Multi-Wavelength Signatures of Magnetic Reconnection of a Flare-Associated Coronal Mass Ejection

The evolution of an X2.7 solar flare, that occurred in a complex β γ δ magnetic configuration region on 3 November 2003 is discussed by utilizing a multi-wavelength data set. The very first signature of pre-flare coronal activity is observed in radio wavelengths as a type III burst that occurred several minutes prior to the flare signature in Hα. This type III burst is followed by the appearance of a loop-top source in hard X-ray (HXR) images obtained from RHESSI. During the main phase of the event, Hα images observed from ARIES solar tower telescope, Nainital, reveal well-defined footpoint (FP) and loop-top (LT) sources. As the flare evolves, the LT source moves upward and the separation between the two FP sources increases. The co-alignment of Hα with HXR images shows spatial correlation between Hα and HXR footpoints, whereas the rising LT source in HXR is always located above the LT source seen in Hα. The evolution of LT and FP sources is consistent with the reconnection models of solar flares. The EUV images at 195 Å taken by SOHO/EIT reveal intense emission on the disk at the flaring region during the impulsive phase. Further, slow-drifting type IV bursts, observed at low coronal heights at two time intervals along the flare period, indicate rising plasmoids or loop systems. The intense type II radio burst at a time in between these type IV bursts, but at a relatively greater height, indicates the onset of CME and its associated coronal shock wave. The study supports the standard CSHKP model of flares, which is consistent with nearly all eruptive flare models. More importantly, the results also contain evidence for breakout reconnection before the flare phase.     

The last glaciation of the Arctic volcanic island Jan Mayen

The volcanic island of Jan Mayen, remotely located in the Norwegian-Greenland Sea, was covered by a contiguous ice cap during the Late Weichselian. Until now, it has been disputed whether parts of the island south of the presently glaciated Mount Beerenberg area were ever glaciated. Based on extensive field mapping we demonstrate that an ice cap covered all land areas and likely also extended onto the shallow shelf areas southeast and east of the island. Chronological interpretations are based on K-Ar and ⁴⁰Ar/³⁹Ar dating of volcanic rocks, cosmogenic nuclide (³⁶Cl) surface exposure dating of bedrock and glacial erratics, and radiocarbon dating. We argue that ice growth started after 34 ka and that an initial deglaciation started some 21.5–19.5 ka in the southern and middle parts of the island. In the northern parts, closer to the present glaciers, the deglaciation might have started later, as evidenced by the establishment of vegetation 17–16 cal. ka BP. During full glaciation, the ice cap was likely thickest over the southern part of the island. This may explain a seemingly delayed deglaciation compared with the northern parts despite earlier initial deglaciation. In a broader context, the new knowledge of the Late Weichselian of the island contributes to the understanding of glaciations surrounding the North Atlantic and its climate history.     

The first MEMIN shock recovery experiments at low shock pressure (5–12.5 GPa) with dry,porous sandstone

Abstract– As part of the MEMIN research program this project is focused on shock deformation experimentally generated in dry, porous Seeberger sandstone in the low shock pressure range from 5 to 12.5 GPa. Special attention is paid to the influence of porosity on progressive shock metamorphism. Shock recovery experiments were carried out with a high‐explosive set‐up that generates a planar shock wave, and using the shock impedance method. Cylinders of sandstone of average grain size of 0.17 mm and porosity of about 19 vol%, and containing some 96 wt% SiO₂, were shock deformed. Shock effects induced with increasing shock pressure include: (1) Already at 5 GPa the entire pore space is closed; quartz grains show undulatory extinction. On average, 134 fractures per mm are observed. Dark vesicular melt (glass) of the composition of the montmorillonitic phyllosilicate component of this sandstone occurs at an average amount of 1.6 vol%. (2) At 7.5 GPa, quartz grains show weak but prominent mosaicism and the number of fractures increases to 171 per millimeter. Two additional kinds of melt, both based on phyllosilicate precursor, could be observed: a light colored, vesicular melt and a melt containing large iron particles. The total amount of melt (all types) increased in this experiment to 2.4 vol%. Raman spectroscopy confirmed the presence of shock‐deformed quartz grains near the surface. (3) At 10 and 12.5 GPa, quartz grains also show weak but prominent mosaicism, the number of fractures per mm has reached a plateau value of approximately 200, and the total amount of the different melt types has increased to 4.8 vol%. Diaplectic quartz glass could be observed locally near the impacted surface. In addition, local shock effects, most likely caused by multiple shock wave reflections at sandstone‐container interfaces, occur throughout the sample cylinders and include locally enhanced formation of PDF, as well as shear zones associated with cataclastic microbreccia, diaplectic quartz glass, and SiO₂ melt. Overall findings from these first experiments have demonstrated that characteristic shock effects diagnostic for the confirmation of impact structures and suitable for shock pressure calibration are rare. So far, they are restricted to the limited formation of PDF and diaplectic quartz glass at shock pressures of 10 GPa and above.     

