On the circulation in the East Frisian Wadden Sea: numerical modeling and data analysis

 In this paper we use a combination of numerical modeling and data analysis to gain a better understanding of the major characteristics of the circulation in the East Frisian Wadden Sea. In particular, we concentrate on the asymmetry of the tidal wave and its modulation in the coastal area, which results in a complex pattern of responses to the sea-level forcing from the North Sea. The numerical simulations are based on the 3-D primitive equation General Estuarine Transport Model (GETM) with a horizontal resolution of 200 m and terrain-following vertical coordinates. The model is forced at its open boundaries with sea-level data from an operational model for the German Bight (German Hydrographic Office). The validation data for our model simulations include time series of tidal gauge data and surface currents measured at a pile in the back-barrier basin of the Island Langeoog, as well as several ADCP transects in the Accumer Ee tidal inlet. Circulation and turbulence characteristics are investigated for typical situations driven by spring and neap tides, and the analysis is focused on dominating temporal and spatial patterns. By investigating the response of five back-barrier basins with rather different morphologies to external forcing, an attempt is made to elucidate the dominating physical balances controlling the circulation in the individual sub-basins. It is demonstrated that the friction at the seabed tends to slow down the tidal signal in the shallow water. This leads to the establishment of flood dominance in the shallow sea north of the barrier islands. South of the islands, where the water volume of the channels at low tide is smaller than the tidal prism, the asymmetry of the tidal signal is shifted towards ebb dominance, a feature which is particularly pronounced at spring tide. At the northern open boundary, the tidal wave propagating from west to east generates a sea-level difference of ∼1 m along the boundary, and thereby triggers vigorous alongshore currents. The frictional control in the model is located in the inlets, as well as along the northern boundary. The correlation between velocity and turbulent kinetic energy tends to the establishment of a net southward transport, giving theoretical support to the observed accumulation of sediments on the intertidal flats. Weak turbulence along the northern shores of the barrier islands and the small magnitude of the residual currents there promote accumulation of suspended matter in these areas, although wave action will generally counteract this effect. Received: 29 May 2002 / Accepted: 26 September 2002 Responsible Editor: Jean-Marie Beckers Acknowledgements We are indebted to S. Dick for providing the data from the operational model of BSH and to B. Flemming for the useful discussions. The topography data and Fig. 1 have been prepared in cooperation with F. Meyer. Figure 2 has been prepared by G. Brink-Spalink. We also thank for the comments from an anonymous reviewer which helped to improve our paper.     

Two and Half Dimensional Simulation of Ridge Effects on the Ground Motion Characteristics

— Seismic responses of weathered and non-weathered ridge models were simulated to study the ridge effects on the ground motion characteristics. The range of ridge slope from 19.98° to 45° was considered to produce a possible set of generalized results. 2.5-D modeling based on parsimonious staggered grid approximation of elastodynamic wave equations was adopted in simulations. Computed results reveal an increase of amplitude of incoming waves with both elevation and the slope of the ridge. Further, the characteristics of surface waves are highly ridge slope dependent. The analysis of responses of weathered and non-weathered ridge models reveals that ridge has caused a strong generation of surface waves near its top. The surface waves are not dominating on the top of the ridge but at some lower elevation. The increase of weathering of ridge further intensified the ridge effect. Analysis in frequency domain, based on spectral ratio method, does not indicate any pattern in the spectral amplification factor and is very much sensitive to slope, source focal mechanism and location. However, on an average there is a continuous decrease of amplification with slope in the vertical component and increase in the transverse component, and it is increasing in the radial component up to slope =38.0° and thereafter decreasing.     

Lateral tidal mixing in the Antarctic marginal seas

Tidal mixing plays an important role in the modification of dense water masses around the Antarctic continent. In addition to the vertical (diapycnal) mixing in the near-bottom layers, lateral mixing can also be of relevance in some areas. A numerical tide simulation shows that lateral tidal mixing is not uniformly distributed along the shelf break. In particular, strong mixing occurs all along the Ross Sea and Southern Weddell Sea shelf breaks, while other regions (e.g., the western Weddell Sea) are relatively quiet. The latter regions correspond surprisingly well to areas where indications for cross-shelf exchange of dense water masses have been found. The results suggest that lateral tidal mixing may account for the relatively small contribution of Ross Sea dense water masses to Antarctic Bottom Water.     

