Abrupt climate change: An alternative view

Hypotheses and inferences concerning the nature of abrupt climate change, exemplified by the Dansgaard-Oeschger (D-O) events, are reviewed. There is little concrete evidence that these events are more than a regional Greenland phenomenon. The partial coherence of ice core δ¹⁸O and CH₄ is a possible exception. Claims, however, of D-O presence in most remote locations cannot be distinguished from the hypothesis that many regions are just exhibiting temporal variability in climate proxies with approximately similar frequency content. Further suggestions that D-O events in Greenland are generated by shifts in the North Atlantic ocean circulation seem highly implausible, given the weak contribution of the high latitude ocean to the meridional flux of heat. A more likely scenario is that changes in the ocean circulation are a consequence of wind shifts. The disappearance of D-O events in the Holocene coincides with the disappearance also of the Laurentide and Fennoscandian ice sheets. It is thus suggested that D-O events are a consequence of interactions of the windfield with the continental ice sheets and that better understanding of the wind field in the glacial periods is the highest priority. Wind fields are capable of great volatility and very rapid global-scale teleconnections, and they are efficient generators of oceanic circulation changes and (more speculatively) of multiple states relative to great ice sheets. Connection of D-O events to the possibility of modern abrupt climate change rests on a very weak chain of assumptions.     

Food Deserts in the Prairies? Supermarket Accessibility and Neighborhood Need in Edmonton,Canada*

The U.S. and U.K. literatures have discussed “food deserts,” reflecting populated, typically urban, low‐income areas with limited access to full‐service supermarkets. Less is known about supermarket accessibility within Canadian cities. This article uses the minimum distance and coverage methods to determine supermarket accessibility within the city of Edmonton, Canada, with a focus on high‐need and inner‐city neighborhoods. The results show that for 1999 both of these areas generally had higher accessibility than the remainder of the city, but six high‐need neighborhoods had poor supermarket accessibility. We conclude by examining potential reasons for differences in supermarket accessibility between Canadian, U.S., and U.K. cities.     

Development of site-specific design ground motions in Western and Eastern North America

This paper presents results recently obtained for generating site-specific ground motions needed for design of critical facilities. The general approach followed in developing these ground motions using either deterministic or probabilistic criteria is specification of motions for rock outcrop or very firm soil conditions followed by adjustments for site-specific conditions. Central issues in this process include development of appropriate attenuation relations and their uncertainties, differences in expected motions between Western and Eastern North America, and incorporation of site-specific adjustments that maintain the same hazard level as the control motions, while incorporating uncertainties in local dynamic material properties. For tectonically active regions, such as the Western United States (WUS), sufficient strong motion data exist to constrain empirical attenuation relations for M up to about 7 and for distances greater than about 10–15 km. Motions for larger magnitudes and closer distances are largely driven by extrapolations of empirical relations and uncertainties need to be substantially increased for these cases.

For the Eastern United States (CEUS), due to the paucity of strong motion data for cratonic regions worldwide, estimation of strong ground motions for engineering design is based entirely on calibrated models. The models are usually calibrated and validated in the WUS where sufficient strong motion data are available and then recalibrated for applications to the CEUS. Recalibration generally entails revising parameters based on available CEUS ground motion data as well as indirect inferences through intensity observations. Known differences in model parameters such as crustal structure between WUS and CEUS are generally accommodated as well. These procedures are examined and discussed.     

Geographies of Displacement: The Karenni and The Shan Across The Myanmar-Thailand Border

First, central to our analysis is the argument that human movement within and across borders fundamentally challenges the view of geopolitics based upon fixed territorial states, inter-state relations, national identities and citizenship; indeed the whole idea of "national geographic". Using the examples of the Karen and Shan peoples, we explore the processes and patterns of forced relocation, displacement and migration in the border regions of Myanmar and Thailand. Our main concern is with forced displacement as a result of political and ethnic conflict; specifically, how the Burmese military regime's desire for "national unity" within Myanmar's "national space" has influenced the militarily inspired displacements of hundreds of thousands of villagers and civilians within the border zones inhabited mostly by so-called "national minorities". We examine the particular problems of the so-called "internally displaced persons" within "national" boundaries compared with the "refugees" and "undocumented migrants" who make it across "international" space into Thailand. We illustrate the ways displaced people are represented by state agencies and the media as "threats" and "transgressors". We consider some of the "long term" aspects of the displacement problem along the Myanmar-Thai border and the vital contribution geographers can make to the study of displacement.     

High spatial resolution hyperspectral mapping of in-stream habitats, depths, and woody debris in mountain streams

This article evaluates the potential of 1-m resolution, 128-band hyperspectral imagery for mapping in-stream habitats, depths, and woody debris in third- to fifth-order streams in the northern Yellowstone region. Maximum likelihood supervised classification using principal component images provided overall classification accuracies for in-stream habitats (glides, riffles, pools, and eddy drop zones) ranging from 69% for third-order streams to 86% for fifth-order streams. This scale dependency of classification accuracy was probably driven by the greater proportion of transitional boundary areas in the smaller streams. Multiple regressions of measured depths (y) versus principal component scores (x₁, x₂,…, x_n) generated R² values ranging from 67% for high-gradient riffles to 99% for glides in a fifth-order reach. R² values were lower in third-order reaches, ranging from 28% for runs and glides to 94% for pools. The less accurate depth estimates obtained for smaller streams probably resulted from the relative increase in the number of mixed pixels, where a wide range of depths and surface turbulence occurred within a single pixel. Matched filter (MF) mapping of woody debris generated overall accuracies of 83% in the fifth-order Lamar River. Accuracy figures for the in-stream habitat and wood mapping may have been misleadingly low because the fine-resolution imagery captured fine-scale variations not mapped by field teams, which in turn generated false “misclassifications” when the image and field maps were compared.The use of high spatial resolution hyperspectral (HSRH) imagery for stream mapping is limited by the need for clear water to measure depth, by any tree cover obscuring the stream, and by the limited availability of airborne hyperspectral sensors. Nonetheless, the high accuracies achieved in northern Yellowstone streams indicate that HSRH imagery can be a powerful tool for watershed-wide mapping, monitoring, and modeling of streams.     

