Aerosol mass loading over the marine environment of Arabian Sea during ICARB: Sea-salt and non-sea-salt components

Mass loading and chemical composition of atmospheric aerosols over the Arabian Sea during the pre-monsoon months of April and May have been studied as a part of the Integrated Campaign for Aerosols, gases and Radiation Budget (ICARB). These investigations show large spatial variabilities in total aerosol mass loading as well as that of individual chemical species. The mass loading is found to vary between 3.5 and 69.2 μg m^?3, with higher loadings near the eastern and northern parts of Arabian Sea, which decreases steadily to reach its minimum value in the mid Arabian Sea. The decrease in mass loading from the coast of India towards west is estimated to have a linear gradient of 1.53 μg m^?3/° longitude and an e^?1 scale distance of ～2300 km. SO ₄ ^2? , Cl^? and Na⁺ are found to be the major ionic species present. Apart from these, other dominating watersoluble components of aerosols are NO ₃ ^? (17%) and Ca²⁺ (6%). Over the marine environment of Arabian Sea, the non-sea-salt component dominates accounting to ～76% of the total aerosol mass. The spatial variations of the various ions are examined in the light of prevailing meteorological conditions and airmass back trajectories.     

A technical note on seismic microzonation in the central United States

Microzonation is an effort to evaluate and map potential hazards found in an area, urban area in particular, that could be induced by strong ground shaking during an earthquake. These hazards include: ground motion amplification, liquefaction, and slope failure. The microzonation maps, depicting ground-motion amplification, liquefaction, and landslide potentials, can be produced if the ground motion on bedrock (input) and the site conditions are known. These maps, in combination with ground-motion hazard maps (on bedrock), can be used to develop a variety of hazard mitigation strategies such as seismic risk assessment, emergency response and preparedness, and land-use planning. However, these maps have certain limitations that result from the nature of regional mapping, data limitations, generalization, and computer modeling. These microzonations show that when strong ground shaking occurs, damage is more likely to occur, or be more severe, in the higher hazard areas. The zones shown on the hazard maps should not serve as a substitute for site-specific evaluations.     

Preliminary results for a semi-automated quantification of site effects using geomorphometry and ASTER satellite data for Mozambique,Pakistan and Turkey

Estimation of the degree of local seismic wave amplification (site effects) requires precise information about the local site conditions. In many regions of the world, local geologic information is either sparse or is not readily available. Because of this, seismic hazard maps for countries such as Mozambique, Pakistan and Turkey are developed without consideration of site factors and, therefore, do not provide a complete assessment of future hazards. Where local geologic information is available, details on the traditional maps often lack the precision (better than 1:10,000 scale) or the level of information required for modern seismic microzonation requirements. We use high-resolution (1:50,000) satellite imagery and newly developed image analysis methods to begin addressing this problem. Our imagery, consisting of optical data and digital elevation models (DEMs), is recorded from the ASTER (Advanced Spaceborne Thermal Emission and Reflection Radiometer) sensor system. We apply a semi-automated, object-oriented, multi-resolution feature segmentation method to identify and extract local terrain features. Then we classify the terrain types into mountain, piedmont and basin units using geomorphometry (topographic slope) as our parameter. Next, on the basis of the site classification schemes from the Wills and Silva (1998) study and the Wills et al (2000) and Wills and Clahan (2006) maps of California, we assign the local terrain units with V _s 30 (the average seismic shear-wave velocity through the upper 30m of the subsurface) ranges for selected regions in Mozambique, Pakistan and Turkey. We find that the applicability of our site class assignments in each region is a good first-approximation for quantifying local site conditions and that additional work, such as the verification of the terrain’s compositional rigidity, is needed.     

Evaluation of coal bed methane potential of coal seams of Sawang Colliery,Jharkhand, India

The coal seams of Sawang Colliery, East Bokaro Coalfields are bituminous to sub-bituminous in nature and categorized as high gaseous seams (degree II to degree III level). These seams have the potential for coal bed methane (CBM) and their maturity increases with increasing depth, as a result of enhanced pressure-temperature conditions in the underground. The vitrinite maceral group composition of the investigated coal seams ranges from 62.50–83.15%, whereas the inertinite content varies from 14.93–36.81%. The liptinite content varies from 0.66% to 3.09%. The maximum micro-pores are confined within the vitrinite group of macerals. The coal seams exhibit vitrinite reflectance values (Ro% calculated) from 0.94% (sample CG-97) to 1.21% (sample CG-119). Proximate analyses of the investigated coal samples reveal that the moisture content (M%) ranges from 1.28% to 2.98%, whereas, volatile matter (VM%) content is placed in the range of 27.01% to 33.86%. The ash content (A%) ranges from 10.92% to 30.01%. Fixed carbon (FC%) content varies from 41.53% to 55.93%. Fuel ratio variation shows a restricted range from 1.53 to 1.97. All the coal samples were found to be strongly caking and forming coke buttons. The present study is based on the adsorption isotherm experiments carried out under controlled P-T conditions for determination of actual gas adsorption capacity of the coal seams. This analysis shows that the maximum methane gas adsorbed in the coal sample CG-81 is 17 m³/t (Std. daf), at maximum pressure of 5.92 MPa and experimental temperature of 30°C. The calculated Langmuir regression parameters P_L and V_L range from 2.49 to 3.75 MPa and 22.94 to 26.88 m³/t (Std. daf), respectively.     

