Long-Term Variations of Potential Temperature and Dissolved Oxygen of the Japan Sea Proper Water

Observed potential temperatures and concentrations of dissolved oxygen are analyzed to elucidate their variations during the period from 1958 to 1996 at Stn. P (37°43′ N, 134°43′ E) and from 1965 to 1996 at Stn. H (40°30′ N, 137°40′ E) in the Japan Sea. At Stn. P, increases of the potential temperature for the period are found below 800 m depth with the largest value of 0.16 ± 0.09°C per century at 800 m depth. At Stn. H, the potential temperature increased below 500 m depth. The increase rate has the largest value of 0.50 ± 0.18°C per century at 500 m depth and it is 0.30 ± 0.09°C per century at 800 m depth. The concentrations of dissolved oxygen increased around 800 m depth at Stn. P. At Stn. H, they increased above 800 m depth. On the other hand, they decreased below 1200 m depth at both stations. The layer of the dissolved oxygen minimum has deepened in these decades. These features appearing in the distributions of temperature and dissolved oxygen are successively simulated by a vertical one-dimensional advection-diffusion model including consumption of dissolved oxygen and termination of the deep water supply. These results suggest that the supply of the Japan Sea Proper Water into the deep layer, which is cold and rich in dissolved oxygen, has been decreasing for the last four decades. This revised version was published online in August 2006 with corrections to the Cover Date.     

Coronal-Temperature-Diagnostic Capability of?the?Hinode/X-Ray Telescope Based on Self-Consistent Calibration

The X-Ray Telescope (XRT) onboard the Hinode satellite is an X-ray imager that observes the solar corona with unprecedentedly high angular resolution (consistent with its 1?? pixel size). XRT has nine X-ray analysis filters with different temperature responses. One of the most significant scientific features of this telescope is its capability of diagnosing coronal temperatures from less than 1 MK to more than 10 MK, which has never been accomplished before. To make full use of this capability, accurate calibration of the coronal temperature response of XRT is indispensable and is presented in this article. The effect of on-orbit contamination is also taken into account in the calibration. On the basis of our calibration results, we review the coronal-temperature-diagnostic capability of XRT.     

Polarization Calibration of the <Emphasis Type="Italic">Chromospheric Lyman-Alpha SpectroPolarimeter</Emphasis> for a 0.1% Polarization Sensitivity in the VUV Range. Part II: In-Flight Calibration

The Chromospheric Lyman-Alpha SpectroPolarimeter is a sounding rocket instrument designed to measure for the first time the linear polarization of the hydrogen Lyman-\({\upalpha }\) line (121.6 nm). The instrument was successfully launched on 3 September 2015 and observations were conducted at the solar disc center and close to the limb during the five-minutes flight. In this article, the disc center observations are used to provide an in-flight calibration of the instrument spurious polarization. The derived in-flight spurious polarization is consistent with the spurious polarization levels determined during the pre-flight calibration and a statistical analysis of the polarization fluctuations from solar origin is conducted to ensure a 0.014% precision on the spurious polarization. The combination of the pre-flight and the in-flight polarization calibrations provides a complete picture of the instrument response matrix, and a proper error transfer method is used to confirm the achieved polarization accuracy. As a result, the unprecedented 0.1% polarization accuracy of the instrument in the vacuum ultraviolet is ensured by the polarization calibration.     

Subsidence associated with the LUSI mud eruption,East Java,investigated by SAR interferometry

