AHP及模糊综合评判法在路基长期稳定性评价中的应用

根据对一低液限粉土路基的现场工程地质调查及检测,确定了影响该路基长期稳定性的主要影响因素,并结合AHP法,应用两级模糊综合评判的方法对该路基的长期稳定性进行了评价。     

北京石花洞地区奥陶纪灰岩36Cl侵蚀速率初探

本文根据理论上灰岩中36Cl的5个来源，论述了36Cl在灰岩深度剖面上的4个分布特征，描述了36Cl的采样方法和AMS的分析技术。计算出北京石花洞地区奥陶纪（O2）灰岩的表面侵蚀速度（ε=17.40μm/a）。     

含钒金红石可见光下催化降解亚甲基蓝实验研究

利用含有钒等杂质的金红石可部分吸收可见光的特性,以500 W卤素灯作为光源,实验研究了其对亚甲基蓝的可见光催化降解,结果表明,该金红石具有催化活性,7 h后亚甲基蓝可降解71 2%。经过加热、粉碎改性方法处理后的金红石光催化活性明显提高,加热1 100 ℃的金红石样品7 h后可使亚甲基蓝的降解率达到90 4%。增加光照强度、加入适当的H2O2 都可提高降解效果。实验为充分开发利用天然金红石提出了新的途径,为环境污染治理提出了新方法。     

钻孔灌注桩后压浆作用机理与应用

通过对桩侧和桩底后压浆,可大幅度提高钻孔灌注桩单桩承载力.应用桩-土理论分析了后压浆中浆液对土体及桩体的作用,并从分析影响桩基承载力的因素出发,研究了后压浆的作用机理.在渗透率小的地层中后压浆以压密注浆为主,在渗透率大的地层中后压浆以渗透注浆为主.为避免过分压裂土层,在压浆过程中应控制灌浆压力.压浆量是影响后压浆质量和提高单桩承载力的关键因素之一.     

Polymorphic phase transition in Superhydrous Phase B

We synthesized superhydrous phase B (shy-B) at 22 GPa and two different temperatures: 1200°C (LT) and 1400°C (HT) using a multi-anvil apparatus. The samples were investigated by transmission electron microscopy (TEM), single crystal X-ray diffraction, Raman and IR spectroscopy. The IR spectra were collected on polycrystalline thin-films and single crystals using synchrotron radiation, as well as a conventional IR source at ambient conditions and in situ at various pressures (up to 15 GPa) and temperatures (down to −180°C). Our studies show that shy-B exists in two polymorphic forms. As expected from crystal chemistry, the LT polymorph crystallizes in a lower symmetry space group (Pnn2), whereas the HT polymorph assumes a higher symmetry space group (Pnnm). TEM shows that both modifications consist of nearly perfect crystals with almost no lattice defects or inclusions of additional phases. IR spectra taken on polycrystalline thin films exhibit just one symmetric OH band and 29 lattice modes for the HT polymorph in contrast to two intense but asymmetric OH stretching bands and at least 48 lattice modes for the LT sample. The IR spectra differ not only in the number of bands, but also in the response of the bands to changes in pressure. The pressure derivatives for the IR bands are higher for the HT polymorph indicating that the high symmetry form is more compressible than the low symmetry form. Polarized, low-temperature single-crystal IR spectra indicate that in the LT-polymorph extensive ordering occurs not only at the Mg sites but also at the hydrogen sites.     

Kimberlite petrogenesis: Insights from clinopyroxene-melt partitioning experiments at 6 GPa in the CaO-MgO-Al2O3-SiO2-CO2 system

