河南省栾川县罗村钼矿成矿特征及找矿

通过对河南省栾川县罗村钼矿区域地质背景、矿床地质特征与南泥湖、三道庄及东沟超大型钼矿的综合对比、分析、研究,总结归纳了矿区NWW构造形迹、小岩体与钼矿成矿关系、围岩对成矿的控制作用、围岩蚀变与成矿的关系、地球化学异常与钼矿床的关系等成矿特征.根据罗村钼矿的成矿特征,初步指出今后的找矿方向.     

三肇凹陷青山口组源岩生成油向下“倒灌”运移层位及其研究意义

为了研究三肇凹陷青山口组源岩生成的油向下“倒灌”运移层位,对油向下“倒灌”运移机制及条件进行了研究,得到三肇凹陷扶杨油层同时具备①青山口组源岩目前应具有足够大的超压;②存在连通青山口组源岩和扶杨油层的T2断裂2个条件,青山口组源岩生成的油能够在超压的作用下在嫩江组沉积末期、明水组沉积末期和古近系沉积末期通过T2断裂向下伏扶杨油层中“倒灌”运移。利用压力封闭原理,对三肇凹陷青山口组源岩生成的油向下“倒灌”运移距离进行了研究,得到三肇凹陷青山口组源岩生成的油向下“倒灌”运移距离一般大于500 m,而三肇凹陷扶杨油层地层厚度最大只有500 m,表明三肇凹陷青山口组源岩生成的油可以向下“倒灌”运移至整个扶杨油层的任何部位。目前三肇凹陷扶杨油层从上至下均含油,且已找到的油藏均分布于青山口组源岩生成的油能够向下“倒灌”运移分布范围内或附近,这表明青山口组源岩生成的油向下“倒灌”运移层位控制着油气富集层位,青山口组源岩生成的油向下“倒灌”运移分布范围控制着三肇凹陷扶杨油层油藏形成与分布范围。青山口组源岩生成的油向下“倒灌”运移分布范围及其附近应是三肇凹陷扶杨油层油下一步勘探的有利地区。     

河南洛宁段河金矿流体包裹体研究和矿床成因

河南省洛宁县段河石英脉型金矿主要包括石寨沟和岭东两个矿区,分别由3～4条含金石英脉构成。矿化过程从早到晚包括石英-黄铁矿、石英-多金属硫化物和石英-碳酸盐等3个阶段．其中中阶段金矿化最强,次为早阶段。各阶段石英中流体包裹体以气液两相包裹体为主．次为纯液体包裹体。激光拉曼测试表明,气液两相包裹体的液相为H2O,气相主要为Ho和CO2混合、纯H2O,次为纯CO2;纯液体包裹体为纯H2O。石寨沟矿区包裹体均一温度从早到晚依次为240．9～315．9℃．188．7～304．5℃,137．3～259．3℃：流体盐度变化依次为（6．74～12．85）wt%NaCl．eq,（2．41～8．68）wt％NaCl．eq,（2．24-7．86）wt%NaCl．eq。岭东矿区均一温度从早到晚依次为303．7-343．1℃,251．8-325．4℃,305．7～355．0℃：流体盐度变化依次为（5．11～11．70）wt％NaCl．eq,（2．74-10．11）wt％NaCl．eq,（0．53-6．74）wt％NaCl．eq。两矿区主成矿期流体均为中温、低盐度,早阶段流体为改造热液和变质热液的混合体,含一定量CO2,且流体CO2含量和盐度从早到晚逐渐降低。石寨沟矿区包裹体均一温度逐渐降低,而岭东矿区包裹体均一温度先降后升,加之岭东矿区各阶段成矿温度均高于石寨沟矿区．表明成矿流体系统主要受岩浆热驱动,岭东矿区更靠近岩体,且在晚阶段又有脉动性的岩浆加热．段河金矿区南部存在隐伏岩体。     

无外加流体、350℃和差异应力条件下硫化物再活化实验研究

红透山块状硫化物矿石主要成分为黄铁矿、磁黄铁矿、黄铜矿、闪锌矿和石英、角闪石、黑云母等脉石矿物。将此矿石烘干后作为试料置于岩石三轴应力试验机,在13h内将轴压、围压和温度分步升至1276MPa、414MPa和350℃,然后在空气中自然冷却至室温。实验产物中黄铁矿、石英、长石等以脆性碎裂为主,而磁黄铁矿、黄铜矿、闪锌矿和云母等以塑性变形为主。再活化的黄铜矿、磁黄铁矿和少量闪锌矿呈脉和网脉穿插黄铁矿碎斑。实验结果表明,即使没有外来流体加入．构造动力作用所导致的流体包裹体破坏所释出的流体,就足以使成矿物质发生活化转移和再活化。     

