Experimental research on a new encapsulated heat-generating hydraulic fracturing fluid system

1 IntroductionFracturing plays an important role in increasingthe production and injection and enhancing the final re-covery of oil and gas. At present, the use of ahydroxypropyl guar gum, borate-crosslinked, hydraulicfracturing fluid systemhas become ext…     

高速公路桥头跳车病害的分析与治理方法探讨

根据高速公路桥头跳车病害探地雷达检测结果,结合路基实际工程地质资料及沉降观测值,分析出造成此病害的原因是桥与路之间沉降差异所致,故搭板与垫层和垫层与路基之间产生了脱空,造成桥搭板、垫层碎裂而出现了桥头跳车病害.针对病害根源,采用了压密注浆进行搭板加固及重新摊铺沥青混合料进行调坡处理的治理方法.     

渗透系数空间变异性研究

水文地质参数的空间变异性是随机理论研究的基础,而渗透系数是最为重要的水文地质参数。国外有关渗透参数空间变异性的研究工作已开展很多,但渗透系数究竟服从什么分布目前尚无确切答案。利用Borden含水层试验数据,对渗透系数的空间变异性进行探讨,结果表明若处理方法得当,渗透系数应服从对数正态分布。同时,还对今后野外开展含水层渗透系数空间变异性试验研究提出几点建议。     

含水介质各向异性对渗透系数空间变异性统计的影响

针对目前渗透系数实测样本假定满足各向同性的局限,以Borden含水层试验场实测数据为例,通过反证法进行相关数据分析,总结了含水介质各向异性对渗透系数空间变异性统计的影响,并指明渗透系数各向同性假设的适用条件以及不合理之处。同时相应地给出了研究尺度下渗透系数场能否采用平稳随机场描述的判定依据。最后为今后进一步开展渗透系数空间变异性研究提出几点建议。     

Parameter identification of inelastic structures under dynamic loads

The generalized model of differential hysteresis contains 13 control parameters with which it can curve‐fit practically any hysteretic trace. Three identification algorithms are developed to estimate the control parameters of hysteresis for different classes of inelastic structures. These algorithms are based upon the simplex, extended Kalman filter, and generalized reduced gradient methods. Novel techniques such as global search and internal constraints are incorporated to facilitate convergence and stability. Effectiveness of the devised algorithms is demonstrated through simulations of two inelastic systems with both pinching and degradation characteristics in their hysteretic traces. Owing to very modest computing requirements, these identification algorithms may become acceptable as a design tool for mapping the hysteretic traces of inelastic structures. Copyright © 2002 John Wiley & Sons, Ltd.     

Study of a semi‐active stiffness damper under various earthquake inputs

Semi‐active stiffness damper (SASD) is one of many semi‐active control systems with the capability to mitigate the dynamic response using only a small amount of external power. The system consists of a hydraulic damper connected to the bracing frame in a selected story unit. In this paper, study of a SASD in two building models of five‐stories under four benchmark earthquake records is reported. The purpose of this study is to evaluate the effectiveness of the control system against structure type and varying earthquake inputs. Various control laws are chosen to work with SASD, such as: resetting control, switching control, linear quadratic regulator (LQR) and modified LQR, and the results are compared with no control and passive control cases. Numerical results show that the use of a SASD is effective in reducing seismic responses. Control effectiveness is dependent on the type of structure and earthquake excitation. Passive control is less effective than other control cases as expected. Resetting control, switching control and LQR generally perform similarly in response reduction. While modified LQR is more efficient and robust compared with other control algorithms. Copyright © 2002 John Wiley & Sons, Ltd.     

强水动力湖泊夏季分层期氮的生物地球化学循环初步研究:以贵州红枫湖南湖为例

湖泊在夏季由于藻类生长而消耗大量硝酸盐,水体硝酸盐含量一般要低于春季。而红枫湖南湖水体硝酸盐含量却高于春季(比平均含量高0.83mg/L),说明尚有其他重要的硝酸盐来源。据估算,南湖水体硝酸盐含量升高0.83mg/L约需要1.66×105kg硝酸盐,另外有约10.1×105kg硝酸盐随下泻水输出南湖,再加上夏季藻类生长(生产的chla量约为640kg)所消耗的硝酸盐3.52×105kg,共消耗硝酸盐15.28×105kg。扣除河流输入的4.42×105kg硝酸盐,南湖尚存在约10.86×105kg硝酸盐的亏空。利用氮稳定同位素示踪技术,结合硝酸盐及叶绿素a(chla)含量、溶解氧(DO)等的变化,认为这部分硝酸盐来自湖泊中下部(斜温层)有机质的大量矿化(硝化),是水动力驱动高DO的上部水体下沉从而引起下部有机质(硝化)的结果。南湖这种强水动力湖泊整个夏季分层期氮的生物地球化学循环是斜温层有机质矿化(硝化)释放硝酸盐和变温层藻类生长同化硝酸盐为有机质同时发生的特殊类型。     

