CS,C34S,and CH3OH observations of the molecular cloud associated with NGC 7538

CS(J=1–0), C³⁴S(J=1–0), and CH₃OH(1₀–0₀A and E) emission lines in the core region of molecular cloud associated with NGC 7538 have been surveyed at angular resolution of 33. Distribution of CS column density shows two prominent peaks. Both blue and red wings in CS line are most prominent at 30 northwest of IRS 11.Paper presented at the IAU Third Asian-Pacific Regional Meeting, held in Kyoto, Japan, between 30 September–6 October, 1984.This work was carried out under the common use observation program at the Nobeyama Radio Observatory (NRO). NRO, a branch of the Tokyo Astronomical Observatory, University of Tokyo, is a cosmic radio observing facility open to outside users.     

Annual variation of methane in seawater in Funka bay,Japan

The concentration of methane in seawater was determined approximately once a month for one year from August 1990 to July 1991 at a station close to the center of Funka bay (92 m depth) and some supplementary observations were also carried out. The concentration of methane was usually increased with increasing depth, suggesting that methane was emitted from the bottom of the bay. While highly variable both spatially and temporally, the emission was intense in March and April, a period immediately after the spring bloom of phytoplankton. The maximum of methane found in the intermediate water suggests its source from the slope of the bay. The concentration of methane in the surface water changed seasonally and also interannually. The annually averaged flux of methane transferred to the atmosphere in the bay was estimated to be 6×10^–3 gCH₄m²/day. The coastal zone in the world may be a significant source of the atmospheric methane, although its source strength has yet to be accurately estimated from more data in different coastal seas.     

Influence of Mesoscale Eddies on Variations of the Kuroshio Path South of Japan

The influences of mesoscale eddies on variations of the Kuroshio path south of Japan have been investigated using time series of the Kuroshio axis location and altimeter-derived sea surface height maps for a period of seven years from 1993 to 1999, when the Kuroshio followed its non-large meander path. It was found that both the cyclonic and anticyclonic eddies may interact with the Kuroshio and trigger short-term meanders of the Kuroshio path, although not all eddies that approached or collided with the Kuroshio formed meanders. An anticyclonic eddy that revolves clockwise in a region south of Shikoku and Cape Shionomisaki with a period of about 5–6 months was found to propagate westward along about 30°N and collide with the Kuroshio in the east of Kyushu or south of Shikoku. This collision sometimes triggers meanders which propagate over the whole region south of Japan. The eddy was advected downstream, generating a meander on the downstream side to the east of Cape Shionomisaki. After the eddy passed Cape Shionomisaki, it detached from the Kuroshio and started to move westward again. Sometimes the eddy merges with other anticyclonic eddies traveling from the east. Coalescence of cyclonic eddies, which are also generated in the Kuroshio Extension region and propagate westward in the Kuroshio recirculation region south of Japan, into the Kuroshio in the east of Kyushu, also triggers meanders which mainly propagate only in a region west of Cape Shionomisaki. This revised version was published online in July 2006 with corrections to the Cover Date.     

Seasonal and interannual variations in the East Sakhalin current revealed by TOPEX/POSEIDON altimeter data

Seasonal and interannual variations in the East Sakhalin Current (ESC) are investigated using ten-year records of the sea level anomaly (SLA) observed by the TOPEX/POSEIDON (T/P) altimeter. The T/P SLA clearly documents seasonal and interannual variations in the ESC along the east coast of Sakhalin Island, although sea ice masks the region from January to April. Estimates of surface current velocity anomaly derived from T/P SLA are in good agreement with drifting buoy observations. The ESC is strong in winter, with a typical current velocity of 30–40 cm s⁻¹ in December, and almost disappears in summer. Southward flow of the ESC is confined to the shelf and slope region and consists of two velocity cores. These features of the ESC are consistent with short-term observations reported in previous studies. Analysis of the ten-year records of T/P SLA confirms that the structure of the ESC is maintained each winter and the seasonal cycle is repeated every year, although the strength of the ESC shows large interannual variations. Seasonal and interannual variations in the ESC are discussed in relation to wind-driven circulation in the Sea of Okhotsk, using wind stress and wind stress curl fields derived from European Centre for Medium Range Weather Forecasts (ECMWF) reanalysis data and a scatterometer-derived wind product. Seasonal and interannual variations of the anticyclonic eddy in the Kuril Basin are also revealed using T/P SLA.     