地幔岩中流体包裹体研究

地幔岩石中的流体包裹体代表地幔流体的样品。地幔流体包裹体可以存在从地幔来的金刚石,地幔捕虏体和岩浆碳酸岩中。研究这些岩石和矿物中的流体包裹体可以得出其所代表的地幔流体的温度、压力、成分和同位素。我们目前见到的这三类地幔岩石的包裹体主要可在橄榄石、辉石、金刚石、方解石和磷灰石中见到。这些包裹体可以粗略地分为CO2包襄体和硅酸盐熔融体包裹体。又可细分为四类包裹体：（1）富碳酸盐的硅酸盐熔融包裹体。这种包裹体在金刚石、地幔岩捕虏体和岩浆碳酸盐岩中见到,它又可分为结晶质熔融包裹体和玻璃包裹体。（2）CO2包裹体。这种包裹体大多见于地幔捕虏体中,在金刚石和岩浆碳酸岩中也可见到。（3）含硫化物的包裹体。这种包裹体见于地幔捕虏体中,与纯CO2包裹体和含CO2的熔融包裹体共存。（4）高密度的流体包裹体。这种包裹体见于金刚石中,是一种高盐度、高密度的含K、Cl和H2O的流体包裹体,又可分为高卤水包裹体和含卤水的富硅的碳酸盐岩浆包裹体。从对金刚石、地幔捕虏体和岩浆碳酸盐岩中流体包裹体的研究表明,地幔流体存在不均匀性和不混溶性。     

Numerical Experiment on Two-Dimensional Line Thermal

The time evolution of a two-dimensional line thermal-a turbulent flow produced by an initial element with signifi-cant buoyancy released in a large water body, is numerically studied with the two-equation k - e model for turbulence closure. The numerical results show that the thermal is characterized by a vortex pair flow and a kidney shaped concentra-tion structure with double peak maxima; the computed flow details and scalar mixing characteristics can be described by self-similar relations beyond a dimensionless time around 10. There are two regions in the flow field of a line thermal: a mixing region where the concentration of tracer fluid is high and the flow is turbulent and rotational with a pair of vortex eyes, and an ambient region where the concentration is zero and the flow is potential and well-described by a model of doublet with strength very close to those given by early experimental and analytical studies. The added virtual mass coeffi-cient of the thermal motion is found to be approximat     

Geophysical evidence of mud diapirism on the Mediterranean Ridge accretionary complex

Mud volcanoes, mud cones, and mud ridges have been identified on the inner portion of the crestal area, and possibly on the inner escarpment, of the Mediterranean Ridge accretionary complex. Four areas containing one or more mud diapirs have been investigated through bathymetric profiling, single channel seismic reflection profiling, heat flow measurements, and coring. A sequence of events is identified in the evolution of the mud diapirs: initially the expulsion on the seafloor of gasrich mud produces a seafloor depression outlined in the seismic record by downward dip of the host sediment reflectors towards the mud conduit; subsequent eruptions of fluid mud may create a flat topped mud volcano with step-like profile; finally, the intrusion of viscous mud produces a mud cone.The origin of the diapirs is deep within the Mediterranean Ridge. Although a minimum depth of about 400 m below the seafloor has been computed from the hydrostatic balance between the diapiric sediments and the host sediments, a maximum depth, suggested by geometric considerations, ranges between 5.3 and 7 km. The presence of thermogenic gas in the diapiric sediments suggests a better constrained origin depth of at least 2.2 km.The heat flow measured within the Olimpi mud diapir field and along a transect orthogonal to the diapiric field is low, ranging between 16 ± 5 and 41 ± 6 mW m^–2. Due to the presence of gas, the thermal conductivity of the diapiric sediments is lower than that of the host hemipelagic oozes (0.6–0.9 and 1.0–1.15 W m^–1 K^–1 respectively).We consider the distribution of mud diapirs to be controlled by the presence of tectonic features such as reverse faults or thrusts (inner escarpment) that develop where the thickness of the Late Miocene evaporites appears to be minimum. An upward migration through time of the position of the décollement within the stratigraphic column from the Upper Oligocene (diapiric sediments) to the Upper Miocene (present position) is identified.     

Validation of a finite difference method for the simulation of vortex-induced vibrations on a circular cylinder

The Karman Vortex Street generated by a circular cylinder is investigated by the numerical solution of the compressible Navier–Stokes equations in the incompressible Mach number range (Mach<0.3) using the Beam and Warming implicit scheme. The agreement with the fully incompressible projection method (Chorin, 1968) is fairly good while convergence time is very much better. The investigation suggests that the compressible Navier–Stokes equations may be used as an efficient alternative to study incompressible flows as well. Mach numbers just below 0.3 are enough to simulate incompressible flow behavior and at the same time do not cause numerical ill-conditioning in the solution. In addition, some relevant features of the vortices generated and carried by the wake of the cylinder could be fairly well captured.     

Numerical Solution of Lock-Release Gravity Current with Viscous Self-Similar Regime

Lock-release gravity currents with a viscous self-similar regime are simulated by use of the renormalization group(RNG) k - ε model for Reynolds-stress closure. Besides the turbulent regime with initially a slumping phase of a conslant current front speed and later an inviseid self-similar phase of front speed decreasing as t^-1/3(where t is the time measured from release), the viseous self-similar regime is satisfactorily reproduced with front speed decreasing as t^-4/5,consistent with well known experimental observations.