Manganese and iron distributions off central California influenced by upwelling and shelf width

In July 2002, a combination of underway mapping and discrete profiles revealed significant along-shore variability in the concentrations of manganese and iron in the vicinity of Monterey Bay, California. Both metals had lower concentrations in surface waters south of Monterey Bay, where the shelf is about 2.5 km wide, than north of Monterey Bay, where the shelf is about 10 km wide. During non-upwelling conditions over the northern broad shelf, dissolvable iron concentrations measured underway in surface waters reached 3.5 nmol L⁻¹ and dissolved manganese reached 25 nmol L⁻¹. In contrast, during non-upwelling conditions over the southern narrow shelf, dissolvable iron concentrations in surface waters were less than 1 nmol L⁻¹ and dissolved manganese concentrations were less than 5 nmol L⁻¹. A pair of vertical profiles at 1000 m water depth collected during an upwelling event showed dissolved manganese concentrations of 10 decreasing to 2 nmol L⁻¹, and dissolvable iron concentrations of 12–20 nmol L⁻¹ in the upper 100 m in the north, compared to 3.5–2 nmol L⁻¹ Mn and 0.6 nmol L⁻¹ Fe in the upper 100 m in the south, suggesting the effect of shelf width influences the chemistry of waters beyond the shelf.These observations are consistent with current understanding of the mechanism of iron supply to coastal upwelling systems: Iron from shelf sediments, predominantly associated with particles greater than 20 μm, is brought to the surface during upwelling conditions. We hypothesize that manganese oxides are brought to the surface with upwelling and are then reduced to dissolved manganese, perhaps by photoreduction, following a lag after upwelling.Greater phytoplankton biomass, primary productivity, and nutrient drawdown were observed over the broad shelf, consistent with the greater supply of iron. Incubation experiments conducted 20 km offshore in both regions, during a period of wind relaxation, confirm the potential of these sites to become limited by iron. There was no additional growth response when copper, manganese or cobalt was added in addition to iron. The growth response of surface water incubated with bottom sediment (4 nmol L⁻¹ dissolvable Fe) was slightly greater than in control incubations, but less than in the presence of 4 nmol L⁻¹ dissolved iron. This may indicate that dissolvable iron is not as bioavailable as dissolved iron, although the influence of additional inhibitory elements in the sediment cannot be ruled out.     

Analysis of seawater for dissolved cadmium, copper and lead: An intercomparison of voltammetric and atomic absorption methods

An intercomparison study of voltammetric and atomic absorption spectrometric methods for determining cadmium, lead and copper in seawater samples was conducted. The voltammetric approach utilizes differential pulse anodic stripping voltammetry using a rotating, glassy carbon, mercury film electrode under conditions developed to minimize contamination sources and to enhance sensitivity for seawater matrices. The atomic absorption approach involves a concentration step using either an organic solvent extraction of metal dithiocarbamate chelates or a Chelex-100 column with detection by graphite furnace atomic absorption spectrometry. Similar and consistent results were obtained using both methods for the three trace metals studied on a wide range of natural seawater samples. Both methods are comparable in sensitivity for cadmium and copper, however the voltammetric method is better suited for the analysis of lead in seawater because of its enhanced sensitivity and low blank. An advantage of the voltammetric approach is its amenability towards real-time shipboard analysis.     

Channelled erosion through a marine dump site of dredge spoils at the mouth of the Puyallup River, Washington State, USA

Channels are relatively common on river-mouth deltas, but the process by which they arise from river sediment discharge is unclear because they can potentially be explained either by negatively buoyant (hyperpycnal) flows produced directly from the river outflow or by flows generated by repeated failure and mobilisation of sediment rapidly deposited at the delta front. Channels eroded through a dump site of dredge spoils are described here from multibeam and older sonar data collected in Commencement Bay, at the mouth of the Puyallup River. Shallow channels on the seaward upper surface of the dump site, away from any flows that could have been produced by delta front failures, suggest that at least some hyperpycnal flows were produced directly from the positively buoyant river outflow up to 200 m from the edge of the river mouth platform. The form of channel bed erosion is revealed by the longitudinal shape of the main eroded channel compared with the adjacent dump site profile. It suggests that the channel evolved by its steep front retreating, rather than by simple vertical entrenchment or diffusive-like evolution of the profile, a geometry interpreted as evidence that repeated failure of the bed occurred in response to shear stress imposed by bottom-travelling flows. Model calculations based on shear strengths back-calculated from the geometry of channel wall failures suggest that, if the main channel were eroded solely by hyperpycnal flows, their generation was remarkably efficient in order to create flows vigorous enough to cause channel bed failure. Besides the sediment concentration and discharge characteristics that have been considered to dictate the ability of rivers to produce hyperpycnal flows, it is suggested that the timing of floods with respect to the tidal cycle should also be important because extreme low tides may be needed to ensure that coarse sediment is transferred vigorously to the edge of river mouth platforms.     