Comments on ‘A comparative study of ANN and neuro-fuzzy for the prediction of dynamic constant of rockmass’

Singh et al (2005) examined the potential of the ANN and neuro-fuzzy systems application for the prediction of dynamic constant of rockmass. However, the model proposed by them has some drawbacks according to fuzzy logic principles. This discussion will focus on the main fuzzy logic principles which authors and potential readers should take into consideration.     

Proposed seismic hazard maps of Sumatra and Java islands and microzonation study of Jakarta city,Indonesia

This paper presents the development of spectral hazard maps for Sumatra and Java islands, Indonesia and microzonation study for Jakarta city. The purpose of this study is to propose a revision of the seismic hazard map in Indonesian Seismic Code SNI 03-1726-2002. Some improvements in seismic hazard analysis were implemented in the analysis by considering the recent seismic activities around Java and Sumatra. The seismic hazard analysis was carried out using 3-dimension (3-D) seismic source models (fault source model) using the latest research works regarding the tectonic setting of Sumatra and Java. Two hazard levels were analysed for representing 10% and 2% probability of exceedance (PE) in 50 years ground motions for Sumatra and Java. Peak ground acceleration contour maps for those two hazard levels and two additional macrozonation maps for 10% PE in 50 years were produced during this research. These two additional maps represent short period (0.2 s) and long-period (1.0 s) spectra values at the bedrock. Microzonation study is performed in order to obtain ground motion parameters such as acceleration, amplification factor and response spectra at the surface of Jakarta. The analyses were carried out using nonlinear approach. The results were used to develop contour of acceleration at the surface of Jakarta. Finally, the design response spectra for structural design purposes are proposed in this study.     

纺织品中偶氮染料还原液内芳香胺的电喷雾电离质谱分析

在优化的条件下,用电喷雾电离质谱(ESI-MS)检测了多种纺织品中由偶氮染料还原获得的芳香胺。当毛细管温度为100℃、鞘气流速为25单位、进样流速为10μL/min、电压为5kV时,信号的总离子流强度高且较稳定。实验分析了19种致癌芳香胺标准溶液的二级质谱,获得了相应物质的特征碎片离子;在此基础上,建立了基于ESI-MS对毛巾、棉布等样品中芳香胺进行快速定性分析的方法,具有灵敏度高、特异性好、检测速度快等优点。     

土壤中氟的形态分析

以宁夏盐池地区高氟土壤为例,采用连续提取法对土壤样品中各形态氟进行提取,离子色谱法测定各形态氟的含量。根据研究目的及土壤特点将氟的形态划分为水溶态、离子交换态、可还原态、可氧化态及残渣态5种形态;对各种形态连续提取过程中使用的提取液进行了选择。采用建立的方法获得提取土壤中F-的检出限为0.76μg/g;方法精密度(RSD,n=7)各形态氟为水溶态氟11.3%,离子交换态氟13.5%,可还原态氟10.7%,可氧化态氟8.9%。     

柴达木盆地北缘侏罗系不同沉积环境烃源岩生物标志物特征及其应用

柴达木盆地北缘地区侏罗系(中下侏罗统)的优质烃源岩主要发育于湖相与三角洲相环境。研究了不同时代、不同沉积环境中烃源岩的生物标志物组成特征,结果发现,有3类化合物的分布与组成差异显著,包括三环萜烷(C19、C20、C21)的分布型式、重排藿烷的丰度以及规则甾烷的相对组成。其中,不同时代的差异主要体现在规则甾烷组成上;而不同沉积环境的差异主要体现为三环萜烷(C19、C20、C21)的分布型式及重排藿烷的丰度。分析认为,这些差异与烃源岩的沉积环境及其生源组成有密切关系。据此,初步将这些参数应用于两方面研究,一是为划分地层沉积环境提供“生物标志物相标志”,二是研究油源对比,取得良好效果。因此,本文研究结果具有重要实用价值与参考意义。     

Using ALSM to map sinkholes in the urbanized covered karst of Pinellas County,Florida—1, methodological considerations

Comparison of a database of interpreted sinkholes made using airborne laser swath mapping (ALSM) with databases of sinkholes made from interpretation of aerial photographs reveals substantial disagreement. The discrepancies involve the location, number, areas, and circularity of interpreted sinkholes. Methodological factors that contribute to the discrepancies include blockage of ALSM laser returns in thick vegetation, multi-path reflections, and misrepresentation of the true extent of sinkholes. Comparison of two ALSM-derived databases made (1) independently from versus (2) in combination with earlier air photo analysis in undeveloped regions had the following result: one-fourth of the sinkholes interpreted by using the composite method were missed by the independent analysis, and one-third of the sinkholes that were interpreted from the independent analysis were not interpreted as sinkholes using the composite method. Subjective interpretation leads to a high level of uncertainty such that the results of the remote sensing studies are suspect, if not invalid.