Aseismic negative dislocation model and deformation analysis of crustal horizontal movement during 1999——2001 in the northeast margin of Qinghai-Xizang block

Through numerical simulation for GPS data, aseism/c negative dislocation model for crustal horizontal movement during 1999-2001 in the northeast margin of Qinghai-Xizang block is presented, combined with the spatial distri-bution of apparent strain field in this area, the characteristics of motion and deformation of active blocks and their boundary faults, together with the place and intensity of strain accumulation are analyzed. It is shown that: a) 9 active blocks appeared totally clockwise motion from eastward by north to eastward by south. Obvious sinistral strike-slip and NE-NEE relative compressive motion between the blocks separated by Qilianshan-Haiyuan fault zone was discovered; b) 20 fault segments (most of them showed compression) locked the relative motion between blocks to varying degrees, among the total, the mid-east segment of Qilianshan fault (containing the place where it meets Riyueshan-Lajishan fault) and the place where it meets Haiyuan fault and Zhuanglanghe fault, more favored accumulation of strain. Moreover, the region where Riyueshan-Lajishan fault meets north boundary of Qaidam block may have strain accumulation to some degree, c) Obtained magnitude of block velocities and locking of their boundaries were less than relevant results for observation in the period of 1993-1999.     

Gravity variation before Kunlun mountain pass western Ms=8.1 earthquake

The relation between the gravity variation features and Ms=8.1 earthquake in Qinghai-Xizang monitoring area is analyzed preliminarily,by using spatial dynamic variation results of regional gravity field from absolute gravity and relative gravity observation in 1998 and 2000.The results show that:1)Ms\8.1 earthquake in Kulun mountain pass westem occurred in the gravity variation high gradient near gravity‘s high negative variation;2)The Main tectonic deformation and emnergy accumulation before MS=8.1 earthquake are distributed at south side of the epicenter;3)The range of gravity‘s high negative variation at east of the MS=8.1 earthquake epicenter relatively coincides with that rupture region according to field geology investigation;4)Gravity variation distribution in high negative value region is just consistent with the second shear strain‘s high value region of strain field obtained from GPS observation.     

CDP mapping in tilted transversely isotropic (TTI) media. Part I: Method and effectiveness

Transverse isotropy with a tilted axis of symmetry (TTI) causes image distortion if isotropic models are assumed during data processing. A simple anisotropic migration approach needs long computational times and is sensitive to the signal-to-noise ratio. This paper presents an efficient, general approach to common-depth-point (CDP) mapping to image the subsurface in TTI media from qP-wave seismic data by adding anisotropic and dip parameters to the velocity model. The method consists of three steps: (i) calculating traveltimes and positions of the CDP points; (ii) determining CDP trajectories; (iii) CDP imaging. A crucial step is the rapid computation of traveltimes and raypaths in the TTI media, which is achieved by the Fermat method, specially adapted for anisotropic layered media. The algorithm can image the subsurface of a given model quickly and accurately, and is suitable for application to a bending reflector. The effectiveness of the method is demonstrated by comparing the raypaths, the traveltimes and the results of CDP mapping, when assuming isotropic media, transversely isotropic media with a vertical axis of symmetry (TIV), and TTI media.     

SHRIMP U-Pb zircon age,geochemistry and Nd isotope of the Guandaoshan pluton in SW Sichuan: Petrogenesis and tectonic significance

SHRIMP U-Pb zircon age, geochemical and Nd isotopic data are reported for the Neo-proterozoic Guandaoshan pluton in the Yanbian region, SW Sichuan. This pluton is of typical I-type granite and emplaced at (857 ± 13) Ma. Geochemical and Nd isotopic characters suggest that the pluton was generated by partial melting of pre-existing, young (late Mesoproterozoic to early Neo-proterozoic) low-K tholeiitic protolith within an intraplate anorogenic setting. The Guandaoshan pluton probably records the earliest magmatism induced by the proposed ca. 860–750 Ma mantle superplume beneath the supercontinent Rodinia.     

Relationship between light rare earth deposits and mantle processes in Panxi rift,China

Many light rare earth deposits, such as Maoniuping, Dalucao, Panzhihua deposits, are collectively distributed in Panxi rift of Sichuan Province, China, and closely associated with the aegirine quartz syenite-carbonatite complex. Carbon and oxygen isotope studies demonstrate that the carbonatites in the complex are of typical igneous origin related to mantle processes. Electronic microprobe studies show that the fluid-melt inclusions found in the complex are enriched in light rare earth elements (LREE), which suggests that the magma was rich in LREE and could serve as the ore source for the regional LREE mineralization. Both the aegirine quartz syenite-carbonatite complex and the LREE mineralization found therein were derived from the mantle. The rare gas isotope analyses also support that there is a genetic association between the LREE mineralization and mantle processes.