We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.
We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.
The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.
ZS9 is made out of 36 zones where earthquakes with Mw > = 5 are expected. It also assumes that earthquakes with Mw up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.
Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates. 相似文献
The effect of moisture on the CO2 and CH4 sorption capacity of three bituminous coals from Australia and China was investigated at 55 °C and at pressures up to 20 MPa. A gravimetric apparatus was used to measure the gas adsorption isotherms of coal with moisture contents ranging from 0 to about 8%. A modified Dubinin–Radushkevich (DR) adsorption model was found to fit the experimental data under all conditions. Moisture adsorption isotherms of these coals were measured at 21 °C. The Guggenheim–Anderson–de Boer (GAB) model was capable of accurately representing the moisture isotherms over the full range of relative pressures.Moist coal had a significantly lower maximum sorption capacity for both CO2 and CH4 than dry coal. However, the extent to which the capacity was reduced was dependent upon the rank of the coal. Higher rank coals were less affected by the presence of moisture than low rank coals. All coals exhibited a certain moisture content beyond which further moisture did not affect the sorption capacity. This limiting moisture content was dependent on the rank of the coal and the sorbate gas and, for these coals, corresponded approximately to the equilibrium moisture content that would be attained by exposing the coal to about 40–80% relative humidity. The experimental results indicate that the loss of sorption capacity by the coal in the presence of water can be simply explained by volumetric displacement of the CO2 and CH4 by the water. Below the limiting moisture content, the CO2 sorption capacity reduced by about 7.3 kg t− 1 for each 1% increase in moisture. For CH4, sorption capacity was reduced by about 1.8 kg t− 1 for each 1% increase in moisture.The heat of sorption calculated from the DR model decreased slightly on addition of moisture. One explanation is that water is preferentially attracted to high energy adsorption sites (that have high energy by virtue of their electrostatic nature), expelling CO2 and CH4 molecules. 相似文献
The belemnite species Praeactinocamax primus (Arkhangelsky, 1912) and Belemnocamax boweri Crick, 1910 are described from the Cenomanian of the abandoned limestone quarry section of Hoppenstedt (Sachsen-Anhalt, northern Germany). They co-occur in the upper part of a prominent tripartite bioclastic limestone bed associated with the ammonite Acanthoceras rhotomagense, indicating the primus Event of the lower middle Cenomanian A. rhotomagense ammonite Zone. An integrated stratigraphical calibration including carbon stable isotope correlation to southern England suggests that the belemnite event horizon at Hoppenstedt occupies exactly the same chronostratigraphical position as elsewhere, highlighting the strictly isochronous character of the primus Event across northwestern Europe. Furthermore, stratigraphical gaps in the Hoppenstedt succession are evaluated. 相似文献
Ultrahelvetic units of the Eastern Alps were deposited on the distal European continental margin of the (Alpine) Tethys. The Rehkogelgraben section (“Buntmergelserie”, Ultrahelvetic unit, Upper Austria) comprises a 5 m thick succession of upper Cenomanian marl-limestone cycles overlain by a black shale interval composed of three black shale layers and carbonate-free claystones, followed by lower Turonian white to light grey marly limestones with thin marl layers. The main biostratigraphic events in the section are the last occurrence of Rotalipora and the first occurrences of Helvetoglobotruncana helvetica and Quadrum gartneri. The thickest black shale horizon has a TOC content of about 5%, with predominantly marine organic matter of kerogen type II. Vitrinite reflectance and Rock-Eval parameter Tmax (<424 °C) indicate low maturity. HI values range from 261 to 362 mg HC/g TOC. δ13C values of bulk rock carbonates display the well documented positive shift around the black shale interval, allowing correlation of the Rehkogelgraben section with other sections such as the Global Boundary Stratotype Section and Point (GSSP) succession at Pueblo, USA, and reference sections at Eastbourne, UK, and Gubbio, Italy. Sediment accumulation rates at Rehkogelgraben (average 2.5 mm/ka) are significantly lower than those at Pueblo and Eastbourne. 相似文献