The stability of a remediated bed in Hamilton Harbour,Lake Ontario,Canada

ABSTRACT In situ measurements of lakebed sediment erodibility were made on three sites in Hamilton Harbour, Lake Ontario, using the benthic flume Sea Carousel. Three methods of estimating the surface erosion threshold (τ_c(0)) from a Carousel time series were evaluated: the first method fits measures of bed strength to eroded depth (the failure envelope) and evaluates threshold as the surface intercept; the second method regresses mean erosion rate (E_m) with bed shear stress and solves for the floc erosion rate (E_f) to derive the threshold for E_m = E_f = 1 × 10^?5 kg m^?2 s^?1; the third method extrapolates a regression of suspended sediment concentration (S) and fluid transmitted bed shear stress (τ₀) to ambient concentrations. The first field site was undisturbed (C) and acted as a control; the second (W) was disturbed through ploughing and water injection as part of lakebed treatment, whereas the third site (OIP) was disturbed and injected with an oxidant used for remediation of contaminated sediment. The main objectives of this study were: (1) to evaluate the three different methods of deriving erosion threshold; (2) to compare the physical behaviour of lacustrine sediments with their marine estuarine counterparts; and (3) to examine the effects of ploughing and chemical treatment of contaminated sediment on bed stability. Five deployments of Sea Carousel were carried out at the control site. Mean erosion thresholds for the three methods were: τ_c(0) = 0·5 (±0·06), 0·27 (±0·01) and 0·34 (±0·03) Pa respectively. Method 1 overpredicted bed strength as it was insensitive to effects in the surface 1–2 mm, and the fit of the failure envelope was also highly subjective. Method 2 exhibited a wide scatter in the data (low correlation coefficients), and definition of the baseline erosion rate (E_f) is largely arbitrary in the literature. Method 3 yielded stable (high correlation coefficients), reproducible and objective results and is thus recommended for evaluation of the erosion threshold. The results of this method correlated well with sediment bulk density and followed the same trend as marine counterparts from widely varying sites. Mass settling rates, expressed as a decay constant, k, of S(t), were strongly related to the maximum turbidity at the onset of settling (S_max) and were also in continuity with marine counterparts. Thus, it appears that differences in salinity had little effect on mass settling rates in the examples presented, and that biological activity dominated any effects normally attributable to changes in salinity. Bedload transport of eroded aggregates (2–4 mm in diameter) took place by rolling below a mean tangential flow velocity (U_y) of 0·32 ms^?1 and by saltation at higher velocities. Mass transport as bedload was a maximum at U_y = 0·4 ms^?1, although bedload never exceeded 1% of the suspended load. The proportion of material moving as bedload was greatest at the onset of erosion but decreased as flow competence increased. Given the low bulk density and strength of the lakebed sediment, the presence of a bedload component is notable. Bedload transport over eroding cohesive substrates should be greater in estuaries, where both sediment density and strength are usually higher. Significant differences between the ploughed and control sites were apparent in both the erosion rate and the friction coefficient (φ), and suggest that bed recovery after disruption is rapid (< 24 h). τ_c(0) increased linearly with time after ploughing and recovered to the control mean value within 3 days. The friction coefficient was reduced to zero by ploughing (diagnostic of fluidization), but increased linearly with time, regaining control values within 6 days. No long‐term reduction in bed strength due to remediation was apparent.     

Petrogenesis of the Greenhills Complex,Southland, New Zealand: magmatic differentiation and cumulate formation at the roots of a Permian island-arc volcano

A Permian (~265 Ma) intrusive complex which formed as a magmatic feeder reservoir to an immature island-arc volcano is fortuitously exposed in southern New Zealand. Known as the Greenhills Complex, this intrusion was emplaced at shallow crustal levels and consists of two layered bodies which were later intruded by a variety of dykes. Cumulates, which include dunite, olivine clinopyroxenite, olivine gabbro, and hornblende gabbro-norite, are related products of parent-magma fractionation. Both primary (magmatic) and secondary platinum-group minerals occur within dunite at one locality. Using the composition of cumulus minerals, mafic dykes and melt inclusions, we have determined that the parent magmas of the complex were hydrous, low-K island-arc tholeiites of ankaramitic affinities. Progressive magmatic differentiation of this parent magma generated fractionated melt of high-alumina basalt composition which is now preserved only as dykes which cut the Complex. Field evidence and cumulus mineral profiles reveal that the magma chambers experienced turbulent magmatic conditions during cumulate-rock formation. Recharge of the chambers by primitive magma is likely to have coincided with eruption of residual melt at the surface. Similar processes are inferred to account for volcanic-rock compositions in other parts of this arc terrane and in modern island-arc systems.