A multi-proxy reconstruction of spatial and temporal variations in Asian summer temperatures over the last millennium

To investigate climate variability in Asia during the last millennium, the spatial and temporal evolution of summer (June–July–August; JJA) temperature in eastern and south-central Asia is reconstructed using multi-proxy records and the regularized expectation maximization (RegEM) algorithm with truncated total least squares (TTLS), under a point-by-point regression (PPR) framework. The temperature index reconstructions show that the late 20th century was the warmest period in Asia over the past millennium. The temperature field reconstructions illustrate that temperatures in central, eastern, and southern China during the 11th and 13th centuries, and in western Asia during the 12th century, were significantly higher than those in other regions, and comparable to levels in the 20th century. Except for the most recent warming, all identified warm events showed distinct regional expressions and none were uniform over the entire reconstruction area. The main finding of the study is that spatial temperature patterns have, on centennial time-scales, varied greatly over the last millennium. Moreover, seven climate model simulations, from the Coupled Model Intercomparison Project Phase 5 (CMIP5), over the same region of Asia, are all consistent with the temperature index reconstruction at the 99 % confidence level. Only spatial temperature patterns extracted as the first empirical orthogonal function (EOF) from the GISS-E2-R and MPI-ESM-P model simulations are significant and consistent with the temperature field reconstruction over the past millennium in Asia at the 90 % confidence level. This indicates that both the reconstruction and the simulations depict the temporal climate variability well over the past millennium. However, the spatial simulation or reconstruction capability of climate variability over the past millennium could be still limited. For reconstruction, some grid points do not pass validation tests and reveal the need for more proxies with high temporal resolution, accurate dating, and sensitive temperature signals, especially in central Asia and before AD 1400.     

铯原子喷泉钟均匀C场的实现

C场均匀度是影响铯原子喷泉钟性能的重要因素。为了消除漏磁等对磁场均匀度的影响,加入补偿线圈,通过用最小二乘法计算,逐次得出补偿线圈的个数、位置与电流。实验表明：计算数据与实验结果吻合,得到c场不均匀性小于2nT、长度达48cm的均匀区。     

基于LabwindowsCVI的外腔半导体激光器数字稳频系统设计

为抑制外腔半导体激光器频率漂移,提高频率稳定性,提出一种数字稳频方法。该方法采用数据采集卡,基于LabwindowsCVI语言实现数字锁相放大模块获得稳频误差信号,通过此信号控制压电陶瓷电压,将852 nm外腔半导体激光器的频率锁在铯原子谱线上,实现20 s频率稳定度8.7×10-11。该数字稳频方法降低了人力成本,易升级和修改,具有移植性好和用户界面友好等优点。     

小兴安岭东南部伊春中生代花岗岩的锆石U-Pb测年及其地质意义

本文首次报道了小兴安岭南部伊春地区的五三零、南岔三林场及寒月林场岩体高精度锆石LA-ICP-MS U-Pb年龄。三个岩体均形成于早侏罗世,侵位年龄分别为175±3 Ma,180±2 Ma和195±2 Ma。岩石学和地球化学特征显示,这些岩体为高硅富碱性的钙碱性系列的二长花岗岩.花岗闪长岩组合,形成于造山后的伸展构造环境中,其大地构造背景与早侏罗世佳木斯板块和松嫩.张广才岭板块碰撞拼合后伸展作用有关。     

基于分形的滑坡易发程度区划方法

本文发展了一种基于分形统计的滑坡易发程度评价方法,该方法仅使用已有的滑坡数据,首先通过分形统计获得滑坡分布的分形丛集关系,再通过GIS的空间操作与分析生成滑坡易发程度区划图。提出一种对滑坡易发程度区划图的可信度和预测效果进行评价的方法。本文介绍了这些方法及其在浙江地区应用的结果。     

流速仪法测流最小水深计算公式推导

在<河流流量测验规范>中,规定了流速仪法测流垂线、流速测点的分布位置和布置测点时的最小水深,[1]也有这方面的刊载,并列举了部分计算公式,但公式考虑不够全面,而且还不符合规范要求.本文依据规范,按流速仪测点布置情况,分析推导出了具体完整的计算公式,并对测点布置方案选择提出了相应的建议.     

