Influence of the zone of weakness on dip angle and shear heating of subducted slabs

We study the importance of the zones of weakness and the pattern of downgoing flow in steady-state models of subducting lithosphere, which interacts mechanically and thermally with the ambient mantle. The non-linear system of governing equations consists of (i) the momentum equation in stream function formulation and (ii) the steady-state heat transfer equation including conduction and advection of heat and dissipation. A finite element method has been applied to this system. We consider the viscosity to be a non-linear function of both the temperature and the stream function. In steady-state two-dimensional (2D) flow, the stream function isolines follow material trajectories. They are used to follow the top of the subducting slab, which because of its possible increase in water content, is assumed to have a lower viscosity. The zone of weakness has been thus obtained in the self-consistent fashion since the stream function as well as the temperature are the output from our modeling and no a priori assumptions about the shape of the bending lithosphere are taken into account. It was shown that several orders decrease of viscosity in the zone of weakness is required to obtain the dip angle of about 45°. If the decrease of viscosity is not sufficient enough, the subducted slab either sinks almost vertically or does not exhibit a plate-like behavior. We have also demonstrated that shear heating can unrealistically increase at the zone of weakness for fast subductions if decrease of viscosity is underestimated.     

A Modeling Study of the Effects of Anomalous Snow Cover over the Tibetan Plateau upon the South Asian Summer Monsoon

The effect of anomalous snow cover over the Tibetan Plateau upon the South Asian summer monsoon is investigated by numerical simulations using the NCAR regional climate model (RegCM2) into which gravity wave drag has been introduced. The simulations adopt relatively realistic snow mass forcings based on Scanning Multi-channel Microwave Radiometer (SNINIR) pentad snow depth data. The physical mechanism and spatial structure of the sensitivity of the South Asian early summer monsoon to snow cover anomaly over the Tibetan Plateau are revealed. The main results are summarized as follows. The heavier than normal snow cover over the Plateau can obviously reduce the shortwave radiation absorbed by surface through the albedo effect, which is compensated by weaker upward sensible heat flux associated with colder surface temperature, whereas the effects of snow melting and evaporation are relatively smaller.The anomalies of surface heat fluxes can last until June and become unobvious in July. The decrease of the Plateau surface temperature caused by heavier snow cover reaches its maximum value from late April to early May. The atmospheric cooling in the mid-upper troposphere over the Plateau and its surrounding areas is most obvious in May and can keep a fairly strong intensity in June. In contrast, there is warming to the south of the Plateau in the mid-lower troposphere from April to June with a maximum value in May.The heavier snow cover over the Plateau can reduce the intensity of the South Asian summer monsoon and rainfall to some extent, but this influence is only obvious in early summer and almost disappears in later stages.     

Nutrient limitation of the macroalgaEnteromorpha intestinalis collected along a resource gradient in a highly eutrophic estuary

We conducted a laboratory experiment to quantify nutrient (nitrogen and phosphorus) limitation of macroalgae collected along a gradient in water column nutrient availability in Upper Newport Bay estuary, a relatively nutrient-rich system in southern California, United States. We collectedEnteromorpha intestinalis and water for use in the experiment from five sites ranging from the lower end of the estuary to the head. Initial algal tissue N and P concentrations and molar N∶P ratios—as well as water column NO₃ and total Kjeldahl nitrogen (TKN)—increased along a spatial gradient from the lower end toward the head. Water column soluble reactive phosphorus (SRP) varied among sites as well but did not follow a pattem of increasing from the seaward end toward the head. Algae from each site were assigned to one of four experimental treatments: control (C), nitrogen enrichment (+N), phosphorus enrichment (+P), and nitrogen and phosphorus enrichment (+N+P). Each week for 3 wk we replaced the water in each unit with the appropriate treatment water to mimic a poorly flushed estuary. After 3 wk, the degree of nutrient limitation ofE. intestinalis varied spatially with distance from the head of the estuary. Growth ofE. intestinalis collected from several sites increased with N enrichment alone and increased further when P was added in combination with N This indicated that N was limiting and that when N was sufficient, P became limiting. Sites from whichE. intestinalis exhibited nutrient limitation spanned the range of background water column NO₃ (12.9±0.4 to 55.2±2.1 μM) and SRP (0.8±0.0 to 2.9±0.2 μM) concentrations. Algae that were N limited had initial tissue N levels ranging from 1.18±0.03 to 2.81±0.08% dry weight and molar N∶P ratios ranging from 16.75±0.39 to 26.40±1.98.     

