Mineral compositions in Antarctic and Greenland micrometeorites

Abstract— The mineral compositions of 250 micrometeorites have been studied and olivines and low-calcium pyroxenes with crystals larger than 5 μm have been analyzed. While magnesium-rich grains dominate, the Fa content of olivine may reach 50% and the Fs content of pyroxene may reach 26%. The Ca and Mn of the olivine show no consistent trends with increasing Fe, but Cr shows a negative correlation. For low-Ca pyroxene, Al and Cr contents are generally higher than in pyroxenes of equilibrated chondrites but similar to those of highly unequilibrated chondrites. Calcium-bearing pyroxene, feldspar and chromite are rare in the micrometeorites which were selected because of their high Mg, Si, Fe and their low Ca and Al content. All these minerals are found as coarse-grained particles often with adhering iron-rich scoria or as clasts in fine-grained or scoriaceous micrometeorites. Apart from a few particles which could be the debris of ordinary chondrites, most micrometeorites probably come from a common source similar, but not identical to carbonaceous chondrites, as shown by their lower Ni and S content and their different oxygen isotopic composition assuming two measurements performed on olivine grains prove to be typical.     

Occurrence of noble metals in aluminum- and chromium- rich objects in ordinary chondrites and of baddeleyite (ZrO2) in a chromite inclusion

Abstract— Platinum group elements (PGE) enrichments are found in Fe-Ni blebs (<1 μm) in Al- and Cr-rich objects in the ordinary chondrites Ste. Marguerite, Forest Vale, Montferré. In Ste. Marguerite, high ZrO₂ concentrations (baddeleyite) are also present in a chromite inclusion. Iridium enrichment in this material compared to its metal content is confirmed by INAA. The widespread occurrence of PGE in Al- and Cr-rich objects, mostly present in H-group chondrites of nearly equilibrated types, must be taken into account to understand their conditions of formation.     

Dahmani,a highly oxidised LL6 chondrite bearing Ni-rich taenite

Abstract Dahmani is a shocked LL6 fragmental breccia. According to the composition of the silicates (olivine Fa_30,32.6, orthopyroxene Fs_24.5–26.3) and of the metal (a 60% Ni taenite) it is one of the most oxidised known.     

The geochemistry of gem opals as evidence of their origin

Seventy-seven gem opals from ten countries were analyzed by inductively coupled plasma-mass spectrometry (ICP-MS) through a dilution process, in order to establish the nature of the impurities. The results are correlated to the mode of formation and physical properties and are instrumental in establishing the geographical origin of a gem opal. The geochemistry of an opal is shown to be dependant mostly on the host rock, at least for examples from Mexico and Brazil, even if modified by weathering processes. In order of decreasing concentration, the main impurities present are Al, Ca, Fe, K, Na, and Mg (more than 500 ppm). Other noticeable elements in lesser amounts are Ba, followed by Zr, Sr, Rb, U, and Pb. For the first time, geochemistry helps to discriminate some varieties of opals. The Ba content, as well as the chondrite-normalized REE pattern, are the keys to separating sedimentary opals (Ba > 110 ppm, Eu and Ce anomalies) from volcanic opals (Ba < 110 ppm, no Eu or Ce anomaly). The Ca content, and to a lesser extent that of Mg, Al, K and Nb, helps to distinguish gem opals from different volcanic environments. The limited range of concentrations for all elements in precious (play-of-color) compared to common opals, indicates that this variety must have very specific, or more restricted, conditions of formation. We tentatively interpreted the presence of impurities in terms of crystallochemistry, even if opal is a poorly crystallized or amorphous material. The main replacement is the substitution of Si⁴⁺ by Al³⁺ and Fe³⁺. The induced charge imbalance is compensated chiefly by Ca²⁺, Mg²⁺, Mn²⁺, Ba²⁺, K⁺, and Na⁺. In terms of origin of color, greater concentrations of iron induce darker colors (from yellow to “chocolate brown”). This element inhibits luminescence for concentrations above 1000 ppm, whereas already a low content in U (≤ 1 ppm) induces a green luminescence.     

