Simple determination of dimethylsulfide (DMS) and dimethylsulfoniopropionate (DMSP) using solid-phase microextraction and gas chromatography-mass spectrometry

Solid-phase microextraction (SPME) is a simple, sensitive and less destructive method for the determination of dimethylsulfide (DMS) in seawater. Combined with detection by gas chromatography-mass spectrometry (GC-MS), the method had sufficient sensitivity (minimum detectable concentration of DMS was 0.05 nM), and practical levels of reproducibility (relative standard deviation ≤7%) and linearity (r ² > 0.995) over a wide concentration range (0.5 to 910 nM). The protocol developed was applied to a Sagami Bay water sample to determine concentrations of DMS and DMSP, and in situ DMSP-lyase activity.     

Eddy Shedding from the Kuroshio Bend at Luzon Strait

TOPEX/POSEDIENT-ERS satellite altimeter data along with the mean state from the Parallel Ocean Climate Model result have been used to investigate the variation of Kuroshio intrusion and eddy shedding at Luzon Strait during 1992–2001. The Kuroshio penetrates into the South China Sea and forms a bend. The Kuroshio bend varies with time, periodically shedding anticyclonic eddies. Criteria of eddy shedding are identified: 1) When the shedding event occurs, there are usually two centers of high Sea Surface Height (SSH) together with negative geostrophic vorticity in the Kuroshio Bend (KB) area. 2) Between the two centers of high SSH there usually exists positive geostrophic vorticity. These criteria have been used to determine the eddy shedding times and locations. The most frequent eddy shedding intervals are 70, 80 and 90 days. In both the winter and summer monsoon period, the most frequent locations are 119.5°E and 120°E, which means that the seasonal variation of eddy shedding location is unclear.     

A novel time-series station in the Wadden Sea (NW Germany): First results on continuous nutrient and methane measurements

In autumn 2002 a time-series station was installed in the tidal inlet between the Islands of Langeoog and Spiekeroog (Southern North Sea, NW Germany) to continuously measure physical, chemical, and meteorological parameters, even during extreme weather conditions (gale-force storms, drifting ice). Inside the pole of the station sensor tubes are installed in direction of the prevailing tidal currents. The tubes are equipped with hydrographic sensors (pressure, temperature, conductivity) and allow retrieval of water for nutrient analysis by automated instruments located inside the pole. Dissolved methane and the nutrients ammonia, nitrite, nitrate, phosphate, and silicate are measured at the station.     

Geodynamics of the deep sedimentary basin of the Caspian Sea region: paragenetic correlation of seismicity and mud volcanism

In this paper we analyze seismic regime and earthquake depth distribution and correlation of seismicity and mud volcanism in the Azerbaijan and the Caspian Sea region. For the present region we have calculated accurate source locations, seismic activity, earthquake repetition and released earthquake energy parameters. It is shown that the active tectonic processes in the region are concentrated within the thick sedimentary cover that we consider as a general source of contemporary stress and a main structural element responsible for the origin of regional earthquakes. The correlation of seismicity and mud volcanism is of paragenetic character.     

A new extended Gibbs thermodynamic potential of seawater

A new and extended Gibbs thermodynamic potential function of seawater is proposed to overcome generally known weaknesses of the International Equation of State of Seawater 1980 and its associated formulas (EOS80). It is valid for applied pressures up to 100 MPa (10,000 dbar), temperatures from −2-40°C, and practical salinities up to 42. At ambient pressure, it is applicable in heat capacity and density up to salinity 50. It includes the triple point of water for reference and is, over its range of validity, fully consistent with the current 1995 international scientific pure water standard, IAPWS95. In conjunction with an improved Gibbs potential of ice, it provides freezing temperatures of seawater for pressures up to 50 MPa (5000 dbar). It is compiled from an extensive set of experimental seawater data, rather than being derived from EOS80 equations. Older seawater data were specifically recalibrated for compatibility with the recent pure water standard. By this procedure, experimental high-pressure densities proved consistent with sound speeds confirmed by deep-sea travel time measurements. Temperatures of maximum density are described within their experimental uncertainty. For very low salinities, Debye-Hückel limiting laws are recompiled using latest physical and chemical constants. The potential function is expressed in the 1990 International Temperature Scale ITS-90.     

The Glarus thrust: excursion guide and report of a field trip of the Swiss Tectonic Studies Group (Swiss Geological Society, 14.–16. 09. 2006)

This excursion guide results form a field trip to the Glarus nappe complex organized by the Swiss Tectonic Studies Group in 2006. The aim of the excursion was to discuss old and recent concepts related to the evolution of the Glarus thrust. The major aspects were (i) the interplay between deformation, fluid flow and geochemical alteration, (ii) episodic versus continuous deformation and fluid flow, and (iii) the link between large-scale structures, microstructures, and geochemical aspects. Despite 150 years of research in the Glarus nappe complex and the new results discussed during the excursion, there exist controversies that still are unsolved.     

