四川盆地西部须家河组致密砂岩成岩作用与孔隙演化模式

应用各种实验分析手段，对四川盆地西部上三叠统须家河组致密砂岩成岩作用进行研究，找出砂岩结构致密的症结所在；成岩作用与油气的研究，建立起该区致密砂岩成岩作用序列以及孔隙演化模式，为储层、油气藏的形成、研究提供了重要依据和信息。     

龙游石窟砂岩的泥质胶结物研究

本文通过对浙江龙游石窟砂岩的岩矿鉴定,砂岩泥质胶结物质的X-衍射定性及定量分析、扫描电镜观察、差热分析,以了解砂岩的泥质胶结特征,为石窟风化研究和保护加固研究提供科学依据。     

库车坳陷克拉苏构造带白垩系砂岩埋藏成岩环境的封闭性及其胶结作用分异特征

以库车坳陷克拉苏构造带白垩系巴什基奇克组为研究层段,分别通过层间泥岩硼元素含量和碳酸盐胶结物流体包体显微测温,对不同成岩期地层流体盐度进行示踪对比.由于自沉积初始至埋藏成岩期碳酸盐胶结阶段,研究层段经历一段较为稳定的构造时期,再加上沉积及构造疏导体系的缺失,地层流体始终缺乏大规模交换与改造,不同成岩场之间水-岩体系在这一阶段呈现出一定的封闭性特征,使得研究层段在碳酸盐胶结期孔隙流体盐度时空分异较好地延续了同沉积期水体盐度的分异规律,这种延续性不仅体现在平面上,也体现在垂向上.研究层段在碳酸盐胶结期后经历了强烈的构造活动,但由于断层的封堵并未对流体介质进行有效的疏导,先期形成的碳酸盐胶结分异规律因而未受到明显干扰,从而呈现出同沉积地层水体盐度时空分异特征造就了埋藏成岩期碳酸盐胶结作用的时空分异规律.     

岩石颗粒度测量方法的研究及其应用

本文介绍了三种不同岩石颗粒度的测量方法,点计法,线计法,带计法及两种不同计算程序。颗粒度测量结果研究表明三种不同测量方法及两种不同计算程序之间存在着差別,其中结合野外的实例,其应用结果带计法为最好,线段长度百分比要比颗粒的频率百分比计算程序要好,前者能较客观地反映颗粒的实际搬运时水介质动力条件和沉积物的沉积环境。     

Granulometric selectivity in Liza ramado and potential contamination resulting from heavy metal load in feeding areas

The stomach contents of thin-lipped grey mullets Liza ramado were analysed in terms of granulometric composition and compared to the sediment of potential feeding areas in the Tagus estuary. Total organic matter (TOM) content and heavy metal content were determined in the surface sediment of three areas and eight trace elements were quantified: Cd, Co, Cr, Cu, Hg, Ni, Pb and Zn. The three sampled areas did not differ in TOM; and the heavy metal content was below Effects Range-Low level for most elements. The mean observed concentrations were present in the following sequence: Zn > Pb > Cr > Cu ≈ Ni > Co > Cd > Hg. Stomach contents granulometric composition provided information about the feeding selectivity of the mullets. Sediment fractions with particle size between 20 and 50 μm are preferred, independently of the fishes' length. Smaller standard length (SL) fishes have a higher positive selection of fine grained sediments than those with a larger SL. Finer fractions usually have higher concentration of heavy metals, which makes younger specimens of the thin-lipped grey mullet potentially more exposed to heavy metal load in the estuary. Metal concentration was not independent from the sampling point, presenting higher values near the margins and the estuary tidal drainage system. This means that during the first period of each tidal cycle, the mullets will feed first on the most contaminated areas, as a consequence of their movement following the rising tide to feed on previously exposed areas.     

Bentheimer sandstone revisited for experimental purposes

Bentheimer sandstone outcrop samples are ideal for laboratory studies due to their lateral continuity and block scale homogeneous nature. Over the years they have been used to investigate reservoir topics ranging from passive and active properties of oil/gas/water/rock interaction and processes to flow and transport.This work shows an evaluation of Bentheimer sandstone properties and their characteristics to advance understanding on the mineral accessory and the physical and electrical transport properties. On the basis of the nature of depositional environments and diagenesis, we measure and characterize spatial attributes of the matrix, mainly by qualitative analysis, laboratory and stereological measurements and statistical 2D/3D reconstructions. The main contribution of this paper is the impact of mineral composition on the petrophysical quality and block scale homogeneity of the reservoir. With 3D techniques reconstructions of the new rock grain framework pore structures have been created.Based on measurements, a review of literature data and interpretation of variation between the outcrops and flow relevant parameters, we conclude that Bentheimer sandstone is a rock that shows constant mineralogy and is largely free of paramagnetic impurities. In accordance with the results of 3D reconstructions techniques and in line with the depositional settings, they show a well sorted grain framework and a pore network that can be used to calculate the permeability and resistivity without conducting any direct laboratory measurements of either parameter. It presents a porosity with a range of 0.21–0.27 and permeabilities varying between 0.52 and 3.02 Darcy. Based on our work and literature, it is found that high permeability together with similar distribution of pore throats and bodies make the sandstone an attractive and easy obtainable candidate for comparative experimental studies. Moreover, we state by comparing various techniques that the efficiency and resolution accuracy of the applied method must be taken into consideration when planning the measurements.     

