In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Decadal Variability of Subsurface Temperature in the Central North Pacific

Decadal variability of subsurface temperature in the North Pacific has been investigated. Two dominant regions were found; the central subarctic region (CSa) and the north-eastern subtropical region (NESt). In CSa, cooling (warming) of wintertime subsurface temperature corresponds to the large (small) temperature gradient and southward (northward) shift of subsurface temperature front, associated with the increase (decrease) of positive wind stress curl and the southward (northward) shift of curl τ zero line with 2 years delay. It is suggested that the relocation of subtropical-subarctic boundary plays an important role. In NESt, importance of heat flux through the sea surface and heat divergence in the Ekman layer is also discussed. This revised version was published online in July 2006 with corrections to the Cover Date.     

Stability of Temperature and Conductivity Sensors of Argo Profiling Floats

After recalibration of the temperature and conductivity sensors of three Argo profiling floats recovered after operations for four to nine months, the results indicate that the floats basically showed no significant drift, either in temperature or salinity, and adequately fulfilled the accuracy requirement of the Argo project (0.005°C for temperature and 0.01 psu for salinity). Only the third float showed a significant offset in salinity of about −0.02 psu, as expected from comparison between the float data and the shipboard conductivity-temperature-depth data. This offset was caused by the operational error of the PROVOR-type float, in which the surface water was pumped immediately after the launch, fouling the conductivity sensor cell. This revised version was published online in July 2006 with corrections to the Cover Date.     

Validity of sea surface temperature observed with the TRITON buoy under diurnal heating conditions

In order to investigate the validity of buoy-observed sea surface temperature (SST), we installed special instruments to measure near-surface ocean temperature on the TRITON buoy moored at 2.07°N, 138.06°E from 2 to 13 March 2004, in addition to a standard buoy sensor for the regular SST measurement at 1.5-m depth. Large diurnal SST variations were observed during this period, and the variations of the temperatures at about 0.3-m depth could be approximately simulated by a one-dimensional numerical model. However, there was a notable discrepancy between the buoy-observed 1.5-m-depth SST (SST_1.5m) and the corresponding model-simulated temperature only during the daytime when the diurnal rise was large. The evaluation of the heat balance in the sea surface layer showed that the diurnal rise of the SST_1.5m in these cases could not be accounted for by solar heating alone. We examined the depth of the SST_1.5m sensor and the near-surface temperature observed from a ship near the buoy, and came to the conclusion that the solar heating of the buoy hull and/or a disturbance in the temperature field around the buoy hull would contribute to the excessive diurnal rise of the SST_1.5m observed with the TRITON buoy. However, the temperature around the hull was not sufficiently homogenized, as suggested in a previous paper. For the diurnal rise of the SST_1.5m exceeding 0.5 K, the daytime buoy data became doubtful, through dynamics that remain to be clarified. A simple formula is proposed to correct the unexpected diurnal amplitude of the buoy SST_1.5m.     

Biogenic Silica Record in Lake Biwa of Central Japan over the Past 145,000 Years

The record of the biogenic silica flux (BSF, g cm⁻²(10³yr)⁻¹) in Lake Biwa reflects changes in diatom productivity in the lake and provides information regarding changes in paleoclimatic conditions. The BSF record of Lake Biwa demonstrates five periods over the past ca. 145,000 yr when the BSF values were significantly greater than 7.5 g cm⁻²(10³yr)⁻¹, and five intervals when they were lower. The data imply that paleoclimatic conditions were warmer and wetter from ca. 123,000 to 115,000, 103,000 to 95,000, 88,000 to 72,000, 57,000 to 32,000 yr B.P., and around ca. 6000 yr B.P. when the BSF values were greater, and relatively dry and cold from ca. 141,000 to 123,000 yr B.P. and during intervals between two of the five warm and wet episodes when the BSF values were lower. Time series of the BSF record can be correlated with the record of biogenic silica content in Lake Baikal and the marine oxygen isotope stages 1 through 6. Furthermore, the BSF values varied with much higher amplitude during the last interglaciation than during the last glaciation, probably implying that the diatom productivity in Lake Biwa was likewise more variable and had a larger range under interglacial conditions than under glacial conditions.     

