Eddy correlation measurements of CO2, latent heat,and sensible heat fluxes over a crop surface

Eddy correlation equipment was used to measure mass and energy fluxes over a soybean crop. A rapid response CO₂ sensor, a drag anemometer, a Lyman-alpha hygrometer and a fine wire thermocouple were used to sense the fluctuating quantities.Diurnal fluxes of sensible heat, latent heat and CO₂ were calculated from these data. Energy budget closure was obtained by summing the sensible and latent heat fluxes determined by eddy correlation which balanced the sum of net radiation and soil heat flux. Peak daytime CO₂ fluxes were near 1.0 mg m^–2 (ground area) s^–1.The eddy correlation technique was also employed in this study to measure nocturnal CO₂ fluxes caused by respiration from plants, soil, and roots. These CO₂ fluxes ranged from - 0.1 to - 0.25 mg m^–2s^–1.From the data collected over mature soybeans, a relationship between CO₂ flux and photosynthetically active radiation (PAR) was developed. The crop did not appear to be light-saturated at PAR flux densities < 1800 Ei m^–2 s^–1. The light compensation point was found to be about 160 Ei m^–2 s^–1.Published as Paper No. 7402, Journal Series, Nebraska Agricultural Experiment Station. The work reported here was conducted under Nebraska Agricultural Experiment Station Project 27-003 and Regional Research Project 11–33.Post-doctoral Research Associate, Professor and Professor, respectively. Center for Agricultural Meteorology and Climatology, Institute of Agriculture and Natural Resources, University of Nebraska, Lincoln, NE 68583-0728.     

Metamorphic incongruent solution,diffusion and pressure solution stripes

The formation of pressure solution stripes is discussed on the basis of previosly published observations and of local chemical equilibria between solution and solid phases. Chemically driven mineral reactions can be localized at early sites of nucleation and be enhanced by stresses to create patterns of cleavage stripes. These reactions cause transport of material over distances greater than single grains. They provide suitable sites and suitable chemistry for later incongruent pressure solution, potentially a much faster process than congruent pressure solution discussed in previous literature. Neither reaction nor straightforward incongruent pressure solution explains the solution of quartz, commonly observed at cleavage stripes. Quartz pressure solution is explicable on certain assumptions about diffusivities and the effects of stresses. This involves interaction between quartz and the established incongruent solution of other minerals, an overall process termed ‘interdependent pressure solution’. Electrical potential differences will be greatest during early mineral reactions, a feature which may provide a means to corroborate the chemical role in initiating ‘pressure solution stripes’.     

A strontium isotope and trace element profile through the Partridge River Troctolite,Duluth complex,Minnesota

Initial ⁸⁷Sr/⁸⁶Sr ratios down a 2,315 foot-long core (DDH-295) through the Partridge River Troctolite are lower in the depth range 710–1,410 feet (0.70443±22) than in the underlying and overlying rocks (0.70500±18). These initial ratio variations define three zones (I, II, and III) thought to be three intrusive units within the troctolite. The best estimate of the Rb-Sr age of the troctolite is 1,050±105 m.y. The olivine compositions and the abundances of the incompatible trace elements Zr, Y, and Rb show identical variations down the core, with downward repetitions of olivine iron-enrichment and incompatible trace element enrichments. Discontinuities in the olivine compositions and incompatible trace element abundances match the initial ⁸⁷Sr/⁸⁶Sr ratio discontinuities in the core. The strontium isotope data imply that involatile components of the Proterozoic Virginia Formation and other Archaean rocks were not significantly assimilated by the troctolites, for only three out of the twenty-three initial ⁸⁷Sr/⁸⁶Sr ratios depart from normal magmatic values. These three anomalous ratios are not systematically related to the Cu-Ni sulphide mineralization and may be the result of secondary calcite in the troctolite. The strontium isotope systematics of the Virginia Formation xenoliths and underlying hornfelses are highly disturbed as a result of Rb loss. The apparently inverted fractionation sequences in the troctolites are interpreted in terms of downward increases in intercumulus liquid in repeated magma batches and controlled by plagioclase flotation. The amount of intercumulus liquid is estimated to range from 7 to 61 weight per cent. The Cu-Ni sulphides are concentrated in the lower 250 feet of zone I (immediately above the Virginia Formation) and through 400 feet of core across the contact between zones I and II, more than 750 feet above the base. Because the sulphide-bearing troctolites are not systematically related to disturbances in the magmatic initial ⁸⁷Sr/⁸⁶Sr ratios, the mineralization probably involved the volatile transfer of sulphur derived from dehydration reactions in the underlying Virginia Formation.     

Climate change drives coherent trends in physics and oxygen content in North American lakes

Using a 25-year record of monitoring data, we show that recent climate change has affected the thermal properties and oxygen content of seven lakes in south-central Ontario, Canada, and five lakes in north-central Wisconsin, USA. Coherent patterns in autumnal lake warming were driven by increased autumn air temperature in both lake districts. Temperature increases were restricted to the epilimnion and metalimnion of the lakes, resulting in increased thermal stability of the water column. Mixing depths also decreased over the study period. Shallower mixing depths in the Ontario lakes were due to climate-driven increases in lake-water dissolved organic carbon concentrations. Collectively, changes in the thermal regime of the lakes suggest autumn mixing of the water column may be delayed. Metalimnetic oxygen also increased in the Wisconsin lakes, perhaps in response to increased algal production as lake thermal regimes changed. The response of individual lakes to climate change was modified by lake chemistry in the Ontario lake district and by lake chemistry and morphometry in the Wisconsin lake district. Our results demonstrate coherent lake response to climate change and highlight the importance of both regional and local factors in regulating individual lake response to global climate change.     

