Using multivariate statistical analysis, we evaluate the possibility to distinguish the sampling stations, in relation to their geographical position. Results have showed metals distribution in the Taranto Gulf is principally influenced by industrial and urban wastes, located mostly in the northern coastal area of the Ionian Sea. Rivers in the Basilicata region and prevailing anticlockwise marine currents are further factors influencing metal accumulation in sediments.     

Modeling of the Guagua Pichincha volcano (Ecuador) lahars

Lahars, here defined as debris flows of volcanic origin, are rapid mass movements that pose a serious threat to cities located in the vicinity of many volcanoes. Quito, capital city of Ecuador and placed at the foot of the Pichincha volcano complex, is exposed to serious inundation hazard as part of the city is built on numerous deposits of large lahars that have occurred in the last 10,000 years.The objective of this paper is to model the potential lahars of the Pichincha volcano to predict inundation areas within the city of Quito. For this purpose two models that apply different approaches were utilized and their results were compared.The programs used were LAHARZ, a semi-empirical model conceived by the United States Geological Survey (USGS), and FLO-2D, a hydraulic model distributed by FLO Software Inc. LAHARZ is designed as a rapid, objective and reproducible automated method for mapping areas of potential lahar inundation (Proc. First Int. Conf. on Debris Flow Hazards Mitigation, San Francisco, USA, ASCE, 1998, p. 176). FLO-2D is a two-dimensional flood routing model for simulating overland flow on complex surfaces such as floodplains, alluvial fans or urbanized areas (FLO-2D Users manual, version 99.2). Both models run within geographical information systems (GIS).Fieldwork was focused on collecting all available information involved in lahar modeling. A total of 49 channel cross-sections were measured along the two main streams and stratigraphic investigations were carried out on the fans to estimate the volume of previous events. A global positioning system was utilized to determine the coordinates of each cross-section. Further data collection concerned topography, rainfall characteristics and ashfall thicknesses. All fieldwork was carried out in cooperation with the Instituto Geofisico of the Escuela Politecnica Nacional.Modeling in a GIS environment greatly aided the exportation of results for the creation of thematic maps and facilitated model comparison. Evaluation of the models was performed by comparing simulation results against each other and against the geometry of existing lahar deposits.