Sediment budgeting: A case study in the Katiorin drainage basin,Kenya

The primary objective of this study was to compute a detailed budget for a small semiarid tropical drainage basin in Kenya. Results indicated that transfer of sediments (‘inputs’) from primary source areas was minor in comparison to changes in storage. The major sediment source area within the Katiorin drainage basin was the colluvial hillslope zone. The net change in storage within this zone was approximately 2100 Mg yr^?1. Surface wash and rilling were the dominant transport processes responsible for the remobilization of colluvial sediments. Sediment storage within the in-channel reservoir increased by 60 Mg yr^?1, which was minor when compared to the total store of sediment in this reservoir. During 1986, the channel network stored only a small fraction ( < 3 per cent) of the sediment delivered from the hillslope subsystem. Therefore, the in-channel reservoir had limited influence on sediment conveyance to the basin outlet. These data indicate that a static equilibrium condition cannot be assumed within the Katiorin drainage basin. Such an assumption would result in erosion estimates of approximately 5.5 mm yr^?1 for the entire basin (based on a sediment output of 7430 Mg km^?2 yr^?1 and a measured bulk density of 1.35 Mg m^?3). However, this masked the actual rates of 1.2 to 7.1 mm yr^?1 in subbasin primary source areas, and rates of 0.6 to 17 mm yr^?1 for colluvial material in the various subbasins. The extreme accelerated erosion rates resulted from minimal ground vegetation, steep slopes, soil crust formation, an erodible substrate, and a well-integrated drainage network for rapid conveyance of sediments from the hillslope subsystem to the basin outlet.     

The mechanical state of the lithosphere in the Altiplano-Puna segment of the Andes

Information about topography, the shape of the geoid, seismicity, Neogene deformation and volcanism in the region of Altiplano-Puna of western South America is used to analyse the state of stress across the convergent plate margin in terms of the effects of topography and simple models of its compensation. An average elevation near 4 km is consistent with compensation by a yet unresolved combination of crustal root and hot uppermost mantle producing a geoid high of 22–27 meters, average horizontal compressive stress (in excess of a reference sea level lithostatic value) of 390 bars in a 150 km thick lithosphere, and an average shear stress of 170 bars along a 30° dipping interplate boundary. The basis for these estimates is evidence for a neutral to extensional stress regime within the high plateau contrasted with a compressional regime on the eastern slopes and along the interplate boundary itself. Comparison with other plateaus in a convergent plate tectonic setting suggests an evolutionary sequence from compressional to extensional tectonics as elevation of the plateau increases.     

Iron metal production in silicate melts through the direct reduction of Fe(II) by Ti(III), Cr(II), and Eu(II)

The production of metallic iron in silicate melts by the chemical reactions, 2Ti³⁺_(melt) + Fe²⁺_(melt) → 2Ti⁴⁺_(melt) + Fe⁰_(crystal)2Cr²⁺_(melt) + Fe²⁺_(melt) → 2Cr³⁺_(melt) + Fe⁰_(crystal)2Eu²⁺_(melt)+ Fe²⁺_(melt) → 2Eu³⁺_(melt) + Fe⁰_(crystal) has been demonstrated under experimental conditions in a simplified basaltic liquid, Such reactions may occur in lunar basalts and other reduced systems, and, thus, may aid in the understanding of the reduced nature of lunar basalts. The reactions were studied in a glass-forming Na-Ca-Mg-Al-silicate composition at a melt temperature of 1250°C and an imposed oxygen fugacity at the C/CO buffer (1 atm total pressure). Microtitrations of individually-doped samples were used in the quantitative assessment of their redox ratios and for the calibration of visible and near-infrared spectral absorptions. These spectral absorptions were then applied to the evaluation of the mutual redox interactions in dual-doped samples.     

Gully‐head erosion processes on a semi‐arid valley floor in Kenya: a case study into temporal variation and sediment budgeting

A three year monitoring programme of gully‐head retreat was established to assess the significance of sediment production in a drainage network that expanded rapidly by gully‐head erosion on the low‐angled alluvio‐lacustrine Njemps Flats in semi‐arid Baringo District, Kenya. This paper discusses the factors controlling the large observed spatial and temporal variation in gully‐head retreat rates, ranging from 0 to 15 m a^?1. The selected gullies differed in planform and in runoff‐contributing catchment area but soil material and land use were similar. The data were analysed at event and annual timescales. The results show that at annual timescale rainfall amount appears to be a good indicator of gully‐head retreat, while at storm‐event timescale rainfall distribution has to be taken into account. A model is proposed, including only rainfall (P) and the number of dry days (DD) between storms: which explains 56 per cent of the variation in retreat rate of the single‐headed gully of Lam1. A detailed sediment budget has been established for Lam1 and its runoff‐contributing area (RCA). By measuring sediment input from the RCA, the sediment output by channelized flow and linear retreat of the gully head for nine storms, it can be seen that erosion shifts between different components of the budget depending on the duration of the dry period (DD) between storms. Sediment input from the RCA was usually the largest component for the smaller storms. The erosion of the gully head occurred as a direct effect of runoff falling over the edge (GH_waterfall) and of the indirect destabilization of the adjacent walls by the waterfall erosion and by saturation (GH_mass/storage). The latter component (GH_mass/storage) was usually much larger that the former (GH_waterfall). The sediment output from the gully was strongly related to the runoff volume while the linear retreat, because of its complex behaviour, was not. Overall, the results show that the annual retreat is the optimal timescale to predict retreat patterns. More detailed knowledge about relevant processes and interactions is necessary if gully‐head erosion is to be included in event‐based soil erosion models. Copyright © 2001 John Wiley & Sons, Ltd.     

