An irregular wave generating approach based on naoe-FOAM-SJTU solver

In this paper, a wave generating approach for long-crest irregular waves in a numerical tank by our in-house solver naoe-FOAM-SJTU is presented. The naoe-FOAM-SJTU solver is developed using an open source tool kit, OpenFOAM. Reynolds-averaged Navier-Stokes (RANS) equations are chosen as governing equations and the volume of fluid (VOF) is employed to capture the two phases interface. Incoming wave group is generated by imposing the boundary conditions of the tank inlet. A spectrum based correction procedure is developed to make the measured spectrum approaching to the target spectrum. This procedure can automatically adjust the wave generation signal based on the measured wave elevation by wave height probe in numerical wave tank. After 3 to 4 iterations, the measured spectrum agrees well with the target one. In order to validate this method, several wave spectra are chosen and validated in the numerical wave tank, with comparison between the final measured and target spectra. In order to investigate a practical situation, a modified Wigley hull is placed in the wave tank with incoming irregular waves. The wave-induced heave and pitch motions are treated by Fourier analysis to obtain motion responses, showing good agreements with the measurements.     

基于加密降水资料的贵州地质灾害概率预报模型

运用信息量法进行了地质灾害易发性评价,将全省划分为3个易发等级。利用贵州省2009—2014年的地质灾害和降水数据,分析了每个等级中地质灾害概率与有效降水量之间的关系。在此基础上,利用概率论方法将动态临界雨量引入预报模型,建立了基于动态临界雨量的地质灾害概率预报模型。结果表明:对于任意的易发区划等级,诱发地质灾害的临界雨量并不是静态的,而是分布在一个非常大的区间上;当有效降水量为该区间上一个特定的值时,用相应的概率来描述地质灾害发生可能性的大小,而不是地质灾害一定发生更为恰当;在2015年的检验中,模型预报准确率超过80%,说明该概率预报方法具有实际应用价值,能起到良好的预报预警作用。     

ZQZ Ⅱ1型自动气象站采集器故障检修方法

针对几年来湖北省ZQZ-Ⅱ1型自动气象站采集器出现的故障及修复情况,分别介绍了采集器电源、面板、主板等部位的故障检修,着重介绍了自然损坏及雷击损坏的检修方法。根据实际电路绘制了电源部分的原理图及各传感器与采集器主板芯片连接框图,按图检修就能很快找到故障部位。并提供了在没有专业工具的情况下,如何拆卸多层电路板芯片的方法。通过几例检修实例,进一步分析说明故障原因及检修方法。对于为什么从风杆引入的雷击会造成主板芯片大面积损坏的原因作了分析判断并提出了改进的方法。     

Prediction of pore-water pressure response to rainfall using support vector regression

Nonlinear complex behavior of pore-water pressure responses to rainfall was modelled using support vector regression (SVR). Pore-water pressure can rise to disturbing levels that may result in slope failure during or after rainfall. Traditionally, monitoring slope pore-water pressure responses to rainfall is tedious and expensive, in that the slope must be instrumented with necessary monitors. Data on rainfall and corresponding responses of pore-water pressure were collected from such a monitoring program at a slope site in Malaysia and used to develop SVR models to predict pore-water pressure fluctuations. Three models, based on their different input configurations, were developed. SVR optimum meta-parameters were obtained using k-fold cross validation and a grid search. Model type 3 was adjudged the best among the models and was used to predict three other points on the slope. For each point, lag intervals of 30 min, 1 h and 2 h were used to make the predictions. The SVR model predictions were compared with predictions made by an artificial neural network model; overall, the SVR model showed slightly better results. Uncertainty quantification analysis was also performed for further model assessment. The uncertainty components were found to be low and tolerable, with d-factor of 0.14 and 74 % of observed data falling within the 95 % confidence bound. The study demonstrated that the SVR model is effective in providing an accurate and quick means of obtaining pore-water pressure response, which may be vital in systems where response information is urgently needed.     

