Response of riparian vegetation to water-table changes in the lower reaches of Tarim River, Xinjiang Uygur, China

The lower reaches of Tarim River in the Xinjiang Uygur region of western China had been dried out for more than 30 years before water began to be diverted from Konqi (Peacock) River via a 927-km-long channel in year 2000, aimed at improving the riparian ecological systems. Since then, eight intermittent water deliveries have been carried out. To evaluate the response of riparian vegetation to these operations, the groundwater regime and vegetation changes have been monitored along the 350-km-long stem of the river using a network of 40 dug wells at nine transects across the river and 30 vegetation plots at key sites. Results show that the water table rose remarkably, i.e. from a depth of 9.87 m before the water delivery to 3.16 m after the third water delivery. The lateral distance of affected water table extended to 1,050 m from the riverbank after the fourth water delivery. The riparian vegetation has changed in composition, type, distribution, and growing behavior. This shows that the water deliveries have had significant effects on restoration of riparian ecosystems.     

微生物对碳酸盐岩的风化作用

微生物-矿物相互作用可以促进许多表生生物地球化学反应过程,是表生地球化学研究的重要内容。通过综合岩石表面的微生物类群及其地质作用,分析碳酸盐岩微生物风化的各种现象,特别是微观尺度上的各种形态,阐述碳酸盐岩的微生物风化机制与风化产物,笔者提出微生物对碳酸盐岩风化的4种途径:(1)通过微生物在岩石表面和缝隙中生长,导致岩石表层发生生物溶蚀、生物磨蚀和生物钻孔作用,加速岩石风化进程;(2)微生物群体形成的钻孔网络可以增强岩石化学溶蚀的有效表面积并导致其表面强度减弱而促进机械侵蚀作用,微生物对周围岩石颗粒胶结结构的破坏、疏松作用也会导致岩石矿物颗粒的分解;(3)微生物的持水作用,微生物分泌的有机酸以及微生物呼吸所释放的CO2对岩表水分的酸化过程亦加速岩石矿物的分解;(4)微生物生长过程中从岩石内摄取营养元素和产生复杂的有机配体,能促进矿物元素的释放。文中提出在开展微生物对碳酸盐岩风化过程和机理研究的基础上,有必要引入微生物生物技术来综合开发本地低品位含钾磷矿产资源,加速岩溶地区山地土壤的形成与演化。     

内蒙古桌子山煤田火区特征及灭火方法探讨

内蒙古自治区桌子山煤田赋存着较为稀缺的煤种一焦煤,煤田内存在的火区不仪烧掉了宝贵的焦性煤炭资源,给煤矿生产带来严重的事故隐患,对当地生态环境也造成极大的破坏。经查明区内有26处子火区,分布面积约760万m^2,通过煤田地质特征、煤质特征、地表指示特征、同位素氡气的浓度相对分布特征、物性特征分析了区内煤层发火原因,根据桌子山煤田火区特点,建议采用浅剥、深灌与覆盖相结合的灭火方法,并对火区进行动态监测。     

南海北部陆缘新生代玄武岩地球化学特征及成因

南海盆地及周缘地区新生代玄武岩对揭示南海盆地的演化历史至关重要，然而这些玄武岩的成因还存在争议。本文研究了位于南海北部陆缘的海南岛临高县多文组玄武岩岩石地球化学和矿物地球化学特征，并探讨其成因和构造背景。多文组玄武岩主要由橄榄石、单斜辉石、斜长石、斜方辉石、铬尖晶石和铁钛氧化物等组成。橄榄石Fo值变化于55. 5~71. 1之间，Ni的含量较低， Fe/Mn比值较高。铬尖晶石Cr#值为74. 1~82. 7，Mg#值为45. 5~63. 8， Ti的含量较高。斜方辉石Mg#值为63. 9~79. 6，单斜辉石为66. 0~80. 6。单斜辉石稀土配分曲线富集MREE，亏损LREE和HREE，呈拱形分布。斜长石以中- 拉长石为主(Ab36. 56~52. 78), 富集LREE、Ba、Sr和Eu。铁钛氧化物的TiO2含量为50. 19%~51. 46%。多文组玄武岩原始岩浆的主量和微量元素组成与夏威夷、峨眉山、塔里木等玄武岩组成一致，地幔源区包含了辉石岩的成分，而且其地幔潜在温度(＞1400℃)和氧逸度(ΔNNO)要高于大洋中脊玄武岩(N- MORB)，表明多文组玄武岩的形成与海南地幔柱活动有关。由于海南地幔柱形成时代明显晚于南海盆地的扩张时代，认为南海地幔柱是南海盆地伸展的被动响应。     

