Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

Exploiting the dual functions of polymer depressants in fine particle flotation

Fine hydrophilic particles are known to be entrained with water in flotation of many ores. Flocculation of the hydrophilic particles by polymer depressants could potentially reduce the mechanical entrainment of these particles. This paper reports testwork completed on fine particles of several solids, iron oxide, hydroxyapatite and sphalerite, as well as on a relatively coarse quartz sample (− 75 + 38 μm). Dodecylamine was used as a collector for quartz, and several dispersants and polymer depressants, including sodium silicate, sodium metaphosphate, zinc sulfate, cornstarch, corn dextrin and carboxymethyl celluloses (with molecular weights of both 700,000 and 80,000) were used as flotation modifiers. The major part of the testwork involved flotation tests in a 200 mL flotation column. It was observed that flocculation of the fine hydrophilic particles significantly reduced their mechanical entrainment, while dispersion severely aggravated it. Thus, in the flotation separation of synthetic mixtures of the − 75 + 38 μm quartz and fine (reagent grade) iron oxide or hydroxyapatite, polymer depressants that caused flocculation performed better than those that did not cause flocculation.     

贵州南部“半边街式”铅锌矿床地质特征及其成因探讨

贵州省南部地区是全国重要的汞、锑资源分布区。2000年由于产于上泥盆统中铅锌矿的陆续发现,贵州省地矿局启动了以铅锌资源评价和成矿规律研究为主的地质工作,目标是总结铅锌矿产出的地质特征和成矿规律。通过三年的研究认为,该区处扬子准地台、华南褶皱带和右江造山带交汇部位,受晚古生代初期发生的陆内裂谷活动影响,产生了一个与桂中台陷相连的大型沉积凹陷区—黔南台陷沉积区,形成了巨厚碳酸盐和碎屑岩沉积,产生了与裂陷盆地边缘同沉积断层活动有关的低温成矿作用,造成了在晚泥盆纪以前的地层中汞、锑、砷、金、铅锌等矿床沿同沉积断层密集分布。本文通过矿床特征总结和矿床成因探讨,建立了准同生沉积成矿作用模式,旨在为该区寻找这类矿床提供参考和借鉴作用。     

中国城市群发育现状分析

伴随着市场经济和工业化、城市化的推进。中国城市群正在逐渐形成并快速发展。文章在对城市群概念进行讨论的基础上，选取2002年各项经济指标，从总体经济实力、人均发展水平、中心城市与县域经济发展状况诸方面，对中国各大城市群的发育状况与存在问题进行了综合对比分析，强调国家应采取以城市群为依托的“多极联动”区域发展战略。     

Adsorption of aluminium by a latosol as affected by phosphate and glutamic acid

The effect of phosphate and glutamic acid on adsorption of aluminium onto a latosol was investigated as a function of pH and ligand concentrations through batch equilibrium experiments. The results showed that adsorption of aluminium by the soil was enhanced after addition of phosphate at low pH, and this promotive effect was gradually eliminated with the increase in pH. The positive effect of phosphate on aluminium adsorption onto latosol was attributed to phosphate-induced surface negative charge and formation of ternary surface complexes involving aluminium and phosphate. While using silica as adsorbent, the inactive surfaces for phosphate, promotion of adsorption of aluminium by phosphate was also found. Then it was proposed that additional aluminium might bind to the phosphate adsorbed onto the silica in the form of surface complexes silica–aluminium–phosphate again, and the mechanism might operate in the soil systems as well. Glutamic acid exhibited no influence on the adsorption of aluminium by the soil at low pH. After increasing the pH, adsorption of aluminium was inhibited especially with the highest addition of glutamic acid, probably owing to weak affinity of complexes between glutamic acid and aluminium to the soil.     

