Effect of spatial variation characteristics on contouring of design storm depth

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.     

BACKGROUND STUDY ON NON-RESIDUAL PHASE OF ELEMENTS IN CHANGJIANG AND HUANGHE ESTUARINE SEDIMENTS

Analysis of Zn, Cu, Pb, Co, Cr, Li, Ni, K, Al, Fe extracted by 1 mol/L HCl or 0.5 mol/LHCl/H_2O_2, showed concentrations of Zn, Cu, Pb, Co, Cr, Fe, Ni were significantly correlated with Li, Al,K, and clay. Two methods are used to indicate the background value of the non-residual phase of elementsin sediments, and are the same as the methods used to indicate the background value of totalconcentrations in sediments. The first method uses correlograms and regression equations,the second usesthe mean element concentrations normalized with grain size. Li, Al, K can be used as reference elements to determine the background value of Zn, Cu, Pb, Co,Cr, Ni, Fe, while the clay concentration's correlation with some extractable concentrations can be used tocalculate the background value of the non-residual phase of elements as a percentage of clay concentrationin the sediments. Based on this study, the concept of using the background value of the non-residualphase of elements to compare the pollution level in differ     

Formation of primary pit connection during conchocelis phase of Porphyra yezoensis （Bangiophyceae, Rhodophyta）

1 INTRODUCTION Pit connection is an important feature in Rhodophyta and significant in algal phylogeny. Various documents have illustrated the existence of pit-connection in red alga previously (Migita, 1967; Ramus 1969a, b; Bourne et al., 1970; Lee and F…     

形变大地测量学的进展、问题与地震预报

简要概括了形变大地测量学的革命性进展，研讨了它的科学特色、功能和定义以及对地球科学和防灾减灾的推动。形变大地测量学有助于从根本上击破多年来制约地震预报的“瓶颈”，但也存在不少急待解决的问题。着重研讨了在21世纪前10年，形变大地测量学如何依托多年的学科积累并充分受益于人造卫星和数字化等新技术，开展创新性研究和试验以推进地震预报。为此，对当前的研究工作提出了12条科学技术途径。最后对学科名称提出了建议。     

Elastic solutions for stresses in a transversely isotropic half‐space subjected to three‐dimensional buried parabolic rectangular loads

In many areas of engineering practice, applied loads are not uniformly distributed but often concentrated towards the centre of a foundation. Thus, loads are more realistically depicted as distributed as linearly varying or as parabola of revolution. Solutions for stresses in a transversely isotropic half‐space caused by concave and convex parabolic loads that act on a rectangle have not been derived. This work proposes analytical solutions for stresses in a transversely isotropic half‐space, induced by three‐dimensional, buried, linearly varying/uniform/parabolic rectangular loads. Load types include an upwardly and a downwardly linearly varying load, a uniform load, a concave and a convex parabolic load, all distributed over a rectangular area. These solutions are obtained by integrating the point load solutions in a Cartesian co‐ordinate system for a transversely isotropic half‐space. The buried depth, the dimensions of the loaded area, the type and degree of material anisotropy and the loading type for transversely isotropic half‐spaces influence the proposed solutions. An illustrative example is presented to elucidate the effect of the dimensions of the loaded area, the type and degree of rock anisotropy, and the type of loading on the vertical stress in the isotropic/transversely isotropic rocks subjected to a linearly varying/uniform/parabolic rectangular load. Copyright © 2002 John Wiley & Sons, Ltd.     

淮山提取液替代羧甲基纤维素钠作为酸奶稳定剂的效果研究

采用正交试验等方法对淮山提取液（DB-Ext）代替羧甲基纤维素钠(CMC)作为调配型酸奶稳定剂的效果进行了初步探讨。结果表明以原料的6.0倍水量在110℃的温度条件下，提取40min，所得的淮山提取液的粘度为3500mPa     

The influence of a non‐associated flow rule on the calculation of the factor of safety of soil slopes

This paper presents a method that incorporates a non‐associated flow rule into the limit analysis to investigate the influence of the dilatancy angle on the factor of safety for the slope stability analysis. The proposed method retain's the advantage of the upper bound method, which is simple and has no stress involvement in the calculation of the energy dissipation and the factor of safety. Copyright © 2001 John Wiley & Sons, Ltd.     

Abundance and isotopic composition of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite

Abstract— Abundances and isotopic compositions of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite were measured. The abundance ratios of spallogenic components in metal reveal a ³He deficiency which is due to the diffusive loss of parent isotopes, that is, tritium (Tilles, 1963; Schultz, 1967). The diffusive loss likely has been induced by thermal heating by the Sun during cosmic‐ray exposure (～160 Ma; Lavielle et al, 1999). Thermal process such as impact‐induced partial loss may have affected the isotopic composition of spallogenic Ne. The ¹²⁹Xe/¹³¹Xe ratio of cosmogenic components in the metal indicates an enhanced production of epi‐thermal neutrons. The abundance ratios of spallogenic components in the graphite reveal that it contained small amounts of metal and silicates. The isotopic composition of heavy noble gases in graphite itself was obtained from graphite treated with HF/HCl. The isotopic composition of the etched graphite shows that it contains two types of primordial Xe (i.e., Q‐Xe and El Taco Xe). The isotopic heterogeneity preserved in the Bohumilitz graphite indicates that the Bohumilitz graphite did not experience any high‐temperature event and, consequently, must have been emplaced into the metal at subsolidus temperatures. This situation is incompatible with an igneous model as well as the impact melting models for the IAB‐IIICD iron meteorites as proposed by Choi et al. (1995) and Wasson et al (1980).     

An algorithm for detecting and estimating cycle slips in single-frequency GPS

An algorithm for detecting outliers and cycle slips in single-frequency GPS using a 3rd order polynomial model of the Kalman filter and for estimating the ambiguity by using optimal wavelet is presented in this paper. It is applicable to the carrier phase measurement with sample rate of one per second. The results of calculation with the GPS data aboard satellite Topex on 1995 June 22 show that the algorithm is so efficient that it can accurately estimate the ambiguity even for signals interrupted by a few seconds.     

Radar observations of Itokawa in 2004 and improved shape estimation

Abstract— We present June 2004 radar images of asteroid 25143 Itokawa (1998 SF36) that improve upon the longitude‐latitude coverage of images obtained in 2001 by Ostro et al. (2004) and use the 2001–2004 data to refine that paper's constraints on Itokawa's shape. The 2004 images, the first of the asteroid's southern side, look distinctly different from the 2001 images, revealing leading edges that are much more curved and rugged than the nearly convex leading edges seen at northern latitudes in 2001. Itokawa is shaped like a slightly asymmetrical, bent, lumpy ellipsoid with dimensions along the principal axes within 10% of 594 times 320 times 288 m. To illustrate the uncertainty space associated with shape reconstruction from images with suboptimal orientational coverage, we present two alternative three‐dimensional models of the object.