近海核电厂核素地下水释放通量的模型计算方法

为了定量计算陵区近海核电站排水管线泄漏情景下核素通过地下水途径向海洋环境的释放通量，以某近海核电站为例进行研究。首先，应用GOCAD软件建立三维地形地质模型，刻画地层的分布、剥蚀以及倾向等特点；然后，运用地下水数值模拟软件FEFLOW精细刻画丘陵区地下水系统的补给、径流和排泄特征；最后，以不被吸附滞留的核素³H和被吸附滞留的核素⁹⁰Sr、¹³⁷Cs为对象，通过实验测定了⁹⁰Sr、¹³⁷Cs在不同岩土介质中的分配系数，模拟计算了排水管线连续渗漏60 a后³H、⁹⁰Sr、¹³⁷Cs在地下水中的放射性分布及释放。结果表明：³H迁移速度基本与地下水流速一致，地下水中的最大放射性浓度为0.285 0 Bq/L，第20 000天时向收纳水域的释放通量达到最大值，约526 Bq/d；⁹⁰Sr吸附性能相对较弱，最大迁移距离约80 m，地下水中的最大放射性浓度为0.032 1 Bq/L；¹³⁷Cs吸附能力较强，相当长的时间内被滞留在管线附近，地下水中最大放射性浓度分别为6.840×10^-3 Bq/L，释放通量为0 Bq/d。由弥散度的不确定分析可知，弥散度越大，地下水中³H的最大放射性浓度越小，向海洋环境的释放通量越多。     

随钻测录井地质导向二维分解实时绘图方法

根据随钻测录井实时地质导向和大斜度、水平井评价成图技术需求，针对传统绘图方法存在的弊端，提出了将测录井信息、井眼轨迹和地质模型进行二维分解的实时绘图方法。针对二维分解绘图方法绘图时空复杂度较高的问题，给出了不同事件驱动下的局部实时计算和拷屏重绘算法，控制了对CPU和内存的消耗、提高了绘图效率，消除了实时绘图的闪烁和卡顿现象。应用实例表明，二维分解实时绘图方法能够实现大尺度随钻测录井地质导向图形的流畅、无卡顿实时绘图，可提高大斜度、水平井储层模型评价的刻画精度和时效。     

多硅白云母b0值对澜沧群中压和高压变质的反映

多硅白云母b₀值作为相对地质压力计的理论和方法,已受到各国地质学家的普遍重视。本文以澜沧群多硅白云母作为研究对象,提出运用多硅白云母b₀值区分不同压力变质的方法。研究结果表明澜沧群经历了中压和高压变质作用,两期变质的多硅白云母b₀值分别为9.027Å和9.047Å。     

Flux determination over a smooth surface under strongly unstable conditions

Careful micrometeorological measurements on an empty parking lot allowed determination of the surface fluxes of sensible heatH and of momentum by applying profile equations derived from Monin-Obukhov similarity theory with two sets of the stability correction function for momentum _m and sensible heat _h . These fluxes were compared with reference values ofH independently determined by means of an eddy correlation technique. In general, better agreement was found betweenH values derived from profiles with the stability functions of Brutsaert (1992) and referenceH values, than when the Businger-Dyer functions were used to deriveH. The disagreement in the latter comparison was especially serious under strongly unstable conditions, with the value ofy=–z/L (wherez is the height andL is the Obukhov length) larger than 10. A closer look at the procedure for calculatingH from the profiles revealed that the large differences between theH values derived with these two different versions of the stability correction functions were caused by the small differences of the _h values, and not by the larger differences of the _m values. This result stems from the strong sensitivity of the resultingH values on the choice of _h .