A mud volcano LUSI initiated its eruption on 29 May 2006, adjacent to a hydrocarbon exploration well in East Java. Ground subsidence in the vicinity of the LUSI eruptive vent was well recorded by a Synthetic Aperture Radar (SAR) PALSAR onboard the Japanese ALOS satellite. We apply an Interferometric SAR (InSAR) technique on ten PALSAR data scenes, acquired between 19 May 2006 and 21 May 2007, in order to obtain continuous maps of ground displacements around LUSI. Although the displacements in the area closest to the eruptive vent (spatial extension of about 1.5 km) are not detectable because of the erupted mud, all the processed interferograms indicate subsidence in an ellipsoidal area of approximately 4 km (north–south) × 3 km (east–west), centered at the main eruptive vent. In particular, interferograms spanning the first four months until 4 Oct. 2006 and the subsequent 46 days between 4 Oct. 2006 and 19 Nov. 2006 show at least about 70 cm and 80 cm of displacements away from the satellite, respectively. Possible causes of the subsidence, i.e., 1) loading effect of the erupted mud, 2) creation of a cylindrical mud conduit, and 3) pressure decrease and depletion of materials at depth, are investigated. The effects of the first two causes are found to be insufficient to explain the total amount of subsidence observed in the first six months. The third possibility is quantitatively examined using a boundary element approach by modeling the source of deformation as a deflating oblate spheroid. The spheroid is estimated to lie at depths of a few hundred to a thousand meters. The estimated depths are significantly shallower than determined from analyses of erupted mud samples; the difference is explained by presence of significant amount of inelastic deformation including compaction and downward transfer of material.     

Tectonic evolution along the northernmost border of the Philippine Sea plate since about 1 Ma

Recent structural, tephrochronologic and magnetostratigraphic studies conducted along the northernmost border of the Philippine Sea (PHS) plate enable us to reconstruct the precise tectonic evolution along the convergent boundary between the PHS plate and the Northeast Japan (NEJ) plate or the North American (NAM) plate since about 1 Ma. The authors of the present study split the tectonic evolution into five stages and present the characteristics of each stage. A plate tectonic interpretation is proposed, based upon the tectonic evolution, with special reference to the mode of convergent motion. In brief, our interpretations are as follows: the relative motion between the PHS and the NEJ plates was not recognized geologically within the area studied from about 1.0 to 0.9 Ma (Stage 1), suggesting either none or small influence from the coupling between the two plates during that period of time. Convergence between the PHS and the NEJ plates was possibly in N-S direction from 0.9 to 0.5 Ma (Stage II), and probably north-northwestward since 0.5 Ma (Stages III to V). The mode of the convergent motion was that of buoyant subduction in Stages II and III. The mode changed gradually from buoyant subduction during Stage IV to collision in Stage V (0.07 Ma to the present).     

Nankai Trough and Zenisu Ridge: a deep-sea submersible survey

Eight submersible dives between 3000 and 4200 m water depth were made off southern Japan in the eastern Nankai subduction zone. Benthic communities associated with chemosynthetic processes were discovered along the 800 m wide active tectonic zone, at the toe of the accretionary prism. A benthic community was also discovered along a zone of active compression, at the foot of Zenisu Ridge, 30 km south of Nankai Trough. Temperature measurements within the sediments below the benthic communities confirm that upward motion of interstitial water occurs there. Studies of water samples indicate advection of methane and light hydrocarbons. Specimens of the benthic community have been shown to have included in their shells carbonate resulting from methane consumption. Thus the benthic communities are related to overpressure-driven fluid advection along tectonic zones with active surface deformation. A 300 m high active scarp at the toe of the accretionary prism is related to relative motion in a 280° direction which is close to the 305° average direction of subduction in this area. The dives establish further that compressive deformation is presently occurring at the foot of Zenisu Ridge. The previous interpretation of the Zenisu Ridge as a zone of recent north-south intraplate shortening, 40 km south of the Nankai Trench, is confirmed. We conclude that tectonic evolution might well lead to future detachment of the Zenisu Ridge and overthrusting of this large piece of oceanic crust over the continental margin. Such a process might be an efficient one to emplace ophiolites over continents.     

K-Ar Ages of Tin-Polymetallic Mineralization in the Oruro Mining District, Central Bolivian Tin Belt

Abstract. K-Ar age determinations were carried out on vein- and rock-forming minerals from five vein-type tin-polymetallic ore deposits of the Oruro mining district in the central part of the Bolivian tin belt. The sericite from vein selvedges and an altered host rock provides good estimates of the ages of hypogene mineralization, and supergene alunite and jarosite provide ages for erosional and weathering episodes. It is concluded that hypogene mineralization in the Oruro mining district took place during the early to middle Miocene: 15.8±0.8 Ma at San José, 20.1±l.l Ma at Morococala, 20.5±1.0 Ma at Avicaya, and 19.6±1.0 Ma at Llallagua. Fine grained supergene alunite (δ³⁴S = -10.1 960) and jarosite yield K-Ar ages of 6.7±0.7 Ma at Avicaya and 3.9±0.7 Ma at Bolivar, respectively, suggesting that erosion and chemical weathering were active at those times.     