Assessment of sandstone deterioration at Ta Keo temple (Angkor): first results and future prospects

A first application of geomorphological methods to the assessment of sandstone deterioration at Angkor is presented. Damage diagnosis was carried out on the first eastern tier of the central pyramid of the 1,000 year-old Ta Keo temple. Methods combine field observations and measurements at 230 sampling points, high-resolution lasergrammetry and stereophotogrammetry on a 2-m² test zone, and SEM observations. The first results indicate that decay operates through a synergistic combination of weathering phenomena dominated by scaling and solution, and exhibits a high spatial variability. Percentages of deteriorated surfaces vary from 17.6 to 93.8%, and average stone recession values from 0.00 to 2.71 cm (minimum) and 0.34 to 5.49 cm (maximum). On the test-zone, stereophotogrammetry and 3D-mapping of the present and reconstructed initial states using lasergrammetry indicate that erosion scars up to 6 cm deep have formed since 1963. On the whole, the amount of deteriorated surfaces more than tripled between 1963 and 2008. The degree of implication of salts in stone decay remains unclear for most efflorescences are composed of calcite (CaCO3), with secondary importance of barite (BaSO4) and gypsum (CaSO₄·2H₂O). Future prospects aim to evaluate the impact on stone decay of the clearing out of the temple from the forest in the 1920s.     

Magnesium isotope systematics of the lithologically varied Moselle river basin, France

Magnesium and strontium isotope signatures were determined during different seasons for the main rivers of the Moselle basin, northeastern France. This small basin is remarkable for its well-constrained and varied lithology on a small distance scale, and this is reflected in river water Sr isotope compositions. Upstream, where the Moselle River drains silicate rocks of the Vosges mountains, waters are characterized by relatively high ⁸⁷Sr/⁸⁶Sr ratios (0.7128-0.7174). In contrast, downstream of the city of Epinal where the Moselle River flows through carbonates and evaporites of the Lorraine plateau, ⁸⁷Sr/⁸⁶Sr ratios are lower, down to 0.70824.Magnesium in river waters draining silicates is systematically depleted in heavy isotopes (δ²⁶Mg values range from −1.2 to −0.7‰) relative to the value presently estimated for the continental crust and a local diorite (−0.5‰). In comparison, δ²⁶Mg values measured in soil samples are higher (∼0.0‰). This suggests that Mg isotope fractionation occurs during mineral leaching and/or formation of secondary clay minerals. On the Lorraine plateau, tributaries draining marls, carbonates and evaporites are characterized by low Ca/Mg (1.5-3.2) and low Ca/Sr (80-400) when compared to local carbonate rocks (Ca/Mg = 29-59; Ca/Sr = 370-2200), similar to other rivers draining carbonates. The most likely cause of the Mg and Sr excesses in these rivers is early thermodynamic saturation of groundwater with calcite relative to magnesite and strontianite as groundwater chemistry progressively evolves in the aquifer. δ²⁶Mg of the dissolved phases of tributaries draining mainly carbonates and evaporites are relatively low and constant throughout the year (from −1.4‰ to −1.6‰ and from −1.2‰ to −1.4‰, respectively), within the range defined for the underlying rocks. Downstream of Epinal, the compositions of the Moselle River samples in a δ²⁶Mg vs. ⁸⁷Sr/⁸⁶Sr diagram can be explained by mixing curves between silicate, carbonate and evaporite waters, with a significant contribution from the Vosgian silicate lithologies (>70%). Temporal co-variation between δ²⁶Mg and ⁸⁷Sr/⁸⁶Sr for the Moselle River throughout year is also observed, and is consistent with a higher contribution from the Vosges mountains in winter, in terms of runoff and dissolved element flux. Overall, this study shows that Mg isotopes measured in waters, rocks and soils, coupled with other tracers such as Sr isotopes, could be used to better constrain riverine Mg sources, particularly if analytical uncertainties in Mg isotope measurements can be improved in order to perform more precise quantifications.     

Tying seismic data to geologic information from core data: an example from ODP Leg 177