离散裂隙渗流方法与裂隙化渗透介质建模

流体渗流模拟的连续介质方法通常适用于多孔地质体，并不一定适用于裂隙岩体，由于裂隙分布及其特征与孔隙差异较大。若流体渗流主要受裂隙的控制，对于一定尺寸的裂隙岩体，多孔介质假设则较难刻划裂隙岩体的渗流特征。离散裂隙渗流方法不但可直接用于模拟裂隙岩体非均质性和各向异性等渗流特征，而且可用其确定所研究的裂隙岩体典型单元体及其水力传导（渗透）张量大小。主要讨论了以下问题：（1）饱和裂隙介质中一般的离散流体渗流模拟；（2）裂隙岩体中的REV（典型单元体）及其水力传导（渗透）张量的确定；（3）利用离散裂隙网络流体渗流模型研究裂隙方向几何参数对水力传导系数和REV的影响；（4）在二维和三维离散裂隙流体渗流模型中对区域大裂隙和局部小裂隙的处理方法。调查结果显示离散裂隙流体渗流数学模型可用来评价不同尺度上的裂隙岩体的水力特征，以及裂隙方向对裂隙化岩体的水力特征有着不可忽视的影响。同时，局部小裂隙、区域大裂隙应当区别对待，以便据其所起的作用及水力特征，建立裂隙化岩体相应的流体渗流模型。     

Mantle structure and rifting processes in the Baikal–Mongolia region: geophysical data and evidence from xenoliths in volcanic rocks

The origin of the Baikal rift zone (BRZ) has been debated between the advocates of passive and active rifting since the 1970s. A re-assessment of the relevant geological and geophysical data from Russian and international literature questions the concept of broad asthenospheric upwelling beneath the rift zone that has been the cornerstone of many “active rifting” models. Results of a large number of early and recent studies favour the role of far-field forces in the opening and development of the BRZ. This study emphasises the data obtained through studies of peridotite and pyroxenite xenoliths brought to the surface by alkali basaltic magmas in southern Siberia and central Mongolia. These xenoliths are direct samples of the upper mantle in the vicinity of the BRZ. Of particular importance are suites of garnet-bearing xenoliths that have been used to construct P–T- composition lithospheric cross-sections in the region for the depth range of 35–80 km.Xenolith studies have shown fundamental differences in the composition and thermal regime between the lithospheric mantle beneath the ancient Siberian platform (sampled by kimberlites) and beneath younger mobile belts south of the platform. The uppermost mantle in southern Siberia and central Mongolia is much hotter at similar levels than the mantle in the Siberian craton and also has significantly higher contents of ‘basaltic’ major elements (Ca, Al, Na) and iron, higher Fe/Si and Fe/Mg. The combination of the moderately high geothermal gradient and the fertile compositions in the off-cratonic mantle appears to be a determining factor controlling differences in sub-Moho seismic velocities relative to the Siberian craton. Chemical and isotopic compositions of the off-cratonic xenoliths indicate small-scale and regional mantle heterogeneities attributed to various partial melting and enrichment events, consistent with long-term evolution in the lithospheric mantle. Age estimates of mantle events based on Os–Sr–Nd isotopic data can be correlated with major regional stages of crustal formation and may indicate long-term crust–mantle coupling. The ratios of ^143/144Nd in many LREE-depleted xenoliths are higher than those in MORB or OIB source regions and are not consistent with a recent origin from asthenospheric mantle.Mantle xenoliths nearest to the rift basins (30–50 km south of southern Lake Baikal) show no unequivocal evidence for strong heating, unusual stress and deformation, solid state flow, magmatic activity or partial melting that could be indicative of an asthenospheric intrusion right below the Moho. Comparisons between xenoliths from older and younger volcanic rocks east of Lake Baikal, together with observations on phase transformations and mineral zoning in individual xenoliths, have indicated recent heating in portions of the lithospheric mantle that may be related to localised magmatic activity or small-scale ascent of deep mantle material. Overall, the petrographic, P–T, chemical and isotopic constraints from mantle xenoliths appear to be consistent with recent geophysical studies, which found no evidence for a large-scale asthenospheric upwarp beneath the rift, and lend support to passive rifting mechanism for the BRZ.     

Heat flow and thermal modeling of the Yinggehai Basin, South China Sea

Geothermal gradients are estimated to vary from 31 to 43 °C/km in the Yinggehai Basin based on 99 temperature data sets compiled from oil well data. Thirty-seven thermal conductivity measurements on core samples were made and the effects of porosity and water saturation were corrected. Thermal conductivities of mudstone and sandstone range from 1.2 to 2.7 W/m K, with a mean of 2.0±0.5 W/m K after approximate correction. Heat flow at six sites in the Yinggehai Basin range from 69 to 86 mW/m², with a mean value of 79±7 mW/m². Thick sediments and high sedimentation rates resulted in a considerable radiogenic contribution, but also depressed the heat flow. Measurements indicate the radiogenic heat production in the sediment is 1.28 μW/m³, which contributes 20% to the surface heat flow. After subtracting radiogenic heat contribution of the sediment, and sedimentation correction, the average basal heat flow from basement is about 86 mW/m².Three stages of extension are recognized in the subsidence history, and a kinematic model is used to study the thermal evolution of the basin since the Cenozoic era. Model results show that the peak value of basal heat flow was getting higher and higher through the Cenozoic. The maximum basal heat flow increased from 65 mW/m² in the first stage to 75 mW/m² in the second stage, and then 90 mW/m² in the third stage. The present temperature field of the lithosphere of the Yinggehai Basin, which is still transient, is the result of the multistage extension, but was primarily associated with the Pliocene extension.