Using winter flounder growth rates to assess habitat quality across an anthropogenic gradient in Narragansett Bay, Rhode Island

We used growth rates of juvenile winter flounderPseudopleuronectes americanus to assess anthropogenic influence on habitat quality at three sites in Narragansett Bay, Rhode Island. The upper bay site, Gaspee Point, had the highest population density and concentration of total nitrogen; human inputs decreased down bay. Growth rates of individually marked fish were measured in three 15-d experiments from June 8 to July 6, 1998 in 1-m² cages placed at upper, middle, and lower bay sites. Water temperature, salinity, dissolved oxygen (DO), and benthic food were also measured. Stable isotopes of nitrogen and carbon were measured in experimental fish as possible indicators of nutrient enrichment and to identify organic carbon sources. Growth rates were 0.22–0.60 mm d⁻¹, with the highest average at the mid-bay site. Growth was initially fastest at Gaspee Point, but dropped off as DO concentrations fell. Step-wise multiple regression indicated that location (upper, middle, or lower bay) explained most of the variability in fish growth (40%). Coefficients of other significant variables indicated that fish grew faster at lower salinities, smaller sizes, and with decreased time that DO was below 2.3 mg l⁻¹. Benthic prey varied among sites and there was significantly less food and fewer species at Gaspee Point.Polydora cornuta was a favored food at all sites and was found in over half the stomachs. Values of δ¹⁵N in fish and sediments did not reflect differences in total nitrogen concentrations recorded near the sites. We suggest that anthropogenic influences, such as nutrients and sewage, affected habitat quality by reducing DO, which lowered fish growth rates.     

Pyrometamorphism and partial melting of shales during combustion metamorphism: mineralogical,textural, and chemical effects

Eocene shales metamorphosed by a naturally ignited coal seam in the Powder River Basin, Wyoming record a continuum of mineralogic and textural changes from relatively unaltered shale to melt developed during pyrometamorphism. Samples collected along a section 2 m in length, corresponding to a temperature range of approximately 1300°C, were examined optically and by XRD, SEM, and STEM. The low temperature samples are comprised primarily of silt-sized quartz, K-feldspar, and minor amounts of other detrital minerals in a continuous matrix of illite/smectite (I/S). Delamination of phyllosilicates due to dehydroxylation occurs early in the sequence with curling of individual layers from rim to core. Within one-half meter of melted areas, phyllosilicates have undergone an essentially isochemical reconstitution with nucleation and growth of mullite crystals with maximum diameters of 50 nm, randomly distributed within a non-crystalline phase that replaces I/S. Large detrital grains remain for the most part unaffected except for the inversion of quartz to tridymite/cristobalite. Within 1 mm of the solid/melt interface, the mullitebearing clay mineral matrix is essentially homogeneous in composition with obscure grain boundaries, caused by apparent homogenization of poorly crystalline material. This material is similar in composition to parent clays and acts as a matrix to angular, remnant tridymite/cristobalite grains. Rounded, smaller silica grains have reaction rims with the non-crystalline matrix; K-feldspar is no longer present (apparently reacted with the matrix) and the matrix contains abundant pore space due to shrinkage upon dehydroxylation. As isolated pods of paralava (glass) or fractures are approached, Fe–Ti–Al oxides become abundant. Vesicular glass is separated from clinker by a well-defined interface and contains numerous phenocrysts. XRF analyses and reduced area rastering using EDS imply enrichment of the melt phase in Fe, Ca, Mg and Mn, apparently due to vapor transport from other layers lower in the sedimentary sequence.Contribution No. 490, the Mineralogical Laboratory, Department of Geological Sciences, The University of Michigan     

Microwave Remote Sensing of the Temperature and Distribution of Sulfur Compounds in the Lower Atmosphere of Venus

