The dynamics and thermodynamics of precipitation loading

A one-dimensional, time-dependent numerical cloud model is used to analyze the factors in the dynamic and thermodynamic equations which lead to a steady-state or nonsteady-state solution for the cloud vertical motion, buoyancy, precipitation, and cloud water fields. ‘Bulk water’ microphysical techniques are used for the cloud, rain, and hail variables. An atmospheric sounding from a severe storm situation is used as initial and environmental conditions, yielding model updrafts of 40 m sec^?1 maximum and more than 10 m sec^?1 over the entire cloud region. ‘Early conversion’ of the cloud water to rain leads to loading of lower portions of the updraft by rain, the formation of appreciable amounts of hail by freezing of the supercooled rain, and subsequent loading of the middle and upper portions of the updraft so that the updraft erodes throughout the cloud depth and the cloud dissipates, yielding a vigorous rain shower. A delay in the conversion of the cloud water to rain results in a steady-state solution, no rain or hail falling through the updraft. A two-dimensional cloud simulation of this same case shows rain and hail in the upper cloud regions recycled in the two-dimensional flow into the updraft near cloud base and a breakdown of the updraft with resultant rainout (negligible hail reaching the ground). The breakdown of the updraft has profound effects on the temperature field within the cloud, causing the lapse rate to deviate from the steady-state condition and approach the initial environmental conditions. The results emphasize the fact that the local change in temperature (and other dependent variables as well) is not independent of the vertical velocity, in general. This has implications for the interpretation of measurements made within clouds.     

Mineral chemistry of layered Archaean anorthosite at Majorqap qâva,near Fiskenæsset,southwest Greenland

Variations of mineral chemistry are described in a layered sheet of partly metamorphosed anorthosite, leucogabbro, gabbro and peridotite. The rocks appear to represent part of two major cycles of crystal deposition in which the anorthite content of plagioclases decreases upwards from An_98?94 to An_90?75 and hornblendes show upward iron enrichment. The composition of corona minerals formed by subsolidus reaction between plagioclase and olivine in gabbro, suggests that these coronas formed under pressures of between 6 and 9 kb and at a temperature of about 800°C during a late magmatic or early metamorphic stage.     

Prospects for the GLAS Rayleigh laser beacon on the 4.2-m WHT

The scientific exploitation of adaptive optics (AO) with natural guide stars is severely constrained by the limited presence of bright guide stars for wavefront sensing. Use of a laser beam as an alternative means to provide a source for wavefront sensing has the potential of drastically improving the sky coverage for AO. For this reason at the 4.2-m William Herschel Telescope a project was started to develop a Rayleigh laser beacon to work together with the existing NAOMI adaptive optics instrumentation and the OASIS integral field spectrograph. This paper presents the rationale for this development, highlights some of the technical aspects, and gives some expected performance measures.     

APEX-SZ a Sunyaev–Zel’dovich galaxy cluster survey

The APEX-SZ experiment is a sky survey designed to discover galaxy clusters via the Sunyaev–Zel’dovich effect at millimeter wavelengths. We describe the components of the instrument, including the 12 m Atacama Pathfinder Experiment telescope, optics, Transition-edge sensor bolometer array and SQUID readout. APEX-SZ will begin observations in 2004.     

Neutralino annihilations and the gas temperature in the dark ages

Assuming that the dark matter is entirely made up of neutralinos, we re-visit the role of their annihilation on the temperature of diffuse gas in the high-redshift universe  ( z > 10)  , before the formation of luminous structures. We consider neutralinos of particle mass 36 and 100 GeV. The former is able to produce  ∼7  e ⁻ e ⁺  particles per annihilation through the fremionic channel, and the latter ∼53 particles assuming a purely bosonic channel. High-energy   e ⁻ e ⁺  particles up-scatter the cosmic microwave background (CMB) photons into higher energies via the inverse-Compton scattering. The process produces a power-law   e ⁻ e ⁺  energy spectrum of index −1 in the energy range of interest, independent of the initial energy distribution. The corresponding energy spectrum of the up-scattered photons is a power law of index −1/2, if absorption by the gas is not included. The scattered photons photoheat the gas by releasing electrons which deposit a fraction (14 per cent) of their energy as heat into the ambient medium. For uniformly distributed neutralinos, the heating is insignificant. The effect is greatly enhanced by the clumping of neutralinos into dense haloes. We use a time-dependent clumping model which takes into account the damping of density fluctuations on mass-scales smaller than  ∼10⁻⁶ M_⊙  . With this clumping model, the heating mechanism boosts the gas temperature above that of the CMB after a redshift of   z ∼ 30  . By   z ≈ 10  , the gas temperature is nearly 100 times its temperature when no heating is invoked. Similar increase is obtained for the two neutralino masses considered.     

Low‐accommodation and backwater effects on sequence stratigraphic surfaces and depositional architecture of fluvio‐deltaic settings (Cretaceous Mesa Rica Sandstone,Dakota Group,USA)

The adequate documentation and interpretation of regional‐scale stratigraphic surfaces is paramount to establish correlations between continental and shallow marine strata. However, this is often challenged by the amalgamated nature of low‐accommodation settings and control of backwater hydraulics on fluvio‐deltaic stratigraphy. Exhumed examples of full‐transect depositional profiles across river‐to‐delta systems are key to improve our understanding about interacting controlling factors and resultant stratigraphy. This study utilizes the ~400 km transect of the Cenomanian Mesa Rica Sandstone (Dakota Group, USA), which allows mapping of down‐dip changes in facies, thickness distribution, fluvial architecture and spatial extent of stratigraphic surfaces. The two sandstone units of the Mesa Rica Sandstone represent contemporaneous fluvio‐deltaic deposition in the Tucumcari sub‐basin (Western Interior Basin) during two regressive phases. Multivalley deposits pass down‐dip into single‐story channel sandstones and eventually into contemporaneous distributary channels and delta‐front strata. Down‐dip changes reflect accommodation decrease towards the paleoshoreline at the Tucumcari basin rim, and subsequent expansion into the basin. Additionally, multi‐storey channel deposits bound by erosional composite scours incise into underlying deltaic deposits. These represent incised‐valley fill deposits, based on their regional occurrence, estimated channel tops below the surrounding topographic surface and coeval downstepping delta‐front geometries. This opposes criteria offered to differentiate incised valleys from flood‐induced backwater scours. As the incised valleys evidence relative sea‐level fall and flood‐induced backwater scours do not, the interpretation of incised valleys impacts sequence stratigraphic interpretations. The erosional composite surface below fluvial strata in the continental realm represents a sequence boundary/regional composite scour (RCS). The RCS’ diachronous nature demonstrates that its down‐dip equivalent disperses into several surfaces in the marine part of the depositional system, which challenges the idea of a single, correlatable surface. Formation of a regional composite scour in the fluvial realm throughout a relative sea‐level cycle highlights that erosion and deposition occur virtually contemporaneously at any point along the depositional profile. This contradicts stratigraphic models that interpret low‐accommodation settings to dominantly promote bypass, especially during forced regressions. Source‐to‐sink analyses should account for this in order to adequately resolve timing and volume of sediment storage in the system throughout a complete relative sea‐level cycle.