和田地区近40年气温变化特征分析

利用和田地区4个代表站1961～2000年的气温资料，对和田地区近40a来的气温变化作了分析。得出近40年来和田地区年平均气温呈上升趋势，春季气温和于田县的年平均气温却呈下降趋势。特别是上世纪90年代增温十分明显，1999年是近40a来和田地区最暖的一年。     

Effects of laser beam alignment tolerance on lidar accuracy

One of the major lidar error sources not yet analyzed in the literature is the tolerance of the laser beam alignment with respect to the scanning mirror. In this paper, the problem of quantifying these errors is solved for rotating polygon mirror type lidar systems. An arbitrary deviation of the beam from its design direction–the vector of beam misalignment–can be described by two independent parameters. We choose these as horizontal and vertical components of the misalignment vector in the body frame. Either component affects both, horizontal and vertical lidar accuracy. Horizontal lidar errors appear as scan line distortions—along and across track shifts, rotations and scaling. It is shown that the horizontal component of misalignment results in a scan line first being shifted across the track and then rotated around the vertical at the new center of the scan line. Resulting vertical lidar error, being a linear function of the scan angle, is similar to that produced by a roll bias. The vertical component of the beam misalignment causes scan line scaling and an along track shift. The corresponding vertical error is quadratic with respect to the scan angle. The magnitude of these effects is significant even at tight alignment tolerances and cannot be realistically accounted for in the conventional calibration model, which includes only range, attitude and GPS biases. Therefore, in order to attain better accuracy, this model must be expanded to include the beam misalignment parameters as well. Addition of new parameters into the model raises a question of whether they can be reliably solved for. To give a positive answer to this question, a calibration method must utilize not only ground control information, which is typically very limited, but also the relative accuracy information from the overlapping flight lines.     

新疆东昆仑木孜塔格蛇绿混杂岩中发现富Nb玄武岩

富Nb 玄武岩以相对高的TiO2 含量、低的LILE/HFSE和LREE/HFSE比值以及(La/Nb)MN＜2为特征,是岛弧环境的典型产物。首次报道发现于新疆东昆仑木孜塔格蛇绿混杂岩中的富Nb玄武岩,并分析了它们的典型地球化学特征和构造环境,表明了它们形成在岛弧环境。     

某既有建筑物改造工程地基加固质量的综合检测

随着既有建筑物的增层改造工程的发展和技术的日益成熟 ,为了提高原有建筑物地基土强度和变形能力 ,对其基础加固处理也愈加频繁。如何准确有效地评价其地基加固质量及其空间变化的均匀性是关系此类工程安全可靠的重要保证。本文以某一工程为例 ,讨论既有建筑物增层改造工程的地基加固质量的检测和综合评价方法。该建筑物建于 5 0年代 ,原设计为 5层 ,现增层为 6层 ,采用高压注浆方法进行地基加固处理.     

强水动力湖泊夏季分层期氮的生物地球化学循环初步研究:以贵州红枫湖南湖为例

湖泊在夏季由于藻类生长而消耗大量硝酸盐,水体硝酸盐含量一般要低于春季。而红枫湖南湖水体硝酸盐含量却高于春季(比平均含量高0.83mg/L),说明尚有其他重要的硝酸盐来源。据估算,南湖水体硝酸盐含量升高0.83mg/L约需要1.66×105kg硝酸盐,另外有约10.1×105kg硝酸盐随下泻水输出南湖,再加上夏季藻类生长(生产的chla量约为640kg)所消耗的硝酸盐3.52×105kg,共消耗硝酸盐15.28×105kg。扣除河流输入的4.42×105kg硝酸盐,南湖尚存在约10.86×105kg硝酸盐的亏空。利用氮稳定同位素示踪技术,结合硝酸盐及叶绿素a(chla)含量、溶解氧(DO)等的变化,认为这部分硝酸盐来自湖泊中下部(斜温层)有机质的大量矿化(硝化),是水动力驱动高DO的上部水体下沉从而引起下部有机质(硝化)的结果。南湖这种强水动力湖泊整个夏季分层期氮的生物地球化学循环是斜温层有机质矿化(硝化)释放硝酸盐和变温层藻类生长同化硝酸盐为有机质同时发生的特殊类型。     

Isothermal annealing of partially metamict zircon: evidence for a three-stage recovery process

 Raman spectroscopy and the powder diffraction technique have been used to monitor the recovery process of two partially metamict zircons (2.6 and 4.8 × 10¹⁸ α-decays g⁻¹) from Sri Lanka during a series of isothermal annealing experiments in the temperature range from 870 to 1622 K. These experiments show for the first time that structural recovery in partially metamict zircon proceeds via three distinct recovery stages, each of which occurs within a distinct time-temperature regime. Whereas the first two stages have previously been recognized (recovery of damaged crystalline remnants and epitaxial recrystallization), the third stage has not yet been identified as a single activated process. It is suggested that anisotropic defect annealing during the first stage at low temperatures, where the structure recovers preferentially along the a(b) plane, produces a geometrical situation where large structural rearrangements are necessary to remove the remaining defects inside the crystalline material. This situation is approximately reached when the amorphous domains start to recrystallize. The reason for anisotropic annealing can be found in a different connectivity between polyhedral linkages in both directions of the zircon lattice. High apparent activation energies, in the range of 6.4 to 7.9 eV, were determined for the third recovery stage from the Raman data, which are interpreted to reflect large structural rearrangements (i.e. polyhedral tilting) associated with the final recovery of the c axis. This explains the occurrence of a distinct recrystallization stage without defect annealing. Finally, it should be mentioned that the first recovery stage is not necessarily expected to occur in less damaged zircon crystals (<∼2 × 10¹⁸ α-decays g⁻¹), since less stable defects along the basal plane might have already been self-annealed during radiation damage accumulation under ambient temperatures. Received: 6 September 2001 / Accepted: 25 February 2002     

