Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.     

Fast genetic mapping in barley: case studies of cuticle mutants using RNA-sequencing

Barley(Hordeum vulgare L.) is one of the earliest domesticated crop species and ranked as the fourth largest cereal production worldwide. Forward genetic studies in barley have greatly advanced plant genetics during the last century; however, most genes are identified by the conventional mapping method. Array genotyping and exome-capture sequencing have also been successfully used to target the causal mutation in barley populations, but these techniques are not widely adopted because of associated costs and partly due to the huge genome size of barley. This review summarizes three mapping cases of barley cuticle mutants in our laboratory with the help of RNA-sequencing. The causal mutations have been successfully identified for two of them and the target genes are located in the pericentromeric regions. Detailed information on the mapping-by-sequencing, mapping-and-sequencing, and RNA-sequencing assisted linkage mapping are presented and some limitations and challenges on the mapping assisted by RNA sequencing are also discussed. The alternative and elegant methods presented in this review may greatly accelerate forward genetics of barley mapping, especially for laboratories without large funding.     

SDSS J143030.22-001115.1： A Misclassified Narrow-line Seyfert 1 Galaxy with Flat X-ray Spectrum

We used multi-component profiles to model the Hβ and [OⅢ]λλ4959,5007 lines of SDSS J143030.22-001115.1, a narrow-line Seyfert 1 galaxy (NLS1) in a sample of 150 NLS1 candidates selected from the Sloan Digital Sky Survey (SDSS), Early Data Release (EDR). After subtracting the Hβ contribution from narrow line regions (NLRs), we found that its full width half maximum (FWHM) of broad Hβ line is nearly 2900km s~(-1) , significantly larger than the customarily adopted criterion of 2000 km s~(-1) . With its weak Fe Ⅱ multiples, we believe that SDSS J143030.22-001115.1 should not be classified as a genuine NLS1. When we calculate the virial black hole masses of NLS1s, we should use the Hβ linewidth after subtracting the NLR component.     

Multistep matched-field inversion for broad-band data from ASIAEX2001

This paper discusses the results of geoacoustic inversion carried out using explosive charge data from the Asian Seas International Acoustic Experiment (ASIAEX) East China Sea (ECS) Experiment. A multifrequency incoherent matched-field inversion processor and a genetic algorithm (GA) are used for the inversion. A multistep matched field inversion approach is presented, which makes use of the varying sensitivities of wave fields at various frequencies to reduce the inversion problem into a sequence of smaller inversions with fewer unknowns to estimate at each stage. Different parameters are estimated using data at different frequencies according to their sensitivities. Inversion results for different areas in the ECS region are summarized and compared with core data.     

Study on numerical simulation to water lowering in an open coal mine digging

In view of the situation of excavation of open coal mine for the underground water disaster,we should carry out simulation studies for the numerical value of the water lowering project and improve the accuracy and the level of the water lowering project.On the basis of the hydrological geological conditions of certain open mine digging,a more reasonable seepage numerical model was built according to MODFLOW.It was simulated in advance that the process of the confined water level descending with the time,and combining with the actual observations to test the correctness of the model.The calculation showed that the results coincided well with the results of actual measurement.Based on this,different water lowering numerical simulations were built for the open coal mine digging.It could be simulated and forecast that the changes of the groundwater level in drainage process within and outside the mine pit,and it was quantitatively assessed that the possible water lowering result of the opencast water drainage process,which provide an important basis for the actual water lowering project and the possible project disposal.     

