Mechanism of loading on plates due to explosive detonation

This paper investigates the various mechanisms and parameters that are responsible for delivering impulse to a vehicle that is unfortunate enough to detonate a buried mine. Small scale tests are used to examine the effects of air blast or ejected sand in imparting impulse to a plate that is located above the surface of the saturated soil that contains the explosive. Parameters such as confinement, stand off distance, depth of burial of the explosive, density of the soil, and saturation level of the soil are also examined.     

Bound and mobile soil water isotope ratios are affected by soil texture and mineralogy,whereas extraction method influences their measurement

Questions persist about interpreting isotope ratios of bound and mobile soil water pools, particularly relative to clay content and extraction conditions. Interactions between pools and resulting extracted water isotope composition are presumably related to soil texture, yet few studies have manipulated the bound pool to understand its influence on soil water processes. Using a series of drying and spiking experiments, we effectively labelled bound and mobile water pools in soils with varying clay content. Soils were first vacuum dried to remove residual water, which was then replaced with heavy isotope-enriched water prior to oven drying and spiking with heavy isotope-depleted water. Water was extracted via centrifugation or cryogenic vacuum distillation (at four temperatures) and analysed for oxygen and hydrogen isotope ratios via isotope ratio mass spectrometry. Water from centrifuged samples fell along a mixing line between the two added waters but was more enriched in heavy isotopes than the depleted label, demonstrating that despite oven drying, a residual pool remains and mixes with the mobile water. Soils with higher clay + silt content appeared to have a larger bound pool. Water from vacuum distillation samples have a significant temperature effect, with high temperature extractions yielding progressively more heavy isotope-enriched values, suggesting that Rayleigh fractionation occurred at low temperatures in the vacuum line. By distinctly labelling bound and mobile soil water pools, we detected interactions between the two that were dependent on soil texture. Although neither extraction method appeared to completely extract the combined bound and mobile (total water) pool, centrifugation and high temperature cryogenic vacuum distillations were comparable for both δ²H and δ¹⁸O of soil water isotope ratios.     

Assessing the ‘two water worlds’ hypothesis and water sources for native and exotic evergreen species in south‐central Chile

Recent studies using water‐stable isotopes (δ¹⁸O and δ²H) have suggested an ecohydrological separation of water flowing to streams or recharging groundwater and water used by trees, known as the ‘two water worlds’ (TWW) hypothesis. In this study, we measured water isotopic composition in precipitation [open field and throughfall, i.e. local meteoric water line (LMWL)] and the mobile water compartment (i.e. stream and soil solution), bulk soil water and xylem water over a period of 1.5 years in two headwater catchments: NF, covered with old growth native evergreen forest (Aetoxicon punctatum, Laureliopsis philippiana and Eucriphya cordifolia), and EP, covered with 4 and 16‐year‐old Eucalyptus nitens stands. Our results show that precipitation, stream and soil solution plot approximately along the LMWL, while xylem waters from all studied tree species plot below the LMWL, supporting the TWW hypothesis. However, we also found evidence of ecohydrological connectivity during the wet season, likely controlled by the amount of antecedent precipitation. These observations hold for all investigated tree species. On both sites, a different precipitation source for stream and xylem water was observed. However, in EP, bulk soil showed a similar precipitation source as xylem water from both E. nitens stands. This suggests that E. nitens may use water that is recharging the bulk soil compartment. We conclude that under a rainy temperate climate, the TWW hypothesis is temporal and does not apply during wet seasons. Copyright © 2016 John Wiley & Sons, Ltd.     

月动力延伸预报500hPa高度场检验及其在重庆月气候预测中降尺度应用

根据2015年国家气候中心实时下发的第二代月动力延伸模式(DERF2.0)逐日资料和历史回算资料,统计构建不同时间起报的月500hPa高度场格点数据序列,针对重庆2月气温和8月降水量方差和预测难度较大的事实,分别分析2010-2014年逐年1月和7月16日、21日、26日、31日起报的2月和8月500hPa高度场预报场与同期NCEP资料实况场的分布型,结果表明：预测效果低纬好于中高纬,8月总体好于2月;基于上述滚动的500hPa预报场,试验了4个关键区和5种统计降尺度方法,对重庆2010-2015年2月气温和2010-2014年8月降水量进行回报预测和检验结果表明,16日起报的模式场对2月气温有较好的参考价值,配合最好的关键区为本区上空,而降尺度方案中Lamb方法效果最佳,二者结合的预测效果最好;8月降水回报检验表明,虽然8月降水预测效果不如2月气温,但在预测关键区取自定义关键区时,车氏方法的降尺度方案预测效果相对较好。     

