Facies analysis and sequence stratigraphy of Kometan Formation (Upper Cretaceous) in the imbricated zone,northeastern Iraq

Facies and sequence stratigraphic analysis of the Kometan Formation (Upper Cretaceous) were studied from Kometan village, Kurdistan region of northeastern Iraq. Lithologically, the formation consists of 44 m of white weathering, light grey, thin to medium-bedded highly fractured limestones with chert nodules. Petrographic study of the carbonates shows that both skeletal and non-skeletal grains were present. The skeletal grains include a variety of planktonic foraminifera (including Oligostegina), calcispheres, ostracods, pelecypods, larva ammonite, and echinoderms. Non-skeletal grains include peloids only. Three main microfacies types are distinguished in the studied formation. The results of stable carbon and oxygen isotopes of the studied carbonate samples show negative values of δ¹⁸O. These indicate that the seawater was warm with low salinity during precipitation of the carbonates in the Kometan Formation in northeastern Iraq. The positive δ¹³C values of carbonate samples, in the middle part of the formation, reflect the widespread deposition of organic-rich marine sediments during a transgression and deepening of the basin. Petrographic, facies and stable isotopic analyses revealed that the Kometan Formation was deposited in a warm, basinal, pelagic (open marine) environment with low salinity. The Kometan Formation consists of one complete third-order depositional sequence, separated by a sequence boundary (SB) of type 2. The third-order sequence is subdivided into a transgressive systems tract (TST) and highstand systems tract (HST). This reflects episodes of transgression and still stands of the relative sea level. The TSTs are topped by maximum flooding surface (MFS) characterized by deepening-/fining-upward parasequences implying a retrogradational stacking pattern. The HST is marked by shallowing-/coarsening-upward parasequences implying a progradational stacking pattern.     

Automatic identification of fake patterns caused by short-width wavelets in seismic data

Despite the popularity of using the Haar wavelet filter in many applications, it sometimes introduces fake patterns into the multi resolution analysis (MRA) of seismic data. In this work, we compared different wavelet filters to demonstrate that these patterns are fake and not part of the original waveforms and to show that they are a result of using the Haar wavelet filter as a short-width wavelet. To achieve this, many seismic waveforms from two different sources: the Egyptian National Seismic Network (ENSN) and the High Sensitivity Seismograph Network Japan (Hi-net) are used with different wavelet filters. We propose an algorithm based on an autoregressive (AR) model to detect these patterns automatically and fully.     

Diversity patterns of free‐living marine nematodes in the southwest continental shelf off Bay of Bengal and their link to abiotic variables

Marine sediments in continental shelf ecosystems harbor a rich biodiversity of benthic communities. In this study, the spatial and temporal diversity and community assemblages of free‐living marine nematodes were studied by sampling at six depths and over 3 years from the southwest continental shelf off Bay of Bengal, one of the least explored tropical shelf ecosystems. The dominant marine nematode species were related with abiotic variables as part of this study. The effects of sediment granulometry generally decreased with increasing depth and the highest nematode density and species diversity were recorded on coarse sand (shallower depths). Multivariate analysis of the nematode community data showed that community structure differed significantly among depths as well as among years. Statistical analyses showed significant correlations between the nematode community and abiotic variables. Sediment texture, organic matter, water pressure and depth profile were crucial factors for determining diversity, vertical profile and feeding types of the nematode community. Other environmental factors, including anthropogenic pressure, did not have an effect on nematode diversity except for the presence of some tolerant species (Metachromadora spp., Sabatieria spp. and Siplophorella sp.). This study represents a baseline of knowledge of free‐living marine nematode communities that can be used in the future to compare nematode assemblages from temperate shelf ecosystems.     

