科尔沁沙地30种植物叶凋落物CO2释放量及释放速率的研究

 采用可以有效控制环境因子的室内土壤培养试验，初步研究了科尔沁沙地30种植物叶凋落物的CO₂释放量及释放速率。结果表明：①在28 d培养期内，不同植物叶凋落物释放的CO₂量差异很大，其中，多年生植物叶凋落物CO₂释放量平均值大于一年生植物，但二者之间的差异不显著；禾本科植物叶凋落物CO₂释放量平均值明显小于其他植物，二者之间呈显著差异。②在28 d培养期内，不同植物叶凋落物每四天CO₂释放速率差异很大。一年生与多年生植物叶凋落物28 d内每四天释放CO₂的速率无显著差异；禾本科与其他植物叶凋落物每四天释放CO₂的速率在培养的前16 d差异呈显著，而后差异消失。③植物叶凋落物的全碳含量，氮含量，C／N，灰分/N及灰分含量不同造成CO₂释放量及释放速率的差异。叶凋落物28 d释放CO₂的量与叶凋落物初始碳含量及灰分含量均无相关关系，与叶凋落物初始氮含量呈显著正相关，与叶凋落物C／N及灰分／N呈显著负相关。叶凋落物培养期内每四天释放CO₂的速率与叶凋落物初始碳含量无相关关系；叶凋落物0\_20天释放CO₂的速率与叶凋落物初始氮含量呈显著正相关，与叶凋落物C／N呈显著负相关；叶凋落物9\_28天CO₂释放速率与灰分／N呈显著负相关；培养后期（17\_28天）的CO₂释放速率与灰分含量呈显著负相关。     

疏松砂岩稠油油藏出砂冷采机理及配套技术研究

稠油出砂冷采技术对地层原油含有溶解气的各类疏松砂岩稠油油藏具有较广泛的适应性，它通过大量砂子的产出和泡沫油的形成，获得较高的原油产量，河南油田于1996年在国内率先开展稠油出砂冷采技术调研及可行性研究，出砂冷采机理及配套工艺技术研究，并于1997年6月进入现场先导试验，矿场试验已展示出明显出砂冷采特征的G4906井，日产油量20t-30t，是常规开采和蒸汽吞吐的10倍和4倍以上，开采成本比蒸汽吞吐降低47%，出砂冷采工业化应用配套技术的形成和应用，将使国内及河南油田稠油资源利用程度进一步提高。     

Evaluation of density in layer compaction using SASW method

SASW test, which is non-intrusive and rapid in the field application, was used to evaluate the layer density in the roller compaction without performing the complicated inversion process. The concept of normalized shear wave velocity was introduced to minimize the effect of confinement in the density evaluation. SASW test was performed to determine the shear wave velocity of the layer, and the free–free resonant column (FF–RC) test was adopted to determine the correlation between the normalized shear wave velocity and density of the site, which is almost unique independent of confinement. Testing and data reduction procedures of both tests were briefly discussed and an evaluation procedure of the field density was proposed by effectively combining in-situ shear wave velocity determined by the SASW test with the correlation between the normalized shear wave velocity and the density determined by the FF–RC test. Finally, the feasibility of the proposed method was verified by performing a field case study at Hoengsung road construction site. Field densities determined by the proposed method matched well with those determined by sand cone tests, showing the potential of applying the proposed method in the field density evaluation.     

Prediction method of sand-movement direction in water by geochemical elements

The analysis of sand samples by x-ray fluorescent spectroscopy (XRF) gives the ratio of the geochemical elements to construct the sand samples. The x-ray analysis therefore shows the geochemical characteristics of sand in the sampled area. In this study, sand is sampled on coasts and rivers of the Noto Peninsula to determine the geochemical elements and to show the geological characteristics that occur, especially iron and calcium. The experiments show the effect of rivers and Kotogahama beach on iron and calcium, respectively. Applying the method of ratio matching to the measured data of the geochemical elements, the direction of movement of sand on the coast is determined by considering the correlation matrix and the ratio of geochemical elements between sand samples at two locations. The predominant longshore direction movement of sand offshore in the study area is from south to north. Sand in rivers is not directly transported to adjacent beaches; however, offshore sand is transported to beaches. The estimated direction of movement of sand longshore near coastal structures agrees with observations. The proposed method to predict the direction of movement of sand gives the correct one in comparison with the observed data in rivers.     

Migrating sand waves

A simple mathematical model is described, which reproduces the major features of sand waves' appearance and growth and in particular predicts their migration speed. The model is based on the linear stability analysis of the flat configuration of the sea bottom subject to tidal currents. Attention is focused on the prediction of the complex growth rate that bottom perturbations undergo because of both oscillatory fluid motions and residual currents. While the real part _r of controls the amplification or decay of the amplitude of the bedforms, the imaginary part _i is related to their migration speed. Previous works on the migration of the sand waves (Németh etal. 2002) consider a forcing tide made up by the M2 constituent (oscillatory period equal to 12 h) plus the residual current Z0 and predict always a downcurrent migration of the bedforms. However, field cases exist of upcurrent-migrating sand waves (downcurrent/upcurrent-migrating sand waves mean bedforms moving in the direction of the steady residual tidal current or in the opposite direction, respectively). The inclusion of a tide constituent characterized by a period of 6 h (M4) is the main novelty of the present work, which allows for the prediction of the migration of sand waves against the residual current Z0. Indeed, the M4 tide constituent, as does also the residual current Z0, breaks the symmetry of the problem forced only by the M2 tide constituent, and induces sand-wave migration. The model proposed by Besio etal. (2003a) forms the basis for the present analysis. Previous works on the subject (Gerkema 2000; Hulscher 1996a,b; Komarova and Hulscher 2000) are thus improved by using a new solution procedure (Besio etal. 2003a) which allows for a more accurate evaluation of the growth rate for arbitrary values of the parameter r, which is the ratio between the horizontal tidal excursion and the perturbation wavelength. Responsible Editor: Jens Kappenberg     

