GEODETIC AND TELESEISMIC CONSTRAINTS ON SLIP DISTRIBUTION OF 2015 MW6.4 PISHAN EARTHQUAKE

On July 3^rd, 2015, a M_W6.4 earthquake occurred on Pishan County, Xinjiang, located in the front of western Kunlun thrust belt, which is the largest earthquake(M_W6.0~7.0)in the past 40 years in this region. In this study, we collected both the near-filed geodetic coseismic deformation observations including 4 GPS sites and one high-resolution ALOS-2 InSAR imagery, and far-field teleseismic P waveforms from 25 stations provided by IRIS/USGS, to invert the fault parameters(strike and dip)and coseismic rupture model of 2015 M_W6.4 Pishan earthquake. Using the finite fault theory, a non-linear simulated annealing algorithm was employed to resolve our joint inversion problem. The strike (120°~130°) and dip angle(35°~40°)of optimal models are different from that of some previous studies, and the dip change is strongly constrained by combined data than that of strike. In fixing the geometric parameters of optimal fault model, we also considered data weight(5)(geodetic data/teleseismic P waveforms)and constrained weight from moment and smooth factor(2.5). Clearly, our results indicate that the slip distribution mainly concentrates in the depth range from 9 to 16km and a length range of 20km along the strike direction, which is similar to the spatial distribution of the relocated aftershocks. The maximum slip is~95cm. The seismic moment release is 5.45×10¹⁸N·m, corresponding to M_W6.42. Compared with the single data set, geodetic data or teleseismic waveform, our joint inversion model could simultaneously constrain the seismic moment and slip distribution well, thus avoiding effectively a lower-resolution rupture distribution determined by teleseismic-only inversion and a bias released moment estimated by the geodetic-only inversion. Importantly, we should consider both the near-field geodetic data and far-field teleseismic data in retrieving the rupture model for accurately describing the seismogenic structure of active fault in western Kunlun region.     

玛尼地震的InSAR形变研究与模拟

采用欧洲空间局ERS-2的星载干涉雷达数据,选取1997年11月8日MW7.6级玛尼地震作为研究对象,采用了差分干涉方法,在通过对覆盖同一地区的SAR数据进行差分干涉处理,得到了玛尼地震的视线向同震形变场。经研究发现:该地震形变场呈长轴近北东东向不规则椭圆形分布,地表破裂带长度约为130km,发震断层走向约为78°,断裂为左行走滑特征。断层以南为隆起区,在发震断层附近最大视线向隆起位移量为113.6cm,断层以北为沉降区,最大视线向沉降位移量为170.4cm。基于Okada模型实现了具有复杂结构的4段断层段参数的InSAR形变场数据模拟,获得断层的最大走滑为6m,估计出玛尼地震的标量地震矩M0为2.69×10^20Nm,计算得到的矩震级MW为7.6。证明了研究方法的正确性和研究结论的可靠性。     

USE OF SEISMIC WAVEFORMS AND INSAR DATA FOR DETERMINATION OF THE SEISMOTECTONICS OF THE MAINLING MS6.9 EARTHQUAKE ON NOV.18, 2017

On November 18, 2017, a M_S6.9 earthquake struck Mainling County, Tibet, with a depth of 10km. The earthquake occurred at the eastern Himalaya syntaxis. The Namche Barwan moved northward relative to the Himalayan terrane and was subducted deeply beneath the Lhasa terrane, forming the eastern syntaxis after the collision of the Indian plate and Asian plates. Firstly, this paper uses the far and near field broadband seismic waveform for joint inversion (CAPJoint method)of the earthquake focal mechanism. Two groups of nodal planes are obtained after 1000 times Bootstrap test. The strike, dip and rake of the best solution are calculated to be 302°, 76° and 84° (the nodal plane Ⅰ)and 138°, 27° and 104° (the nodal plane Ⅱ), respectively. This event was captured by interferometric synthetic aperture radar (InSAR)measurements from the Sentinel-1A radar satellite, which provide the opportunity to determine the fault plane, as well as the co-seismic slip distribution, and assess the seismic hazards. The overall trend of the deformation field revealed by InSAR is consistent with the GPS displacement field released by the Gan Wei-Jun's team. Geodesy (InSAR and GPS)observation of the earthquake deformation field shows the northeastern side of the epicenter uplifting and the southwestern side sinking. According to geodetic measurements and the thrust characteristics of fault deformation field, we speculate that the nodal plane Ⅰ is the true rupture plane. Secondly, based on the focal mechanism, we use InSAR data as the constraint to invert for the fine slip distribution on the fault plane. Our best model suggests that the seismogenic fault is a NW-SE striking thrust fault with a high angle. Combined with the slip distribution and aftershocks, we suggest that the earthquake is a high-angle thrust event, which is caused by the NE-dipping thrust beneath the Namche Barwa syntaxis subducted deeply beneath the Lhasa terrane.     