The Canadian Fourth Generation Atmospheric Global Climate Model (CanAM4). Part I: Representation of Physical Processes

The Canadian Centre for Climate Modelling and Analysis (CCCma) has developed the fourth generation of the Canadian Atmospheric Global Climate Model (CanAM4). The new model includes substantially modified physical parameterizations compared to its predecessor. In particular, the treatment of clouds, cloud radiative effects, and precipitation has been modified. Aerosol direct and indirect effects are calculated based on a bulk aerosol scheme. Simulation results for present-day global climate are analyzed, with a focus on cloud radiative effects and precipitation. Good overall agreement is found between climatological mean short- and longwave cloud radiative effects and observations from the Clouds and Earth's Radiant Energy System (CERES) experiment. An analysis of the responses of cloud radiative effects to variations in climate will be presented in a companion paper.

[Traduit par la rédaction] Le Centre canadien de la modélisation et de l'analyse climatique (CCmaC) a mis au point la quatrième génération du modèle canadien de circulation générale de l'atmosphère (CanAM4). Le nouveau modèle comprend des paramétrisations physiques passablement modifiées comparativement à son prédécesseur. En particulier, le traitement des nuages, des effets radiatifs des nuages et des précipitations a été modifié. Les effets directs et indirects des aérosols sont calculés à l'aide d'un schéma d'aérosols en bloc. Nous analysons des résultats de simulation pour le climat général du jour présent en mettant l'accent sur les effets radiatifs des nuages et les précipitations. Nous trouvons un bon accord général entre la moyenne climatologique des effets radiatifs des nuages pour les courtes et les grandes longueurs d'onde et les observations de l'expérience CERES (Clouds and Earth's Radiant Energy System). Une analyse de la réponse des effets radiatifs des nuages aux variations du climat sera présentée dans un article connexe.     

Water contents of Roberts Victor xenolithic eclogites: primary and metasomatic controls

A suite of eclogites from the Roberts Victor kimberlite has been extensively characterized in terms of petrology and geochemical compositions (Gréau et al. in Geochim Cosmochim Acta 75(22):6927–6954, 2011; Huang et al. in Lithos 142–143:161–181, 2012a). In the present study, the water contents of eclogitic garnet and omphacite were analyzed by Fourier transform infrared spectrometry. Garnet does not contain measureable OH in any sample. The water content of omphacite in the studied eclogites ranges from 211 to 1,496 ppm. Mantle metasomatism has modified the water content of some of the eclogites, while others retain water contents characteristic of their original environment. The OH contents of the metasomatized eclogites may be mainly controlled by the H₂O fugacity and mineral compositions. The OH contents of the non-metasomatized samples are interpreted to be more sensitive to their mantle equilibration temperature, pressure, and the local fugacities of H₂O and O₂. The calculated water content of the metasomatic medium is similar to that of carbonatitic–kimberlitic melts/fluids. Eclogites contain more water than peridotites recorded in the literature (341 ± 161 vs 122 ± 54 ppm) and represent an important water reservoir in the lithospheric mantle wherever they occur. This is an important parameter to be considered in the interpretation of mantle processes and geophysical data such as seismic wave speeds and electrical conductivity, and in geodynamic modeling.     

A three-dimensional analytical tool for modeling reactive transport

In this note, we present a public domain analytical reactive transport modeling tool (ART3D, version 2.0). The tool is developed in FORTRAN and can be used for solving a system of a set of partial differential equations coupled with a first-order reaction network. ART3D uses a novel analytic solution technique proposed by Clement. The new software includes options for performing Monte Carlo simulations and automated parameter estimation.     

Morphometric comparisons between automated and manual karst depression inventories in Apalachicola National Forest,Florida, and Mammoth Cave National Park,Kentucky, USA

Karst depression catalogs are critical to assessing the hydrology and geohazards of an area; yet, the delineation of these features within a landscape can be a difficult, time-consuming and subjective task. This study evaluates the efficacy of karst depression inventorying using an automated fill-difference method operating on high-resolution lidar-derived digital elevation models (DEMs). The resulting catalog is compared with existing karst depression inventories for two low-development areas of the USA, Mammoth Cave National Park (MACA) and Apalachicola National Forest (ANF), where karst depressions have been mapped previously using a manual closed-contour approach. The automated fill method captures 93 and 85 % of these previously mapped karst depressions at MACA and ANF, respectively. Field observations and topographic analysis suggest that the omitted features were likely misclassified within the existing catalogs. The automated routine returns 797 and 3377 additional topographic depressions, at MACA and ANF, respectively, which are not included in the existing catalogs. While the geology of ANF is mostly homogenous Quaternary deposits, the newly identified, typically smaller-scale depressions found within MACA tend to be disproportionally located in non-carbonate-dominated formations, where the development of karst may be restricted by geologic heterogeneity. Within both areas, the size distributions of the two inventories are statistically identical for features larger than ~10³ m² in area or ~3 m in depth. For individual depressions captured by both methods at MACA, the automated fill-difference routine tends to return a slightly larger estimate of depression size and aggregate small depressions into larger ones. Conversely, at ANF, some low-relief depressions may be disaggregated by the fill-difference technique, with a trend toward smaller estimated depression areas when the automated method is employed. The automated fill-difference method, operating on high-resolution lidar-derived DEMs, can reproduce and expand the existing inventories of karst depressions, while minimizing false detections that may be inherent within pre-existing catalogs.