Late Pleistocene-Holocene Paleoclimatic History of the Southern Kerala Basin, Southwest India

The South Kerala Sedimentary Basin (SKSB) constitutes one of the most significant landward extensions of the southwest offshore sedimentary basins of India, and is situated between 8^o45^' and 10^o15^' N latitudes. With a maximum width of about 20 km and incorporating a 700 m thick sedimentary succession ranging in age from Early Miocene to Holocene, this belt lies almost entirely under water or alluvium-covered coastal plains. In this study, we use two continuously cored bore holes at Eruva (7.25m deep) and Muthukulam (3m deep) separated by a distance of about 7km to investigate the depositional environment as well as paleo ecology of the depocentre and climatic aspects during the Late Pleistocene and Holocene. Results from C¹⁴ dating of shell fragments from Eruva (depth zone: 2.10–6.64m) yielded ages in the range of 36.2 to 42.5 kyBP corresponding to the late Pleistocene. Wood fragments in the Muthukulam core sample (depth zone: 1.27–3.00m) gave C¹⁴ ages in the range of 3.7 to 7.2 kyBP indicating a Holocene history. The lower half of the Eruva bore hole indicates a marginal marine environment with an abundant supply of terrestrial carbonaceous debris probably corresponding to a period of abnormally high rainfall recorded in many parts of the globe covered by the Asian summer monsoon. The sediments in the upper part of this bore hole indicate a continuation of this environment but with much less input of terrestrial organic carbon. The lower part of the bore hole from this locality, corresponding to the Holocene transgression, is similar to the lower part of Eruva bore hole in the case of TOC. Deposition took place in water bodies with considerable marine influence but receiving high amounts of terrestrial plant debris-mostly in the form of finely divided particles mixed with mud. This transgressive sequence was also deposited during a time when the Asian summer monsoon was abnormally high in intensity as indicated by many examples in India, Africa, Madagascar and elsewhere. It is significant that during the deposition of this part, the sea level was probably the same as present or higher suggesting possible lowering of the stream velocities and resultant deposition of only muddy sediments laden with terrestrial organic material along the coast. The upper part of the section shows a progressively reduced rainfall pattern culminating in a period of very low precipitation with the development of a paleosol, which is traceable all over the SKSB where Late Holocene sediments are available. This period also witnessed aeolian activity modifying the sand ridges in the ridge-runnel systems formed by the Holocene regression.     

Neodymium isotopic variations in Northwest Pacific waters

Four vertical profiles of the concentration and isotopic composition of Nd in seawater were obtained in the western North Pacific. Two profiles from the Kuroshio Current regime showed congruently that although the Nd concentration increases gradually with depth, its isotopic composition varies significantly with depth depending upon the water mass occupying the water column. The high-salinity Kuroshio waters originating from the North Pacific Tropical Water (NPTW) carry the least radiogenic Nd (?_Nd = −7.4 to −8.7) to this region at ∼250 m from the western margin continental shelves, most likely from the East China Sea. The Nd isotopic compositions in the North Pacific Intermediate Water (NPIW) that occurs at 600 to 1000 m in the subtropical region are fairly uniform at ?_Nd = −3.7. The profile data from the ∼38° to 40°N Kuroshio/Oyashio mixed water region off Sanriku of Honshu, Japan, also suggest that the newest NPIW with ?_Nd = −3.2 is formed there by the mixing of various source waters, and the radiogenic component of Nd is derived mainly from the Oyashio waters.In the Pacific Deep Water (PDW) below ∼1000 m, the Nd isotopic composition is neither vertically nor horizontally homogeneous, suggesting that it serves as a useful tracer for sluggish deep water circulation as well. Two profiles from the Izu-Ogasawara Trench showed a minimum ?_Nd value at ∼2000 m, suggesting that there exists a horizontal advective flow in the vicinity of Honshu, Japan. There is some evidence from other chemical properties to support this observation. The waters below 4000 m including those within the trench in the subtropical region have ?_Nd values of around −5, suggesting that the deep waters are fed from the south along the western boundary, ultimately from the Antarctic Bottom Water (AABW) in the South Pacific. This extends up to ∼40°N along the Japanese Islands. In the subarctic region (>∼42°N), the waters have more radiogenic Nd with ?_Nd > −4.0 throughout the water column, presumably due to the supply of Nd by weathering in such igneous provinces as the Kuril-Kamchatska-Aleutian Island chain. The lateral inhomogeneity of the Nd isotopic composition in PDW suggests that there may be different circulation and mixing regimes in the North Pacific Basin.     

