检波器尾锥与地表耦合阻尼研究

结合检波器与松散地表耦合的实际,设计了双自由度耦合模型,从理论上分析了检波器与地表耦合系统的特性,并结合野外实验定性地分析了在不同表土情况下,检波器尾锥与地表耦合系统中尾锥与地表之间的阻尼变化时对耦合系统特性及地震资料的影响,揭示了合理的选择检波器尾锥与地表之间的阻尼在地震信号采集中的意义。     

东准噶尔纸房地区晚石炭世巴塔玛依内山组陆相火山-沉积体系特征

东准噶尔巴塔玛依内山组是典型陆相火山．沉积体系(盆地)，主体由基性及中酸性火山熔岩组成，火山碎屑岩及火山碎屑沉积岩较少，通过对纸房地区晚石炭世巴塔玛依内山组陆相火山岩的岩石化学、地球化学特征进行系统研究，认为它属于造山期后固结初期，新陆壳裂谷向高原火山岩演化的同岩浆源、同沉积盆地、同火山作用的钙碱系列双峰式火山岩．     

磁铁石英岩型铁矿岩芯光谱编录研究

 对河北省昌黎县闫庄铁矿床的磁铁石英岩型铁矿石261件样品进行了光谱反射率测量，并与其铁含量进行了相关关系研究，目 的是对钻孔岩芯编录的新方法即高光谱岩芯编录在此类矿床中的可行性进行分析。研究结果表明，铁矿石反射率较低，一般为5%~20% ，铁离子的吸收峰主要表现在400~1 100 nm范围内，铁矿石中铁含量与850~900 nm的反射率均值呈现显著指数负相关关系，为高光谱 岩芯编录在此类矿床中的可行性提供了理论依据和技术途径。     

和田地区近40年气温变化特征分析

利用和田地区4个代表站1961～2000年的气温资料，对和田地区近40a来的气温变化作了分析。得出近40年来和田地区年平均气温呈上升趋势，春季气温和于田县的年平均气温却呈下降趋势。特别是上世纪90年代增温十分明显，1999年是近40a来和田地区最暖的一年。     

新疆东昆仑木孜塔格蛇绿混杂岩中发现富Nb玄武岩

富Nb 玄武岩以相对高的TiO2 含量、低的LILE/HFSE和LREE/HFSE比值以及(La/Nb)MN＜2为特征,是岛弧环境的典型产物。首次报道发现于新疆东昆仑木孜塔格蛇绿混杂岩中的富Nb玄武岩,并分析了它们的典型地球化学特征和构造环境,表明了它们形成在岛弧环境。     

某既有建筑物改造工程地基加固质量的综合检测

随着既有建筑物的增层改造工程的发展和技术的日益成熟 ,为了提高原有建筑物地基土强度和变形能力 ,对其基础加固处理也愈加频繁。如何准确有效地评价其地基加固质量及其空间变化的均匀性是关系此类工程安全可靠的重要保证。本文以某一工程为例 ,讨论既有建筑物增层改造工程的地基加固质量的检测和综合评价方法。该建筑物建于 5 0年代 ,原设计为 5层 ,现增层为 6层 ,采用高压注浆方法进行地基加固处理.     

强水动力湖泊夏季分层期氮的生物地球化学循环初步研究:以贵州红枫湖南湖为例

湖泊在夏季由于藻类生长而消耗大量硝酸盐,水体硝酸盐含量一般要低于春季。而红枫湖南湖水体硝酸盐含量却高于春季(比平均含量高0.83mg/L),说明尚有其他重要的硝酸盐来源。据估算,南湖水体硝酸盐含量升高0.83mg/L约需要1.66×105kg硝酸盐,另外有约10.1×105kg硝酸盐随下泻水输出南湖,再加上夏季藻类生长(生产的chla量约为640kg)所消耗的硝酸盐3.52×105kg,共消耗硝酸盐15.28×105kg。扣除河流输入的4.42×105kg硝酸盐,南湖尚存在约10.86×105kg硝酸盐的亏空。利用氮稳定同位素示踪技术,结合硝酸盐及叶绿素a(chla)含量、溶解氧(DO)等的变化,认为这部分硝酸盐来自湖泊中下部(斜温层)有机质的大量矿化(硝化),是水动力驱动高DO的上部水体下沉从而引起下部有机质(硝化)的结果。南湖这种强水动力湖泊整个夏季分层期氮的生物地球化学循环是斜温层有机质矿化(硝化)释放硝酸盐和变温层藻类生长同化硝酸盐为有机质同时发生的特殊类型。     

Modelling of meteorological conditions at an urban scale for the PUMA winter campaign

For the winter 2000 campaign of the Pollution of Urban Midlands Atmosphere project, observation and numerical modelling of meteorological conditions over the West Midlands conurbation, UK, was undertaken. Modelling was performed using the regional atmospheric meteorological system (RAMS). This paper presents a comparison of modelled and observed wind and temperature for 25 and 26 January 2000. The RAMS model uses two nested grids with a mesh size of 2 km for the inner grid which is embedded in the outer grid with a mesh size of 8 km. Statistical evaluation of the model results against the observational data of wind speed, direction and temperature at 10 m was conducted. In general, the modelling results are in a reasonable agreement with observation. The statistical evaluation suggests that model performance is poorer for the inner grid than the outer grid as the model uncertainties (mainly mean bias) transfer from the outer to inner one. The low indices of agreement of temperature and wind are mainly associated with the systematic root-mean-square-difference values. For temperature, the systematic bias may also be affected by representation of cloud amount by the model. For wind, the model tends to have a poor performance for calm conditions, as under a stable anti-cyclonic situation local wind patterns associated with topography may develop, although the topography of the region is relatively flat. The results for the inner grid reveal some subtle spatial patterns at a scale smaller than 10 km near hills and valleys with differences in elevation of a few hundred metres.     

Development and testing of numerical methods for two-way nested air pollution modelling

A new 3-D model REGINA (REGIonal high resolutioN Air pollution model) is under development at the National Environmental Research Institute (NERI). The model is based on pieces from several models developed over the last decades at NERI. The aim of the work is to develop a nested model which can operate with very high resolution in both space and time. To fulfill this aim the choice and implementation of accurate numerical methods is crucial. The model will be applied for studying air pollution phenomena (both monitoring, forecasting and scenarios) over Denmark. The present paper is focussed on the modification, implementation and testing of a numerical method for treating the horizontal advection in the model as well as the implementation of two-way nesting techniques. The horizontal transport in the model is solved using an accurate space derivative algorithm. This method is traditionally implemented with periodic boundary conditions, however, this is not an option for nested modelling. A new method for calculating non-periodic boundary conditions has been developed in order to overcome this problem. Extensive testing of the numerical solution of the advection and the coupling of the solution of advection and chemistry in the model using Molenkamp–Crowley rotation tests have been carried out. The results show that the model with the current implementation of numerical methods is suitable for calculating air pollution levels with high resolution.