Sequence stratigraphic analysis of Eocene Rock Strata,Offshore Indus,southwest Pakistan

In this study, seismic data from two wells (Pak G2-1 and Indus Marine-1C) and age diagnostic larger benthic foraminifera (LBF) within drill cuttings has been used for the first time to identify depositional sequences within the carbonates in the Offshore Indus Basin, Pakistan. The Offshore Indus is tectonically categorized as a passive continental margin where carbonates occur as shelf carbonates in the near offshore and on volcanic seamounts in deeper waters. Seismic data analysis has indicated the presence of minor faults and carbonate buildups above the igneous basement in the south. Patterns of the seismic reflections enabled definition of three seismic facies units identified as: Unit 1 basement, represented by chaotic, moderate amplitude reflection configuration; while parallel bedding and the drape of overlying strata is typical character of Unit 2, carbonate mound facies. The younger Miocene channels represent Unit 3. The diagnosis of Alveolina vredenburgi/cucumiformis biozone confirmed the Ilerdian (55–52 Ma) stage constituting a second order cycle of deposition for the Eocene carbonates (identified as Unit 2). The carbonate succession has been mainly attributed to an early highstand system tract (HST). The environmental conditions remained favorable leading to the development of keep-up carbonates similar to pinnacle buildups as a result of aggradation during late transgressive system tract and an early HST. The carbonate sequence in the south (Pak G2-1) is thicker and fossiliferous representing inner to middle shelf depths based on fauna compared to the Indus Marine-1C in the north, which is devoid of fossils. Three biozones (SBZ 5, SBZ 6 and SBZ 8) were identified based on the occurrence of LBF. The base of the SBZ 5 zone marks the larger foraminifera turnover and the Paleocene–Eocene (P–E) boundary. The LBF encountered in this study coincides with earlier findings for the P–E boundary. Our findings indicate that the entire Ilerdian stage ranges from 55.5 to 52 Ma that was the episode of warmer water conditions on the carbonate shelves leading to the diversification of K-strategist larger foraminifera. The larger foraminiferal assemblage encountered in this study confirms the findings. The possible indication of stratigraphic-combination traps, revealed as reflection terminations, make carbonate mounds in the south a potential exploration target.     

<Emphasis Type="Italic">H-M</Emphasis> bearing capacity of a modified suction caisson determined by using load-/displacement-controlled methods

This paper presents a series of monotonically combined lateral loading tests to investigate the bearing capacity of the MSCs (modified suction caissons) in the saturated marine fine sand. The lateral loads were applied under load- and displacement-controlled methods at the loading eccentricity ratios of 1.5, 2.0 and 2.5. Results show that, in the displacement-controlled test, the deflection-softening behavior of load-deflection curves for MSCs was observed, and the softening degree of the load-deflection response increased with the increasing external skirt length or the decreasing loading eccentricity. It was also found that the rotation center of the MSC at failure determined by the load-controlled method is slightly lower than that by the displacement-controlled method. The calculated MSC capacity based on the rotation center position in serviceability limit state is relatively conservative, compared with the calculated capacity based on the rotation center position in the ultimate limit state. In the limit state, the passive earth pressures opposite the loading direction under load- and displacement-controlled methods decrease by 46% and 74% corresponding to peak values, respectively; however, the passive earth pressures in the loading direction at failure only decrease by approximately 3% and 7%, compared with their peak values.     

Spatial multi-criteria analysis for selecting potential sites for aquifer recharge via harvesting and infiltration of surface runoff in north Jordan

In (semi-)arid regions, available water resources are scarce and groundwater resources are often overused. Therefore, the option to increase available water resources by managed aquifer recharge (MAR) via infiltration of captured surface runoff was investigated for two basins in northern Jordan. This study evaluated the general suitability of catchments to generate sufficient runoff and tried to identify promising sites to harvest and infiltrate the runoff into the aquifer for later recovery. Large sets of available data were used to create regional thematic maps, which were then combined to constraint maps using Boolean logic and to create suitability maps using weighted linear combination. This approach might serve as a blueprint which could be adapted and applied to similar regions. The evaluation showed that non-committed source water availability is the most restricting factor for successful water harvesting in regions with <200 mm/a rainfall. Experiences with existing structures showed that sediment loads of runoff are high. Therefore, the effectiveness of any existing MAR scheme will decrease rapidly to the point where it results in an overall negative impact due to increased evaporation if maintenance is not undertaken. It is recommended to improve system operation and maintenance, as well as monitoring, in order to achieve a better and constant effectiveness of the infiltration activities.     