In this experimental study, we examine the mineral-melt partitioning of major and trace elements between clinopyroxene and CO₂-rich kimberlitic melts at a pressure of 6 GPa and temperatures of 1410°C and 1430°C. The melts produced contain ∼ 28 wt% dissolved CO₂, and are saturated with olivine and clinopyroxene. To assess the effects of temperature, crystal and melt compositions on trace element partitioning, experiments were performed in the model CaO-MgO-Al₂O₃-SiO₂-CO₂ system. Our results reveal that all the elements studied, except Al, Mg, Si, and Ga, are incompatible in clinopyroxene. Partition coefficients show a considerable range in magnitude, from ∼ 10⁻³ for D_U and D_Ba to ∼ 2.5 for D_Si. The two experimental runs show similar overall partitioning patterns with the D values being lower at 1430°C. Rare earth elements display a wide range of partition coefficients, D_La (0.012-0.026) being approximately one order of magnitude lower than D_Lu (0.18-0.23). Partition coefficients for the 2+ and 3+ cations entering the M2-site exhibit a near-parabolic dependence on radius of the incorporated cations as predicted from the lattice strain model. This underlines the contribution made by the crystal structure toward controlling the distribution of trace elements. Using data obtained in this study combined with that in the published literature, we also discuss the effects that other important parameters, namely, melt composition, pressure, and temperature, could have on partitioning.Our partition coefficients have been used to model the generation of the Group I (GI) kimberlites from South Africa. The numerical modeling shows that kimberlitic melts can be produced by ∼0.5% melting of a MORB-type depleted source that has been enriched by small-degree melts originating from a similar depleted source. This result suggests that the source of GI kimberlites may be located at the lithosphere-asthenosphere transition. Percolation of small degree melts from the asthenosphere would essentially create a metasomatic horizon near the bottom of the non-convecting sublithospheric mantle. Accumulation of such small degree melts together with the presence of volatiles and conductive heating would trigger melting of the ambient mantle and subsequently lead to eruption of kimberlitic melts. Additionally, our model shows that the GI source can be generated by metasomatism of a 2 Ga old MORB source ca. 1 Ga ago. Assuming that MORB-type mantle is the most depleted source of magmas on earth, then this is the oldest age at which the GI source could have existed. However, this age most likely reflects the average age of a series of metasomatic events than that of a single event.     

Soil property variation mapping through data mining of soil category maps

Spatial information on soil properties is an important input to hydrological models. In current hydrological modelling practices, soil property information is often derived from soil category maps by the linking method in which a representative soil property value is linked to each soil polygon. Limited by the area‐class nature of soil category maps, the derived soil property variation is discontinuous and less detailed than high resolution digital terrain or remote sensing data. This research proposed dmSoil, a data‐mining‐based approach to derive continuous and spatially detailed soil property information from soil category maps. First, the soil–environment relationships are extracted through data mining of a soil map. The similarity of the soil at each location to different soil types in the soil map is then estimated using the mined relationships. Prediction of soil property values at each location is made by combining the similarities of the soil at that location to different soil types and the representative soil property values of these soil types. The new approach was applied in the Raffelson Watershed and Pleasant Valley in the Driftless Area of Wisconsin, United States to map soil A horizon texture (in both areas) and depth to soil C horizon (in Pleasant Valley). The property maps from the dmSoil approach capture the spatial gradation and details of soil properties better than those from the linking method. The new approach also shows consistent accuracy improvement at validation points. In addition to the improved performances, the inputs for the dmSoil approach are easy to prepare, and the approach itself is simple to deploy. It provides an effective way to derive better soil property information from soil category maps for hydrological modelling. Copyright © 2014 John Wiley & Sons, Ltd.     

Box-Behnken设计-效应面法优选百合防褐变加工工艺研究

目的：优选百合防褐变的加工工艺。方法：在单因素试验基础上,以王百合苷B含量、褐变度、浸出物为评价指标,采用Box-Behnken设计效应面法考察烫片时间、干燥温度、干燥时间对其质量的影响,优选百合的防褐变加工工艺参数。结果:百合防褐变加工工艺为烫片时间3.5 min,干燥温度90℃,干燥时间3.0 h。结论：优选的百合防褐变加工工艺合理可行,可适用于工业生产。     

海域使用权属数据质量控制系统设计

海域使用权属数据是海域使用科学研究和海域综合管理决策制定的重要依据。文章分析了海域使用权属数据质量控制的现状,研究了海域使用权属问题数据质量控制的判别方法。设计了计算机与人工校验相结合的数据质量控制系统,实现海域使用权属数据系统化的质量控制和管理,为海域使用统计和海域使用管理决策支持提供参考。