Coupled changes in sand grain size and sand transport driven by changes in the upstream supply of sand in the Colorado River: Relative importance of changes in bed-sand grain size and bed-sand area

Sand transport in the Colorado River in Marble and Grand canyons was naturally limited by the upstream supply of sand. Prior to the 1963 closure of Glen Canyon Dam, the river exhibited the following four effects of sand supply limitation: (1) hysteresis in sediment concentration, (2) hysteresis in sediment grain size coupled to the hysteresis in sediment concentration, (3) production of inversely graded flood deposits, and (4) development or modification of a lag between the time of a flood peak and the time of either maximum or minimum (depending on reach geometry) bed elevation. Construction and operation of the dam has enhanced the degree to which the first two of these four effects are evident, and has not affected the degree to which the last two effects of sand supply limitation are evident in the Colorado River in Marble and Grand canyons. The first three of the effects involve coupled changes in suspended-sand concentration and grain size that are controlled by changes in the upstream supply of sand. During tributary floods, sand on the bed of the Colorado River fines; this causes the suspended sand to fine and the suspended-sand concentration to increase, even when the discharge of water remains constant. Subsequently, the bed is winnowed of finer sand, the suspended sand coarsens, and the suspended-sand concentration decreases independently of discharge. Also associated with these changes in sand supply are changes in the fraction of the bed that is covered by sand. Thus, suspended-sand concentration in the Colorado River is likely regulated by both changes in the bed-sand grain size and changes in the bed-sand area. A physically based flow and suspended-sediment transport model is developed, tested, and applied to data from the Colorado River to evaluate the relative importance of changes in the bed-sand grain size and changes in the bed-sand area in regulating suspended-sand concentration. Although the model was developed using approximations for steady, uniform flow, and other simplifications that are not met in the Colorado River, the results nevertheless support the idea that changes in bed-sand grain size are much more important than changes in bed-sand area in regulating the concentration of suspended sand.     

Aggregate production: Fines generation during rock crushing

The energy required to crush rocks is proportional to the amount of new surface area that is created; hence, a very important percentage of the energy consumed to produce construction aggregates is spent in producing non-commercial fines. Data gathered during visits to quarries, an extensive survey and laboratory experiments are used to explore the role of mineralogy and fracture mode in fines production during the crushing of single aggregates and aggregates within granular packs. Results show that particle-level loading conditions determine the failure mode, resulting particle shape and fines generation. Point loading (both single particles and grains in loose packings) produces clean fractures and a small percentage of fines. In choked operations, high inter-particle coordination controls particle-level loading conditions, causes micro-fractures on new aggregate faces and generates a large amount of fines. The generation of fines increases when shear is imposed during crushing. Aggregates produced in current crushing operations show the effects of multiple loading conditions and fracture modes. Results support the producers' empirical observations that the desired cubicity of aggregates is obtained at the expense of increased fines generation when standard equipment is used.     

Compressional behavior of clayey sand and transition fines content

Clayey sand can be considered as a composite matrix of coarse and fine grains. The interaction between coarser and finer grain matrices affects the overall stress–strain behavior of these soils. Intergranular void ratio, e_s (which is the void ratio of the coarser grain matrix) can be utilized as an alternative parameter to express the compressive response of such soils. Oedometer tests conducted on reconstituted kaolinite–sand mixtures indicate that initial conditions, percentage of fines, and stress conditions influence the compression characteristics evidently. Tests showed that, up to a fraction of fines, which is named as transition fines content (FC_t), compression behavior of the mixtures is mainly controlled by the sand grains. When concentration of fines exceeds FC_t, kaolinite controls the compression. It was found that FC_t varies between 19% and 34% depending on the above mentioned factors. This range of fines content is also consistent with various values reported in literature regarding the strength alteration. Performed direct shear tests revealed that there is also a close relationship between transition fines content and shear strength, which is harmonic with the oedometer test results.     

甘肃河西走廊沙尘暴与赤道中,东太平洋海温之间的遥相关分析

春、夏季甘肃河西走廊沙尘暴发生次数与赤道中、东太平洋海温之间遥相关分析结果表明：春、夏季河西走廊沙尘暴发生次数与前二年赤道中、东太平洋海温的负相关最好,时间过远或过近,相关性反而较差。利用前期的赤道中、东太平洋海温可以较好地预报出河西走廊春季沙尘暴发生的多寡。     

塔克拉玛干沙漠石油公路沿线风沙活动的气候环境

塔克拉玛干沙漠石油公路沿线风沙活动是由塔木盆地内热能释放与冷空气入侵相互作用的结果。冷期,盆地内冷高压逆温作用较强,地面热能不足,使得风力和风沙活动强度弱;暖期,盆地内热源剧增,每当热能源饱和遇到冷空气入侵诱导,导致了强风及强风沙活动天气。可见,区内风沙活动及风成景观的塑造过程,主要是在暖干期进行的。