Geometry of the Nojima Fault at Nojima-Hirabayashi, Japan – II. Microstructures and their Implications for Permeability and Strength

Samples of damage-zone granodiorite and fault core from two drillholes into the active, strike-slip Nojima fault zone display microstructures and alteration features that explain their measured present-day strengths and permeabilities and provide insight on the evolution of these properties in the fault zone. The least deformed damage-zone rocks contain two sets of nearly perpendicular (60–90° angles), roughly vertical fractures that are concentrated in quartz-rich areas, with one set typically dominating over the other. With increasing intensity of deformation, which corresponds generally to increasing proximity to the core, zones of heavily fragmented rock, termed microbreccia zones, develop between prominent fractures of both sets. Granodiorite adjoining intersecting microbreccia zones in the active fault strands has been repeatedly fractured and locally brecciated, accompanied by the generation of millimeter-scale voids that are partly filled with secondary minerals. Minor shear bands overprint some of the heavily deformed areas, and small-scale shear zones form from the pairing of closely spaced shear bands. Strength and permeability measurements were made on core collected from the fault within a year after a major (Kobe) earthquake. Measured strengths of the samples decrease regularly with increasing fracturing and fragmentation, such that the gouge of the fault core and completely brecciated samples from the damage zone are the weakest. Permeability increases with increasing disruption, generally reaching a peak in heavily fractured but still more or less cohesive rock at the scale of the laboratory samples. Complete loss of cohesion, as in the gouge or the interiors of large microbreccia zones, is accompanied by a reduction of permeability by 1-2 orders of magnitude below the peak values. The core samples show abundant evidence of hydrothermal alteration and mineral precipitation. Permeability is thus expected to decrease and strength to increase somewhat in active fault strands between earthquakes, as mineral deposits progressively seal fractures and fill pore spaces.     

SHRIMP zircon and EPMA monazite dating of granitic rocks from the Maizuru terrane, southwest Japan: Correlation with East Asian Paleozoic terranes and geological implications

Abstract The Maizuru terrane, distributed in the Inner Zone of southwest Japan, is divided into three subzones (Northern, Central and Southern), each with distinct lithological associations. In clear contrast with the Southern zone consisting of the Yakuno ophiolite, the Northern zone is subdivided into the western and eastern bodies by a high-angle fault, recognized mainly by the presence of deformed granitic rocks and pelitic gneiss. This association suggests an affinity with a mature continental block; this is supported by the mode of occurrence, and petrological and isotopic data. Newly obtained sensitive high mass-resolution ion microprobe (SHRIMP) zircon U–Pb ages reveal the intrusion ages of 424 ± 16 and 405 ± 18 Ma (Siluro–Devonian) for the granites from the western body, and 249 ± 10 and 243 ± 19 Ma (Permo–Triassic) for the granodiorites from the eastern body. The granites in the western body also show inherited zircon ages of around 580 and 765 Ma. In addition, electron probe microanalysis (EPMA) monazite U–Th–total Pb dating gives around 475–460 Ma. The age of intrusion, inherited ages, mode of occurrence, and geological setting of the Siluro–Devonian granites of the Northern zone all show similarities with those of the Khanka Massif, southern Primoye, Russia, and the Hikami granitic rocks of the South Kitakami terrane, Northeast Japan. We propose that both the Siluro–Devonian and Permo–Triassic granitic rocks of the Northern zone are likely to have been juxtaposed through the Triassic–Late Jurassic dextral strike-slip movement, and to have originated from the Khanka Massif and the Hida terrane, respectively. This study strongly supports the importance of the strike-slip movement as a mechanism causing the structural rearrangement of the Paleozoic–Mesozoic terranes in the Japanese Islands, as well as in East Asia.     

Review on observational studies of western tropical Pacific Ocean circulation and climate

The Western Tropical Pacific(WTP) Ocean holds the largest area of warm water(28℃) in the world ocean referred to as the Western Pacific Warm Pool(WPWP),which modulates the regional and global climate through strong atmospheric convection and its variability.The WTP is unique in terms of its complex 3-D ocean circulation system and intensive multiscale variability,making it crucial in the water and energy cycle of the global ocean.Great advances have been made in understanding the complexity of the WTP ocean circulation and associated climate impact by the international scientific community since the 1960 s through field experiments.In this study,we review the evolving insight to the 3-D structure and multi-scale variability of the ocean circulation in the WTP and their climatic impacts based on in-situ ocean observations in the past decades,with emphasis on the achievements since 2000.The challenges and open que stions remaining are reviewed as well as future plan for international study of the WTP ocean circulation and climate.     

