PRESSURE GRADIENT FROM THE CONTRIBUTION OF BOTH GEOTHERMAL AND GRAVITY IN THE LITHOSPHERE

1 Introduction The pressure, a scalar quantity, is defined as P = F/S (F is force, S is the area for F) which can be widely used for both solid and fluid. The formula P = g ρh (g-gravitation acceleration,ρ-density, h-depth) is only used for even density static solid and fluid. The delivery of pressure in the fluid follows the law of Pascal, and the average pressure of uneven density fluid can be calculated with the formula of P = g ρh. The temperature influence on pressure is notHU Ba…     

The variation of crustal stretching and different modes of rifting along the Australian southern continental margin

The southern margin of Australia is a passive continental margin, formed during a Late Jurassic–Cretaceous rifting phase. The development of this passive margin is mainly associated with extensional processes that caused crustal thinning. In this work, we have measured the amount of extension and the stretching factor (β factor) across seven transect profiles approximately evenly distributed across the margin. The obtained results show that the amount of extension and the β factor along the margin vary from west to east. The lowest amount of extension, low–intermediate β factors and a very narrow margin are observed in the western part with 80 km of extension and is underlain mostly by the Archean Yilgarn Craton and the Albany–Fraser Orogen. The Gawler Craton in the centre of the south Australian margin is another region of low extension and low–intermediate β factor. The largest amount of extension (384 km) and the largest β factor (β = 1.88) are found in the eastern part of the passive margin in an area underlain by Phanerozoic Tasman Orogen units. Our results imply that there is a strong control of the age and thickness of the continental lithosphere on the style of rifting along the Australian passive margin. Rifting of old and cold lithosphere results in a narrow passive margin, with the formation of relatively few faults with relatively wide spacing, while rifting of younger, warmer lithosphere leads to wide rifting that is accommodated by a large number of faults with small spacing.     

从藏南陆-陆碰撞带深部结构构造演化探讨斑岩铜矿的成岩成矿问题

本文以INDEPTH项目对印度大陆与欧亚大陆碰撞带深部成像结果为基础,从构造演化角度探讨藏南陆-陆碰撞带冈底斯斑岩铜矿带的成矿作用问题。深部探测给出的碰撞带深部结构与侯增谦等地质学家提出的深部结构有较大的异同,如何协调起来以深化对藏南陆-陆碰撞条件下成矿作用的认识,这是本文讨论的中心。藏南碰撞带成矿实际上是在新特提斯大洋岩石圈俯冲形成的冈底斯岩浆弧成矿作用的基础上,再经过陆-陆碰撞挤压强烈改造后的再成矿。碰撞带的深部结构构造演化的特点是:(1)新特提斯大洋岩石圈板块向北连续俯冲了约120 Ma,形成的冈底斯陆缘火山岩浆弧带,这导致了陆缘带地壳增厚并含有大量的地幔岩浆流体物质(如南美安第斯成矿带那样);(2)在印度大陆与冈底斯陆缘弧接近碰撞时,在对挤中新特提斯大洋洋壳与大洋岩石圈地幔发生向上挤出与向下拆沉,并使部分洋壳残片和大洋岩石圈物质保存在中上地壳内;(3)两大陆岩石圈碰撞对接后,印度岩石圈地幔加深达70~80 km并沿地壳底部向北推进,并将加厚地壳内大量的成矿物质、钙碱性岩浆,洋壳及新生的下地壳,以及部分地幔物质从地壳底部将其围限起来,成为后期再成矿的物质基础;(4)查明了碰撞带深部壳/幔间产生了一层中间速度层(相当于MASH层),在中上地壳部位出现一层巨大的部分熔融层;(5)在碰撞挤压下冈底斯带内产生多组断裂构造,大型逆冲断裂系与背冲断裂,并引发了含矿岩浆的再活动,并在浮力(下地壳内)和挤压力作用下多次活动上升生成斑岩型铜矿床;(6)成矿后地表遭受过强烈的风化剥蚀作用,使矿床出露地表。     

