Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

Exploiting the dual functions of polymer depressants in fine particle flotation

Fine hydrophilic particles are known to be entrained with water in flotation of many ores. Flocculation of the hydrophilic particles by polymer depressants could potentially reduce the mechanical entrainment of these particles. This paper reports testwork completed on fine particles of several solids, iron oxide, hydroxyapatite and sphalerite, as well as on a relatively coarse quartz sample (− 75 + 38 μm). Dodecylamine was used as a collector for quartz, and several dispersants and polymer depressants, including sodium silicate, sodium metaphosphate, zinc sulfate, cornstarch, corn dextrin and carboxymethyl celluloses (with molecular weights of both 700,000 and 80,000) were used as flotation modifiers. The major part of the testwork involved flotation tests in a 200 mL flotation column. It was observed that flocculation of the fine hydrophilic particles significantly reduced their mechanical entrainment, while dispersion severely aggravated it. Thus, in the flotation separation of synthetic mixtures of the − 75 + 38 μm quartz and fine (reagent grade) iron oxide or hydroxyapatite, polymer depressants that caused flocculation performed better than those that did not cause flocculation.     

贵州南部“半边街式”铅锌矿床地质特征及其成因探讨

贵州省南部地区是全国重要的汞、锑资源分布区。2000年由于产于上泥盆统中铅锌矿的陆续发现,贵州省地矿局启动了以铅锌资源评价和成矿规律研究为主的地质工作,目标是总结铅锌矿产出的地质特征和成矿规律。通过三年的研究认为,该区处扬子准地台、华南褶皱带和右江造山带交汇部位,受晚古生代初期发生的陆内裂谷活动影响,产生了一个与桂中台陷相连的大型沉积凹陷区—黔南台陷沉积区,形成了巨厚碳酸盐和碎屑岩沉积,产生了与裂陷盆地边缘同沉积断层活动有关的低温成矿作用,造成了在晚泥盆纪以前的地层中汞、锑、砷、金、铅锌等矿床沿同沉积断层密集分布。本文通过矿床特征总结和矿床成因探讨,建立了准同生沉积成矿作用模式,旨在为该区寻找这类矿床提供参考和借鉴作用。     

位场自动反演技术的研究现状及意义

本文首先叙述了重、磁异常自动反演技术的特点。与传统的定性分析重、磁场分布特征的方法不同,重、磁异常自动反演方法通过反演得到地下场源分布,即地下密度或磁性的分布特征。由于密度体或磁性体与地质体的关系更为直接,因此这种新一代重、磁解释成果及图件将成为人们从新的角度来认识地质构造的基础材料。文中不但阐述了该方法的研究现状,同时也说明了存在的问题。     

燕山褶断带中生代盆地变形-板内变形过程的记录--以下板城、承德-上板城、北台盆地为例

本文通过对燕山褶断带下板城和承德地区中生代三个世代的盆地沉积记录和变形分析,阐述了中生代燕山板内造山的发展过程。这三个中生代盆地从老至新分别是三叠纪至中侏罗世时期的下板城盆地,中侏罗世晚期至晚侏罗世的承德—上板城盆地,早白垩世的北台盆地。三个盆地发育的沉积充填序列构成了区域中生代时期的三套构造层。下板城盆地为一倒转向斜,盆地沉积充填序列为河流—冲积相沉积;承德—上板城盆地为一不对称向斜,盆地沉积充填序列为火山—冲积相沉积;北台盆地为宽缓的向斜,盆地沉积充填序列为火山沉积序列。三个世代盆地之间的变形是不协调的,应分别属于原地复杂变形的不同构造层,较新的盆地呈明显的角度不整合覆盖在经历了强烈褶皱变形的较老地层之上。划分三套构造层之间的两个区域性角度不整合的时代分别为160MA前和135MA前,相当于燕山运动A幕和B幕。     

长白山北坡垂直植被带表土植硅体组合研究

长白山垂直分布的植被是欧亚大陆从温带到寒带植被水平地带性的缩影。对其北坡不同海拔高度植被带土壤中的植硅体进行初次研究,结果发现,该山北坡海拔700m到2630m的土壤中发育了形态和数量丰富的植硅体。不同植被带植硅体组合的含量各不相同,主要特征表现为随海拔升高示冷型的植硅体含量整体呈上升趋势,而示暖型的植硅体含量整体呈下降趋势。温泉附近土壤中的植硅体则表现出明显的与其上下相邻地点不同的特点。它对中国东北第四纪沉积物中植硅体组合的研究及第四纪古植被和古环境的重建可提供重要的基础性资料。     

塔里木盆地早二叠世岩浆特征及其对油气成藏关系初探

塔里木盆地早二叠世裂谷盆地阶段有一次强烈的岩浆活动,主要为玄武岩—中酸性凝灰岩喷发和大规模基性岩墙群的侵入,玄武岩K-Ar法同位素年龄为241~278Ma,而辉长岩的Sm-Nd法年龄为259Ma。火山活动产生的能量使得塔里木盆地内的寒武系—奥陶系烃源岩大量生烃并运移,自生伊利石K-Ar年龄测定数据显示哈得4石炭系油藏、塔中4CⅢ油藏油气充注时间为224~275Ma,与上述火成岩的活动时间相当。东河砂岩,一套深埋的优质储层,其形成的原因可能是二叠纪末油气的注入并导致其后期深埋时只有机械压实而无其他成岩作用的缘故。     

重庆金佛山表层岩溶生态系统土壤的CO2释放规律

采用碱溶液吸收法通过对重庆金佛山林地、裸地表层岩溶生态系统土壤CO2释放量进行野外监测,研究了影响土壤CO2释放量变化的主要因素,揭示土壤CO2释放变化规律。土壤CO2释放量的变化主要随着温度而变化,即气温降低,土壤CO2释放量减少,在昼夜时段,土壤CO2也随温度而变化,但相比温度变化有明显滞后性;降雨对土壤CO2释放有比较复杂的影响,但非简单的线性相关;同时植被也会影响到土壤CO2的释放,总体上,相比裸地而言,林地的土壤CO2的释放量大,但在不同时间段内土壤CO2释放强度与气温的关系有较大差异。一天时间段内林地土壤CO2释放强度与温度的关系较裸地灵敏,这是因为林地本身生物量大,对温度反应敏感,温度很小的变化就能引发土壤CO2释放量的大幅度地改变。而在以月为单位观测时间段时,裸地土壤CO2释放强度与气温的关系较林地灵敏,这可能是因为植被覆盖减缓气温对土温的影响,对土温有较强的调节作用。这种不同植被系统下,在不同时段土壤的CO2释放量动态差异在讨论岩溶作用与碳循环时应充分注意。     

包气带粘性土层的防污性能试验研究及其对地下水脆弱性评价的影响

大量文献资料分析表明,平原地区地下水脆弱性主控因素为地下水位埋深、包气带土层及其特征,而包气带粘性土层的截污性能及其厚度则又是脆弱性主要的影响因子。试验研究结果显示,粘性土的截污容量大小可以通过模拟淋滤实验测试得出,有效阻隔足额厚度也可计算得出。根据不同粘性土层的截污容量、有效阻隔厚度等,可以评判土层的污染防护能力,并可据此评价平原区地下水的脆弱性。     

CQK-50型车载化钻机的研制

在分析研究小型地质车载钻机的形式、功能与特点的基础上，提出了钻机车载化的新思路。根据地质调查工作现状，结合国内现有小型地质取样钻机，研制了CQK-50型全液压多功能车载取样钻机，并在野外物化探遥感异常验证钻探中取得了良好效果。