Size-Fractionated Primary Production Estimated by a Two-Phytoplankton Community Model Applicable to Ocean Color Remote Sensing

In order to estimate primary production from ocean color satellite data using the Vertical Generalized Production Model (VGPM; Behrenfeld and Falkowski, 1997), we propose a two-phytoplankton community model. This model is based on the two assumptions that changes in chlorophyll concentration result from changes of large-sized phytoplankton abundance, and chlorophyll specific productivity of phytoplankton tends to be inversely proportional to phytoplankton size. Based on the analysis of primary production data, P _opt ^B , which was one parameter in the VGPM, was modeled as a function of sea surface temperature and sea surface chlorophyll concentration. The two-phytoplankton community model incorporated into the VGPM gave good estimates in a relatively high productive area. Size-fractionated primary production was estimated by the two-phytoplankton community model, and P _opt ^B of small-sized phytoplankton was 4.5 times that of large-sized phytoplankton. This result fell into the ranges observed during field studies.     

Long-term Sensor Drift Found in Recovered Argo Profiling Floats

We recovered three Argo profiling floats after 2 to 2.5 years of operation, and recalibrated their temperature, conductivity, and pressure sensors. The results demonstrate that these floats exhibited a significant drift in salinity of −0.0074 to −0.0125, primarily due to the conductivity sensor drift. Combined with the recalibration result for another previously recovered float, the indication is that the negative salinity drift increases nearly in proportion to the operating period of floats. The increasing rate is −0.0041 (±0.0015) year⁻¹, which yields a salinity drift of −0.016 (±0.006) for the expected float lifetime of four years. The present result suggests that reducing the float surfacing time would improve the accuracy of the salinity measurements.     

Impacts of stormwater discharges on the nearshore benthic environment of Santa Monica Bay

Although large loads of potentially toxic constituents are discharged from coastal urban watersheds, very little is known about the fates and eventual impacts of these stormwater inputs once they enter the ocean. The goal of this study was to examine the effects of stormwater discharges on the benthic marine environment of Santa Monica Bay. Sediment samples were collected across a gradient of stormwater impact following significantly sized storm events offshore Ballona Creek (a predominantly developed watershed) and Malibu Creek (a predominantly undeveloped watershed). Sediments offshore Malibu Creek had a greater proportion of fine-grained sediments, organic carbon, and naturally occurring metals (i.e., aluminum and iron), whereas sediments offshore Ballona Creek had higher concentrations of anthropogenic metals (i.e., lead) and organic pollutants (i.e., total DDT, total PCB, total PAH). The accumulation of anthropogenic sediment contaminants offshore Ballona Creek was evident up to 2 km downcoast and 4 km upcoast from the creek mouth and sediment concentrations covaried with distance from the discharge. Although changes in sediment texture, organic content, and an increase in sediment contamination were observed, there was little or no alteration to the benthic communities offshore either Ballona or Malibu Creek. Both sites were characterized as having an abundance, species richness, biodiversity and benthic response index similar to shallow water areas distant from creek mouths throughout the Southern California Bight. There was not a preponderance of pollution tolerant, nor a lack or pollution sensitive, species offshore either creek mouth.     

The regime shift of the 1920s and 1930s in the North Atlantic

During the 1920s and 1930s, there was a dramatic warming of the northern North Atlantic Ocean. Warmer-than-normal sea temperatures, reduced sea ice conditions and enhanced Atlantic inflow in northern regions continued through to the 1950s and 1960s, with the timing of the decline to colder temperatures varying with location. Ecosystem changes associated with the warm period included a general northward movement of fish. Boreal species of fish such as cod, haddock and herring expanded farther north while colder-water species such as capelin and polar cod retreated northward. The maximum recorded movement involved cod, which spread approximately 1200 km northward along West Greenland. Migration patterns of “warmer water” species also changed with earlier arrivals and later departures. New spawning sites were observed farther north for several species or stocks while for others the relative contribution from northern spawning sites increased. Some southern species of fish that were unknown in northern areas prior to the warming event became occasional, and in some cases, frequent visitors. Higher recruitment and growth led to increased biomass of important commercial species such as cod and herring in many regions of the northern North Atlantic. Benthos associated with Atlantic waters spread northward off Western Svalbard and eastward into the eastern Barents Sea. Based on increased phytoplankton and zooplankton production in several areas, it is argued that bottom-up processes were the primary cause of these changes. The warming in the 1920s and 1930s is considered to constitute the most significant regime shift experienced in the North Atlantic in the 20th century.     

Simple determination of dimethylsulfide (DMS) and dimethylsulfoniopropionate (DMSP) using solid-phase microextraction and gas chromatography-mass spectrometry

Solid-phase microextraction (SPME) is a simple, sensitive and less destructive method for the determination of dimethylsulfide (DMS) in seawater. Combined with detection by gas chromatography-mass spectrometry (GC-MS), the method had sufficient sensitivity (minimum detectable concentration of DMS was 0.05 nM), and practical levels of reproducibility (relative standard deviation ≤7%) and linearity (r ² > 0.995) over a wide concentration range (0.5 to 910 nM). The protocol developed was applied to a Sagami Bay water sample to determine concentrations of DMS and DMSP, and in situ DMSP-lyase activity.