Urban albedo as a function of the urban structure — A two-dimensional numerical simulation

Urban albedo change as a function of urban geometrical structure has been examined by using a two-dimensional urban block-canyon array model. The complex multiple reflections of incident photons in the urban canyon are simulated by using a Monte-Carlo method. The photons are tracked until they leave the canyon or are completely absorbed. In the model, the direct and diffuse components of incident solar radiation are introduced and the specular and isotropic reflection characteristics are considered for the relevant urban surfaces. The result shows that the urban albedo decreases as the urban irregularity increases as indicated by the model experiment of Aida (1982). The dependence of albedo on the incident solar zenith angle observed in the experiment is also confirmed for various urban models.As an application, some actual urban structures in the Marunouchi area in Tokyo are examined. Urban planning for absorption and reflection of solar radiation in urban areas is also discussed based on the analysis of the change in albedo with canyon dimensions and solar zenith angle.     

A new fracture criterion for brittle rocks

A general form of a “fracture function” for isotropic brittle materials is expressed in terms of the three invariants of the stress tensor. The coefficients in the function are determined by use of the small number of experimental data under specific conditions. This function is applicable to an estimate of the fracture condition of brittle rocks under a general stress state i.e., σ₁ ≠ σ₂ ≠ σ₃. The application of this function is attempted for the data of three brittle rocks i.e., Dunham dolomite, Mizuho trachyte, and Westerly granite, reported by previous workers. For the first two, this criterion gives a good estimation of the effect of the intermediate principal stress σ₂ on failure. For the last, the fracture strength at high confining pressure is estimated by use of the several data obtained under very low confining pressures, and the agreement with experimental data is also satisfactory.     

Spectroscopic Studies of the Solar Corona – V. Physical Properties of Coronal Structures

Spectra around the 6374 Å [Fex] and 7892 Å [Fexi] emission lines were obtained simultaneously with the 25-cm coronagraph at Norikura Observatory covering an area of 200 ×500 of the solar corona. The line width, peak intensity and line-of-sight velocity for both the lines were computed using Gaussian fits to the observed line profiles at each location (4 ×4 ) of the observed coronal region. The line-width measurements show that in steady coronal structures the FWHM of the 6374 Å emission line increases with height above the limb with an average value of 1.02 mÅ arc sec^–1. The FWHM of the 7892 Å line also increases with height but at a smaller average value of 0.55 mÅ arc sec^–1. These observations agree well with our earlier results obtained from observations of the red, green, and infrared emission lines that variation of the FWHM of the coronal emission lines with height in steady coronal structures depends on plasma temperatures they represent. The FWHM gradient is negative for high-temperature emission lines, positive for relatively low-temperature lines and smaller for emission lines in the intermediate temperature range. Such a behaviour in the variation of the FWHM of coronal emission lines with height above the limb suggests that it may not always be possible to interpret an increase in the FWHM of emission line with height as an increase in the nonthermal velocity, and hence rules out the existence of waves in steady coronal structures.     

Electrical Structure in Marine Tectonic Settings

This review paper presents recent research on electrical conductivity structure in various marine tectonic settings. In at least three areas, marine electromagnetic studies for structural exploration have increasingly progressed: (1) data accumulations, (2) technical advances both for hardware and software, and (3) interpretations based on multidisciplinary approaches. The mid-ocean ridge system is the best-studied tectonic setting. Recent works have revealed evidence of conductive zones of hydrothermal circulation and axial magma chambers in the crust and partial melt zones of the mid-ocean ridge basalt source in the mantle. The role of water or dissolved hydrogen and its redistribution at mid-ocean ridges is emphasized for the conductivity pattern of the oceanic lithosphere and asthenosphere. Regions of mantle upwelling (hotspot or plume) and downwelling (subducting slab) are attracting attention. Evidence of heterogeneity exists not only in the crust and the upper mantle, but also in the mantle transition zone. Electrical conductive zones frequently overlap seismic low-velocity zones, but discrepancies are also apparent. Some studies have compared conductivity models with the results of seismic and other studies to investigate the physical properties or processes. A new laboratory-based conductivity model for matured oceanic lithosphere and asthenosphere is proposed. It takes account of both the water distribution in the mantle as well as the thermal structure. It explains observed conductivity patterns in the depth range of 60–200 km.     

The 1998 Hida Mountain, Central Honshu, Japan, earthquake swarm: Double-difference event relocation, frequency–magnitude distribution and Coulomb stress changes

By using the double-difference relocation technique, we have determined the fine structure of seismicity during the 1998 Hida Mountain earthquake swarm. The distribution of seismic activity defines two main directions (N–S and E–W) that probably correspond to the regional stress pattern. The detailed structure of seismicity reveals intense spatio-temporal clustering and earthquake lineations. Each cluster of events contains a mainshock and subsequent aftershock activity that decays according to the Omori law. The seismicity and the b-value temporal and spatial patterns reflect the evolution of the static stress changes during the earthquake swarm. About 80% of the swarm's best-relocated events occur in regions of increased ΔCFF. The smaller value of b found in the northern part of the swarm region and a larger b-value observed to the south, for the same period of time, could be well explained by the static stress changes caused by the larger events of the sequence. We argue that the state of stress in the crust is the main factor that controls the variation of b-value.     

Stray-light correction in magnetograph observations using the maximum entropy method

We have developed a method of stray-light correction which is applicable to filter-based magnetograph observations. Stray-light-corrected Stokes images are obtained by performing the deconvolution of observed Stokes images by the point spread function which is determined from the Stokes I image. For image deconvolution, the maximum entropy principle is used to guarantee that intensity should be positive and polarization degrees should be less than unity. We present an iterative algorithm for the maximum entropy method, which seeks the solution in Fourier space and thus accomplishes fast convergence. We find that our method is effective in correcting stray light which has a spread angle greater than the full width at half maximum of the point spread function. We also discuss the effect of stray light on magnetograph calibration.     

