全站仪似水准法和对向法高程测量的比较研究

通过对似水准法和对向法高程测量原理、误差来源及精度的比较分析,我们发现随着距离和竖直角度的增大,对向法高程测量中误差的变化大于似水准法高程测量中误差的变化;当两观测点间的水平距离小于等于1km时,对向法高程测量精度一般高于似水准法高程测量精度,但是当两观测点间的水平距离大于1km时,似水准法高程测量精度一般高于对向法高程测量精度。     

基于LBV变换的遥感影像多步骤分类法研究

面对与日俱增的遥感数据,如何快速准确地进行影像分类成为遥感领域亟待解决的问题。本文在前人的基础上提出了一种基于LBV变换的遥感影像多步骤分类方法。L:地物的总辐射水平,集中反映了裸地的信息;B:地物的可见-红外光辐射平衡,是地面水分状况和水体存在的一个良好指标;V:地物辐射随波段变化的方向和速度向量,能集中反映地面植被状况。多步骤分类法遵循由易到难的原则,能克服类别之间的互相影响,从而提高分类精度。文章结合LBV变换和多步骤分类法的优点对影像进行了分类,结果表明该方法简单易行,且能达到良好的分类精度。     

全程注浆在隧道穿越既有建筑物中的试验研究

厦门市成功大道工程是福建省2005年重点建设项目,项目由多座立交和两条特长城市隧道组成,其中莲前至梧村山隧道里程长度为3 700 m,采用双洞双向6车道标准.隧道在埔南工业区的685 m段采用跨度达34 m的浅埋连拱结构穿越地面67栋密集建构筑物.洞项至地表的覆盖层只有7～24 m,水文、地质较差,洞顶基本为杂填土和残积亚黏土层,洞底多为全、强风化花岗岩,地下饱和水位高(局部洞身地处海平面以下20 m左右),施工风险极大.为了保证既有地面建构筑物的安全,提出了以过程控制和过程恢复为核心的全过程注浆方案,并预留104#和105#拆迁房为试验楼,采取地面注浆和洞内注浆的方法来进行过程控制和房屋抬升的试验.在现场试验中,根据全过程注浆的思路,提出了建筑物安全风险控制标准.通过室内试验比较了不同浆液的注浆效果,分析实际施工中房屋摹础改造和地基注浆加固、动态跟踪注浆以及工后房屋恢复抬升的特点和效果.在注浆过程中进行实时的信息反馈和分析,进而了解注浆工艺和参数与地层加崮效果和建筑物抬升效果之间的关系,得出了一系列有意义的结论.试验结果为隧道后续穿越建构筑物施工提供经验和指导,研究思路可为类似的隧道穿越工程提供一定的参考.     

Accuracy assessment of lidar-derived digital elevation models

Despite the relatively high cost of airborne lidar-derived digital elevation models (DEMs), such products are usually presented without a satisfactory associated estimate of accuracy. For the most part, DEM accuracy estimates are typically provided by comparing lidar heights against a finite sample of check point coordinates from an independent source of higher accuracy, supposing a normal distribution of the derived height differences or errors. This paper proposes a new methodology to assess the vertical accuracy of lidar DEMs using confidence intervals constructed from a finite sample of errors computed at check points. A non-parametric approach has been tested where no particular error distribution is assumed, making the proposed methodology especially applicable to non-normal error distributions of the type usually found in DEMs derived from lidar. The performance of the proposed model was experimentally validated using Monte Carlo simulation on 18 vertical error data-sets. Fifteen of these data-sets were computed from original lidar data provided by the International Society for Photogrammetry and Remote Sensing Working Group III/3, using their respective filtered reference data as ground truth. The three remaining data-sets were provided by the Natural Environment Research Council's Airborne Research and Survey Facility lidar system, together with check points acquired using high precision kinematic GPS. The results proved promising, the proposed models reproducing the statistical behaviour of vertical errors of lidar using a favourable number of check points, even in the cases of data-sets with non-normally distributed residuals. This research can therefore be considered as a potentially important step towards improving the quality control of lidar-derived DEMs.     

Formation Dynamics and Quantitative Prediction of Hydrocarbons of the Superpressure System in the Dongying Sag

Based on the theory of formation dynamics of oil/gas pools, the Dongying sag can be divided into three dynamic systems regarding the accumulation of oil and gas： the superpressure closed system, the semi-closed system and the normal pressure open system. Based on the analysis of genesis of superpressure in the superpressure closed system and the rule of hydrocarbon expulsion, it is found that hydrocarbon generation is related to superpressure, which is the main driving factor of hydrocarbon migration. Micro fractures formed by superpressure are the main channels for hydrocarbon migration. There are three dynamic patterns for hydrocarbon expulsion： free water drainage, hydrocarbon accumulation and drainage through micro fissures. In the superpressure closed system, the oil-driving-water process and oil/gas accumulation were completed in lithologic traps by way of such two dynamic patterns as episodic evolution of superpressure systems and episodic pressure release of faults. The oil-bearing capacity of lithologic traps is intimately related to reservoir-forming dynamic force. Quantitative evaluation of dynamic conditions for pool formation can effectively predict the oil-bearing capability of traps.     

数字测图技术在阜新市地理数据库更新中的应用

采用GPS和全站仪联合作业的数字测图方式进行了外业快速数据采集。并利用南方CASS软件对数据进行内业成图工作,最后利用大型的地理信息系统软件ArcGIS进行地理数据的入库,从而实现了阜新市区地理数据库的更新,此方式具有速度快、效率高和精度高等优点,可以借鉴到同类的地区。     

六道湾煤矿塌陷西区地面沉降监测设计方法探讨

介绍乌鲁木齐市六道湾煤矿塌陷区综合治理过程中地面沉降观测站、观测线的设计方法,所需观测内容,观测方法以及所使用观测仪器的精度。在观测站、观测线设计时综合考虑老采空区变形的影响,并针对该区两个不同时段开采变形观测站布设方法分别进行了设计。其中所介绍的设计方法对其它地区类似煤矿塌陷区综合治理有一定意义。     

半参数平差模型估计量的精度评定

将半参数估计理论引入测量数据处理理论中,利用Blight和Ott提出的思想,用多项式函数来表示半参数平差模型中的非参数分量,从而得到了半参数平差模型中参数分量和非参数分量的Bayes估计量,通过理论证明,半参数模型参数分量的Bayes估计为通常意义下高斯马尔可夫模型参数估计值与参数期望的加权平均,是一致、渐近无偏和渐近有效估计量,并且其方差小于参数模型中参数估计量的方差。在一定情况下推广了平差理论,具有一定的理论价值。     

基于圆增长特征的点状要素群选取算法

控制点、独立地物等在地图上呈点群状表达,如何高效、合理地实现此类要素的自动综合是地图多尺度表达的重要问题。文中在前人研究的基础上,提出一种基于圆增长特征的点状要素群结构化选取算法,实现点状要素群的自动选取。其基本原理是：根据一个点与其周围点重要性程度的比较来确定该点删除与否,从而确保其拓扑关系和几何信息的正确性。实验证明：该算法实用、有效。     

加固需求度分析在某水电站右岸边坡的应用

边坡工程需要合理确定加固区与非加固区,在施工过程中,要动态调整设计方案。加固需求度方法将影响边坡稳定的主要因素与现场实际的位移监测结果结合起来,依靠专家经验知识,能够得到比较好的结果。在边坡加固需求度的基础上,引入影响权值,对某水电站右岸边坡稳定性进行分析,计算出一段位移监测期内边坡各部分的加固需求程度,得到了比较好的应用。