共查询到20条相似文献,搜索用时 93 毫秒
1.
2-(2-咪唑偶氮)-5-二乙氨基酚与钒的显色反应及其应用 总被引:1,自引:1,他引:0
研究了新试剂 2 - (2 -咪唑偶氮 ) - 5-二乙氨基酚 (IZAPN)与V(Ⅴ )的显色反应 ,在pH 5的HAc NaAc介质中 ,V(Ⅴ )与IZAPN形成稳定的紫红色络合物 ,其组成比为nV∶nR=1∶2 ,最大吸收波长位于 575nm ,表观摩尔吸光系数为 2 96× 1 0 4 L·mol- 1 ·cm- 1 ,V(Ⅴ )在 0~ 0 8mg/L内服从比尔定律。在NaF和硫脲联合掩蔽下 ,方法可用于铝合金和合成废水中V(Ⅴ )的测定 ,加标回收率 1 0 0 0 %~ 1 0 0 5% ,RSD(n =6)≤ 2 0 %。 相似文献
2.
3.
4.
报道了1-(4-硝基苯基)-3-(3-硝基-5-氯吡啶)三氮烯(NPNCPDT)的合成及其与锌的显色反应研究。在Triton X-100存在下,pH 10.5的Na2B4O7-NaOH缓冲溶液中,该试剂能与锌发生显色反应,锌与NPNCPDT形成摩尔比为1∶2的黄色配合物,在450 nm处有一最大正吸收,540 nm处有一最大负吸收。以450 nm为参比波长、540 nm为测量波长进行双波长测定,表观摩尔吸光系数为2.50×105L.mol-1.cm-1。锌量在0~480μg/L符合比尔定律。用拟定方法测定人发中的微量锌,方法精密度小于2.5%(RSD,n=6)。 相似文献
5.
6.
2-(2-苯并噻唑偶氮)-5-二羧甲氨基苯甲酸的合成及其应用——多元显色体系光度法测定金属材料中的镍 总被引:2,自引:0,他引:2
报道了新显色剂2-(2-苯并噻唑偶氮)-5-二羧甲氨基苯甲酸(BTACB)的合成,研究了在十二烷基硫酸钠(NaLS)存在下Ni~(2+)与BTACB形成蓝紫色配合物的条件,其λ_(max)~(MR)=600nm,ε=2.79×10~4L·mol~(-1)·cm~(-1),Ni在0~0.6μg/ml范围内服从比尔定律,反应具有一定的选择性。方法已用于直接测定铝合金、纯镁及含一定量Co的钢铁中痕量Ni和经萃取分离后测定纯钴中痕量Ni。 相似文献
7.
研究了2-[2-(6-氯苯并噻唑)偶氮]-5-二乙氨基苯甲酸(6-Cl-BTAEB)与Ni2+的显色反应。结果表明:在pH4.5~7.6的HAc-NaAc缓冲溶液中及十二烷基硫酸钠存在下,试剂与Ni2+形成稳定的蓝紫色配合物,组成为n(Ni2+)∶n(6-Cl-BTAEB)=1∶2,最大吸收波长650nm,表观摩尔吸光系数为1.59×105L·mol-1·cm-1,Ni2+浓度在0~400μg/L内符合比尔定律。用铝合金和合金钢中的微量镍验证该分析方法,所得结果与推荐值相符,6次测定的RSD<2%。 相似文献
8.
2-(2-喹啉偶氮)-1,3-二羟基苯固相萃取光度法测定水中铀 总被引:2,自引:0,他引:2
研究了2-(2-喹啉偶氮)-1,3-二羟基苯(QADHB)与铀的显色反应,在TritonX-100和F-存在下,pH7.8的三乙醇胺-HCl缓冲介质中,QADHB与U(Ⅵ)、F-反应生成1∶1∶1紫色三元稳定配合物,配合物的λmax=560nm,ε=7.41×104L·mol-1·cm-1。铀含量在0~2000μg/L内符合比尔定律。环境水样中的铀经磷酸三丁脂萃淋树脂固相萃取柱分离和富集后测定。方法已用于实际样品的测定,分析结果与国标(5-Br-PADAP)法一致,相对标准偏差(n=5)为2.4%~4.7%,回收率为96%~105%。 相似文献
9.