A laboratory experiment to monitor the contact state of a fault by transmission waves

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.     

Microseismicity Induced by Heavy Rainfall Around Flooded Vertical Ore Veins

—?Microseismicity (M?M?M?M??6 were also monitored at a crustal movement monitoring station located several hundred meters from the veins. It was found that the opening of the vertical ore veins primary led to significant strain and tilt, but not to seismicity, because the delay and the longer duration of the seismicity were significant. Most seismic events involve thrusting mechanisms that are consistent with the present stress state of E-W-oriented tectonic compression, but are not consistent with the opening of the deepest ore vein. Interstingly, all the events within a few months of the heavy rainfall occurred near the faults that offset the deepest ore veins, wheareas all those events located away from the deepest ore veins occurred many months after the heavy rainfall. Consequently, the delayed diffusion of water appears to have played a dominant role in reducing rock strength, which led to seismicity in the Ikuno mine.     

Magnetic petrology of the 1991–1995 dacite lava of Unzen volcano,Japan: Degree of oxidation and implications for the growth of lava domes

To understand the oxidation state and process of oxidation of lava domes, we carried out magnetic petrological analyses of lava samples obtained from domes and block-and-ash-flow deposits associated with the 1991–1995 eruption of Unzen volcano, Japan. As a result, we recognize three different types of magnetic petrology, each related to deuteric high-temperature oxidation during initial cooling. Type A oxides are characterized by homogenous titanomagnetite and titanohematite, indicating a low oxidation state and high titanomagnetite concentrations. Type B oxides are weakly exsolved and contain titanohematite laths and rutile lenses, indicating a higher oxidation state. Type C oxides, which represent the highest oxidation state, are completely exsolved and composed of Ti-poor titanomagnetite, titanohematite, rutile, and pseudobrookite, indicating high hematite concentrations. Some grains in Types A and B show indications of reduction, which was related to interaction with volcanic gases subsequent to high-temperature oxidation. In terms of geological occurrence, the oxidation processes probably differed for endogenous and exogenous domes. Endogenous dome lavas are oxidized concentrically and are classified into the three types according to their location within the dome: samples from the surface are strongly oxidized and classified as Type C, while the inner part is unoxidized and classified as Type A. Exogenous dome lavas are unoxidized and assigned to Type A. Some samples show signs of reduction, which may have occurred around fumaroles. We propose that location within the dome and the process of dome growth are the factors that control oxidation.     

Lithological and physical properties of core samples from the Sagara oil field: Oil occurrence in Sagara core samples

Abstract   A drilling and coring investigation of the Sagara oil field, central Honshu, Japan, was conducted to contribute to the understanding of hydrocarbon migration processes in a forearc basin. Core samples were analyzed to determine lithology, physical properties (specifically gas permeability) and the characteristics of oil occurrence. Gas permeability values greater than approximately 10⁻¹¹ m² constitute the basic precondition for any lithology to serve as a potential fluid conduit or reservoir in the Sagara oil field. Cores recovered from the 200.6-m-deep borehole were primarily composed of alternating siltstone, sandstone and conglomerate, all of which are correlated to the late Miocene Sagara Group. Both sandstone and conglomerate can be classified into two types, carbonate-cemented and poorly to non-cemented, based on matrix material characteristics. Oil stains are generally absent in the former lithology and more common in the latter. Variations in physical properties with respect to gas permeability values are directly related to the presence and character of carbonate cement, with higher permeabilities common in poorly to non-cemented rocks. The relationships between lithology, oil-staining, cementation and permeability indicate that cementation preceded oil infiltration and that cementation processes exerted significant control on the evolution of the reservoir.