Oil-generation kinetics for organic facies with Type-II and -IIS kerogen in the Menilite Shales of the Polish Carpathians

The Menilite Shales (Oligocene) of the Polish Carpathians are the source of low-sulfur oils in the thrust belt and some high-sulfur oils in the Carpathian Foredeep. These oil occurrences indicate that the high-sulfur oils in the Foredeep were generated and expelled before major thrusting and the low-sulfur oils in the thrust belt were generated and expelled during or after major thrusting. Two distinct organic facies have been observed in the Menilite Shales. One organic facies has a high clastic sediment input and contains Type-II kerogen. The other organic facies has a lower clastic sediment input and contains Type-IIS kerogen. Representative samples of both organic facies were used to determine kinetic parameters for immiscible oil generation by isothermal hydrous pyrolysis and S₂ generation by non-isothermal open-system pyrolysis. The derived kinetic parameters showed that timing of S₂ generation was not as different between the Type-IIS and -II kerogen based on open-system pyrolysis as compared with immiscible oil generation based on hydrous pyrolysis. Applying these kinetic parameters to a burial history in the Skole unit showed that some expelled oil would have been generated from the organic facies with Type-IIS kerogen before major thrusting with the hydrous-pyrolysis kinetic parameters but not with the open-system pyrolysis kinetic parameters. The inability of open-system pyrolysis to determine earlier petroleum generation from Type-IIS kerogen is attributed to the large polar-rich bitumen component in S₂ generation, rapid loss of sulfur free-radical initiators in the open system, and diminished radical selectivity and rate constant differences at higher temperatures. Hydrous-pyrolysis kinetic parameters are determined in the presence of water at lower temperatures in a closed system, which allows differentiation of bitumen and oil generation, interaction of free-radical initiators, greater radical selectivity, and more distinguishable rate constants as would occur during natural maturation. Kinetic parameters derived from hydrous pyrolysis show good correlations with one another (compensation effect) and kerogen organic-sulfur contents. These correlations allow for indirect determination of hydrous-pyrolysis kinetic parameters on the basis of the organic-sulfur mole fraction of an immature Type-II or -IIS kerogen.     

T -distributed Random Fields: A Parametric Model for Heavy-tailedWell-log Data1

Histograms of observations from spatial phenomena are often found to be more heavy-tailed than Gaussian distributions, which makes the Gaussian random field model unsuited. A T-distributed random field model with heavy-tailed marginal probability density functions is defined. The model is a generalization of the familiar Student-T distribution, and it may be given a Bayesian interpretation. The increased variability appears cross-realizations, contrary to in-realizations, since all realizations are Gaussian-like with varying variance between realizations. The T-distributed random field model is analytically tractable and the conditional model is developed, which provides algorithms for conditional simulation and prediction, so-called T-kriging. The model compares favourably with most previously defined random field models. The Gaussian random field model appears as a special, limiting case of the T-distributed random field model. The model is particularly useful whenever multiple, sparsely sampled realizations of the random field are available, and is clearly favourable to the Gaussian model in this case. The properties of the T-distributed random field model is demonstrated on well log observations from the Gullfaks field in the North Sea. The predictions correspond to traditional kriging predictions, while the associated prediction variances are more representative, as they are layer specific and include uncertainty caused by using variance estimates.     

Superdense CO2 inclusions in Cretaceous quartz–stibnite veins hosted in low-grade Variscan basement of the Western Carpathians, Slovakia

CO₂ inclusions with density up to 1,197 kg m⁻³ occur in quartz–stibnite veins hosted in the low-grade Palaeozoic basement of the Gemericum tectonic unit in the Western Carpathians. Raman microanalysis corroborated CO₂ as dominant gas species accompanied by small amounts of nitrogen (<7.3 mol%) and methane (<2.5 mol%). The superdense CO₂ phase exsolved from an aqueous bulk fluid at temperatures of 183–237°C and pressures between 1.6 and 3.5 kbar, possibly up to 4.5 kbar. Low thermal gradients (∼12–13°C km⁻¹) and the CO₂–CH₄–N₂ fluid composition rule out a genetic link with the subjacent Permian granites and indicate an external, either metamorphogenic (oxidation of siderite, dedolomitization) or lower crustal/mantle, source of the ore-forming fluids.According to microprobe U–Pb–Th dating of monazite, the stibnite-bearing veins formed during early Cretaceous thrusting of the Gemeric basement over the adjacent Veporic unit. The 15- to 18-km depth of burial estimated from the fluid inclusion trapping PT parameters indicates a 8- to 11-km-thick Upper Palaeozoic–Jurassic accretionary complex overlying the Gemeric basement and its Permo-Triassic autochthonous cover.