Experimental observation of strong mixing due to internal wave focusing over sloping terrain

This paper reports on experimental observation of internal waves that are focused due to a sloping topography. A remarkable mixing of the density field was observed. This result is of importance for the deep ocean, where internal waves are believed to play a role in mixing. The experiments were performed on the rotating platform at the Coriolis Laboratory, Grenoble. The rotation, its modulation and density stratification were set to be in the internal wave regime. After applying various data processing techniques we observe internal wave rays, which converge to a limiting state: the wave attractor. At longer time scales we observe a remarkably efficient mixing of the density field, possibly responsible for driving observed sheared mean flows and topographic Rossby waves. We offer the hypothesis that focusing of internal waves to the wave attractor leads to the mixing.     

Polychlorinated biphenyls (PCB) and organochlorine pesticides in sediments of the baltic and coastal waters of Mecklenburg-Vorpommern

Summary The distribution of polychlorinated biphenyls (PCB) and organochlorine pesticides, e.g. the isomers of hexachlorocyclohexane (HCH), hexachlorobenzene (HCB), p,p’-dichiorodiphenyitrichloroethane (DDT) and its primary metabolites DDE and DDD was investigated in surface sediments (0–2 cm) and sediment cores (0–45 cm) from the western Baltic Sea and the coastal waters of Mecklenburg-Vorpommern. Sediment sampling was carried out in the Belt Sea, the Arkona Basin, the Pomeranian Bight and in almost all Bodden and Haff areas of Mecklenburg-Vorpommern in autumn 1993 and 1994. The highest concentrations of PCB and DDT compounds, measured in the innercoastal waters, reached 214 ng g^-1 dry weight (d. w.). The values of HCH isomers ranged between 0.01 and 2.9 ng g^-1 d.w., the highest levels being those of Β-HCH. Levels of chlorinated hydrocarbons, which varied depending on the sediment properties, indicated increased riverine inputs (Oder, Peene, and Uecker). Elevated levels in the Oderhaff and Peenestrom characterize that area as a sink and, due to remobilization of the upper sediment layer (fluffy layer) into the pelagic, also as a source of organic contaminants. Input from agriculture and industrial point sources (shipyards, shipbuilding) was observed in the coastal waters. The homogeneous PCB and DDT distribution (TOC standardization) observed in the surface sediments of some areas in the western Baltic indicates high sediment dynamics. This is supported by the results of sediment core analyses which showed a constant PCB and DDT distribution down to a depth of 15 to 20 cm.

---

Polychlorierte Biphenyle (PCB) und Organochlorpestizide im Sediment der Ostsee und der Küsten-gew?sser Mecklenburg-Vorpommerns

Zusammenfassung Die Verteilungen von polychlorierten Biphenylen (PCB) und Organochlorpestiziden (DDT, HCH und HCB) wurden in Oberfl?chensedimenten (0–2 cm) und in Sedimentkernen (0–45 cm) der westlichen Ostsee und der Küstengew?sser Mecklenburg-Vorpommerns untersucht. Die Sedimentprobenahme erfolgte in der Beltsee, der Arkonasee, der Pommerschen Bucht und in nahezu allen Bodden-und Haffgew?ssern Mecklenburg-Vorpommerns im Herbst 1994 und 1995. Die h?chsten Konzentrationen wurden für die PCB-und DDT-Verbindungen bis 214 ng g^-1 Trockenmasse (TM) in den Küstengew?ssern gemessen. Für die HCH-Isomeren lagen die Werte zwischen 0,01 und 2,9 ng g^-1 TM, mit h?chsten Konzentrationen für das Β-HCH. Die Werte der chlorierten Kohlenwasserstoffe (CKW) variieren nach der Sedimentbeschaffenheit und weisen auf erh?hte Eintr?ge über die Flu\systeme (Oder und Peene) hin. Die h?heren Konzentrationen in den Bodden-und Haffgew?ssern charakterisieren diese Gebiete als Senke und durch erneute Mobilisierung der oberen Sedimentschicht in das Pelagial auch als Quelle für die organischen Schadstoffe. Insbesondere konnten die Eintr?ge aus der Landwirtschaft und aus industriellen Punktquellen (Werftstandorte, Schiffbau) in den Küstengew?ssern festgestellt werden. Die nahezu homogene PCB-und DDT-Verteilung im Oberfl?chensediment der westlichen Ostsee ist ein Hinweis auf die hohe Sedimentdynamik in diesem Gebiet. Dieses wird durch die Ergebnisse der Untersuchungen an Sedimentkernen unterstützt, die eine konstante PCB-und DDT-Verteilung bis zu einer Tiefe von 15 bis 20 cm zeigten.

