Relief-rejuvenation and topographic length scales in a fluvial drainage basin, Napf area, Central Switzerland

This paper explores how, and to what extent, a phase of relief-rejuvenation modifies the mode of surface erosion in an approximately 63 km² drainage basin located at the northern border of the Swiss Alps (Luzern area). In the study area, the retreat of the Alpine glaciers at the end of the Last Glacial Maximum (LGM) caused base level to lower by approximately 80 m. The fluvial system adapted to the lowered base level by headward erosion. This is indicated by knickzones in the longitudinal stream profiles and by the continuous upstream narrowing of the width of the valley floor towards these knickzones. In the headwaters above these knickzones, processes are still to a significant extent controlled by the higher base level of the LGM. There, frequent exposure of bedrock in channels and especially on hillslopes implies that sediment flux is to a large extent limited by weathering rates. In the knickzones, however, exposure of bedrock in channels implies that sediment flux is supply-limited, and that erosion rates are controlled by stream power.The morphometric analysis reveals the existence of length scales in the topography that result from distinct geomorphic processes. Along the tributaries where the upstream sizes of the drainage basins exceed 100,000–200,000 m², the mode of sediment transport and erosion changes from predominantly hillslope processes (i.e., landsliding, creep of regolith, rock avalanches and to some extent debris flows) to processes in channels (fluvial processes and debris flows). This length scale reflects the minimum size of the contributing area for channelized processes to take over in the geomorphic development (i.e., threshold size of drainage basin). This threshold size depends on the ratio between production rates of sediment on hillslopes, and export rates of sediment by processes in channels. Consequently, in the headwaters, erosion rates and sediment flux, and hence landscape evolution rates, are to a large extent limited by weathering processes. In contrast, in the lower portion of the drainage basin that adjusts to the lowered base-level, rates of channelized erosion and relief formation are controlled mainly by stream power. Hence, this paper shows that base-level lowering, headward erosion and establishment of knickzones separate drainage basins in two segments with different controls on rates of surface erosion, sediment flux and relief formation.     

Soil–rock-forming processes and engineering mechanical properties of the ancient gravel stratum near Nanjing, China

The ancient gravel stratum near Nanjing, China, is a major stratum of Cenozoic age along the middle–lower reaches of the Yangtze River. This paper first presents a typical geological profile and material composition of the ancient gravel stratum, and then discusses its geologic origin, soil–rock-forming processes, engineering mechanical properties, and their relations. These analyses are useful for city planning, geotechnical engineering, construction, and characterization of the geological environment in the Nanjing area.     

Geochemical characteristics of mineral air particles emitted inside a clay atomisation plant which introduces waste recycling processes

The objective of this work is to assess the concentrations of three factions of air particles (settable particles, TSP and PM10) and the levels of several toxic elements in a clay atomisation industry through aerosol sampling at several points inside an industrial plant. Mechanical activities, which produce diffuse emissions, are the main process of discharge of particles in both indoor and outdoor workplace environments in the atomisation plant. The levels of As, Cd, Pb, Zn, Ba and Ni increase in the zones with higher concentrations of particles and lower ventilation. The concentrations of As and F are not influenced by the recycling processes. The levels of Cd and Pb do not show great enrichment in air particles collected inside the atomisation plant although the content of both elements is associated with ceramic muck recycling. Finally, the content of B in waste water is mainly transferred in gaseous phase to the atmosphere during the process of drying by atomisation.     

关于成矿作用地球化学研究的几个问题

成矿作用地球化学是矿床地球化学的基础理论分支,属于应用基础类学科,以地球化学原理和方法研究造成元素沉淀富集形成矿床的地球化学作用的原因和机理。本文讨论了热液矿床成矿作用的几个问题。指出花岗岩与矿床类型之间是否存在相关性,即花岗岩是否具有成矿专属性仍然存在争论,需要继续探索。花岗岩类具有成矿潜力不等于这些花岗岩最终都能成矿。决定岩浆发生成矿作用的因素很多,其中岩浆分异作用过程和流体释放时间及其机制可能是决定成矿发生和矿床类型的关键,岩浆熔体中挥发组分及其行为可能是岩浆能否发生成矿作用的决定性要素,聚焦流体流动是成矿作用能否发生的关键环节,而自组织临界性和反馈作用决定了成矿效率和矿床的规模。     

地质微生物作用与油气资源

地质微生物作用与油气资源的生成、保存、破坏、开采和勘探的各个环节都有着密切的联系。微生物(细菌)本身不仅是良好的成烃母质,还是促使有机物转化为石油烃的主要营力。微生物作用使沉积有机质向更有利于生烃的物质转化,并使有机质中表征成熟度的一些指标在尚未受热成熟作用前就显示成熟特征。沉积环境中微生物的发育对有机质的贡献与保存有积极作用,细菌对有机质的降解也有利于有机质中成烃组分的保存与富集。微生物作用生成的天然气、煤层气和甲烷水合物在世界各地已成为有商业开采价值的资源。然而,微生物对已成藏的油气资源又具有破坏作用。储层中喜氧与厌氧菌的存在,不仅破坏石油储量,还使原油质量明显下降。     

地质微生物地球化学作用的意义与展望

概要论述了地质微生物学、地下水微生态学、微生物地球化学作用的基本概念、研究内容、研究现状、科学意义、关键问题、发展前景和在地下水环境保护中的作用。该研究领域不仅拓宽了整个地质科学的研究范畴,而且推动了地质科学的发展,具有一定的创新性。     