1-(2,6-二溴-4-硝基苯)-3-(4-硝基苯)-三氮烯光度法测定铜 总被引:21,自引:3,他引:21
建立了用 1 - ( 2 ,6-二溴 - 4-硝基苯 ) - 3- ( 4 -硝基苯 ) -三氮烯 (DBNPNPT)分光光度法直接测定铜矿及铝合金样品中铜的方法。在表面活性剂TritonX - 1 0 0的存在下 ,pH在 9.5~ 1 1 .5的Na2 B4O7-NaOH介质中 ,DBNPNPT与Cu2 +可生成黄色络合物 ,以 5 35nm为参比波长 ,45 0nm为测定波长的双峰双波长法进行测定 ,表观摩尔吸光系数可达 1 .1 1× 1 0 5L·mol- 1 ·cm- 1 ,Cu2 +的质量浓度在 0~ 360 μg/L符合比尔定律。方法用于铜矿中铜的测定 ,结果与原子吸收法吻合。对于w(Cu)为 0 .1 1 %的BY2 1 70 - 1铝合金试样测定 1 0次 ,其RSD为3.4%。 相似文献
10.
11.
12.
Dietrich Gurlitt 《International Journal of Earth Sciences》1939,30(7-8):765-776
13.
Background
Reactive-transport simulation is a tool that is being used to estimate long-term trapping of CO2, and wellbore and cap rock integrity for geologic CO2 storage. We reacted end member components of a heterolithic sandstone and shale unit that forms the upper section of the In Salah Gas Project carbon storage reservoir in Krechba, Algeria with supercritical CO2, brine, and with/without cement at reservoir conditions to develop experimentally constrained geochemical models for use in reactive transport simulations.Results
We observe marked changes in solution composition when CO2 reacted with cement, sandstone, and shale components at reservoir conditions. The geochemical model for the reaction of sandstone and shale with CO2 and brine is a simple one in which albite, chlorite, illite and carbonate minerals partially dissolve and boehmite, smectite, and amorphous silica precipitate. The geochemical model for the wellbore environment is also fairly simple, in which alkaline cements and rock react with CO2-rich brines to form an Fe containing calcite, amorphous silica, smectite and boehmite or amorphous Al(OH)3.Conclusions
Our research shows that relatively simple geochemical models can describe the dominant reactions that are likely to occur when CO2 is stored in deep saline aquifers sealed with overlying shale cap rocks, as well as the dominant reactions for cement carbonation at the wellbore interface. 相似文献14.
15.
Guo XuequanSoutheast Hubei Geological Party Hubei Bureau of Geology Mineral Resources Daye Hubei 《《地质学报》英文版》1994,68(3)
This paper discusses geological-geophysical-geochemical models of such typical deposits as the Tieshan-type Fe-Cu deposit, the Tonglushan-type Cu-Fe deposit, the Yehuaxiang-type Cu deposit, the Jiguanzui-type Cu-Au deposit, and the Tongshankou-type Cu (Mo) deposit. The models were established based on practical data of the polymetallic deposits dominated by copper ore in southeastern Hubei. These models, which are graphically illustrated in the paper, systematically summarize the metallogenic geological conditions and the geophysical-geochemical characteristics of copper deposits in this area. The models are of practical significance for studying copper deposits, predicting mineral resources, choosing exploration methods, and searching for ore deposits based on existing ones in the study area. 相似文献
16.
多极距中梯测深法是一种效率高、信息丰富的新型体积测深技术,而当前常规多极距中梯测深应用与研究多数局限于二维空间,其三维正反演一直是人们研究的热点。本文在四面体交错网格剖分基础上,采用有限单元法对球体等三维模型进行多极距中梯测深数值模拟计算。研究表明,三维数值模拟可有效反映模型的空间分布;在不增加太多工作量的情况下,实现高效体积测深;电阻率和极化率参数模拟相结合分析,模拟精度高,稳定性好;开展倾斜铜板、铜块水槽物理模拟,模拟结果较好反映了模型的空间及电性分布,验证了多极距中梯测深的可行性和正确性,为该方法的实际应用及后续的反演工作提供了重要依据。 相似文献
17.
Guo Xuequan 《《地质学报》英文版》1994,7(3):299-309
Abstract This paper discusses geological - geophysical - geochemical models of such typical deposits as the Tieshan - type Fe-Cu deposit, the Tonglushan - type Cu - Fe deposit, the Yehuaxiang - type Cu deposit, the Jiguanzui-type Cu - Au deposit, and the Tongshankou - type Cu(Mo) deposit. The models were established based on practical data of the polymetallic deposits dominated by copper ore in southeastern Hubei. These models, which are graphically illustrated in the paper, systematically summarize the metallogenic geological conditions and the geophysical-geochemical characteristics of copper deposits in this area. The models are of practical significance for studying copper deposits, predicting mineral resources, choosing exploration methods, and searching for ore deposits based on existing ones in the study area. 相似文献
18.
19.