High temperature creep of single crystal gadolinium gallium garnet

High temperature creep of single crystal gadolinium gallium garnet (GGG) was studied in the temperature range of 1723–1853 K (0.86–0.94 T_m, T_m: melting temperature) and strain rate from 9 · 10^?7 s^?1 to 2 · 10^?5 s^?1. The compression tests were made along the 〈100〉 and 〈111〉 orientations. We have performed both constant strain-rate and stress-dip tests. For the 〈100〉 orientation, deformation occurs via the 〈111〉 slip systems. For the 〈111〉 orientation, both the 〈100〉 {010} and the 〈111〉 slip systems can be activated. GGG garnet is very strong under these conditions: σ/μ=(1–3)×10^?3 (σ: creep strength, μ: shear modulus). The creep behavior is characterized by a power law with stress exponent n=2.9–3.3 and high activation energies E^*=612–743 kJ/mol (E^*～45×RT_m, at zero stress which decrease with the increase of stress). Stress-dip tests suggest a small internal stress (σ_i/σ～0.62; σ_i: internal stress, σ: applied stress) compared to other materials. These results suggest that the high creep strength of GGG is mainly due to difficulty of dislocation glide rather than dislocation climb.     

Crustal structure of the Mizuho Plateau, East Antarctica from geophysical data

Various kinds of geophysical surveys have been carried out in the Mizuho Plateau, East Antarctica by the Japanese Antarctic Research Expeditions (JARE). The correlation between the high-level gravity anomaly and the bedrock elevation is examined along a route where both data are sufficient to permit deriving a crustal model from gravity, radio-echo sounding and explosion seismic data. The bedrock elevation usually correlates well with the high-level gravity anomaly. However, along the traverse route S-H-Z from the Syowa to Mizuho stations, the bedrock elevation has a weak negative correlation with the high-level gravity anomaly. Such a weak negative correlation is attributed to the deeper part of the crust.The crustal structure between the Syowa and Mizuho stations is modeled from the gravimetric data and the radio-echo sounding of bedrock elevations, so as to fit the P-wave velocity structure derived from the data of explosion seismic experiments. Then the structure is extended from Syowa Station seaward across Lützow-Holm Bay and from Mizuho Station southeastwards inland, where only gravimetric data are available. Thus, a crustal section about 600 km long is obtained on a margin of East Antarctica. The depth of the Moho increases by about 7 km from Syowa Station to the point Y200 (71° 46′S, 48° 56′E), about 500 km from the coast. A graben-like structure is obtained along the line across Lützow-Holm Bay. This suggests that both sides of the bay are bounded by faults.     

Geophysical studies of crustal structure of the Ongul Islands and the Northern Mizuho Plateau, East Antarctica

Explosion seismic experiments, gravity measurements and aeromagnetic surveys were made in the northern Mizuho Plateau including the Ongul Islands, East Antarctica, from 1979 to 1982 by the Japanese Antarctic Research Expeditions. The objective of these field operations was to determine the crustal structure along the 300 km-long oversnow traverse route between Syowa and Mizuho Stations. Three big shots were fired; at sea near Syowa Station, in an ice hole near Mizuho Station and in an ice hole between both stations. Twenty-seven temporal seismic stations were set up along the route. Gravity measurements were carried out at 30 points along this route. Aeromagnetic surveys over the area were made four times.In the seismic experiments, clear refracted waves from the Conrad (estimated depth 30 km) and the Moho (estimated depth 40 km) discontinuities were recorded. No layer with a velocity of less than 6 km/s was found in the Ongul Islands nor beneath the ice sheet in the surveyed area. The P-wave velocity in the upper layer varies with depth from 6.0 km/s on the surface to 6.4 km/s at a depth of 13 km. Comparing the observed record section with synthetic seismograms, it was derived that the Conrad was not associated with a sharp velocity discontinuity, but a linear velocity increase of 0.55 km/s in a transition zone of 2.4 km thick. Velocities of P^* and P_n were determined as 6.95 km/s and 7.93 km/s assuming a flat layered structure.Bouguer gravity anomalies could not be calculated along the whole profile because of a lack of data on bedrock topography, so reduced gravity anomalies were calculated. These anomalies indicate no abrupt changes of the bedrock topography.     

Evaluation of the non-hydrostatic stress produced in a multi-anvil high pressure apparatus

Olivine single crystals have been deformed under high confining pressure (P=5?GPa) and temperature (T=1400?°C) conditions in a multi-anvil high pressure apparatus. NaCl, diamond and NaCl+diamond (2:1 by volume) powders were encapsulated along with the olivine single crystals in order to produce a range of stress states. The change of the non-hydrostatic stress transmitted to the olivine samples, enclosed within these three different media, during heating has been evaluated by observation of dislocation microstructure and density. A higher differential stress can be generated with diamond powder (0.1?GPa) than with NaCl powder (0.02?GPa). Although an intermediate differential stress between 0.1?GPa and 0.02?GPa had been expected to be generated using NaCl+diamond powder, the generation of non-hydrostatic stress in the olivine sample was unsuccessful. This may be caused by the fact that compaction (or sintering) proceeded in the capsule throughout the experiments. The most important finding of these experiments is that a constant non-hydrostatic stress can be applied to a sample under very high pressure and temperature conditions within the multi-anvil high pressure apparatus for the duration of the experiment. This approach is therefore suitable for investigating the steady-state rheological properties of mantle minerals at near-mantle conditions.