The control of polluted surface runoff and the assessment of possible impacts on groundwater is a concern at the local and
regional scale. On this background, a study investigates possible impacts of organic and inorganic pollutants (including bacteria)
originating from a permeable asphalt parking lot on the water quality immediately beneath it. The functioning of the permeable
pavement, including clogging and restricted vertical percolation, was also evaluated. Four nested sample ports (shallow and
deep) were installed below low- and high-traffic areas, including one port outside the parking lot. At least initially there
was a good hydraulic connection between the parking surface and the shallow sample ports. The presence of a geotextile layer
at the base of the parking lot structure, however, was identified in lab tests as one factor restricting vertical percolation
to the deeper ports. Clogging of the permeable surface was most pronounced in heavy traffic areas and below snow pile storage
areas. Corroborated by high electric conductivity and chloride measurements, sand brought in by cars during winter was the
principal cause for clogging. No bacteria or BOD were found in percolating water. Polycyclic aromatic hydrocarbons (PAH) were
present at concentrations near minimum detection limit. Nutrients (nitrate and phosphate) were being leached into the ground
via the permeable parking lot surface at annual flux rates of 0.45–0.84 g/m2/year. A multi-species tracer test demonstrated a retention capacity of the permeable parking lot structure of >90% for metals
and 27% for nutrients, respectively. 相似文献
Understanding people’s willingness to participate in projects and programmes of payments for ecosystem services (PES) has not been a key analytical concern of the scholarly literature around this new field of environmental policy and practice. This paper analyses participation in four communities benefiting from payments for biodiversity and carbon fixation in Mexico, and contrasts the results for each case with neighbouring communities that do not receive payments. We take a holistic approach that accounts for procedural rules, actors’ interactions, institutions and values, and individuals’ characteristics. We show that the nature of PES rules and the effectiveness of communication with government officers and NGOs influence resource managers’ ability and willingness to participate. We highlight community size, resource managers’ ability to diversify livelihood activities and local perspectives on the conservation of common forests, particularly sacred values and intergenerational concerns on forest conservation, as critical participation drivers. This analysis provides insights on why and how these new institutions may be attractive for some resource managers and permits to draw some recommendations for the future design of PES projects and programmes. 相似文献
Economic concentrations of Fe–Ti oxides occur as massive,conformable lenses or layers in the lower part of the Panzhihuaintrusion, Emeishan Large Igneous Province, SW China. Mineralchemistry, textures and QUILF equilibria indicate that oxidesin rocks of the intrusion were subjected to extensive subsolidusre-equilibration and exsolution. The primary oxide, reconstructedfrom compositions of titanomagnetite in the ores and associatedintergrowths, is an aluminous titanomagnetite (Usp40) with 40wt % FeO, 34 wt % Fe2O3, 16·5 wt % TiO2, 5·3 wt% Al2O3, 3·5 wt % MgO and 0·5 wt % MnO. This compositionis similar to the bulk composition of the oxide ore, as inferredfrom whole-rock data. This similarity strongly suggests thatthe ores formed from accumulation of titanomagnetite crystals,not from immiscible oxide melt as proposed in earlier studies.The occurrence of oxide ores in the lower parts of the Panzhihuaintrusion is best explained by settling and sorting of densetitanomagnetite in the ferrogabbroic parental magma. This magmamust have crystallized Fe–Ti oxides relatively early andabundantly, and is likely to have been enriched in Fe and Tibut poor in SiO2. These features are consistent with fractionationof mantle-derived melts under relatively high pressures (10kbar), followed by emplacement of the residual magma at 5 kbar.This study provides definitive field and geochemical evidencethat Fe–Ti oxide ores can form by accumulation in ferrogabbro.We suggest that many other massive Fe–Ti oxide depositsmay have formed in a similar fashion and that high concentrationsof phosphorus or carbon, or periodic fluctuation of fO2 in themagma, are of secondary importance in ore formation. KEY WORDS: ELIP; Fe–Ti oxide ore; layered intrusion; Panzhihua; QUILF相似文献