Transport of dissolved methoxy-nonafluorobutane through a saturated column

Solute transport experiments were conducted in a one-dimensional saturated column using dissolved methoxy-nonafluorobutane (HFE-7100), a Novec engineered fluid developed by the 3M Corporation, as the solute. Novec engineered fluids are considered dense non-aqueous phase liquids (DNAPLs) because they are immiscible with water and have a specific gravity greater than one. The HFE-7100 fluid is safer and environmentally friendlier than common DNAPL contaminants such as tetrachloroethylene (PCE) or trichloroethylene (TCE); thus, it is an ideal substitute DNAPL for laboratory groundwater contamination research. Three sets of solute transport experiments were conducted. The first set of experiments was conducted in a glass-bead-packed column using dissolved HFE-7100 as the solute. The second set of experiments was conducted in a sand-packed column using dissolved HFE-7100 as the solute. The third set of experiments was conducted in a sand-packed column using dissolved PCE as the solute. The dissolved HFE-7100 column breakthrough concentrations were compared with dissolved PCE breakthrough concentrations. Results show that the one-dimensional solute transport equation was successful in describing the transport behavior of dissolved HFE-7100. This study demonstrates that the HFE-7100 fluid can be used as a safer substitute DNAPL for groundwater contaminant dissolution and transport research.     

Sediment deposition in the flood plain of Stemple Creek Watershed, northern California

Over the past 150 years, major land use changes have occurred in the Stemple Creek Watershed in northern California that have caused erosion to move soils from the upland to the flood plain, stream channels, and the bay. The purpose of this study is to document the recent (1954 to present) sediment deposition patterns in the flood plain area adjacent to Stemple Creek using the ¹³⁷Cesium technique. Sediment deposition ranged from 0.26 to 1.84 cm year⁻¹ for the period from 1964 to 2002 with an average of 0.85±0.41 cm year⁻¹. Sediment deposition rates were higher for the 1954 to 1964 period with a range of 0.31–3.50 cm year⁻¹ and an average of 1.29±1.04 cm year⁻¹. These data indicate that sediment deposition in the flood plain has decreased since the middle 1950s, probably related to reduction in row crop agriculture and an increase in pasturelands. This study shows that the flood plains in the Stemple Creek Watershed are a significant sink for the soils being eroded from the upland area. Given the significance of the flood plain for trapping eroded materials before they reach the stream channels or the bay, efforts need to be made to manage these flood plain areas to insure that they do not change and become a source rather than a sink for eroded materials as improved management practices on the upland areas reduce sediment input to the flood plain.     

Tetrahedral Plots of the Phase Relations for Basalts

The phase relations of quaternary systems are generally represented by projections onto ternary compositional planes. Such projections often obscure relationships that would only be evident in a three-dimensional tetrahedral plot. The tetrahedral plot requires that compositions of the minerals and melts be transformed into Cartesian coordinates. It is shown here how this transformation is carried out. The application is demonstrated by tetrahedral plots of experimental melt compositions of partially molten lherzolite. Furthermore, the plot can be used to evaluate whether or not a particular basaltic composition represents a primary melt. The methods are applicable to any four-component system.     

Analysis of seafloor backscatter strength dependence on the survey azimuth using multibeam echosounder data

The sediment backscatter strength measured by multibeam echosounders is a key feature for seafloor mapping either qualitative (image mosaics) or quantitative (extraction of classifying features). An important phenomenon, often underestimated, is the dependence of the backscatter level on the azimuth angle imposed by the survey line directions: strong level differences at varying azimuth can be observed in case of organized roughness of the seabed, usually caused by tide currents over sandy sediments. This paper presents a number of experimental results obtained from shallow-water cruises using a 300-kHz multibeam echosounder and specially dedicated to the study of this azimuthal effect, with a specific configuration of the survey strategy involving a systematic coverage of reference areas following “compass rose” patterns. The results show for some areas a very strong dependence of the backscatter level, up to about 10-dB differences at intermediate oblique angles, although the presence of these ripples cannot be observed directly—neither from the bathymetry data nor from the sonar image, due to the insufficient resolution capability of the sonar. An elementary modeling of backscattering from rippled interfaces explains and comforts these observations. The consequences of this backscatter dependence upon survey azimuth on the current strategies of backscatter data acquisition and exploitation are discussed.