Sound velocity and elastic properties of Fe–Ni and Fe–Ni–C liquids at high pressure

The sound velocity (V _P) of liquid Fe–10 wt% Ni and Fe–10 wt% Ni–4 wt% C up to 6.6 GPa was studied using the ultrasonic pulse-echo method combined with synchrotron X-ray techniques. The obtained V _P of liquid Fe–Ni is insensitive to temperature, whereas that of liquid Fe–Ni–C tends to decrease with increasing temperature. The V _P values of both liquid Fe–Ni and Fe–Ni–C increase with pressure. Alloying with 10 wt% of Ni slightly reduces the V _P of liquid Fe, whereas alloying with C is likely to increase the V _P. However, a difference in V _P between liquid Fe–Ni and Fe–Ni–C becomes to be smaller at higher temperature. By fitting the measured V _P data with the Murnaghan equation of state, the adiabatic bulk modulus (K _S0) and its pressure derivative (K _S ^′ ) were obtained to be K _S0 = 103 GPa and K _S ^′  = 5.7 for liquid Fe–Ni and K _S0 = 110 GPa and K _S ^′  = 7.6 for liquid Fe–Ni–C. The calculated density of liquid Fe–Ni–C using the obtained elastic parameters was consistent with the density values measured directly using the X-ray computed tomography technique. In the relation between the density (ρ) and sound velocity (V _P) at 5 GPa (the lunar core condition), it was found that the effect of alloying Fe with Ni was that ρ increased mildly and V _P decreased, whereas the effect of C dissolution was to decrease ρ but increase V _P. In contrast, alloying with S significantly reduces both ρ and V _P. Therefore, the effects of light elements (C and S) and Ni on the ρ and V _P of liquid Fe are quite different under the lunar core conditions, providing a clue to constrain the light element in the lunar core by comparing with lunar seismic data.     

Preliminary study of light variations of the eclipsing binary AB Cassiopeiae

Preliminary study of the eclipsing binary AB Cas is presented here by using the photometric observational data. The primary component is one of the Sct variables with period of 0^d.054, and whether the oscillation is of a radial mode or of a non-radial one is discussed. Two colour indices (B-V andU-B) data and the light curve analysis suggest that this binary system is a typical Algol type binary system, in which the primary component is near the ZAMS with about 2.3M and the secondary one is a subgiant star with about 0.5M .     

CFC Indicating Renewal of the Japan Sea Deep Water in Winter 2000–2001

The distributions of CFC (chlorofluorocarbon) in the water column was determined twice in 2000 and 2001 in the northwestern Japan Sea. In 2000 the CFC-11 concentration decreased almost exponentially with depth from 6 pmol/kg at a few hundred m deep to 0.3 pmol/kg or less at the bottom of about 3400 m depth at three stations (40–41°N, 132–133°E) about 300 km off Vladivostok. In 2001 the CFC-11 concentration increased sharply up to 2 pmol/kg in the bottom water, while it did not increase at a station (42.0°N, 136.5°E) about 450 km away to the northeast. This is due to the renewal of the bottom water which is replaced by the surface water flowing down along the continental slope, as suggested by Tsunogai et al. (1999), who proposed the continental shelf pump. Furthermore, an increase in the CFC-11 concentration was observed throughout the entire water column above 3000 m depth, although the proportion of the increase was about 20%, which was one order of magnitude smaller than that in the bottom water. The increase in inventory is almost four times larger than that in the bottom water below 3000 m depth which is equivalent to about 1/6 of the total inventory found in 2000. The increase also means that 3% of the deep water was replaced by the recent surface water, or, if the turnover occurs every year, that the turnover time of the deep water to be about 30 years. This revised version was published online in July 2006 with corrections to the Cover Date.     