Spectroscopic evidence for pressure-induced phase transitions in diopside

 Raman spectra of diopside were collected from atmospheric pressure to 71 GPa. The pressure dependences of 22 modes were determined. Changes occurred in the spectra at three different pressures. First, at approximately 10 GPa, the two Raman modes at 356 and 875 cm⁻¹ disappeared, while the mode at 324 cm⁻¹ split into two modes, diverging at this pressure with significantly different pressure shifts; second, at approximately 15 GPa, a small (1 to 2 cm⁻¹) drop in several of the frequencies was observed accompanied by changes in the pressure dependency of some of the modes; and third, above 55 GPa, the modes characteristic of chains of tetrahedrally coordinated silicon disappeared, while those for octahedrally coordinated silicon appeared. The first change at 10 GPa appears to be a C2/c to C2/c transition involving a change in the Ca coordination. The third change above 55 GPa appears to be a change in the silicon coordination. At 15 GPa, it is suggested that a change in compressional mechanism takes place. Received: 14 November 2000 / Accepted: 9 January 2002     

Premelting and calcium mobility in gehlenite (Ca2Al2SiO7) and pseudowollastonite (CaSiO3)

 Premelting effects in gehlenite (Ca₂Al₂SiO₇) have been studied by Raman spectroscopy and calorimetry, and in gehlenite and pseudowollastonite (CaSiO₃) by electrical conductivity. The enthalpy of premelting of gehlenite is 17.3 kJ mol⁻¹ and represents 9% of the reported enthalpy of fusion, which is in the range of the reported fraction of other minerals. The Raman and electrical conductivity experiments at high temperatures, for gehlenite and pseudowollastonite, show that the premelting effects of both compositions are associated with enhanced dynamics of calcium atoms near the melting point. This conclusion agrees with the results obtained for other minerals like diopside, but contrasts with those found for sodium metasilicate in which the weaker bonding of sodium allows the silicate framework to distort near the melting temperature and deform in such a way to prefigure the silicate entities present in the melt. Received: 30 April 2002 / Accepted: 7 August 2002 Acknowledgements We thank Y. Linard for help with DSC measurements and two anonymous reviewers for their constructive comments. This work has been partly supported by the EU Marie-Curie fellowship contract no. HPMF-CT-1999-00329, the CNRS-Carnegie Institution of Washington program PICS no.192, and the NSF grants EAR-9614432 and EAR-9901886 to B.O.M.     

3D characterization of coarse aggregates

A new and accurate characterization method for dimensions, shape and roughness of aggregate particles has been developed. The method is based on the 3D-laser scanning technique and evaluation of coarse-grain aggregate-particle images. Parameters are obtained with either analytical Fourier analysis or geometrical analysis. The results from the two methods are compared with each other as well as with manual measurements. Although the Fourier-based analysis gives about 10% smaller size values, the comparison of the results shows, in general, a good agreement between the different techniques. This new method for analysis of coarse-grain aggregates gives reliable results for both the shape and topographical parameters of particles.     

Modelling of meteorological conditions at an urban scale for the PUMA winter campaign

For the winter 2000 campaign of the Pollution of Urban Midlands Atmosphere project, observation and numerical modelling of meteorological conditions over the West Midlands conurbation, UK, was undertaken. Modelling was performed using the regional atmospheric meteorological system (RAMS). This paper presents a comparison of modelled and observed wind and temperature for 25 and 26 January 2000. The RAMS model uses two nested grids with a mesh size of 2 km for the inner grid which is embedded in the outer grid with a mesh size of 8 km. Statistical evaluation of the model results against the observational data of wind speed, direction and temperature at 10 m was conducted. In general, the modelling results are in a reasonable agreement with observation. The statistical evaluation suggests that model performance is poorer for the inner grid than the outer grid as the model uncertainties (mainly mean bias) transfer from the outer to inner one. The low indices of agreement of temperature and wind are mainly associated with the systematic root-mean-square-difference values. For temperature, the systematic bias may also be affected by representation of cloud amount by the model. For wind, the model tends to have a poor performance for calm conditions, as under a stable anti-cyclonic situation local wind patterns associated with topography may develop, although the topography of the region is relatively flat. The results for the inner grid reveal some subtle spatial patterns at a scale smaller than 10 km near hills and valleys with differences in elevation of a few hundred metres.