Toxicity of chromated copper arsenate (CCA)-treated wood to non-target marine fouling communities in Langstone Harbour, Portsmouth, UK

The effect of the anti-marine-borer timber preservative chromated copper arsenate (CCA) (a pressure impregnated solution of copper, chromium and arsenic compounds) on non-target marine fouling animals was investigated during a subtidal exposure trial. Panels of Scots pine treated to target retentions of 12, 24 and 48 kg CCA per m-3 of wood, plus untreated controls were submerged at a coastal site on the south coast of the UK for 6, 12 and 18 months. After each exposure period the fouling communities that formed on the surface of panels were assessed both qualitatively and quantitatively. Community structure was similar on panels treated to the three CCA loadings, but was significantly different from community structure on untreated panels. The total number of species (species richness) was similar on all panels, although the number of individual organisms attached to the surface of panels was significantly higher on CCA-treated panels than on untreated panels. k-dominance curves revealed that the difference in numbers of individuals between CCA-treated and untreated panels was caused by higher numbers of the dominant species (Elminius modestus, Hydroides ezoensis, and Electra pilosa) on CCA-treated panels. Other species were present in similar numbers on panels of all treatments. Results indicate that there are no detrimental toxic effects to epibiota caused by the presence of CCA preservative within the matrix of the wood at any of the treatment levels. Differences in community structure between CCA-treated and untreated panels may be due to enhanced larval settlement on CCA-treated timber by some species as a result of modifications to the surface properties of the timber by the CCA preservative.     

Multivariate analysis of Kenya's urban system

The study analyzes the structure, spatial interaction, and dimension of the post-colonial urban systems of Kenya using component factor analysis and based on selected socio-cultural, economic, and demographic variables. The study identified seven major dimensions of variation accounting for 72.0%. The analysis of the urban spatial variation is compared and intertwined with studies done in other countries to find out the regional variation of the loadings. Finally, a seven-order characteristics of Kenya urban systems is suggested, based on the study. The accurate knowledge of these salient characteristics of Kenya urban sub-systems is important before any viable spatial planning should be implemented.     

Simulations to verify horizontal flow measurements from a borehole flowmeter

This paper reports on experiments and simulations of subsurface flow from a slotted acrylic tube deployed in a sand-tank flow chamber for two different purposes. In the first instance, the slotted tube is used to represent a single fracture intersected by an uncased well. In the second instance, the slotted tube is used to represent a multislot well screen within a porous medium. In both cases, the scanning colloidal borescope flowmeter (SCBFM) measures ground water velocity within the well by imaging colloids traveling through a well to measure their speed and direction. Measurements are compared against model simulations. For the case of a slotted tube representing a single fracture, SCBFM and model results agree with respect to the flow direction and to within a factor of 1.5 for the speed near the well's center. Model and experimental agreement lend confidence that for an uncased well drilled in a fractured-rock medium, a calibrated SCBFM could be used to identify and quantify flowing features. Next, the SCBFM was deployed in a four-column multislotted casing with slots aligned with the flow direction. Another numerical model was developed to estimate the flow field within this well screen to evaluate the potential usefulness of employing the SCBFM in a screened well to estimate flow speed and direction in the surrounding porous medium. Results indicate that if the slots are not aligned with the flow, the SCBFM may only provide order-of-magnitude speed measurements and direction measurements with an uncertainty of approximately +/-25 degrees .     

Differences in the response of a striped dolphin (Stenella coeruleoalba) and a harbour porpoise (Phocoena phocoena) to an acoustic alarm

Small cetacean bycatch in gillnet fisheries may be reduced by deterring odontocetes from nets acoustically. However, different odontocete species may respond differently to acoustic signals from alarms. Therefore, in this study a striped dolphin and a harbour porpoise were subjected simultaneously to sounds produced by the XP-10 experimental acoustic alarm. The alarm produced 0.3s tonal signals randomly selected from a set of 16 with fundamental frequencies between 9 and 15kHz, with a constant pulse interval of 4.0s (duty cycle 8%) and a Source Level range of 133-163dB re 1muPa (rms). The effect of the alarm was judged by comparing the animals' respiration rate and position relative to the alarm during test periods with those during baseline periods. As in a previous study on two porpoises with the same alarm, the porpoise in the present study reacted strongly to the alarm by swimming away from it and increasing his respiration rate. The striped dolphin, however, showed no reaction to the active alarm. Based on harbour porpoise audiograms and the specific audiogram of the striped dolphin in the present study, and the low background noise levels during the experiment, both animals must have heard the alarm signals clearly. This study indicates that cetacean species are not equally sensitive to human-made noise disturbance. Therefore, source levels of acoustic alarms should be adapted to the species they are supposed to deter. In addition, alarms should be tested on each odontocete species for which they are intended to reduce bycatch.     

Deterring effects of 8-45 kHz tone pulses on harbour seals (Phoca vitulina) in a large pool

The marine aquaculture industry suffers losses due to pinniped attacks which damage net enclosures and fish stocks. Acoustic harassment devices (AHDs) emit loud sounds which are intended to deter pinnipeds from approaching aquaculture enclosures. At present, many AHDs emit sounds in the 8-20 kHz frequency range. It is not known whether sounds of higher frequencies have a deterrent effect on seals. Therefore five captive harbour seals (Phoca vitulina) were subjected to four series of tone pulses together spanning a broad frequency range (8, 16, 32 and 45 kHz). Pulse duration was 250 ms and pulse interval was 5s. Each of the four sounds was made deterrent by increasing the amplitude. The seals reacted by swimming away from the sounds. The displacement effect of each sound was judged by comparing the animals' surface positions, and number of surfacings, during ten 45 min baseline periods with ten 45 min test periods per frequency (one frequency per day in rotation, 40 sessions in total). The seals were displaced by all four frequencies throughout the 40 trial days. The seals came to the surface more often when the test tones were produced than in the baseline periods. The initial displacement distances did not change over the 40 test days. This suggests that operating AHDs for only short periods will be more effective and less likely to result in habituation by the seals than operating them continuously. The discomfort threshold sound pressure level (SPL) was established for each of the four pulse frequencies. The acoustic discomfort threshold SPL is defined as the boundary SPL between the area that the animals generally occupied during the transmission of the sounds and the area that they generally did not enter during sound transmission. The discomfort threshold SPL may depend on the context.