Highly alkaline,high-temperature hydrothermal fluids in the early Archean ocean

Based on the petrology of hydrothermally altered Archean basaltic greenstones, thermodynamic calculations of phase equilibria were conducted to estimate the composition of a high-temperature (∼350 °C) hydrothermal fluid in an Archean subseafloor basalt-hosted hydrothermal system. The results indicate that the hydrothermal fluid was highly alkaline attributed to the presence of calcite in the alteration minerals under a high-CO₂ condition, and predict a generation of SiO₂-rich, Fe-poor hydrothermal fluids in the Archean subseafloor hydrothermal system. The chemically reactive mixing zones between alkaline hydrothermal fluids and slightly acidic-neutral seawater are characterized by inverse pH and chemical polarity to modern hydrothermal systems, leading to extensive precipitation of silica and iron oxyhydroxides on/under the seafloor. Such processes can be responsible for the abiotic formation of voluminous chert and subseafloor silica dike, the mechanism of silicification, and the pH-controlled generation of banded iron formation that has been arising mainly from the redox chemistry in the Archean ocean. Such high-temperature alkaline fluids could have had a significant role not only in the early ocean geochemical processes but also in the early evolution of life.     

Possibility of a major earthquake in the tokai district, Japan and its pre-estimated seismotectonic effects

Crustal deformations, tsunamis and seismic intensity are pre-estimated for a large hypothetical earthquake, which it is feared may occur in the Tokai district along the Nankai trough. The long-term seismic quiescence since 1854, as well as the high rate of the present crustal movements in the district, form the principal evidence for the risk of the approaching catastrophe. The location and the mode of faulting in this earthquake are hypothesized in reference to the source mechanisms of the recent and historical earthquakes there. The fault parameters thus assumed are as follows: dip direction: N30°W; dip angle: 25°; fault dimension : 100 km × 70 km; dislocation: 4 m (reverse dip-slip: 3.8 m; right-lateral strike-slip: 1.3 m). The following are the principal conclusions: (a) the eastern part of the epicentral region including the Point Omaezaki will rise up about 100 cm, whereas the western part covering Ise and Mikawa bays will subside about 10–30 cm; (b) the coast extending from Omaezaki to the Shima peninsula will receive tsunami waves as high as 3 m in maximum, which may be locally amplified by the factor 2 or more on the rias coast along the Shima peninsula; (c) the Tokai coastal region with thick alluvium layers may suffer seismic damages as severe as those experienced in the 1854 Ansei I earthquake.     

Evaluation of the non-hydrostatic stress produced in a multi-anvil high pressure apparatus

Olivine single crystals have been deformed under high confining pressure (P=5?GPa) and temperature (T=1400?°C) conditions in a multi-anvil high pressure apparatus. NaCl, diamond and NaCl+diamond (2:1 by volume) powders were encapsulated along with the olivine single crystals in order to produce a range of stress states. The change of the non-hydrostatic stress transmitted to the olivine samples, enclosed within these three different media, during heating has been evaluated by observation of dislocation microstructure and density. A higher differential stress can be generated with diamond powder (0.1?GPa) than with NaCl powder (0.02?GPa). Although an intermediate differential stress between 0.1?GPa and 0.02?GPa had been expected to be generated using NaCl+diamond powder, the generation of non-hydrostatic stress in the olivine sample was unsuccessful. This may be caused by the fact that compaction (or sintering) proceeded in the capsule throughout the experiments. The most important finding of these experiments is that a constant non-hydrostatic stress can be applied to a sample under very high pressure and temperature conditions within the multi-anvil high pressure apparatus for the duration of the experiment. This approach is therefore suitable for investigating the steady-state rheological properties of mantle minerals at near-mantle conditions.     

Three‐dimensional microstructure of samples recovered from asteroid 25143 Itokawa: Comparison with LL5 and LL6 chondrite particles

In this study, the three‐dimensional (3‐D) microstructure of 48 Itokawa regolith particles was examined by synchrotron microtomography at SPring‐8 during the preliminary examination of Hayabusa samples. Moreover, the 3‐D microstructure of particles collected from two LL6 chondrites (Ensisheim and Kilabo meteorites) and an LL5 chondrite (Tuxtuac meteorite) was investigated by the same method for comparison. The modal abundances of minerals, especially olivine, bulk density, porosity, and grain size are similar in all samples, including voids and cracks. These results show that the Itokawa particles, which are surface materials from the S‐type asteroid Itokawa, are consistent with the LL chondrite materials in terms of not only elemental and isotopic composition of the minerals but also 3‐D microstructure. However, we could not determine whether the Itokawa particles are purely LL5, LL6, or a mixture of the two. No difference between the particles collected from Rooms A and B of the sample chamber, corresponding to the sampling sequence of the spacecraft's second and first touchdowns, respectively, was detected because of the statistically small amount of particles from Room B.