三峡库区范家坪滑坡地表形变InSAR监测与综合分析

位于湖北省秭归县的范家坪滑坡是长江三峡库区干流上的大型岩质滑坡之一。阐述了高分辨率合成孔径雷达干涉测量技术(InSAR)监测滑坡地表形变的工作方法与技术体系,采用22景3m空间分辨率的TerraSAR-X数据,辅以人工反射体布设和GPS测量,对范家坪滑坡变形进行监测,发现滑坡处在缓慢匀速变形状态,其谭家河滑坡体的形变比木鱼包滑坡体更为强烈,形变最大处的雷达视线向形变速率达到300mm/a。通过综合分析滑坡区2012年大气降雨和长江水位资料,发现年度内范家坪滑坡变形受水位变化和大气降雨影响微弱。     

基于InSAR和GPS观测数据的尼泊尔地震发震断层特征参数联合反演研究

利用日本ALOS-2和欧空局Sentinel-1A卫星获得的尼泊尔地震同震形变场,结合GPS同震位移数据,联合反演了断层滑动分布特征和空间展布.结果表明:尼泊尔地震的同震形变场主要集中在150km×100km的范围内,且分为南北两个相邻的形变中心,南形变中心的视线向抬升量约为1.2m,北形变中心的视线向沉降量约为0.8m,均位于发震断层上盘.位于形变抬升区的KKN4和NAST两个GPS站,抬升量和南向运动量均达到了m级,而远离震区的其他GPS台水平和垂直观测量均在1cm以内.联合反演得到的断层位错分布主要集中在沿走向150km,沿倾向70km的范围内,最大滑动量为5.59m,平均滑动量为0.94m.断层面倾角在浅部约为7°,随着深度增加,倾角逐渐变大,到垂直深度20km时倾角接近12°;5月12日MW7.2级余震位于主震破裂区的"凹"型滑动缺损区域;主震破裂区的上边界与MBT空间位置十分吻合,主震破裂区主要集中的MBT以北50~60km处,垂直深度为8~9km,倾角为9°,继续向北时主震破裂面以10°~12°的倾角向深延伸,在18~20km可能与MHT交汇.因此,初步判定MBT为此次地震的发震断层.     

汶川地震同震形变场的GPS和InSAR邻轨平滑校正与断层滑移精化反演

为克服InSAR观测汶川地震同震形变场的邻轨不连续问题,提出联合GPS观测值与邻轨平滑约束的同震位移校正方法,采用GPS观测形变去除PALSAR轨道误差引入的残留平地相位,基于形变平滑条件校正邻轨干涉相位的不连续性.ALOS/PALSAR干涉处理结果表明,校正后同震形变场的准确度与平滑性得以显著提高,InSAR高相干点残差达3.6 cm,校正后精度提高约60%,低相干点精度提高约40%,校正后形变场的邻接平滑因子标准差减小约33%,验证了轨道误差校正与邻轨平滑约束方法的准确性与可靠性.进一步基于弹性半空间位错模型的断层滑移反演结果表明,断层滑移主要分布于映秀、北川和青川地区,集中于地壳深度0~16 km范围,最大滑动量（位于北川县城）约为9.0 m,GPS反演模型残差为5.5 cm,InSAR反演模型残差达9.2 cm,InSAR反演精度约有30%的显著提高,由模型反演计算得到的地震矩为8.0469×10²⁰ N·m.     

InSAR约束下的2008年汶川地震同震和震后形变分析

2008年5月12日,青藏高原东缘的龙门山断裂带上发生了M_w7.9级汶川地震.本文通过分析覆盖汶川地震震中区域的ALOS/PALSAR像对的方位向偏移量来选择无明显电离层扰动影响的像对进行干涉处理,获取了高精度、连续的InSAR地表形变场.在此基础上,结合高精度GPS同震形变数据,采用同震、黏弹性松弛震后形变联合反演模型同时确定了汶川地震的同震滑动分布和龙门山地区的流变结构参数.研究结果表明,汶川地震是一个断层破裂非常复杂的地震事件,其中,北川段、岳家山段、虹口段和汉旺段的滑动以逆冲为主,而青川段以右旋走滑为主.滑动主要发生在10 km深度以上的区域,最大滑动量位于虹口段的东北端,达10.7 m.地震释放的总能量为9.28×10²⁰ N·m（M_w7.91）,与地震学的结果一致.联合反演模型确定的龙门山地区中下地壳的黏性系数为2×10¹⁸ Pa·s,为青藏高原东部地区的黏性系数提供了一个可靠的下限值.如果有更长时间的震后形变观测时间序列,将为该区域提供更为可靠的流变结构.     

Using Envisat InSAR time-series to investigate the surface kinematics of an active salt extrusion near Qum,Iran

Lower Oligocene-Miocene rock salt is exposed in several diapirs in the central plateau of Iran along the northern margin of the Great Kavir basin. These include a small but mature salt extrusion known as Qum Kuh located near the city of Qum. We use small-baseline interferograms to study the surface displacements of Qum Kuh. The interferometric dataset consisted of 149 interferometric displacement maps derived from 35 C-band ASAR images collected by Envisat satellite in both descending and ascending orbits from 2003 through 2009.The results of the displacement time series analyses show significant long-term trend of horizontal motion toward gentle slopes of Qum Kuh, punctuated by seasonal variations during dry and wet seasons. Interferometric Synthetic Aperture Radar (InSAR) time series results suggest that the salt near the spreading center, where the salt first surfaces from depth, is extruded to the more gentle flanks of Qum Kuh and that down-slope gravitational spreading of the extruded salt accelerates when it is wet.     

InSAR干涉条纹图去噪方法的研究

分析了干涉条纹图中相位噪声的来源,介绍了几种专门用于InSAR干涉条纹图噪声滤除的方法,针对干涉条纹图的相位跳跃现象,提出了正余弦变换的方法解决相位跳跃的问题,并在此基础上提出了两种新的相位噪声滤除方法———正余弦均值滤波法和正余弦中值滤波法,最后进行了对比试验,证明了本文提出的方法具有噪声抑制效果好、边缘信息保持能力强、算法简单的特点。     

����SARӰ�񹹽���άͬ���α䳡�����о�

??2008?????????????????InSAR??MAI????????????????????λ????α???????????InSAR+AZI?????1????Multi-LOS?????2?????????????????????????α?????????????????????????????????????????￡???????????1???????????????????2??????????档