Practical Incorporation of Multivariate Parameter Uncertainty in Geostatistical Resource Modeling

There is a need to bridge theory and practice for incorporating parameter uncertainty in geostatistical simulation modeling workflows. Simulation workflows are a standard practice in natural resource and recovery modeling, but the incorporation of multivariate parameter uncertainty into those workflows is challenging. However, the objectives can be met without considerable extra effort and programming. The sampling distributions of statistics comprise the core theoretical notion with the addition of the spatial degrees of freedom to account for the redundancy in the spatially correlated data. Prior parameter uncertainty is estimated from multivariate spatial resampling. Simulation-based transfer of prior parameter uncertainty results in posterior distributions which are updated by data conditioning and the model domain extents and configuration. The results are theoretically tractable and practical to achieve, providing realistic assessments of uncertainty by accounting for large-scale parameter uncertainty, which is often the most important component impacting a project. A simulation-based multivariate workflow demonstrates joint modeling of intrinsic shale properties and uncertainty in estimated ultimate recovery in a shale gas project. The multivariate workflow accounts for joint prior parameter uncertainty given the current well locations and results in posterior estimates on global distributions of all modeled properties. This is achieved by transferring the joint prior parameter uncertainty through conditional simulations.     

Reflectance spectroscopy and remote sensing data for finding sulfide-bearing alteration zones and mapping geology in Gilgit-Baltistan,Pakistan

Gilgit-Baltistan region is covering the northern most part of Pakistan where the rocks of the Kohistan-Ladakh island arc and Karakoram plate are exposed. The area has greater potential for precious and base metals deposits which are needed to be explored through spectroscopy and remote sensing techniques. Minerals and rocks can nowadays be identified through the measurement of their absorption and reflectance features by spectroscopic analysis. Spectral reflectance analysis is also very important in selecting the appropriate spectral bands for remote-sensing data analysis of unknown or inaccessible areas. In this study, reflectance spectra in the spectral range of 0.35–2.5 μm of different types of unaltered and altered rocks found in the Machulu and Astor areas of northern Pakistan were obtained using an ASD spectroradiometer. The fresh rock samples showed low spectral reflectance as compared to the altered rock samples. The minerals jarosite, goethite, and hematite showed depth of absorption minima in the range of 0.4–1.15 μm due to the presence of iron (Fe), while jarosite and limonite showed absorption depth at 2.2 μm due to the presence of hydroxyl ions (OH^¯). The clay minerals montmorillonite and illite showed absorption depth at 1.93 and 2.1 μm, respectively. Muscovite showed depth of absorption minima at 1.4 and 1.9 μm in some samples. Calcite showed deep absorption minima at 2.32 μm, while anorthite showed absorption features at 1.4, 1.9, 2.24, and 2.33 μm. Olivine showed a slight depressed absorption feature at 1.07 μm. The copper-bearing phases malachite, chrysocolla, and azurite showed, respectively, a broad absorption feature in the range of 0.6–0.9 μm, a small absorption at 1.4 μm, and a deep absorption at 1.93 μm. The unmineralized samples exhibited high reflectance in the wavelength ranges of 0.6–0.8, 1.6–1.9, 2.0–2.3, 2.1–2.25, and 2.4–2.5 μm, respectively, while the mineralized samples showed reflectance bands in the wavelength ranges of 0.4–0.6, 1.3–1.8, and 2.1–2.2 μm. On this basis, the band ratio combinations 7/5–4/3–6/3 and 7/5–6/3–4/3 of Landsat 8 and 4/7–4/3–2/1 for ASTER data were found to be very effective in the lithological differentiation of major rock units.