Quaternary folding of the eastern Tian Shan, northwest China

The Tian Shan, east–west trending more than 2000 km, is one of most active intracontinental mountain building belts that resulted from India–Eurasia collision during Cenozoic. In this study, Quaternary folding related to intracontinental mountain building of the Tian Shan orogenic belt is documented based on geologic interpretation and analyses of the satellite remote sensing images [Landsat Thematic Mapper (TM)/Enhanced Thematic Mapper (ETM) and India Remote Sensing (IRS) Pan] combined with field geologic and geomorphic observations and seismic reflection profiles. Analyses of spatial–temporal features of Quaternary folded structure indicate that the early Quaternary folds are widely distributed in both piedmont and intermontane basins, whereas the late Quaternary active folds are mainly concentrated on the northern range-fronts. Field observations indicate that Quaternary folds are mainly characterized by fault-related folding. The formation and migration of Quaternary folding are likely related to decollement surfaces beneath the fold-and-fault zone as revealed by seismic reflection profiles. Moreover, analysis of growth strata indicates that the Quaternary folding began in late stage of early Pleistocene (2.1–1.2 Ma). Finally, tectonic evolution model of the Quaternary deformation in the Tian Shan is presented. This model shows that the Quaternary folding and faulting gradually migrate toward the range-fronts due to the continuous compression related to India–Eurasia collision during Quaternary time. As a result, the high topographic relief of the Tian Shan was formed.     

An unconformity in the early Miocene syn-rifting succession, northern Noto Peninsula, Japan: Evidence for short-term uplifting precedent to the rapid opening of the Japan Sea

Abstract   The present paper describes the newly discovered early Miocene unconformity in the northern Noto Peninsula, on the Japan Sea side, central Japan. The unconformity marks the boundary between an early Miocene non-marine to marine succession and a more extensive, late early to early middle Miocene marine succession, and contains a time gap of an order of 1 million years or less from 18 Ma or earlier to 17 Ma. The early Miocene succession likely represents an early phase of marine transgression and initial slow rifting. The overlying early to early middle Miocene succession records the climax of the opening of the Japan Sea at ca  16 Ma with widespread, rapid subsidence of the Japan Arc. The unconformity between the two transgressive successions may represent a global sealevel fall or, more likely, crustal uplifting because no upward-shallowing or regressive facies remains between the two successions. Early Miocene unconformities that are thought to be correlative with this unconformity in the northern Noto Peninsula occur in places along the Japan Sea coast of Sakhalin and Japan. They are likely to have been produced during rifting in response to upwelling of asthenospheric mantle, although more accurate age constraints are necessary to evaluate this idea.     

Geochemical and hydrological controls on biannual lamination of tufa deposits

Fluvial tufa deposits in southwest Japan commonly develop biannual lamination consisting of dense summer layers and porous winter layers, and the clearness of the laminae varies among the sites. The laminae have been largely attributed to a seasonally variable inorganic precipitation rate of calcite. This rate-controlled hypothesis was examined by using quantitative data for calcite packing-density (CPD) and the precipitation rate of calcite (PWP rate) calculated from water chemistry. The results for four tufa-depositing sites in SW Japan show that a positive correlation between CPD and PWP rate becomes less certain with increasing PWP rate. In the temperature realm of SW Japan, tufas develop regular distinct seasonal change in CPD when deposited in water containing Ca values less than 65 mg/l, which results in a relatively low precipitation rate. The CPD of tufa deposits rarely exceeds 65%, owing to pore space between fine-grained calcite crystals and to porosity derived from decomposed cyanobacteria and other microorganisms. By increasing the Ca content to more than 65 mg/l, the CPD often attains an upper limit and becomes insensitive to seasonal changes in the PWP rate. Therefore, seasonal variations in CPD at sites with a higher Ca content are unclear, as seen in two examples from tropical islands in southern Japan and in one locality in a temperate climate. The flow rate and microbial density on the tufa surface are subordinate factors with respect to the CPD. Seasonal changes in these two factors often enhance the porous/dense contrast of biannual lamination in SW Japan.