珠江流域实际蒸散发与潜在蒸散发的关系研究

采用水量平衡模型和Penman公式分别计算了珠江流域七个子流域1961—2000年实际蒸散发(I_(ETa))和潜在蒸散发(I_(ETp)),并对供水条件变化下I_(ETa)与I_(ETp)的关系进行了定量化分析,对各子流域I_(ETa)和I_(ETp)关系的理论从属性进行判定,主要结论如下:1)珠江流域年实际蒸散发量远低于潜在蒸散发量,多数子流域I_(ETa)值不到I_(ETp)值的1/2。7个流域面积加权平均I_(ETa)为681.4 mm/a,I_(ETp)为1 560.8 mm/a。从蒸散发的变异性来看,则实际蒸散发I_(ETa)的变异性明显要高于潜在蒸散发I_(ETp)。2)东江、西江、北江、柳江和盘江等5个流域实际蒸散发I_(ETa)都与降水量呈现正相关关系,韩江、郁江两个流域I_(ETa)随降水变化的变化趋势不明显。各子流域的潜在蒸散发I_(ETp)与降水量呈现显著负相关关系。7个子流域平均情况下,随着降水量的增加,I_(ETa)呈现明显的增加趋势,而I_(ETp)呈现明显的下降趋势。3)通过对降水量P与实际蒸散发I_(ETa)及潜在蒸散发I_(ETp)的联合回归方程P-IET回归系数的T检验,判定韩江、柳江和盘江等三个子流域以及七流域面积加权平均I_(ETa)与P和I_(ETp)与P的关系满足理论意义上的严格互补相关;东江、西江、北江等三个流域I_(ETa)与P和I_(ETp)与P的关系满足"非对称"互补相关。4)基于极端干旱和极端湿润的边界条件,推导出非对称条件下的实际蒸散发互补相关理论模型。     

冰盖下矩形河道的综合糙率

综合糙率是采用曼宁公式确定河道水位和流量关系的关键参数。在河道冰封期,冰盖的出现增加了流动的阻力,明流条件下确定的综合糙率不再适用,需要重新估算。基于Einstein阻力划分过流断面的原理,冰盖下矩形河道的过水断面可划分为冰盖区、河床区和边壁区。根据总流的连续性方程,在确定各分区糙率系数、水力半径和断面面积的基础上,提出了冰盖下矩形河道综合糙率的计算公式。采用已有的试验水槽测量数据和天然河道实测资料对公式进行了验证,结果表明:公式计算的综合糙率与实测值吻合较好,与Einstein公式和Sabaneev公式相比,计算精度更高;对于冰封水流,宽浅河道采用分区水深代替水力半径进行简化计算的条件有别于明渠水流,在宽深比大于20时,计算结果才满足精度要求。     

COPEX和HM2000与APEX型剖面浮标比测试验及资料质量评价

利用船载CTD仪、国外剖面浮标(APEX)和实验室盐度计等标准仪器设备,在西北太平洋海域对2种型号国产剖面浮标(COPEX和HM2000)进行了现场比测试验,并对观测资料质量进行了定性和定量分析与评价.结果表明:(1) COPEX和HM2000型剖面浮标观测的盐度资料均能达到国际Argo计划提出的±0.01的精度要求;(2)HM2000的最小观测深度离海面1 m以内,最大观测深度基本稳定在2 000 m左右,并能保持在1000 m深度附近漂移,而COPEX的最小观测深度在8～9 m之间,最大观测深度则在1 800～1 900 m之间波动,且漂移深度都在600～800 m之间;(3)COPEX和HM2000都获得了70条以上有效观测剖面.总体而言,两种国产剖面浮标观测的温、盐度资料都是可信、可靠的.但试验中暴露的一些问题和不足仍有待不断改进和完善.     

Helical probe tests in residual soils of the Appalachian Piedmont

Helical probe tests (HPT) are a quick and economical means for manual field testing of soils to depths of 1.5 m with readings taken at 0.15-m intervals in only 10 min. The equipment is lightweight (only 2 kg) and thus amenable to deploy on initial site reconnaissance explorations, shallow pavement projects, earth retention walls, and/or compaction of fills. Although suitable for use in a variety of geomaterials: sands, silts, clays, and mixed soils, the specific application to residual fine sandy silts and silty fine sands of the Appalachian Piedmont and Blue Ridge geologic provinces is shown here. Existing relationships for converting the measured HPT torque reading to equivalent cone penetration testing (CPT) tip resistances are reviewed, as well as other trends.     

海上高产高含蜡井测试工艺优化研究和应用

为研究海上高产高含蜡油气井测试工艺优化方案,以东海西湖凹陷某井测试作业中所暴露出的问题为导向,开展西湖高产高含蜡储集层测试问题原因分析和国内外技术调研,同时进行了测试管柱和地面测试流程的流动性保障技术研究及原油燃烧保障技术研究。研究表明地面流程结蜡、大油嘴放喷返排出大颗粒碎屑及大产量原油燃烧导致燃烧头损坏是影响测试的主要原因,因此对测试管柱、地面测试流程及燃烧保障等进行工艺优化,以解决高产高含蜡油气井测试相关问题。