9: Processes of tectonism, magmatism and mineralization: Lessons from Europe

Metallogenic provinces in Europe range in age from the Archaean to the Neogene. Deposit types include porphyry copper and epithermal Cu–Au, volcanic-hosted massive sulphide (VMS), orogenic gold, Fe-oxide–Cu–Au, anorthosite Fe–Ti-oxide and sediment-hosted base-metal deposits. Most of them formed during short-lived magmatic events in a wide range of tectonic settings; many can be related to specific tectonic processes such as subduction, hinge retreat, accretion of island arcs, continental collision, lithosphere delamination or slab tear. In contrast, most sediment-hosted deposits in Europe evolved in extensional, continental settings over significant periods of time. In Europe, as elsewhere, ore formation is an integral part of the geodynamic evolution of the Earth's crust and mantle. Many tectonic settings create conditions conducive to the generation of water-rich magma, but the generation of ore deposits appears to be restricted to locations and short periods of change in temperature and stress, imposed by transitory plate motions. Crustal influence is evident in the strong structural controls on the location and morphology of many ore deposits in Europe. Crustal-scale fault–fracture systems, many involving strike-slip elements, have provided the fabric for major plumbing systems. Rapid uplift, as in metamorphic core complexes, and hydraulic fracturing can generate or focus magmatic–hydrothermal fluid flow that may be active for time spans significantly less than a million years. Once a hydrologically stable flow is established, ore formation is strongly dependent on the steep temperature and pressure gradients experienced by the fluid, particularly within the upper crust. In Europe, significant fracture porosity deep in the crystalline basement (1%) is not only important for magmatic–hydrothermal systems, but allows brines to circulate down through sedimentary basins and then episodically upward, expelled seismically to produce sediment-hosted base-metal deposits and Kupferschiefer copper deposits. Emerging research, stimulated by GEODE, can improve the predicting power of numerical simulations of ore-forming processes and help discover the presence of orebodies beneath barren overburden.     

Geochemical and isotopic investigation of the aquifer system in the Djerid-Nefzaoua basin, southern Tunisia

In the Djerid-Nefzaoua region, southern Tunisia, about 80% of agricultural and domestic water supply is provided by the complex terminal (CT) aquifer. However, 20% of this demand is provided by other hydraulically connected aquifers, namely the continental intercalaire (CI) and the Plio-Quaternary (PQ). Overexploitation of the CT aquifer for agricultural practices has contributed to the loss of the artesian condition and the decline of groundwater level which largely increased the downward leakage from the shallow PQ aquifer. Excess irrigation water concentrates at different rates in the irrigation channels and in the PQ aquifer itself. Then, it returns to the CT aquifer and mixes with water from the regional flow system, which contributes to the salinization of the CT groundwater. A geochemical and isotopic study had been undertaken over a 2-years period in order to investigate the origin of waters pumped from the CT aquifer with an emphasis on its hydraulic relationships with the underlying and the overlying CI and PQ aquifers. Geochemistry indicates that groundwater samples collected from different wells show an evolution of the water types from Na-Cl to Ca-SO₄-Cl. Dissolution of halite, gypsum and anhydrite-bearing rocks is the main mechanism that leads to the salinization of the groundwater. Isotopic data indicate the old origin of all groundwater in the aquifer system. Mixing and evaporation effects characterizing the CT and the PQ aquifers were identified using δ²H and δ¹⁸O relationship and confirmed by the conjunction of δ²H with chloride concentration.     

Characterizing spatial and temporal variation in 18O and 2H content of New Zealand river water for better understanding of hydrologic processes

Time series of hydrogen and oxygen stable isotope ratios (δ²H and δ¹⁸O) in rivers can be used to quantify groundwater contributions to streamflow, and timescales of catchment storage. However, these isotope hydrology techniques rely on distinct spatial or temporal patterns of δ²H and δ¹⁸O within the hydrologic cycle. In New Zealand, lack of understanding of spatial and temporal patterns of δ²H and δ¹⁸O of river water hinders development of regional and national-scale hydrological models. We measured δ²H and δ¹⁸O monthly, together with river flow rates at 58 locations across New Zealand over a two-year period. Results show: (a) general patterns of decreasing δ²H and δ¹⁸O with increasing latitude were altered by New Zealand's major mountain ranges; δ²H and δ¹⁸O were distinctly lower in rivers fed from higher elevation catchments, and in eastern rain-shadow areas of both islands; (b) river water δ²H and δ¹⁸O values were partly controlled by local catchment characteristics (catchment slope, PET, catchment elevation, and upstream lake area) that influence evaporation processes; (c) regional differences in evaporation caused the slope of the river water line (i.e., the relationship between δ²H and δ¹⁸O in river water) for the (warmer) North Island to be lower than that of the (cooler, mountain-dominated) South Island; (d) δ²H seasonal offsets (i.e., the difference between seasonal peak and mean values) for individual sites ranged from 0.50‰ to 5.07‰. Peak values of δ¹⁸O and δ²H were in late summer, but values peaked 1 month later at the South Island sites, likely due to greater snow-melt contributions to streamflow. Strong spatial differences in river water δ²H and δ¹⁸O caused by orographic rainfall effects and evaporation may inform studies of water mixing across landscapes. Generally distinct seasonal isotope cycles, despite the large catchment sizes of rivers studied, are encouraging for transit time analysis applications.