Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

Numerical study of enhanced energy dissipation near a seamount

Using a two-dimensional primitive equation model, we examine nonlinear responses of a semidiurnal tidal flow impinging on a seamount with a background Garrett-Munk-like (GM-like) internal wavefield. It is found that horizontally elongated pancake-like structures of high vertical wavenumber near-inertial current shear are created both in the near-field (the region over the slope of the seamount) and far-field (the region over the flat bottom of the ocean). An important distinction is that the high vertical wavenumber near-inertial current shear is amplified only at mid-latitudes in the far-field (owing to a parametric subharmonic instability (PSI)), whereas it is amplified both at mid-and high-latitudes (above the latitude where PSI can occur) in the near-field. In order to clarify the generating mechanism for the strong shear in the near-field, additional numerical experiments are carried out with the GM-like background internal waves removed. The experiments show that the strong shear is also created, indicating that it is not caused by the interaction between the background GM-like internal waves and the semidiurnal internal tides. One possible explanation is proposed for the amplification of high vertical wavenumber near-inertial current shear in the near-field where tide residual flow resulting from tide-topography interaction plays an important role in transferring energy from high-mode internal tides to near-inertial internal waves.     

辽东湾S2冰侧限剪切强度的试验研究

利用试验方法系统地研究了辽东湾S2型海冰侧限剪切强度随剪切应变速率、加载方向、法向应力、温度和冰内孔隙率的变化规律。介绍了S2型海冰各向异性特点及剪切应变速率对剪切破坏方式的效应和韧脆破坏转变的条件。分析了不同加载方向海冰峰值剪切强度的差异 ,获得 - 6 2℃温度下S2冰内摩擦角和内聚力分别为 42°和 70 0kPa。利用统计分析给出峰值剪切强度与冰温和孔隙率的试验关系     

Gradation affects basic mechanical characteristics of Chinese calcareous sand as airport subgrade of reefs

Abstract

Construction of the reefs in the South China Sea is a significant foundation to the secure stability and economic development of China. The construction of an airport runway is necessary for this realization. The calcareous sand is the main primary material in the runway construction. A certain type of calcareous sand near a certain reef of the South China Sea was studied in this paper. To investigate this specific calcareous sand, quartz sand was used as a reference for comparison. Microscopic 3-D imaging, compression and triaxial tests were conducted to test the micro, squeezing and shear properties. The effect mechanism of gradation on the calcareous sand’s compressibility and shear characteristics are discussed from a mesoscopic viewpoint using 3-D morphology. Calcareous sand particles are multiangular and flatter in comparison with quartz sand. The larger the particle sizes are, the more different the two sands’ morphologies are. The compressibility of calcareous sand is greater, and the effect of the coarse fraction (5–1?mm) content in the gradation plays the most significant role in this feature. When the coarse particles’ content is less than 25% and the mass ratio of the middle and fine particles (M) is constant, there is the worst coarse fraction content causing the calcareous sand to be most likely compressed. The worst coarse fraction content decreases with the increase in M, and an empirical formula is proposed. When the gradation, relative density and confining pressure are the same, the peak shear stress and strain of calcareous sand are all at a high level. The effect of confining pressure is manifested in calcareous sand. The shear strength and dilation of calcareous sand are also most affected by the medium coarse fraction (5–0.25?mm) content.     

具有内波特性的渤海南部次重力波

次重力波(infragravity waves)是频率范围介于局地平均Brunt-V¾is¾l¾频率和0.05Hz(涌浪频率)之间的一种海洋波动,其能量在深水大洋中一般甚低,但在浅海中却很强.该波动的研究对于浅海海洋内部混合、近岸海洋工程、海洋生态学、海洋沉积学及军事海洋学均有重要的意义.Munk[1]很早就开始研究这类波动,然而主要由于观测技术的限制,对于该类波动的动力学机制的研究进展迟缓.     

A Preliminary Study of Shear Wave in Seafloor Surface Sediments

This article preliminarily reports and analyses the transmission characteristics and behaviors of shear wave in the offshore seafloor surface sediments in China, discusses the relationships between the physical and mechanical features of the shear wave and the compression wave, and compares the testing results with that of Hamilton and Chen et al. The result shows that the shear wave can be tested if the seafloor surface sediment has tangent modulus. The shear wave velocity ranges from 50-600 m/s and the measuring frequency from 50-200 kHz. The sound velocity rate of shear wave and compression wave can be used to appraise the stress-strain feature of seafloor surface sediments. This study provides a basis for further describing and appraising the seafloor sedimentary acoustic-mechanical feature and building a geological-acoustic model on China's offshore sea area.     