激光天文动力学弱光锁相的研究

近年来激光物理与应用的进展促成了激光天文动力学空间任务概念的提出。在激光天文动力学任务概念研究方面 ,必须对由远程航天器上传回的激光进行讯号的测量与处理。激光经过长距离的传输后 ,功率大幅下降 ,因此在空间任务概念的考虑上 ,弱光锁相是计划中关键性的技术。由航天器射来的激光 ,经过望远镜聚光后与本地激光进行锁相 ,由本地激光承载及传达太空激光的相位信息。实验中 ,我们使用 2支半导体激光泵浦非平面环形共振腔钇镏石激光 (Diodelaserpumpednon -planarringcavityNd :YAGlaser) ,分别代表远程的弱光及代表本地的强光 ,建立弱光锁相环路系统 (weak -lightphase -lockedloopsystem)。以中性光强度滤光器 (ND -filter;neutraldensityfilter)减弱光讯号来仿真远程激光传来的弱光。在相位探测部分使用均衡探测法 ,消除激光强度噪声 ,以提高讯噪比。同时配合适当的环路滤波器 ,控制激光频率 ,提高锁相的能力。对 2nW的弱光与 2mW的强光可长时间锁相 ,其均方根相位误差为 57mrad。 2 0 0pW的弱光与 2 0 0 μW的强光锁相时间可达 2h以上 ,其相位误差为 2 0 0mrad。 2 0pW的弱光与 2 0 0 μW的强光锁相时间亦可达 2h以上 ,其相位误差为 1 60mrad。最后 ,我们对 2pW的弱光与 2 0 0 μW的强光锁相 ,     

Theory of stability, and regulation and control of ecological system in oasis

Starting with analysis on the evolving course of oasis and the characteristics and evolution of transitional zone between oasis and desert, in consideration of ecological elements including plant stomata resistance, area covered by vegetation, and physical elements including albedo of vegetation and bare soil, atmosphere temperature, and humidity, under the condition of the balance among net radiation flux, latent heat flux, and sensible heat flux, the following are calculated: temperatures of vegetation and bare soil in different conditions, as well as the evapotranspiration rate of ecosystem. Analysis on evapotranspiration rate indicates that it depends on both the climate of environment and the physiological and ecological conditions of plants. On certain conditions, the evapotranspiration rate of transitional zone between oasis and desert (i.e. area covered by vegetation less than 20%), in some parameter domains, appears in bifurcation or multiequilibrium state. Meanwhile, in such area, ecosystem is extremely unstable. Any minor change to the balance will cause either increase or reduction of area covered by vegetation in ecosystem, on the basis of discussion on the emergency of these phenomena. This paper is attempting to propose an effective way of destruction and rebuilt ecosystem in transitional zone. The way is to control the evaporation of plant through selecting anti-drought country plant with big stomata resistance, and modify the roughness of the underlying surface in ecosystem by establishing rational interspace structure of plant community, so as to put the degenerative ecosystem into the natural succession track. This primary theory is being verified through observation and analysis on historical data.     

Zircon U–Pb and Hf isotopic study of gneissic rocks from the Chinese Altai: Progressive accretionary history in the early to middle Palaeozoic

Gneissic rocks in the Chinese Altai Mountains have been interpreted as either Paleozoic metasedimentary rocks or Precambrian basement. This study reports geochemical and geochronological data for banded paragneisses and associated gneissic granitoids collected along a NE–SW traverse in the northwestern Chinese Altai. Petrological and geochemical data suggest that the protoliths of the banded gneisses were possibly immature sediments with significant volcanic input and that the gneissic granitoids were derived from I-type granites formed in a subduction environment. Three types of morphological features can be recognized in zircons from the banded gneisses and are interpreted to correlate with different sources. Zircons from five samples of banded paragneiss cluster predominantly between 466 and 528 Ma, some give Neoproterozoic ages, and a few yield discordant Paleoproterozoic to Archean ages. Zircon Hf isotopic compositions indicate that both juvenile/mantle and crust materials were involved in the generation of the source rocks from which these zircons were derived. In contrast, zircons occur ubiquitously as elongated euhedral prismatic crystals in the four samples of the gneissic granitoids, and define single populations for each sample with mean ages between 380 and 453 Ma. The general absence of Precambrian inheritance and positive zircon ?Hf values for these granitoids suggest insignificant crustal contribution to the generation of the precursor magmas. Our data can be interpreted in terms of a progressive accretionary history in early to middle Palaeozoic times, and the Chinese Altai may possibly represent a magmatic arc built on a continental margin dominated by Neoproterozoic rocks.     

桩静载荷试验快速法与慢速法对比研究

通过对54根管桩静载荷试验快速法与慢速法对比试验研究,找出了在各级荷载作用下,快速法与慢速法沉降差异规律及快速法与慢速法分别得出的极限承载力差异规律;得出了将快速法静载试验下的沉降及单桩极限承载力修正成慢速法静载试验的沉降及单桩极限承载力的公式;提出了适应天津地区管桩的快速法静载试验方法。     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。