Experimental study of a biotite-bearing granitic system under water-saturated and water-undersaturated conditions

Phase relationships in haplogranitic melts containing ferromagnesian minerals were investigated in the temperature range 760–850°C, atP _total=2 kbar, =0.25 1.00, and at NNO buffer conditions. The compositions of coexisting biotite, orthopyroxene, magnetite and granitic melt were determined by electron microprobe. Biotite was the only Fe–Mg mineral in the starting material. It disappeared in water-undersaturated melts at temperatures above 830°C and in melts saturated with water above 810°C. Magnetite was present in all runs. Orthopyroxene became stable between 780 and 800°C. The Mg/(Mg+Fe) ratios of biotite (0,63–0,72) and orthopyroxene (0,63–0,71) are similar in water-saturated and undersaturated melts at comparable temperatures and increase slightly with increasing temperature. The solubility of Mg in haplogranitic melts is very low (0,07–0,24 wt% MgO). It increases slightly with temperature and is independent of the prevailing water activity. The solubility of Fe is low (0,91–1,37 wt% FeO); it also increases with increasing temperature, and it is higher in water-saturated than in water-undersaturated melts.     

Geothermal gradients and heat flow in the Beaufort-Mackenzie Basin,Arctic Canada

Thermal gradients have been calculated and heat flow estimates made for 34 petroleum exploration wells along four regional profiles crossing the Mesozoic-Cenozoic Beaufort-Mackenzie Basin of northern Canada. The geothermal gradients vary from 22 mKm^–1 to 44 mKm^–1. Four sets of possible thermal conductivity values were used to calculate a range of heat flow values for each well. Generally low heat flow is observed in wells within the deeper portions of the basin and higher heat flow values occur in wells along the Aklavik Arch Complex which forms the southeastern margin of the basin.The contribution to heat flow by heat generation below the Mesozoic-Cenozoic basin fill sediments has been considered. The heat flow contribution from sub-Mesozoic sedimentary strata and underlying basement is highest along the basin-bounding Aklavik Arch Complex. The decrease in heat flow from below the basin fill sediments toward the basin depocenter may be related to basinward crustal thinning and corresponding reductions in intra-crustal radiogenic heat production.     

Ground Surface Warming History in Northern Canada Inferred from Inversions of Temperature Logs and Comparison with Other Proxy Climate Reconstructions

— Well temperature logs from 61 sites located in discontinuous and continuous permafrost regions of northern Canada are analyzed. The method of functional space inversion (FSI) is applied to the set of precise temperature logs from wells located between 60 ° and 82 °N. There is strong evidence of extensive ground surface temperature (GST) warming beginning in the late 18^th century and lasting until the 20^th century. This was preceded by a lengthy period of cooling. The approximate average increase of the surface temperature of Canadian Arctic, based on all individual GST histories, is > 1.3 °C for the last 200 years. Simultaneous inversion of all well temperature data suggests an even higher warming (approximately 2 °C). There has been no strong south-to-north gradient in the ground warming magnitude when northern Canadian data are compared with eastern and central Canadian data south of 60 °N which also shows warming close to 2 °C. In Alaska, warming of some 2 °C has been restricted mainly to the 20^th century. In general, however, a high warming magnitude is common for most of Canada and Alaska for the previous century. The averaged GST history (GSTH) for the Canadian Arctic is calibrated with and compares visually with a variety of recently published regional and hemispheric proxy climate reconstructions. These show that GST warming derived from well temperature logs is generally higher than one shown by other proxy (mainly tree-ring reconstructions).Received April, 2003     

Terrestrial heat flow and geothermal gradients in relation to hydrodynamics in the Alberta basin, Canada

Geothermal gradients in the Alberta part of the Western Canadian sedimentary basin have been studied on the basis of 55,244 bottom-hole temperature values from 28,260 petroleum exploration wells. Gradient estimates for different depth and stratigraphic intervals together with a study of the heat conductivity distribution indicate both regional heat flow variations and variations with depth. The regional hydrodynamics of the basin strongl influences both grad ifT gradient and heat flow increase with depth in water recharge areas to the west and decrease with depth in discharge areas to the north and east. The results indicate that heat flow in the central part of the basin should be approximately equal to the deep crustal heat flow.     