西北地区泥石流沟形态因素的非线性分析——以兰州市为例

以兰州市区96条主要的泥石流沟为例,利用分形理论的统计自相似性对泥石流沟数的累计分布随沟谷形态要素沟道比降、汇水面积和沟道长度的变化进行了分析;并与不同流域形态要素的分维进行了比较,探讨了分维不同的原因。兰州市区泥石流沟三个形态要素均具有统计意义上的自相似性,其中以汇水面积显示出分维最小(0.46),沟道长度次之(0.71),沟道比降最大(1.09)。分维的大小描述了作为系统的沟谷及其泥石流的形成的空间结构,即分形结构,同时也反映了不同形态要素对系统所起作用的差异,分维越小,所起作用越显著。其结果对西北干旱半干旱地区石流灾害的进一步研究与防治提供了新的思路。     

科尔沁沙地土地利用与耕作方式对土壤风蚀的影响

土壤风蚀造成的直接生态后果是土地资源的退化。在春播前两次沙尘暴事件中,对科尔沁沙地几种具有代表性的土地类型的土壤风蚀量及土壤特性进行了野外测定、分析,结果表明:(1)在同一沙尘暴天气下,由于土地利用和耕作方式的不同,土壤风蚀量存在着差异,新垦农地和翻耕农地的风蚀量显著高于未垦草地、免耕农地和麻黄地;免耕农地则与未垦草地的风蚀量相差不大,风蚀危害较轻;麻黄地几乎不受风蚀侵害。新垦农地、翻耕农地、免耕农地、未垦草地、麻黄地两次观测的土壤风蚀量平均值依次为24.59、15.60、2.26、1.46和0.22 g/h.cm2。(2)基于土壤特性计算的土壤退化指数结果表明,新垦农地和翻耕农地发生了较为严重的退化。     

Towards models of strategic spatial choice behaviour: theory and application issues

Models of spatial choice behaviour have been around in geography urban planning for decades to assess the feasibility of planning actions or to predict external (competition) effects on existing destinations. Although these models differ in terms of complexity and key concepts, they all have in common that spatial choice behaviour is predicted as a function of the attributes of the choice alternatives and distance or travel time separation only. None of these models do take into account that the attributes of choice alternatives and travel time may be highly non-stationary and that often the utility that people derive from visiting a particular location also depends on the choice behaviour of other individuals. Under these circumstances, individuals may exhibit strategic choice behaviour. That is, they will choose particular choice options taking into account their expected behaviour of others such as to maximize their own utility. The purpose of the proposed paper is to discuss possible models of strategic choice behaviour for these urban planning problems. Theory will be outlined and some critical issues in the application of such models to problems of spatial choice will be discussed.     

二维电子地图和三维虚拟场景的互响应

本文提出了基于二维电子地图与三维虚拟场景之间相互响应的思想来克服它们各自的局限性.简要的描述了相互响应的原理、表现形式、实现流程及实现方法.最后提出了一些结论和展望.     

ZnS柱撑高岭石-蒙脱石混层矿物纳米复合材料的制备及其光降解伊红-B的研究

以硫尿和乙酸锌为前驱物,通过离子交换和溶液热反应的方法在有机高岭石蒙脱石混层矿物(高蒙混层矿物)层间原位合成了ZnS纳米粒子,得到ZnS柱撑高岭石蒙脱石混层矿物纳米复合材料。X射线粉末衍射分析(XRD)表明高蒙混层矿物的d001从原来的0.98nm被柱撑到1.95nm,表明层间被插入了直径小于1nm的ZnS纳米颗粒。扫描电镜(SEM)观察发现,原高蒙混层矿物的有序片层结构部分被破坏,在被剥离的片层上面均匀覆盖了ZnS颗粒聚集体,粒径在25nm左右。透射电镜(TEM)显示,ZnS颗粒聚集体是由3～5nm的颗粒堆积而成,夹杂在被剥离的高蒙混层矿物层中。选区电子衍射(SAED)和能量散射谱(EDS)测定表明形成的ZnS属于六方晶系,结晶度较低。光降解伊红_B(eosion_B)实验表明该纳米复合物具有极高的反应活性,紫外可见吸收光谱(UV_Vis)跟踪反应历程,表明降解过程中没有其他中间产物生成,20min之内降解率达到99.1%。本方法制备的ZnS柱撑高蒙混层矿物纳米复合材料与前人制备的ZnS纳米粒子相比具有更高的催化活性,方法更简单,原料较便宜,可重复利用。