Meteorology and haze structure during AGASP-II,Part 1: Alaskan Arctic flights, 2–10 April 1986

The second Arctic Gas and Aerosol Sampling Program (AGASP-II) was conducted across the Alaskan and Canadian Arctic in April 1986, to study the in situ aerosol, and the chemical and optical properties of Arctic haze. The NOAA WP-3D aircraft, with special instrumentation added, made six flights during AGASP-II. Measurements of wind, pressure, temperature, ozone, water vapor, condensation nuclei (CN) concentration, and aerosol scattering extinction (b_sp) were used to determine the location of significant haze layers. The measurements made on the first three flights, over the Arctic Ocean north of Barrow and over the Beaufort Sea north of Barter Island, Alaska are discussed in detail in this report of the first phase of AGASP II. In the Alaskan Arctic the WP-3D detected a large and persistent region of haze between 960 and 750 mb, in a thermally stable layer, on 2, 8, and 9 April 1986. At its most dense, the haze contained CN concentrations >10,000 cm^–3 and b_sp of 80×10^–6 m^–1 suggesting active SO₂ to H₂SO₄ gas-to-particle conversion. Calculations based upon observed SO₂ concentrations and ambient relative humidities suggest that 10⁴–10⁵ small H₂SO₄ droplets could have been produced in the haze layers. High concentrations of sub-micron H₂SO₄ droplets were collected in haze. Ozone concentrations were 5–10 ppb higher in the haze layers than in the surrounding troposphere. Outside the regions of haze, CN concentrations ranged from 100 to 400 cm^–3 and b_sp values were about (20–40)×10^–6 m^–1. Air mass trajectories were computed to depict the air flow upwind of regions in which haze was observed. In two cases the back trajectories and ground measurements suggested the source to be in central Europe.     

Multiple scattering of seismic waves in fractured media: Velocity and effective attenuation of the coherent components ofP waves andS waves

We show that the multiple scattering by small fractures of seismic waves with wavelengths long compared to the fracture size and fracture spacing is indistinguishable from multiple-scattering effects produced by regular porosity, except for an orientation factor due to fracture alignment. The fractures reduce theP-wave andS-wave velocities and produce an effective attenuation of the coherent component of the seismic waves. The attenuation corresponds to 1000/Q of about unity for a Gaussian spectrum of fractures, and it varies with frequencyf asf ³. For a Kolmogorov spectrum of fractures of spectral index the attenuation is an order of magnitude or so larger and varies with frequency asf ^3-v The precise degree of attenuation depends upon the matrix properties, the fracture porosity, the degree of fracture anisotropy, the type of fluid filling the fractures, and the incidence angle of the wave.For fracture porosities less than about 15% theP-wave andS-wave velocities are decreased by the order of 5–10% with a lesser dependence on the type of fluid filling the fractures (gas, oil, or brine) and with a dependence on both the degree of anisotropy and the incident angle made by the wave. The tendency of fractures to occur perpendicularly to bedding suggests that the best way to measure seismically fractured rock behavior in situ is by using the travel-time delay and reflection amplitude. As both the offset and the azimuth of receivers vary from a shot, the travel-time delay and reflection amplitude should both show an elliptical pattern of behavior—the travel-time delay in response to the varying seismic speed, and the reflection amplitude in response to angular variations in the multiple scattering. Observations of attenuation at several frequencies should permit (a) determination of the spectrum of fractures (Gaussian versus Kolmogorovian) and (b) determination of the contribution of viscous damping to the effective attenuation.     

圆弧型沉积盆地对平面SH波的散射

采用波函数展开方法给出圆弧型沉积盆地对面ＳＨ波二维散射问题的封闭级数解答。利用外域Ｇｒａｆ加法公式将解答归结为无穷代数方程组的求解。通过截断计算得到解答的数值结果，并通过连续条件的满足程度检验了截断计算的精度。将本文结果已有的近似解析解进行比较，指出了近似解答的误差来源和适用范围。给出一些典型算例说明盆地深度比对地震动的复杂作用。     

一种利用积分球原理的日照计新方案

该文提出了一种利用积分球原理设计的新型日照传感器。该传感器由限角挡环、积分球体和光电探测器组成。积分球为一有5个针孔的空心正球体。针孔可阻挡散射光进入球内，而射入球内的直射光，经内壁多次漫反射后，其亮度呈均匀分布。与日照阈值下相应的亮度相比较可确定日照之有无。该日照传感器具有无转动部件、结构简单、无需调整及便于操作等优点。     

Uncertainty in Coal Property Valuation in West Virginia: A Case Study

Interpolated grids of coal bed thickness are being considered for use in a proposed method for taxation of coal in the state of West Virginia (United States). To assess the origin and magnitude of possible inaccuracies in calculated coal tonnage, we used conditional simulation to generate equiprobable realizations of net coal thickness for two coals on a 7 min topographic quadrangle, and a third coal in a second quadrangle. Coals differed in average thickness and proportion of original coal that had been removed by erosion; all three coals crop out in the study area. Coal tonnage was calculated for each realization and for each interpolated grid for actual and artificial property parcels, and differences were summarized as graphs of percent difference between tonnage calculated from the grid and average tonnage from simulations. Coal in individual parcels was considered minable for valuation purposes if average thickness in each parcel exceeded 30 inches. Results of this study show that over 75% of the parcels are classified correctly as minable or unminable based on interpolation grids of coal bed thickness. Although between 80 and 90% of the tonnages differ by less than 20% between interpolated values and simulated values, a nonlinear conditional bias might exist in estimation of coal tonnage from interpolated thickness, such that tonnage is underestimated where coal is thin, and overestimated where coal is thick. The largest percent differences occur for parcels that are small in area, although because of the small quantities of coal in question, bias is small on an absolute scale for these parcels. For a given parcel size, maximum apparent overestimation of coal tonnage occurs in parcels with an average coal bed thickness near the minable cutoff of 30 in. Conditional bias in tonnage for parcels having a coal thickness exceeding the cutoff by 10 in. or more is constant for two of the three coals studied, and increases slightly with average thickness for the third coal.     