黔中地区震旦系洋水组地球化学特征及其对古海洋环境的指示*

为重建黔中地区震旦纪陡山沱期古海洋环境,选取小河磷矿(XH)、息烽磷矿(XF)含磷岩系剖面,通过系统采样及岩矿鉴定、扫描电镜、微量元素和稀土元素分析,揭示古海洋环境对磷块岩沉积的影响作用。结果表明,磷矿成矿受黔中古陆长期剥蚀夷平形成的无障壁海岸海滩环境控制。陡山沱期洋水组磷块岩Sr/Ba值一般大于1,均值分别为1.90(XH)和0.95(XF),而澄江组沉积物Sr/Ba值均小于1,均值分别为0.11(XH)和0.18(XF),说明沉积环境由澄江期的湖泊相转变为陡山沱期的海相。小河剖面V/Cr和Ni/Co均值分别为1.77和2.17,息烽剖面V/Cr和Ni/Co均值分别为1.26和2.83,均位于弱氧化—氧化区间。息烽磷矿磷块岩δCe为0.75~0.95,均值0.85,小河磷矿磷块岩δCe为0.74~1.09,均值0.88,Ce负异常由底部至顶部逐渐增大,显示沉积环境由次氧化—氧化的转变。这种氧化转变不仅造成了浅水富磷海岸大洋生产力的提升,进一步促使与生物作用相关的磷块岩沉积,同时造成的生命演化也改变了大洋含氧结构,因此成磷环境的氧化转变是对新元古代氧化事件与生命演化的响应。     

用隔绝法对极干旱区土壤水分来源的分析

 通常认为极干旱区土壤水分来源于降水、大气或凝结水,深埋区不存在潜水蒸发。然而通过使用拱棚法初步证明在极干旱深埋区存在潜水蒸发,而潜水是土壤水分的重要来源。为了进一步求证土壤水分来源,开挖200 cm×200 cm×200 cm的土坑,完全隔绝与下层土壤及四周的水分联系,回填后监测土壤10、30、50、100、150 cm的空气温湿度;同时设置与四周隔绝但底面联通的对照坑。27 d后都模拟25 mm降雨。监测发现模拟降雨前联通土壤的水分含量、空气相对湿度、绝对湿度都明显高于隔绝土壤。1 a后远离降雨时土壤水分的检测发现隔绝土壤水分含量低于联通对照,但因隔绝土壤处于潜水蒸发漫溢的相同气象环境,其湿度不会无限下降。隔绝对比实验反演证明深埋极干旱区存在潜水蒸发。     

福建浅海潮流沙脊分布及形态特征

福建浅海海砂资源丰富,沿海岸线分布广且资源量大,主要以潮流沙脊为主。对潮流沙脊的形态和分布特征进行研究,有利于海砂资源的勘查开发以及对资源量进行合理评价。基于福建海域多波束全覆盖资料,利用ArcGIS的ArcMap对多波束资料进行配准和数据化,对区内潮流沙脊的形态特征进行初步分析。结果显示,福建浅海潮流沙脊形态上长宽分别在2.8～31.3、1.9～12.3 km之间,面积在3.7～200.9 km2之间;分布上由北往南、自西向东,走向由东西向变为北东—南西向,沙脊发育规模逐渐增大且沙质变好,近岸以粉沙为主,远岸以沙为主。对比沙脊主体长与宽,将福建浅海潮流沙脊划分为A型（长度＞10 km,宽度＞5 km）、B型（长度＞10 km,宽度＜5 km）和C型（长度＜5 km,宽度＜5 km）3种类型。综合福建浅海潮流沙脊分布及形态特征,海砂资源勘查时可优选南部远岸区域。     

济阳坳陷富林洼陷中生界复杂岩性风化壳储集层成岩作用*

风化壳储集层成因及其差异性特征分析是当今储层地质学研究热点。渤海湾盆地济阳坳陷沾化凹陷富林洼陷中生界油气勘探遇到瓶颈,目前探井仅钻揭白垩系顶部风化壳,且风化壳储集层岩性复杂、非均质性极强,明确风化壳储集层成岩改造、储集空间类型和组合关系,对本区乃至济阳坳陷中生界潜山油气勘探至关重要。通过岩心和薄片观察,结合录井、测井等资料,对富林洼陷白垩系西洼组复杂岩性风化壳储集层开展研究。结果表明: 风化壳岩性主要为安山岩和凝灰岩,其次为脉岩、隐爆角砾岩和砂砾岩。由于不同构造单元在复杂埋藏过程中经历了“洼—隆—隆”或“洼—隆—洼”的演化过程,不同岩性储集层的成岩序列和孔隙演化差异明显。火成岩和碎屑岩原生孔隙类型和成因明显不同,但现今储集空间均以次生孔隙特别是溶蚀孔为主,被溶蚀物质包括斑晶、基质以及火山岩屑等。溶蚀作用的主导流体多变,继抬升暴露过程中富含CO₂的大气淡水之后,有机质成熟时排出的有机酸对储集层改善有积极作用。有利风化壳储集层的形成受到岩性、埋藏演化过程和成岩流体的共同控制。整体上,富林洼陷白垩系西洼组储集层质量由好到次的顺序为: 凝灰质砂砾岩,火山角砾岩,含残余气孔安山岩,凝灰岩,次火山岩;不同岩性风化壳储集层在复杂埋藏过程中,经历了不同的成岩改造。