Characterization and cycling of atmospheric mercury along the central US Gulf Coast

Concentrations of atmospheric Hg species, elemental Hg (Hg^°), reactive gaseous Hg (RGM), and fine particulate Hg (Hg-PM_2.5) were measured at a coastal site near Weeks Bay, Alabama from April to August, 2005 and January to May, 2006. Mean concentrations of the species were 1.6 ± 0.3 ng m⁻³, 4.0 ± 7.5 pg m⁻³ and 2.7 ± 3.4 pg m⁻³, respectively. A strong diel pattern was observed for RGM (midday maximum concentrations were up to 92.7 pg m⁻³), but not for Hg^° or Hg-PM_2.5. Elevated RGM concentrations (>25 pg m⁻³) in April and May of 2005 correlated with elevated average daytime O₃ concentrations (>55 ppbv) and high light intensity (>500 W m⁻²). These conditions generally corresponded with mixed continental-Gulf and exclusively continental air mass trajectories. Generally lower, but still elevated, RGM peaks observed in August, 2005 and January–March, 2006 correlated significantly (p < 0.05) with peaks in SO₂ concentration and corresponded to periods of high light intensity and lower average daytime O₃ concentrations. During these times air masses were dominated by trajectories that originated over the continent. Elevated RGM concentrations likely resulted from photochemical oxidation of Hg^° by atmospheric oxidants. This process may have been enhanced in and by the near-shore environment relative to inland sites. The marine boundary layer itself was not found to be a significant source of RGM.     

Deep-seated gravitational slope deformations and their influence on consequent mass movements (case studies from the highest part of the Czech Carpathians)

Gravitational spreading of mountain ridges displays primary disequilibrium of flysch mountain areas of the Czech Carpathians. The progression of various types of mass movements is a product of long-term ridge disintegration and is predisposed by the geological structure of the area and the upper Tertiary-Quaternary morphogenesis of the mountain area. Deep-seated slope deformations are spatially interconnected by the occurrence of some other types of slope deformations (e.g. debris flows, debris slides, slumps, rock avalanches, etc.), which pose a considerable risk for the existence of human society. An important causative factor in these dynamically developing hazardous processes is, among other factors, the way in which land has been used in the last three centuries. Therefore, the occurrence of various types of slope deformations is studied in terms of their relation to deep-seated gravitational deformations and in terms of other limiting factors (structural geological, morphological and climatic factors, manmade impacts, etc.). The paper presents several case studies of slope deformations (Velká Čantoryje Mt, Lysá hora Mt, Ropice Mt and Smrk Mt) in the area of the Outer Carpathians within the territory of the Czech Republic and also adverts to some consequences in terms of the socioeconomic structure of the landscape.     

Numerical estimation of REV and permeability tensor for fractured rock masses by composite element method

The Monte Carlo method is used to generate parent stochastic discrete fracture network, from which a series of fractured rock samples of different sizes and orientations are extracted. The fracture network combined with a regular grid forms composite element mesh of the fractured rock sample, in which each composite element is composed of sub‐elements incised by fracture segments. The composite element method (CEM) for the seepage is implemented to obtain the nodal hydraulic potential as well as the seepage flow rates through the fractured rock samples. The application of CEM enables a large quantity of stochastic tests for the fractured rock samples because the pre‐process is facilitated greatly. By changing the sizes and orientations of the samples, the analysis of the seepage characteristics is realized to evaluate the variation of the permeability components, the existence of the permeability tensor and the representative element volume. The feasibility and effectiveness are illustrated in a numerical example. Copyright © 2008 John Wiley & Sons, Ltd.     

Biaxial test simulations using a packing of polygonal particles

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.     

Flexural isostatic response of the Alps to increased Quaternary erosion recorded by foreland basin remnants,SE France

We test the hypothesis that flexural isostatic compensation of the mass removed by enhanced Quaternary erosion is responsible for uplift of the Western European Alps and their forelands. We use two well‐preserved and well‐dated (1.8 Ma) abandonment surfaces of foreland basin remnants in SE France (the Chambaran and Valensole plateaux) as passive benchmarks for tilting of the foreland. Estimating their initial slope from morphometric scaling relationships, we determine bulk post‐depositional tilting of 0.5–0.8% for these surfaces. The calculated isostatic response of the Alpine lithosphere to erosional unloading, using the method recently proposed by Champagnac et al. [Geology 35 (2007) 195–198] , yields a predicted tilting of 0.3–0.4% in the considered areas, explaining approximately half of the determined post‐depositional tilting. Such long‐term deformation being insensitive to cyclic loading/unloading because of glaciations, we suspect the other half to be related to as yet undetermined long‐wavelength and long‐lived tectonic process(es).     