Viscosity of peridotite liquid up to 13 GPa: Implications for magma ocean viscosities

The viscosity of synthetic peridotite liquid has been investigated at high pressures using in-situ falling sphere viscometry by combining a multi-anvil technique with synchrotron radiation. We used a newly designed capsule containing a small recessed reservoir outside of the hot spot of the heater, in which a viscosity marker sphere is embedded in a forsterite + enstatite mixture having a higher solidus temperature than the peridotite. This experimental setup prevents spheres from falling before a stable temperature above the liquidus is established and thus avoids difficulties in evaluating viscosities from velocities of spheres falling through a partially molten sample.

Experiments have been performed between 2.8 and 13 GPa at temperatures ranging from 2043 to 2523 K. Measured viscosities range from 0.019 (± 0.004) to 0.13 (± 0.02) Pa s. At constant temperature, viscosity increases with increasing pressure up to  8.5 GPa but then decreases between  8.5 and 13 GPa. The change in the pressure dependence of viscosity is likely associated with structural changes of the liquid that occur upon compression. By combining our results with recently published 0.1 MPa peridotite liquid viscosities [D.B. Dingwell, C. Courtial, D. Giordano, A. Nichols, Viscosity of peridotite liquid, Earth Planet. Sci. Lett. 226 (2004) 127–138.], the experimental data can be described by a non-Arrhenian, empirical Vogel-Fulcher-Tamman equation, which has been modified by adding a term to account for the observed pressure dependence of viscosity. This equation reproduces measured viscosities to within 0.08 log₁₀-units on average. We use this model to calculate viscosities of a peridotitic magma ocean along a liquid adiabat to a depth of  400 km and discuss possible effects on viscosity at greater pressures and temperatures than experimentally investigated.     

A new fault rupture scenario for the 2003 Mw 6.6 Bam earthquake, SE Iran: Insights from the high-resolution QuickBird imagery and field observations

The December 26, 2003 M_w 6.6 Bam earthquake is one of the most disastrous earthquakes in Iran. QuickBird panchromatic and multispectral satellite imagery with 61 cm and 2.4 m ground resolution, respectively provide new insights into the surface rupturing process associated with this earthquake. The results indicate that this earthquake produced a 2–5 km-wide surface rupture zone with a complex geometric pattern. A 10-km-long surface rupture zone developed along the pre-existing Bam fault trace. Two additional surface rupture zones, each 2–5 km long, are oblique to the pre-existing Bam fault in angles of 20–35°. An analysis of geometric and geomorphic features also shows that movement on the Bam fault is mainly right-lateral motion with some compressional component. This interpretation is consistent with field investigations, analysis of aftershocks as well as teleseismic inversion. Therefore, we suggest that the 2003 Bam earthquake occurred on the Bam fault, and that the surface ruptures oblique to the Bam fault are caused by secondary faulting such as synthetic shears (Reidel shears). Our fault model for the Bam earthquake provides a new tectonic scenario for explaining complex surface deformations associated with the Bam earthquake.