Temperature dependent grain boundary migration in deformed-then-annealed material: Observations from experimentally deformed synthetic rocksalt

Grain boundary migration between strained, substructured grains and newly appearing, strain free grains has been observed during static in-situ annealing of pre-deformed rocksalt in the SEM. With increasing temperature (T) the migration velocity increases and the character of grain boundary migration changes. As temperature increases there is an increase in the length of individual migrating boundary segments that move at similar rates. In addition, the frequency of migrating boundaries that form traces of a {100} boundary plane of at least one of the crystals involved increases, and moving grain boundaries between new and old grains change from highly irregular to smooth, straight boundaries. At the same time there is a decrease in the influence of the substructure of pre-existing strained grains on the grain boundary movement. Resultant microstructures reflect these changes. At  325–350 °C, the deformed-then-annealed microstructure is characterized by very irregular grain boundaries, a high abundance of 5–50 m scale remnants of old, substructured grains within new grains, giving a poikilitic microstructure. At  350–400 °C, grain boundaries often exhibit elongate embayments into the strained grains and most remnants of old, strained grains are located at former grain boundaries. At > 400 °C, grain boundaries between new and old, strained grains are straight to smoothly curved.The grain boundary velocity observations are explained by the effect of temperature on mobility coupled with local driving force variations. Additionally, at low annealing temperature, impurity (solute) drag and driving-force variations are influential, while at high temperature the anisotropy in grain boundary energy with crystallographic orientation becomes more important. Transferring the knowledge from our experiments to geological samples enables us to recognize and interpret similar microstructures in rocks, thereby making it is possible to relate microstructural characteristics to the pre-annealing and post-deformational annealing history.     

Estimation of rice grain yield from dual-polarization Radarsat-2 SAR data by integrating a rice canopy scattering model and a genetic algorithm

Fast and accurate estimation of rice yield plays a role in forecasting rice productivity for ensuring regional or national food security. Microwave synthetic aperture radar (SAR) data has been proved to have a great potential for rice monitoring and parameters retrieval. In this study, a rice canopy scattering model (RCSM) was revised and then was applied to simulate the backscatter of rice canopy. The combination of RCSM and genetic algorithm (GA) was proposed for retrieving two important rice parameters relating to grain yield, ear length and ear number density, from a C-band, dual-polarization (HH and HV) Radarsat-2 SAR data. The stability of retrieved results of GA inversion was also evaluated by changing various parameter configurations.Results show that RCSM can effectively simulate backscattering coefficients of rice canopy at HH and HV mode with an error of <1 dB. Reasonable selection of GA’s parameters is essential for stability and efficiency of rice parameter retrieval. Two rice parameters are retrieved by the proposed RCSM-GA technology with better accuracy. The rice ear length are estimated with error of <1.5 cm, and ear number density with error of <23 #/m². Rice grain yields are effectively estimated and mapped by the retrieved ear length and number density via a simple yield regression equation. This study further illustrates the capability of C-band Radarsat-2 SAR data on retrieval of rice ear parameters and the practicability of radar remote sensing technology for operational yield estimation.     

地理信息系统支持下的中国粮食生产潜力研究

在地理信息系统（ＧＩＳ）及全国农业空间数据库和属性数据库的支持下,在前人关于农业生产潜力研究的基础上进行了全国粮食生产潜力的研究。作者首先论述粮食生产潜力研究进展,探讨了基于ＧＩＳ的粮食生产潜力研究方法;然后,就粮食生产潜力的土壤有效系数、土地生产潜力和社会有效系数、社会生产潜力提出了新型的计算模型,并应用机制法通过光、温、水、土、社逐级衰减,具体计算了全国分组粮食生产潜力;最后,针计算结果与实现     

陕北地区退耕还林还草工程土壤保护效应的时空特征

以中国退耕还林生态工程重点区域陕北地区作为研究区,基于耕地遥感监测数据集,分析了陕北地区2000-2013年耕地的时空变化特征;基于梯田空间分布,对RUSLE模型进行改进,模拟生成陕北地区土壤侵蚀模数栅格数据并进行精度验证;最后结合耕地变化数据集对陕北地区退耕还林（草）地及未退耕地的土壤侵蚀变化特征进行对比分析,以明确工程对全区土壤侵蚀变化的影响。结果表明,2000-2010年,陕北退耕农田内部侵蚀模数减少了22.70 t/hm ²,是退耕农田区2000年土壤侵蚀模数的47.08%。同期,陕北地区未退耕农田侵蚀模数减少了10.99 t/hm ²,占未退耕农田区域2000年土壤侵蚀模数的28.60%。从陕北全区的角度看,各种土地利用类型2000-2010年土壤侵蚀模数平均减少了14.51 t/hm ²,占2000年全区土壤侵蚀模数的41.87%。由此可见,退耕还林还草工程可以有效减少土壤侵蚀模数,达到土壤保护的作用。其中,由耕地转为林草所导致的侵蚀减少最为显著,对土壤保护的贡献作用最大。但是,2010年以后（2010-2013年）为退耕还林还草巩固时期,因此该阶段陕北地区土壤侵蚀模数和土壤侵蚀量变化较前10年显著降低。