The Ectoparasitic Gastropod Boonea (= Odostomia) impressa: Population Ecology and the Influence of Parasitism on Oyster Growth Rates

Abstract. Boonea (= Odostomia) impressa is a common ectoparasite of oysters. In the laboratory, small oysters (Crassostrea virginica) parasitized by natural densities of B. impressa produced 75 % less new shell than unparasitized oysters. Shell deposition rates of previously parasitized oysters increased significantly after all B. impressa were removed. Thus, the decrease in growth rate, although significant, apparently was not permanent. B. impressa preferentially parasitized small, living oysters (≤2.5cm) in the field, even though a higher percentage of large, living oysters (>2.5cm) was available. The snails maintained an aggregated distribution on the oyster reef. The number of B. impressa per oyster clump was positively correlated with the number of living oysters per clump, however some clumps with few or no living oysters had many B. impressa. Thus, food availability only partially explained the pattern of distribution. B. impressa was very mobile. About 50 % of the population moved in one week. Reproduction occurred throughout the year with a peak period in May. Recruitment was greatest in July, however new recruits were observed throughout the year. The reduction in growth rate of parasitized oysters, the snaiľs propensity towards parasitizing small oysters and the snail's tendency to be contagiously distributed suggests that B. impressa potentially exerts a significant influence on the population structure and health of oyster populations.     

Application of the Single-Bubble Airgun Technique for OBS-Data Acquisition Across the Jan Mayen Ridge,North Atlantic

A 140 km long wide-angle seismic profile has been acquired by use of 6 Ocean Bottom Seismographs across the Jan Mayen Ridge, North Atlantic. The profile was acquired twice; once with a traditionally tuned standard source and secondly with a somewhat smaller source tuned on the first bubble pulse. Analysis of the frequency content of the data reveals that the single-bubble source within the 10-15 Hz frequency range generates a signal with a level about 5 db above that of the standard source. These differences can partly be related to differences in airgun depth. The higher output level for these frequencies enables the single-bubble source to resolve intra-crustal structures with a higher degree of certainty, when compared to the data acquired by use of the standard source array. The standard source seems to generate slightly more energy for frequencies around 6 Hz, probably due to the use of a large 1200 in/sup3 gun in this array. These low frequencies a re of importance for mapping of lower crustal and upper mantle structures, and it is recommended that this is taken into account when seismic sources for mapping of deep crustal and upper mantle structures are designed.     

Sheet flow and suspension of sand in oscillatory boundary layers

after revisionTime-dependent measurements of flow velocities and sediment concentrations were conducted in a large oscillating water tunnel. The measurements were aimed at the flow and sediment dynamics in and above an oscillatory boundary layer in plane bed and sheet-flow conditions. Two asymmetric waves and one sinusoidal wave were imposed using quartz sand with D₅₀ = 0.21 mm. A new electro-resistance probe with a large resolving power was developed for the measurement of the large sediment concentrations in the sheet-flow layer. The measurements revealed a three layer transport system consisting of a pick-up/deposition layer, an upper sheet flow layer and a suspension layer.In the asymmetric wave cases the total net transport was directed “onshore” and was mainly concentrated in the thin sheet flow layer (< 0.5 cm) at the bed. A small net sediment flux was directed “offhore” in the upper suspension layer. The measured flow velocities, sediment concentrations and sedimenl fluxes showed a good qualitative agreement with the results of a (numerical) 1DV boundary-layer flow and transport model. Although the model did not describe all the observed processes in the sheet-flow and suspension layer, the computational results showed a reasonable agreement with measured net transport rates in a wide range of asymmetric wave conditions.     

Carbon and oxygen isotope composition of foraminifera in two cores from the Bannock Basin area, eastern Mediterranean

Two cores from the Bannock Basin in the eastern Mediterranean have been analysed for δ¹⁸0 and the δ¹³C in planktonic foraminifera. One core (02-PC) was extracted from the anoxic brine, the other (08-GC) from a plateau east of the brine.

The absence of sapropelic muds in Core 08-GC from the two Holsteinian euxinic cycles, together with the presence of isotopic spikes, suggests that the plateau has risen during the last ca. 200,000 years by ca. 2.5 mm/yr.

The δ¹⁸0 amplitude of Globigerinoides ruber in eastern Mediterranean cores is only ca. 0.5%. larger than for this species in North Atlantic cores. This suggests that the surface oxygen isotopic composition of both bodies of water followed each other fairly closely during the Late Pleistocene, except during the stagnant phases.