梭梭(Haloxylon ammodendron)主根周围土壤特征

通过建立米级的空间尺度进行分层取样,研究了准噶尔盆地南缘建群种——梭梭(Haloxylon ammodendron)主根周围土壤的含水率、容重、pH值、电导率和养分含量的变化状况。结果表明:(1)土壤含水量在表层5cm处最小,土壤容重在0~40cm土层变动幅度不大,但随着与茎基垂线距离的增加,二者出现显著变化(p0.05)。(2)土壤pH值和电导率在主根区周围呈现聚集现象,最大聚集率均在0~1m圈层,但随着距离的增加,土层深度逐渐成为主导因素。(3)土壤养分在表层5cm处聚集,但水平聚集范围中除有机质和全氮可扩增到3~4m外,全磷和速效养分均在0~2m。本研究结论对于荒漠区耐盐性植被的合理密植有一定的理论意义。     

坡折带控制下的砂质碎屑流对油气勘探的意义——以四川盆地上三叠统须家河组为例

坡折带近年来日益受到重视,它明显控制了上覆地层分布、岩性岩相变化和油气藏的分布。通过层序地层法恢复古地貌,在川中-川西过渡带识别大型地貌坡折带,川西地区晚三叠世接受其西部和东部两个方向的物源供给。在大量岩心观察、地震资料和测井资料研究基础上,认为在坡折带控制下,龙泉山断裂带以西须二、须四段发育砂质碎屑流重力流沉积,分析其基本特征和储集性能,最后指出砂质碎屑流储层物性总体优于川西地区南部其它类型砂体,是新型的勘探对象,具有一定的勘探潜力。     

Optimization of calcium-based bioclogging and biocementation of sand

Bioclogging and biocementation can be used to improve the geotechnical properties of sand. These processes can be performed by adsorption of urease-producing bacterial cells on the sand grain surfaces, which is followed by crystallization of calcite produced from the calcium salt and urea solution due to bacterial hydrolysis of urea. In this paper, the effect of intact cell suspension of Bacillus sp. strain VS1, suspension of the washed bacterial cells, and culture liquid without bacterial cells on microbially induced calcite precipitation in sand was studied. The test results showed that adsorption/retention of urease activity on sand treated with washed cells of Bacillus sp. strain VS1 was 5–8 times higher than that treated with culture liquid. The unconfined compressive strength of sand treated with the suspension of washed cells was 1.7 times higher than that treated with culture liquid. This difference could be due to fast inactivation of urease by protease which was present in the culture liquid. The adsorption of bacterial cells on sand pretreated with calcium, aluminum, or ferric salts was 29–37 % higher as compared with that without pretreatment. The permeability of sand varied with the content of precipitated calcium. For bioclogging of sand, the content of precipitated calcium had to be 1.3 % (w/w) or higher. The shear strength of biotreated sand was also dependent on the content of precipitated calcium. To achieve an unconfined compressive strength of 1.5 MPa or higher, the content of precipitated calcium in the treated sand had to be 4.2 % (w/w) or higher. These data can be used as the reference values for geotechnical applications such as bioclogging for reducing the permeability of sand and biocementation for increasing the shear strength of soil.     

谈钻探项目施工管理

钻探生产远离人烟、通讯不便的生产环境一直干扰人们对其进行有效的生产管理。粗放式管理、管理意识不强、管理行为不规范等现象大量存在,造成了很多重大的安全、质量事故,产生了巨大的损失。结合钻探项目生产,以项目管理理论为基础,对其进行理论分析,以探索一套适合我国地质勘探行业野外工程施工的管理模式与方法。