The Vema Transverse Ridge (Central Atlantic)

Transverse ridges are elongate reliefs running parallel and adjacent to transform/fracture zones offsetting mid-ocean ridges. A major transverse ridge runs adjacent to the Vema transform (Central Atlantic), that offsets the Mid-Atlantic Ridge by 320 km. Multibeam morphobathymetric coverage of the entire Vema Transverse ridge shows it is an elongated (300 km), narrow (<30 km at the base) relief that constitutes a topographic anomaly rising up to 4 km above the predicted thermal contraction level. Morphology and lithology suggest that the Vema Transverse ridge is an uplifted sliver of oceanic lithosphere. Topographic and lithological asymmetry indicate that the transverse ridge was formed by flexure of a lithospheric sliver, uncoupled on its northern side by the transform fault. The transverse ridge can be subdivided in segments bound by topographic discontinuities that are probably fault-controlled, suggesting some differential uplift and/or tilting of the different segments. Two of the segments are capped by shallow water carbonate platforms, that formed about 3–4 m.y. ago, at which time the crust of the transverse ridge was close to sea level. Sampling by submersible and dredging indicates that a relatively undisturbed section of oceanic lithosphere is exposed on the northern slope of the transverse ridge. Preliminary studies of mantle-derived ultramafic rocks from this section suggest temporal variations in mantle composition. An inactive fracture zone scarp (Lema fracture zone) was mapped south of the Vema Transverse ridge. Based on morphology, a fossil RTI was identified about 80 km west of the presently active RTI, suggesting that a ridge jump might have occurred about 2.2 m.a. Most probable causes for the formation of the Vema Transverse ridge are vertical motions of lithospheric slivers due to small changes in the direction of spreading of the plates bordering the Vema Fracture Zone.     

0220号热带风暴(米克拉)特征分析

南海是热带气旋活动较为频繁的地区之一。该地区因其独特的地理环境和复杂的热带大气环流系统，在热带气旋预报工作上存在一定的困难。本文在分析一些气象图表资料的基础上，对2002年第20号热带风暴(米克拉)的形成、发展及消亡进行了探讨和研究。主要从形成的背景环流，气旋的结构等方面入手，总结出一些该气旋所具备韵特有流场，从而为以后的南海自生热带气旋预报工作积累一定经验。     

海底浅层介质切变波的初步研究

初步分析了中国沿海海底浅层介质切变波的传播特性,讨论了多种海底浅层介质切变波与压缩波、物理力学性质之间的关系,并与Hamilton和Chen等人的结果进行了比较。认为海底浅层介质存在切变模量,切变波可以被测量出来,切变波速为50—600m·s-1,测量频率在50—200kHz之间,用波速比可以评价海底浅层介质的应力 应变性质。研究工作有助于描述和评价中国沿海海底浅层介质声学物理性状,并为最终建立中国沿海海底地声模型提供依据。     

震前卫星热红外环形应力场特征

本文包括两部分内容:①描述了1996年2月3日云南丽江Ms7.0级地震,震前几天的卫星热红外图像呈现圆形,它的NNW、NW、SN、及NE向的热旋扭面往S收敛。该地震地表破裂由一系列张扭性裂缝组成,呈左旋左列,水平位错不明显,垂直断距数厘米。垂直力对构造变动的作用较为明显;而丽江地震震源机制解破裂面II的走向NNE6o,倾向W,倾角44o,P轴方位为NNE3o、仰角75o,近于直立,综合热旋扭面展布、地震地表破裂特征及震源机制解,得出该旋扭椭圆为地幔外侧右旋上涌所造成;②菲律宾萨马岛Ms7.0～7.5强震群及青海共和Ms7.0地震前热应力环椭圆的推进路径。根据这一特征得出交变潮汐力的地球动力学解释。卫星热红外图像震前应力热场的方法是临震预测地震的有效方法,卫星热红外技术辅以震源机制解和地表破裂带力学分析是研究地球动力学有力工具。地球自转速度变化,交变潮汐力和地幔旋扭上涌力是地球动力学的主因。