硬土—软岩工程地质信息管理分析系统及其应用

在中国大规模的工程建设实践中,人们积累了大量与硬土-软岩有关的工程经验和测试数据,总结这些测试结果并用现代计算机技术进行自动化管理是十分必要的,作者以中国科学院地质与地球物理研究所工程地质力学开放研究实验室多年来的室内试验结果为基础,研制开发了“硬土-软岩工程地质信息管理分析系统（HRGISM）”软件,实现了岩土工程地质信息资源管理的自动化和可视化,并在信息管理的基础上强化了试验数据分析和工程特性预测功能,本文简要地介绍了HRGIMS系统的主要功能和实际应用。     

航空物探在酸性岩岩性划分中的效果

北山地区近几年来开展的大比例尺、高精度航空物探(磁、伽马能谱)测量,为岩性分类提供了可靠的高分辨率基础资料,也为这一地区的地质矿产勘查提供了新的信息.以北山东段岩性构造填图酸性侵入岩分类为例,介绍航空物探岩性分类的技术方法及工作要点.     

Heat capacity of γ-Fe2SiO4 between 5 and 303 K and derived thermodynamic properties

A multi-anvil device was used to synthesize 24 mg of pure γ-Fe₂SiO₄ crystals at 8.5 GPa and 1,273 K. The low-temperature heat capacity (C _p) of γ-Fe₂SiO₄ was measured between 5 and 303 K using the heat capacity option of a physical properties measurement system. The measured heat capacity data show a broad λ-transition at 11.8 K. The difference in the C _p between fayalite and γ-Fe₂SiO₄ is reduced as the temperature increases in the range of 50–300 K. The gap in C _p data between 300 and 350 K of γ-Fe₂SiO₄ is an impediment to calculation of a precise C _p equation above 298 K that can be used for phase equilibrium calculations at high temperatures and high pressures. The C _p and entropy of γ-Fe₂SiO₄ at standard temperature and pressure (S°₂₉₈) are 131.1 ± 0.6 and 140.2 ± 0.4 J mol⁻¹ K⁻¹, respectively. The Gibbs free energy at standard pressure and temperature (ΔG° _f,298) is calculated to be −1,369.3 ± 2.7 J mol⁻¹ based on the new entropy data. The phase boundary for the fayalite–γ-Fe₂SiO₄ transition at 298 K based on current thermodynamic data is located at 2.4 ± 0.6 GPa with a slope of 25.4 bars/K, consistent with extrapolated results of previous experimental studies.     

福建开展森林人家休闲健康游的探讨

通过对国内开展乡村旅游现状的调研,分析了目前福建开展乡村旅游存在的问题,借鉴川、渝、浙等地乡村旅游"农家乐"的成功经验,结合福建依托森林资源特色开展森林人家的主要措施,对如何进一步提升森林人家品牌进行了探讨.     

Walsh列率域中多维分形模型与GIS环境下地球物理信号处理

地球物理信号通常在多个尺度段表现尺度不变性，这些不变性起因于不同的地质、地球物理或成矿过程的自相似性. 利用这种在多个尺度段的尺度不变性可以设计多维分形滤波器，滤波所得信号表征了具尺度不变性的地质地球物理或成矿过程，可以用于成矿预测或环境评价. 本文研究了Walsh变换列率空间地球物理信号的列率功率谱密度与列率之间的分形与多维分形关系, 试验证实了大洋钻探、石油以及煤系地层地球物理测井资料在Walsh域的多维分形性质，提出了用于分解地球物理场,提取有用信号并用于矿产资源勘探或环境评价的多维分形W-A模型. 利用波列率域中的多维分形关系构造了W A图解(W-A Plot). 借助W-A图解可以确定最小平方误差（LS）意义下Walsh功率谱变化的不同自相似性的频率分界点,从而用于设计W-A分形滤波器. 这种滤波器可将地球物理场分解成具有不同自相似性的局部场,并且保留原场的各向异性结构. 与通常使用的基于Fourier变换的滤波技术相比,W-A模型具有许多优点：W-A适用于检测地球物理信号中的突变、线性、环状、局部与纹理结构等弱信号. 同时，由于Walsh变换中只有简单的变号(加法与减法)，其计算速度远快于建立在复数乘法之上的Fourier变换，所以W-A计算速度远快于Fourier域的滤波方法，可以用于地球物理信号的现场实时处理. 用加拿大Nova-cotia省西南地区的布格重力异常进行了W-A方法的试算，处理结果反映了地质、矿产分布规律，能够很好地进行矿产预测.