The drainage pattern of Hansbreen and Werenskioldbreen, two polythermal glaciers in Svalbard

To improve our understanding of Svalbard-type polythermal glacier drainage, hydraulic geometry models of the subglacial hydrology of two contrasting glaciers in Svalbard have been constructed. The models are tested against a uniquely long and rich set of field observations spanning 45 years. Digital elevation models (DEMs) were constructed from bedrock data measured with ground penetrating radar and surface data of two medium-sized polythermal glaciers, Hansbreen and Werenskioldbreen, in south-west Spitsbergen. Hansbreen has a low angle bed with over-deepenings and a calving front, while Werenskioldbreen has steeper bed and terminates on land. Together they are representative of many Svalbard glaciers. The DEMs were used to derive maps of hydraulic potential and subglacial drainage networks. Validation of the models was done using field observations including location mapping and speleological exploration of active moulins, positions of main river outflows, dyetracing and water chemistry studies, and observations of water pressure inside moulins. Results suggest that the water pressure is generally close to ice overburden pressure but varies greatly depending on local conditions such as bed location, the thickness of cold ice layer, the thickness of the glacier and seasonal changes in meltwater input.     

Crustal thickness, discontinuity depth, and upper mantle structure beneath southern Africa: constraints from body wave conversions

The technique of receiver function analysis is applied to the study of crustal and upper mantle structures beneath the Kaapvaal craton in southern Africa and its surroundings. Seismic data were recorded by the seismic array of 82 sites deployed from April 1997 to April 1999 across southern Africa, as well as a dense array of 32 sites near Kimberley, in operation from December 1998 to June 1999. Arrival times for phases converted at the Moho are used to determine crustal thickness. The Moho depth in the south–western section of the craton was found to vary between 37 and 40 km, except for one station that recorded a depth of 43 km (SA23). Farther north along the western block of the craton (into Botswana) the depth increases up to 43 km. The depth increases even further in the north–eastern section of the craton, where results vary from 40 to 52 km. Just north of the Kaapvaal craton, in the neighbouring Zimbabwe craton, the crustal thickness drops significantly. The results obtained there varied from 36 to 40 km. For the Kimberley area, using the dense array, the Moho depth was found to be 37.3 km. Arrivals of the Ps and Ppps phases were used to determine the Poisson’s ratio in the region. This was found to be 0.26±0.01. Arrivals of phases from the 410 and 660 km mantle discontinuities are used to interpret the relative positions of these discontinuities, as well as for comparison of mantle temperatures and seismic velocities in the region with global averages. In the Kimberley area the 410 and 660 km discontinuities were found at their expected depth, implying that mantle temperatures in the region are close to the global average. The seismic velocities above the ‘410’ were found up to 5% faster than the averages from the global iasp91 model, which is fast even by Precambrian standards. In other sections of the Kaapvaal craton, the velocities are also faster than global averages, but not as fast as beneath Kimberley. In these sections, the ‘410’ is also slightly elevated, while the ‘660’ is depressed, which implies a slightly lower mantle temperature relative to the global average. Beneath the Kaapvaal craton we find evidence suggesting the presence of a zone with a reduced wavespeed gradient at an upper bound of approximately 300 km, which may mark the lower chemical boundary of the craton.     

On the Use of Weighted Linear Combination Method in GIS: Common and Best Practice Approaches

The weighted linear combination (WLC) technique is a decision rule for deriving composite maps using GIS. It is one of the most often used decision models in GIS. The method, however, is frequently applied without full understanding of the assumptions underling this approach. In many case studies, the WLC model has been applied incorrectly and with dubious results because analysts (decision makers) have ignored or been unaware of the assumptions. This paper provides a critical overview of the current practice with respect to GIS/WLC and suggests the best practice approach.