     

Recent environmental changes in a naturally acidic rocky lake in southern Finland, as reflected in its sediment geochemistry and biostratigraphy

Paleolimnological methods are combined with statistical multivariate analyses (PCA and CCA) to study the effects of local environmental disturbances and changes in loading of atmospheric origin on water acidity and the physiochemical properties of the sediment in a small, naturally acidic rocky lake in southern Finland. The pH of the lake as calculated from the diatom flora increased by 0.9 pH units as a consequence of a forest fire in the catchment area at the turn of the last century, and the changes in the diatom assemblages point to an increase in dys(eu)trophy and turbulence. In terms of element influx (in µg cm^-2 yr^-1), the effects of the fire are seen in a slight increase in the accumulation of lithophilous elements. Diatom-inferred pH values decline upwards in the sediment, but do not regain the level recorded before the fire. This is attributed to reactions between Fe³⁺ and S, which has partly accumulated from the air as SO^2-, producing internal alkalinity. Accumulation rates of many elements increase markedly after the 1960s, an effect for Al, Mg, Na, P and Zn may be connected mainly with the enhanced accumulation of dry matter, whereas the accumulation of K, Ni, Pb, Ti and V in surface sediment are obviously related to atmospheric loading. Measured accumulation rates of Cd and Cu are lower than the calculated values especially in the surface sediment, possibly because of diagenetic changes. Accumulation of Ca and Mn decreases towards the surface on account of acidification of anthropogenic origin.     

Acceleration Phase of Coronal Mass Ejections: I. Temporal and Spatial Scales

We study kinematics of 22 coronal mass ejections (CMEs) whose motion was traced from the gradual pre-acceleration phase up to the post-acceleration stage. The peak accelerations in the studied sample range from 40, up to 7000 m s⁻², and are inversely proportional to the acceleration phase duration and the height range involved. Accelerations and velocities are, on average, larger in CMEs launched from a compact source region. The acceleration phase duration is proportional to the source region dimensions; i.e., compact CMEs are accelerated more impulsively. Such behavior is interpreted as a consequence of stronger Lorentz force and shorter Alfvén time scales involved in compact CMEs (with stronger magnetic field and larger Alfvén speed being involved at lower heights). CMEs with larger accelerations and velocities are on average wider, whereas the widths are not related to the source region dimensions. Such behavior is explained in terms of the field pile-up ahead of the erupting structure, which is more effective in the case of a strongly accelerated structure.     

Demographic and environmental conditions are uncoupled in the social–ecological system of the Pribilof Islands

Since the end of the commercial fur seal hunt in 1984, the economy of the Pribilof Islands, Alaska, has lacked a stable, lasting basis. As a contribution to the effort to understand and promote the effective management of the Pribilof Islands as a social–ecological system, we examined current and recent conditions on the islands to assess local perceptions of, and prospects for, economic, social and environmental well-being. We found few correlations between environmental conditions and socio-economic indicators. The lack of apparent connection between population levels and economic or environmental stimuli is likely attributable to one or more of several factors: (a) modest economic dependence on the environment; (b) predominance of other economic inputs to the economies of the islands; (c) islanders basing residence choices largely on non-economic factors; and (d) the islanders' tolerance for economic fluctuations and uncertainty. These results suggest economic analysis alone is insufficient to explain the dynamics of this social–ecological system, contrary to many other case studies and an expectation of tight coupling and clear connections between society and ecology in the Pribilofs.