The integration of seismic data with core data should provide ground-truth to a structural interpretation of seismic data. The main difficulty in such an integration effort is the correct translation of physical property measurements on cores to a form which can be used in seismostratigraphic interpretation. In the absence of down-hole well data and check-shots, required knowledge of the velocity structure at the drilling locations can be obtained directly from measurements of the physical properties of core samples. This involves upscaling of the data from physical properties of cores to the sample interval used in the seismic data. In the present study, three of the seven drill-sites of ODP (Ocean Drilling Program) Leg 177 in 1997/1998, located on the Agulhas Ridge in the south-eastern Atlantic (sites 1088–1090), were connected with eight seismic profiles. Physical properties data measured on the cores from the various holes at each site were combined to create a single continuous log and used to construct synthetic seismograms. The synthetics generally show a good agreement with real seismic data in terms of amplitude and waveform. Some reflections in these generated traces may have a time-shift due to sections with incomplete or spurious P-wave velocity measurements in the ODP datasets. The main reflectors identified in the real seismic data correspond to hiatuses or periods of reduced sedimentation rates, and correlate well with density variations. One particular hiatus, clearly observable in the real seismic data, was not unequivocally identifiable in the various types of core data, and tying core data to seismic data can confirm its existence in the core data, showing the benefit of including seismic data in an interpretation of core log data. On the other hand, core data provide a calibration tool for the geological timescale of seismic data and information about the lithology, needed in the interpretation of seismic data.     

Gravity Anomaly and Tectonics in the Northern Part of the North Fiji Basin - Preliminary Result of the 1994 NOFI Cruise under the NEW STARMER Programme

A surface ship gravity survey was carried out in the northern part of the North Fiji Basin during the NOFI cruise by the R/V l'Atalante in August-September, 1994. The two ridges inside the study area, the South Pandora Ridge and the Tripartite Ridge, present different structures and states of isostatic equilibrium in terms of gravity anomaly and its tectonic implications. The former is supported by a restoring force of an imaginary elastic plate in the crust and the latter by the Airy type isostasy. These characteristics can be derived from the difference in magmatic activity, as influenced by the difference in lithospheric structure. The latter is characterised by greater active magmatism and hydrothermalism underneath the ridge than the former. Such a difference in the magmatic activity and the horizontal scale of the shallow subsurface structure is derived from the difference in the stiffness or viscosity of the lithosphere beneath the two ridges.     

Geochemical and hydrodynamic constraints on the distribution of trace metal concentrations in the lagoon of Nouméa, New Caledonia

Seawater samples were collected in the lagoon of Nouméa (southwest New Caledonia) along two transects from eutrophic coastal bays to the oligotrophic barrier reef. Land-based emissions to the lagoon were measured with dissolved and particulate concentrations of chromium (Cr) and nickel (Ni), used as tracers of both terrigenous and industrial (Ni ore treatment) activities, as well as dissolved and particulate concentrations of zinc (Zn), used as a tracer of urban effluents. The spatial variability of metal concentrations was related to geochemical and hydrodynamic conditions, i.e., respectively: (1) natural and anthropogenic emission sources, and chemical processes occurring in the water column; and (2) water residence times. The parameter used to describe the residence time of water masses was the local e-flushing time, i.e. the time required for a tracer mass contained within a given station to be reduced by a factor 1/e. High metal concentrations were found in coastal areas (up to 9000 ng dissolved Ni L⁻¹), and steeply decreased with distance from the coast (down to 101 ng dissolved Ni L⁻¹ near the barrier reef) to reach levels similar to those found in remote Pacific waters, suggesting a rapid renewal of waters close to the barrier. Distributions of metals in the lagoon are controlled upstream by land-based emission sources and later chemical processes. Then hydrodynamics constrain metal distributions, as shown by the observed relationship between local e-flushing times and the spatial variability of metal concentrations. In addition, a change in the direction of prevailing winds yielded a decrease of dissolved metal concentrations at the same site by a factor of 2.5 (Cr and Ni) and 2.9 (Zn). It is suggested that the residence time is a key parameter in the control of elemental concentrations in the lagoon waters, as much as land-based emission sources.     

Active spreading and hydrothermalism in North Fiji Basin (SW Pacific). Results of Japanese French Cruise Kaiyo 87

The aim of the Japanese-French Kaiyo 87 cruise was the study of the spreading axis in the North Fiji Basin (SW Pacific). A Seabeam and geophysical survey allowed us to define the detailed structure of the active NS spreading axis between 16° and 22° S and its relationships with the left lateral motion of the North Fiji Fracture Zone. Between 21° S and 18°10′ S, the spreading axis trends NS. From 18°10 S to 16°40 S the orientation of the spreading axis changes from NS to 015°. North of 16°40′ S the spreading axis trends 160°. These two 015° and 160° branches converge with the left lateral North Fiji fracture zone around 16°40′ S to define an RRFZ triple junction. Water sampling, dredging and photo TV deep towing give new information concerning the hydrothermal activity along the spreading axis. The discovery of hydrothermal deposits associated with living communities confirms this activity.