阿留申俯冲带几何学特征及运动学成因模式

阿留申俯冲带位于环太平洋俯冲带最北端,是东太平洋型俯冲和西太平洋俯冲的过渡区域。该俯冲带火山岛弧距离海沟的距离从东向西逐渐增大,而形成地球上独特的岛弧火山链与海沟V字型斜交的现象。这一现象的运动学成因目前并没有统一的认识。本文通过对阿留申俯冲带几何形态数据、运动学数据进行整理分析,尝试运用构造赤道理论探讨该现象形成的运动学背景。阿留申俯冲带的几何学数据表明:从俯冲带东段(175°E)至俯冲带西段(155°W),火山岛弧距俯冲海沟的距离从80 km增加至250 km。与此同时,俯冲板片的倾角由60°减小至30°。板块的运动学分析表明:相对北美板块,太平洋板块的东段的运动矢量为48 mm/a,向北运动;逐渐转变为西段的78mm/a,向西北方向运动。相对于软流圈,太平洋板块的运动方向没有改变,始终向西北方向运动,速率向西逐渐增加。因此,在俯冲带的东段太平洋板块的绝对运动方向和相对运动方向存在30°左右的夹角,而这个夹角在西段几乎不存在。太平洋板块的绝对运动方向和相对运动方向之间的夹角不同,会导致软流圈对俯冲板片的反作用力差异,从而形成不同的俯冲角度和俯冲带宽度。太平洋板块相对北美板块和相对地幔的速度方向夹角的变化被认为是引起阿留申火山弧与海沟"V"字型斜交的运动学成因。     

月球岩石圈弹性厚度研究进展

月球热演化研究需要丰富的月表热流数据.当前唯一的月表热流数据不完全可靠,单一数据也不足代表月球全球热流特征,通过月球岩石圈弹性厚度估算月表热流将会是有效的替代方案.针对弹性厚度估算的问题,概要回顾了以往估算的研究方法和成果,并对近年来利用重力地形导纳估算弹性厚度的理论方法进行了详细的介绍.近年来的研究结果表明月球全球岩石圈的Te可能较小,暗示月表地形形成于岩石圈冷却前较长的一段时间.个别研究成功地估算了个别质量瘤盆地的Te ,但大部分质量瘤盆地的较难估算,这不仅与质量瘤盆地复杂物理过程有关,还可能与岩石圈复杂的补偿机制有关.由于Te仅仅是岩石圈强弱的表征,不同研究方法得出的Te值存在差异是可能的.随着后续探月活动的开展,与国际社会合作布设月球热流载荷,结合后续研究对月球内部结构、月壳和月幔流变学特征的丰富认识,有望优化现有Te估算的理论与方法,进而为全球热流估算及热演化研究提供约束.     

Evolution of the Australian lithosphere

The evolution of the Australian plate can be interpreted in a plate‐tectonic paradigm in which lithospheric growth occurred via vertical and horizontal accretion. The lithospheric roots of Archaean lithosphere developed contemporaneously with the overlying crust. Vertical accretion of the Archaean lithosphere is probably related to the arrival of large plumes, although horizontal lithospheric accretion was also important to crustal growth. The Proterozoic was an era of major crustal growth in which the components of the North Australian, West Australian and South Australian cratons were formed and amalgamated during a series of accretionary events and continent‐continent collisions, interspersed with periods of lithospheric extension. During Phanerozoic accretionary tectonism, approximately 30% of the Australian crust was added to the eastern margin of the continent in a predominantly supra‐subduction environment. Widespread plume‐driven rifting during the breakup of Gondwana may have contributed to the destruction of Archaean lithospheric roots (as a result of lithospheric stretching). However, lithospheric growth occurred at the same time due to mafic underplating along the eastern margin of the plate. Northward drift of Australia during the Tertiary led to the development of a complex accretionary margin at the leading edge of the plate (Papua New Guinea).     

岩石圈深层扩张与青藏高原隆升——岩石圈深层扩张模式初论

在综述有关青藏高原隆升的各种观点和模式后,依据青藏高原新生代变形和岩石圈组构特征,提出了高原隆升的新的动力学模式——岩石圈深层扩张模式。其基本观点是强调由于印度板块向欧亚板块的强烈俯冲造成岩石圈组构和变形的不均一性及岩石圈中存在的碰撞→收缩(重力不均衡)→伸展(均衡调整)的正向转变和由伸展→收缩的逆向转变的反复交替。据此将青藏高原的造山带划分为三种成因类型:喜马拉雅型、冈底斯型和昆仑型。