A multi-wavelength radio frequency observation of Venus was performed on April 5, 1996, with the Very Large Array to investigate potential variations in the vertical and horizontal distribution of temperature and the sulfur compounds sulfur dioxide (SO₂) and sulfuric acid vapor (H₂SO₄(g)) in the atmosphere of the planet. Brightness temperature maps were produced which feature significantly darkened polar regions compared to the brighter low-latitude regions at both observed frequencies. This is the first time such polar features have been seen unambiguously in radio wavelength observations of Venus. The limb-darkening displayed in the maps helps to constrain the vertical profile of H₂SO₄(g), temperature, and to some degree SO₂. The maps were interpreted by applying a retrieval algorithm to produce vertical profiles of temperature and abundance of H₂SO₄(g) given an assumed sub-cloud abundance of SO₂. The results indicate a substantially higher abundance of H₂SO₄(g) at high latitudes (above 45°) than in the low-latitude regions. The retrieved temperature profiles are up to 25 K warmer than the profile obtained by the Pioneer Venus sounder probe at altitudes below 40 km (depending on location and assumed SO₂ abundance). For 150 ppm of SO₂, it is more consistent with the temperature profile obtained by Mariner 5, extrapolated to the surface via a dry adiabat. The profiles obtained for H₂SO₄(g) at high latitudes are consistent with those derived from the Magellan radio occultation experiments, peaking at around 8 ppm at an altitude of 46 km and decaying rapidly away from that altitude. At low latitudes, no significant H₂SO₄(g) is observed, regardless of the assumed SO₂ content. This is well below that measured by Mariner 10 (Lipa and Tyler 1979, Icarus39, 192-208), which peaked at ∼14 ppm near 47 km. Our results favor ≤100 ppm of SO₂ at low latitudes and ≤50 ppm in polar regions. The low-latitude value is statistically consistent with the results of Bézard et al. (1983, Geophs. Res. Lett.20, 1587-1590), who found that a sub-cloud SO₂ abundance of 130±40 ppm best matched their observations in the near-IR. The retrieved temperature profile and higher abundance of H₂SO₄(g) in polar regions are consistent with a strong equatorial-to-polar, cloud-level flow due to a Hadley cell in the atmosphere of Venus.     

Risk analysis of possible impacts of climate change on South Australian wheat production

This study presents a model-based risk assessment of wheat production under projected climate change by 2080 in eight locations of South Australia. The vulnerability of wheat production under future climate change was quantitatively evaluated via a risk analysis in which the identification of critical yield thresholds applies. Research results show that risk (conditional probability of not exceeding the critical yield thresholds) increased more or less across all locations under the most likely climate change. Wheat production in drier areas such as Minnipa, Orroroo and Wanbi will not be economically viable under the most likely climate change. Intensive studies on adaptation are now required.     

A Similarity Model for Maximum Ground-Level Concentration in a Freely Convective Atmospheric Boundary Layer

A model of buoyancy- and momentum-driven industrial plumes in a freely convective boundary layer is proposed. The development combines the Lagrangian similarity models of Yaglom for non-buoyant releases in the convective surface layer with the Scorer similarity model for industrial plumes. Constraints on the validity of the extension of Yaglom’s model to the entire convective planetary boundary layer, arrived at by consideration of Batchelor’s formulation for diffusion in an inertial subrange, are often met in practice. The resulting formulation applies to an interval of time in which the entrainment of the atmosphere by the plume is balanced by the entrainment of the plume by the atmosphere. It is argued that during this interval, both maximum plume rise and ground contact are achieved. Further examination of the physical interrelationship with the Csanady-Briggs formulation serves to consolidate the model hypotheses, as well as to simplify the derivation of maximum ground-level concentrations. Experimental evidence is presented for the validity of the model, based on Moore’s published data.     

Runoff and erosion processes and rates in the Zin valley badlands,northern Negev,Israel

Badland areas are usually regarded as impermeable zones which generate high runoff and are very vulnerable to sheetwash and rainsplash. To test those considerations sprinkling experiments using two rainfall simulators were carried out on slopes of varying aspect in the northern Negev (Israel). For one unit 1·5 m² plots were used with rainfall of natural characteristics at 36 mm/hr intensity and 43–48 minute duration, runoff being recorded and water/sediment samples taken every 5 minutes. The second unit was used on 30–50 m² plots but rainfall energy production was below that of natural rainfall. Results show that due to the high stability and strong flocculation of clay-rich aggregates rainsplash is ineffective in surface sealing so that infiltration capacities remain high despite intense, prolonged rainfall. Aspect differences are reflected in variation of surface properties despite homogenous bed-rock, which cause marked differences in hydrological response. North-facing slopes respond more quickly, more frequently and produce more runoff than south-facing slopes. Non-uniform runoff generation is also seen within plots of one aspect reflecting subtle variations in surface properties. Comparison of rainfall intensity and duration used during the experiments with those prevailing under natural conditions shows that under present day conditions surface flow in the Zin valley badlands must be extremely infrequent and denudation rates very low.